-
Integra TUN-3.7 - page 1
TUN-3.7 Instr uction Manual Multi-Platf or m T uner TUN-3.7_En.book Page 1 Monday, March 17, 2008 10:11 AM ...
-
Integra TUN-3.7 - page 2
2 Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follo w all instructions. 5. Do not use this apparatus near water . 6. Clean only with dry cloth. 7. Do not block any v entilation openings. Install in accordance with the manufacturer’ s instructions. 8. Do not install near an y heat ...
-
Integra TUN-3.7 - page 3
3 Precautions 1. Recording Copyright —Unless it’ s for personal use only , recording copyrighted material is illegal with- out the permission of the copyright holder . 2. A C Fuse —The AC fuse inside the unit is not user - serviceable. If you cannot turn on the unit, contact your Integra/Onk yo dealer . 3. Care —Occasionally you should dust ...
-
Integra TUN-3.7 - page 4
4 Features General ❑ T uner board slot ❑ 12V trigger IN/OUT ❑ IR IN/OUT ❑ RS232 port for interface control ❑ Hi-rigidity , anti-resonant chassis ❑ Aluminum front panel ❑ RI (Remote Interactiv e) capable With C-HDXM T uner Boar d Installed ❑ HD Radio reception and XM Satellite Radio ❑ RDS (Radio Data System) ❑ Automatic AM/FM/XM ...
-
Integra TUN-3.7 - page 5
5 Contents Important Safety Instructions ..................................................................................................... 2 Precautions ................................................................................................................................... 3 Features .................................................. ...
-
Integra TUN-3.7 - page 6
6 Supplied Accessories Make sure you ha ve the follo wing accessories: Remote controller and tw o batteries (AA/R6) Audio cab le (1) cable (1) To use , the TUN-3.7 must be connected with an cable and an audio cable. Po wer cord (Plug type varies from country to countr y .) * In catalogs and on packaging, the letter added to the end of the product n ...
-
Integra TUN-3.7 - page 7
7 Before Using the TUN-3.7 —Continued Notes: • If the remote controller doesn’t w ork reliably , try replacing the batteries. • Don’t mix ne w and old batteries or dif ferent types of batteries. • If you intend not to use the remote controller for a long time, remov e the batteries to prev ent damage from leakage and corrosion. • Flat ...
-
Integra TUN-3.7 - page 8
8 Getting to Kno w the TUN-3.7 For detailed information, refer to the pages in parentheses. A Standby/On b utton (19) Sets the TUN-3.7 to On or Standby . B Standby indicator (19) Lights up when the TUN-3.7 is on Standby . C Category [ ]/[ ] b uttons (23, 26) Used to select categories for satellite radio. W ith HD Radio stations, they’ re used to ...
-
Integra TUN-3.7 - page 9
9 Getting to Know the TUN-3.7 —Continued A XM (requires C-HDXM tuner board) Lights up if the installed tuner board supports XM Satellite Radio. When XM is selected, a box appears around it. B FM Lights up if the installed tuner board supports FM. When FM is selected, a box appears around it. C AM Lights up if the installed tuner board supports AM ...
-
Integra TUN-3.7 - page 10
10 Getting to Know the TUN-3.7 —Continued ■ C-HDXM tuner board installed ■ C-AMFM tuner board installed For detailed information, refer to the pages in parentheses. A XM ANTENNA (C-HDXM tuner board onl y) (21) This jack is for connecting the XM Mini-T uner (not supplied). B FM 75 Ω ANTENNA (14) This jack is for connecting an indoor or outdo ...
-
Integra TUN-3.7 - page 11
11 Remote Contr oller A Standby/On b utton (19) Sets the TUN-3.7 to On or Standby . B Number buttons (20, 23, 28) Used to select radio presets by number , and to enter AM/FM station frequencies and XM Radio channel numbers in Direct T uning mode. C Direct T uning button (20, 23) Selects the Direct T uning mode. W ith AM and FM, you can select a sta ...
