English dropdown-ico

Manual AEG SCN71800S1

28 pages Not applicable
Download

Go to site of 28

Summary
  • AEG SCN71800S1 - page 1

    SCN71800S1 EN User manual ...

  • AEG SCN71800S1 - page 2

    CONTENTS 1. SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 2. CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 3. DAILY USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

  • AEG SCN71800S1 - page 3

    1. SAFETY INSTRUCTIONS In the interest of your safety and to en- sure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mis- takes and accidents, it is important to ensure that all people u sing the appli- ance are thoroughly familiar with its op ...

  • AEG SCN71800S1 - page 4

    WARNING! Any electrical component (p ower cord, plug, compressor) must be replaced by a certified service agent or qualified service per- sonnel to avoid hazard . 1. Power cord must not be length- ened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A sq uashed or damage d power plug ma y overheat and caus ...

  • AEG SCN71800S1 - page 5

    • The appliance must not be located close to radiators or cookers. • Make sure that the mains plug is a c- cessible after the installation of the ap- pliance. • Connect to potable water supply only (If a water connection is foreseen). 1.6 Service • Any electrical work required to do the servicing of the appliance should be carried out by a ...

  • AEG SCN71800S1 - page 6

    9 Alarm indicator 10 Child Lock function 11 Minute Minder function 2.2 Switching on To switch on the appliance do these steps: 1. Connect the mains plug to the pow- er socket. 2. Press the appliance ON/OFF button if the display is off. 3. The alarm buzzer could operate af - ter few seconds. To reset the alarm r efer to "High temperature alarm& ...

  • AEG SCN71800S1 - page 7

    1. Remove any drinks contained in the freezer compartment. 2. Press OK button to switch off the sound and terminate the function. It is possible to deactivate the function at any time during th e countdown: 1. Press the Mode button until the Mi- nute Minder indicator flashes. 2. Press the OK button to confirm. 3. The Minute Minder indicator goes of ...

  • AEG SCN71800S1 - page 8

    The fridge temperature indicator shows the set temperature. 2. Press the OK button to confirm. The Holiday indicator is shown. To switch off the function: 1. Press the Mode button until the Hol- iday indicator flashes. 2. Press the OK button to confirm. 3. The Holiday indicator goes off. The function switches off by se- lecting a different fridge s ...

  • AEG SCN71800S1 - page 9

    In the event of accidental de- frosting, for example due to a power failure, if the power has been off for longer that the value shown in the technical character- istics chart under "rising time", the defrosted food must be con- sumed quickly or cooked imme- diately and then re-frozen (after cooling). 3.4 Thawing Deep-frozen or frozen foo ...

  • AEG SCN71800S1 - page 10

    3.9 Positioning the sliding box The sliding box can be pla ced at differ- ent heights. Do make these adjustments proceed as follow: 1. lift the shelf with the sliding box up - wards and out of the holders in the door 2. remove the retaining bracket out of the guide under the shelf 3. Reverse the above operation to in- sert the sliding box at a diff ...

  • AEG SCN71800S1 - page 11

    zen and to make it possible subse- quently to thaw only the quantity r e- quired; • wrap up the food in aluminium foil or polythene and make sure that the packages are airtight; • do not allow fresh, unfrozen food to touch food which is already frozen, thus avoiding a rise in temperature of the latte r; • lean foods store better and longer th ...

  • AEG SCN71800S1 - page 12

    • leave the door/doors ajar to prevent unpleasant smells. If the cabinet will be kept on, ask som e- body to check it once in a while to pre- vent the food inside from spoiling in case of a power failure. 5.3 Defrosting the refrigerator Frost is automatically eliminated from the evaporator of the refrigerator com- partment every time the motor co ...

  • AEG SCN71800S1 - page 13

    Problem Possible cause Solution The appliance has no power. There is no volt- age in the mains socket. Connect a different electri- cal appliance to the mains socket. Contact a qualified electri- cian. The lamp does not work. The lamp is in stand-by. Close and open the door. The lamp is defective. Refer to "Replacing the lamp". The buzzer ...

  • AEG SCN71800S1 - page 14

    Problem Possible cause Solution The door is not closed correctly. Refer to "Closing the door". The product temperature is too high. Let the product tempera- ture decrease to room temperature before stor- age. Many products are stored at the same time. Store less products at the same time. The temperature in the refrigerator is too high. T ...

  • AEG SCN71800S1 - page 15

    7. INSTALLATION WARNING! Read the "Safety Information" carefully for your safety and cor- rect operation of the appliance before installing the appliance. 7.1 Positioning Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: Cli- mate class Ambie ...

