English dropdown-ico

Manual TOA Electronics N-CC2360

20 pages 0.57 mb
Download

Go to site of 20

Summary
  • TOA Electronics N-CC2360 - page 1

    NETWORK COLOR CAMERA N-CC2360 INSTRUCTION MANUAL 1. SAFETY PRECAUTIONS .......................... 2 2. LIST OF INCLUDED COMPONENTS AND PARTS ............ 3 3. GENERAL DESCRIPTION ........................ 4 4. HANDLING PRECAUTIONS ..................... 4 5. NOMENCLATURE ..................................... 5 6. INSTALLATION ........................ ...

  • TOA Electronics N-CC2360 - page 2

    2 1. SAFETY PRECAUTIONS • Before installation or use, be sure to carefully read all the instructions in this section for correct and safe operation. • Be sure to follow all the precautionary instructions in this section, which contain important warnings and/or cautions regarding safety. • Keep this instruction manual handy for future referenc ...

  • TOA Electronics N-CC2360 - page 3

    3 Indicates a potentially hazardous situation which, if mishandled, could result in moderate or minor personal injury, and/or property damage. CAUTION When Installing the Unit • Avoid installing the unit in humid or dusty locations, in locations exposed to the direct sunlight, near the heaters, or in locations generating sooty smoke or steam as d ...

  • TOA Electronics N-CC2360 - page 4

    4 3. GENERAL DESCRIPTION 4. HANDLING PRECAUTIONS • Do not direct the camera lens to the sun or strong lighting or light reflection. Exposure to direct sunlight could cause the CCD's color filter to deteriorate, leading to image discoloration. • Do not give the camera a great shock or vibration, as this will damage the camera. • It is rec ...

  • TOA Electronics N-CC2360 - page 5

    5 (1) Power Input Terminal [24 V AC, 24 V DC] Connect this terminal to the 24 V AC or 24 V DC power supply. Note Do not connect 24 V AC or 24 V DC power when using a PoE-compatible hub. (2) Indicators [RDY BUSY ERR] RDY (green): Remains lit during normal operation. BUSY (yellow): Lights continuously during communications. ERR (red): Lights when an ...

  • TOA Electronics N-CC2360 - page 6

    6 Ceiling surface Lock lever Camera mounting bracket (optional) Pedestal Camera mount Camera mount Pedestal Camera mounting bracket (optional) Lock lever Camera mounting bracket (optional) W all surface W all surface LENS 1 3 2 4 Lens connector 1 2 3 4 Lens connector pin No. DC input type Damping coil Damping coil Driving coil Driving coil – – ...

  • TOA Electronics N-CC2360 - page 7

    7 6mm or less Lens • To avoid damaging the internal sections of the camera's lens mount, be sure that the lens flange is 6 mm or less thick as illustrated on the right. • C-mount lenses must be used in conjunction with the Lens Mounting Adapter CF-5 (optional). Notes 3. Mount the optional Camera Mounting Bracket to the ceiling or wall. The ...

  • TOA Electronics N-CC2360 - page 8

    8 7.1. Connection Example PoE compatible HUB Software Decorder 10BASE-T/ 100BASE-TX 10BASE-T/ 100BASE-TX 24V 2 1 24V 12C12C 10/100M PoE AUDIO OUT MONITOR OUT OUT IN CONT ACT RDY BUSY ERR FD/COL LINK /ACT AC Mains 1 2 3 4 5 6 7 8 DC-IN 100BASE-TX/1000BASE-T Network Color Camera N-CC2360 N-SD2000 N-VR2010 Network Video Receiver BNC plug (optional) Pi ...

  • TOA Electronics N-CC2360 - page 9

    9 8. ADJUSTMENT 1. The RDY indicator lights when the power is supplied to the network camera. 2. Connect the monitor output terminal to the monitor so that the picture may be displayed on the monitor. 3. Set the Flicker-reduction switch of the mode switch to "ON" position if flicker is annoying. Flickering of the picture may interfere wit ...

  • TOA Electronics N-CC2360 - page 10

    10 6. Adjust the iris level • When using the DC input type lens Adjust the iris level on the Camera menu screen's "IRIS" item. 6-1 Check to confirm that Camera menu setting items are selected as follows. Lens selection: "DC" Backlight compensation: "OFF" ( factory default: OFF ) 6-2 Moving the bar toward "H ...

  • TOA Electronics N-CC2360 - page 11

    11 F. A D J ANTI - FLICKER NC OFF ON Mode switch Focus adjustment switch Flicker-reduction switch Not used. Mode switch ( factory default ) [ N-CC2360 ] F. A D J ANTI-FLICKER NC ON OFF INITIALIZE RESET OFF ON OFF ON OFF ON OFF ON 9. ABOUT THE MODE SWITCH Set each switch to the position that provides the best picture reproduction. • Focus adjustme ...