-
Integra TUN-3.7 - page 12
12 Optional T uner Boar ds The following optional tuner boards are a v ailable for the TUN-3.7. Caution: • Before installing or removing a board, be sure to turn of f the TUN-3.7 and unplug the power cord from the w all out- let. Failure to do so could seriously damage your equipment. In most cases, you do not need to perform the following proced ...
-
Integra TUN-3.7 - page 13
13 Optional T uner Boards —Continued Use the Allen wrench, hexagonal socket head screws, remov al thumbscrews, and so on supplied with the tuner board. Installing a T uner Board 1 T urn off the TUN-3.7, and then unplug the power cor d from the wall outlet. 2 Use the supplied Allen wrench to unscrew the two he xagonal socket head scre ws that are ...
-
Integra TUN-3.7 - page 14
14 Connecting Antennas This section explains ho w to connect the indoor FM antenna and AM loop antenna, and how to connect com- mercially av ailable outdoor FM and AM antennas. * An indoor FM antenna and AM loop antenna are sup- plied with each tuner board. The indoor FM antenna is for indoor use only . If you cannot achiev e good reception with th ...
-
Integra TUN-3.7 - page 15
15 Connecting Antennas —Continued Connecting an Outdoor FM Antenna If you cannot achiev e good reception with the indoor FM antenna, try a commercially av ailable outdoor FM antenna instead. Notes: • Outdoor FM antennas work best outside, b ut usable results can sometimes be obtained when installed in an attic or loft. •F or best results, ins ...
-
Integra TUN-3.7 - page 16
16 Connecting the TUN-3.7 Use the supplied audio cable to connect the TUN-3.7’ s A UDIO OUTPUT L/R jacks to the TUNER IN jacks on your amplifier , as shown. To use the system functions, use the supplied cable to make an connection (see the ne xt column). Note: • If the TUN-3.7 is used with another Integra/Onk yo component, refer to its instruc ...
-
Integra TUN-3.7 - page 17
17 Connecting the TUN-3.7 —Continued W ith (Remote Interacti ve), you can control your -capable Integra/Onk yo CD player , TUN-3.7, and so on with your amp’ s remote controller . •T o use , y ou must make an analog audio con- nection between your amplifier and each audio component. Notes: • Push each plug in all the way to make a good conn ...
-
Integra TUN-3.7 - page 18
18 Connecting the TUN-3.7 —Continued Y ou can use the following multi-room kits to control the TUN-3.7 when it’ s out of range of the remote controller: • Multiroom A V distribution and control systems such as those made by Niles ® and Xantech ® . Controlling the TUN-3.7 When It’ s Out of Range If the TUN-3.7 is located in another room, i ...
-
Integra TUN-3.7 - page 19
19 T urning On and Listening to AM and FM Radio T urning On the TUN-3.7 1 Connect the power cor d to a suit- able wall outlet. 2 Press the [Standby/On] b utton on the TUN-3.7 or remote control- ler . The TUN-3.7 turns on, and the Standby indicator goes off. To turn off the TUN-3.7, press the [Standby/On] button. The TUN-3.7 will enter Standby mode. ...
-
Integra TUN-3.7 - page 20
20 T urning On and Listening to AM and FM Radio —Continued T uning into weak ster eo FM stations If the signal from a stereo FM station is weak, it may be impossible to get good reception. In this case, switch to Manual T uning mode and listen to the station in mono. Y ou can tune into AM and FM stations directly by entering the appropriate frequ ...
-
Integra TUN-3.7 - page 21
21 Listening to XM Satellite Radio Note: Hardware and required monthly subscription sold sepa- rately . Other fees and taxes, including a one-time activ a- tion fee may apply . Subscription fee is consumer only . All fees and programming subject to change. Channels with frequent explicit language are indicated with an XL. Channel blocking is av ail ...
-
Integra TUN-3.7 - page 22
22 Listening to XM Satellite Radio —Continued Once you hav e installed the XM Mini-T uner and Home Dock, you are ready to subscribe to XM Satellite Radio. Y ou’ll need a major credit card and your XM Radio ID. There are three places you can find your 8-character XM Radio ID: 1. On the XM Mini-T uner 2. On the XM Mini-T uner packaging 3. On XM ...