  • AEG SCN71800S1 - page 16

    13 amp ASTA approved (BS 136 2) fuse must be used. WARNING! A cut off plug inserted into a 13 amp socket is a serious safety (shock) ha zard. En sure that it is disposed of safely. 7.3 Door reversibility The door of the appliance opens to the right. To open the door to the left, do these steps before you install the a ppli- ance. • Loosen and rem ...

  • AEG SCN71800S1 - page 17

    7.4 Ventilation requirements 5 cm min. 200 cm 2 min. 200 cm 2 The airflow behind the appliance must be sufficient. 7.5 Installing the appliance CAUTION! Make sure that the mains cable can move freely. Do these steps. x x If necessary cut the adhesive sealing strip and then apply it to the appliance as shown in figure. ENGLISH 17 ...

  • AEG SCN71800S1 - page 18

    1 2 Install the applian ce in the niche. Push the appliance in the direction of the arrow (1) until the upper gap cover stops against the kitchen furniture. Push the appliance in the direction of the arrow (2) against the cupboard on the opposite side of the hinge. 4 mm 44 mm Adjust the appliance in the niche. Make sure that the distance between th ...

  • AEG SCN71800S1 - page 19

    Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hing e, SX in op- posite case. B E E D C Attach the covers (C, D) to the lugs and the hinge holes. Install the vent grille (B). Attach the hinge covers (E) to the hinge. G H Connect the appliance laterally to the kitchen furniture sidewall: 1. Lo ...

  • AEG SCN71800S1 - page 20

    Disconnect the parts (Ha), (Hb), (Hc) and (Hd). ca. 50 mm ca. 50 mm 21 mm 90° 90° 21 mm Install the part (H a) on the inner sid e of the kitchen furniture. Ha Hc Push the part (Hc) on the part (Ha). 20 www.aeg.com ...

  • AEG SCN71800S1 - page 21

    Ha Hb 8 mm Open the appliance door and the kitch- en furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes. Ha K 8 mm Remove the brackets and mark a dis- tance of 8 mm from the outer edge of the door where the na il must be fitted (K). Hb Place the ...

  • AEG SCN71800S1 - page 22

    Hb Hd Press the part (Hd) on the part (Hb). Do a final check to make sure that: • All screws are tightened . • The sealing strip is attached tightly to the cabinet. • The door opens and closes correctly. 8. NOISES There are some sounds during normal running (compressor, refrigerant circula- tion). BRRR ! HISSS! CLICK! BLUBB! CRACK! SSSRR R! O ...

  • AEG SCN71800S1 - page 23

    BRRR! BRRR! HISSS! HISSS! BLUBB! BLUBB! CRACK! CRACK! 9. TECHNICAL DATA Dimension of the recess Height 1780 mm Width 560 mm Depth 560 mm Rising Time 25 h Voltage 230-240 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. ENGLISH 23 ...

  • AEG SCN71800S1 - page 24

    10. ENVIRONMENT CONCERNS Recycle the materials with th e symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not dispose appliances marked with the sym bol with the household waste. Return the product to your local recycling ...

  • AEG SCN71800S1 - page 25

    ENGLISH 25 ...

  • AEG SCN71800S1 - page 26

    26 www.aeg.com ...

  • AEG SCN71800S1 - page 27

    ENGLISH 27 ...

  • AEG SCN71800S1 - page 28

    www.aeg.com/shop 222358251-A-020213 ...

Manufacturer AEG Category Refrigerator

Documents that we receive from a manufacturer of a AEG SCN71800S1 can be divided into several groups. They are, among others:
- AEG technical drawings
- SCN71800S1 manuals
- AEG product data sheets
- information booklets
- or energy labels AEG SCN71800S1
All of them are important, but the most important information from the point of view of use of the device are in the user manual AEG SCN71800S1.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals AEG SCN71800S1, service manual, brief instructions and user manuals AEG SCN71800S1. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product AEG SCN71800S1.

Similar manuals

A complete manual for the device AEG SCN71800S1, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use AEG SCN71800S1 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of AEG SCN71800S1.

A complete AEG manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual AEG SCN71800S1 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the AEG SCN71800S1, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the AEG SCN71800S1, that we can find in the current document
3. Tips how to use the basic functions of the device AEG SCN71800S1 - which should help us in our first steps of using AEG SCN71800S1
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with AEG SCN71800S1
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of AEG SCN71800S1 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning AEG SCN71800S1?

Use the form below

If you did not solve your problem by using a manual AEG SCN71800S1, ask a question using the form below. If a user had a similar problem with AEG SCN71800S1 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)