  • TOA Electronics N-CC2360 - page 12

    12 No. 1 2 3 4 5 6 IN 1 IN 2 C OUT 1 OUT 2 C Contact input 1 Contact input 2 COM Contact output 1 Contact output 2 COM T erminal Name Contact name Day/ Night Select Contact input 1 or Contact input 2. COM IN GND 1 2 3 4 5 6 Color: Open Black & white: Closed The figure shows that IN1 Contact Input/Output terminal is set to Day/Night Input termin ...

  • TOA Electronics N-CC2360 - page 13

    13 1 1. SETTING INITIALIZA TION Network settings can be reset to their factory defaults. 1. Either press the Reset key or switch on the power again while holding down the INITIALIZE key. 2. Continue to press the INITIALIZE key until the Ready indicator has switched from flashing to steady-on mode. Note To return camera settings other than those use ...

  • TOA Electronics N-CC2360 - page 14

    14 12. TROUBLESHOOTING Remedy Supply power independently to the Camera. Confirm that the cable type (category, null modem or straight) is appropriate for the connected port, then connect correctly. If the rough noise is annoying and distracting, lower the AGC level. If the after image is annoying and distracting, decrease the Slow Shutter magnifica ...

  • TOA Electronics N-CC2360 - page 15

    15 24 V AC, 50/60 Hz or 24 V DC or PoE (IEEE802.3af) 13 W (at 24 V AC), (8 W: PoE, 350mA: 24 V DC) Screwless connector (Solid cable: ø 0.4– ø 1.2 mm (AWG 26 – 16), Stranded cable: 0.3–1.25 mm 2 (AWG 22 – 16) VBS 1.0 V(p-p), 75 Ω , RCA pin jack, NTSC Omnidirectional, electret condenser microphone 1channel, –10 dB * , low impedance, unba ...

  • TOA Electronics N-CC2360 - page 16

    16 Note: The design and specification are subject to change without notice for improvement. MPEG-4: max. 4 Mbps 5 (MPEG-4: 4, JPEG: 1) In streaming mode: No limit (MPEG-4 only) Password authentication, Motion detection – 10°C to + 50°C (continuously active for operation at temperature below 0°C) 14°F to 122°F (continuously active for operati ...

  • TOA Electronics N-CC2360 - page 17

    17 24 V AC, 50/60 Hz or 24 V DC or PoE (IEEE802.3af) 13 W (at 24 V AC), (8 W: PoE, 350mA: 24 V DC) Screwless connector (Solid cable: ø 0.4– ø 1.2 mm (AWG 26 – 16), Stranded cable: 0.3–1.25 mm 2 (AWG 22 – 16) VBS 1.0 V(p-p), 75 Ω , RCA pin jack, PAL Omnidirectional, electret condenser microphone 1channel, –10 dB * , low impedance, unbal ...

  • TOA Electronics N-CC2360 - page 18

    18 Note: The design and specification are subject to change without notice for improvement. MPEG-4: max. 4 Mbps 5 (MPEG-4: 4, JPEG: 1) In streaming mode: No limit (MPEG-4 only) Password authentication, Motion detection – 10°C to + 50°C (continuously active for operation at temperature below 0°C) 14°F to 122°F (continuously active for operati ...

  • TOA Electronics N-CC2360 - page 19

    19 ...

  • TOA Electronics N-CC2360 - page 20

    133-12-993-90 URL: http://www.toa.jp/ ...

Manufacturer TOA Electronics Category Digital Camera

Documents that we receive from a manufacturer of a TOA Electronics N-CC2360 can be divided into several groups. They are, among others:
- TOA Electronics technical drawings
- N-CC2360 manuals
- TOA Electronics product data sheets
- information booklets
- or energy labels TOA Electronics N-CC2360
All of them are important, but the most important information from the point of view of use of the device are in the user manual TOA Electronics N-CC2360.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals TOA Electronics N-CC2360, service manual, brief instructions and user manuals TOA Electronics N-CC2360. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product TOA Electronics N-CC2360.

Similar manuals

A complete manual for the device TOA Electronics N-CC2360, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use TOA Electronics N-CC2360 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of TOA Electronics N-CC2360.

A complete TOA Electronics manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual TOA Electronics N-CC2360 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the TOA Electronics N-CC2360, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the TOA Electronics N-CC2360, that we can find in the current document
3. Tips how to use the basic functions of the device TOA Electronics N-CC2360 - which should help us in our first steps of using TOA Electronics N-CC2360
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with TOA Electronics N-CC2360
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of TOA Electronics N-CC2360 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning TOA Electronics N-CC2360?

Use the form below

If you did not solve your problem by using a manual TOA Electronics N-CC2360, ask a question using the form below. If a user had a similar problem with TOA Electronics N-CC2360 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)