-
Integra TUN-3.7 - page 23
23 Listening to XM Satellite Radio —Continued There are three ways to select XM Radio channels: • Channel Search mode: select any channel. • Category Search mode: select channels by category . • Direct tuning: enter channel number . Channel Searc h Mode Category Search Mode Direct T uning Y ou can select an XM Radio channel directly by ente ...
-
Integra TUN-3.7 - page 24
24 Listening to XM Satellite Radio —Continued Press the [Display] b utton repeatedly to cyc le through the a vailable inf ormation. Note: If the category , artist, or song title is not av ailable, “- - -” will be displayed instead. ■ XM Radio Messages The following messages may appear while using XM Radio. CHECK ANTENN A The XM Mini-T uner ...
-
Integra TUN-3.7 - page 25
25 Listening to HD Radio™ Stations HD Radio technology brings digital radio to con ven- tional analog AM and FM radio stations, with improved sound quality , better reception, and new data services. HD Radio technology provides CD-quality sound for FM stations, and FM-quality sound for AM stations. In addition, FM HD Radio stations can transmit m ...
-
Integra TUN-3.7 - page 26
26 Listening to HD Radio™ Stations — Continued ■ Using the TUN-3.7: HD Radio stations transmit both analog and digital ver - sions of their programs and you can choose which one you want to listen to. Note: • Multicast channels 2 through 8 only carry a digital signal, so to select an audio format, you must select multicast channel #1 first ...
-
Integra TUN-3.7 - page 27
27 Using Presets Y ou can store any combination of up to 40 of your f av orite AM, FM, and XM Satellite radio stations as presets. ■ Using the TUN-3.7: ■ Using the Preset buttons: ■ Using the Auto Scan function: ■ Using the TUN-3.7: Presetting Y our Fa v orite Stations 1 T une into the station that y ou want to store as a preset. 2 Press th ...
-
Integra TUN-3.7 - page 28
28 Changing the Remote ID If the TUN-3.7’ s remote controller interferes with other Integra/Onk yo components located in the same room, you can change the remote control ID. Y ou can select remote control ID #1, #2, or #3. By default, the remote control ID is set to #1. If you change the ID, you must also change the ID on the remote controller to ...
-
Integra TUN-3.7 - page 29
29 Tr oubleshooting If you hav e any trouble using the TUN-3.7, look for a solution in this section. Can’t turn on the TUN-3.7. • Make sure that the po wer cord is properly plugged into the wall outlet (see page 19). And also, make sure that the other end of the power cord is properly connected to the TUN-3.7’ s AC INLET (see page 6). • Unp ...
-
Integra TUN-3.7 - page 30
30 Tr oubleshooting —Continued The remote controller doesn’t w ork properly . • Make sure the batteries ha ve been installed with the correct polarity (+/–) (see page 7). • Replace both batteries with new ones. (Do not mix dif ferent types of batteries or ne w and old batteries.) • The remote controller is too far aw ay from the TUN-3.7 ...
-
Integra TUN-3.7 - page 31
31 Specifications Specifications and features are subject to change without notice. General Power Supply: A C 120 V , 60 Hz Power Consumption: 27 W (when C-HDXM board is used) Stand-by Power Consumption: 0.2 W Dimensions (W × H × D): 435 × 81 × 306 mm (17-1/8" × 3-3/16" × 12-1/16") (not include a board) W eight: 4.5 kg (9.9 l ...
-
Integra TUN-3.7 - page 32
32 SN 29344350A (C) Copyright 2008 ONKY O CORPORA TION Japan. All rights reser ved. I0803-2 Integra Division of ONKYO U.S.A. CORPORATION 18 park Way, Upper Saddle River, N.J. 07458, U.S.A. Tel: 201-785-2600 Fax: 201-785-2650 http://www.integrahometheater.com Integra Division of ONKYO CORPORATION Sales & Product Planning Div.: 2-1, Nisshin-cho, ...
Do you have a question concerning Integra TUN-3.7?
Use the form below
If you did not solve your problem by using a manual Integra TUN-3.7, ask a question using the form below. If a user had a similar problem with Integra TUN-3.7 it is likely that he will want to share the way to solve it.