English dropdown-ico

Manual Fuego T0375

20 pages 1.82 mb
Download

Go to site of 20

Summary
  • Fuego T0375 - page 1

    T0375 version: 17/03/2004 • T0375 W ARNING ! This R/C kit and the model you will build is not a toy . LET OP ! Deze bouwdoos van een ra- diobestuurd vliegtuig is geen speelgoed. ACHTUNG ! Ein Dieser Bausatz ferngesteuertes Modell ist kein Spielzeug. A TTENTION ! Ce planeur R/C à assembler n’est pas un jouet. INSTRUCTION MANUAL • GEBRUIKSAANW ...

  • Fuego T0375 - page 2

    2 S p ecifi cations / Specifi caties T echnische Daten / Spécifi cations 1. Wing 2. Horizontal stabilizer 3. V ertical fi n 4. Fuselage 5. Cockpit + Accessories 1. Vleugel 2. Hoogteroer 3. Richtingsroer 4. Romp 5. Cockpit + T oebehoren 1. Flügel 2. Höhenruder 3. Seitenruder 4. Rumpf 5. Kabinehaube + Zubehör 1. Aile 2. Stabilisateur 3. Déri ...

  • Fuego T0375 - page 3

    3 Sharp hobby knife / Scherp hobby mes / Couteau de modéliste / scharfes Hobbymesser Needle nose pliers / Bektang / Pince à becs / Beißzange Philips screw driver / Kruisschroevendraaier / T ournevis Philips / Schraubendreher T riangle / Driehoeksmeetlat / Equerre à dessin / Winkel Scissors / Schaar / Ciseaux / Schere Wire cutter / Draadstripper ...

  • Fuego T0375 - page 4

    4 Important Safety Notes. Be sure to read right through the instructions covering assembly and operation of your model before you at tempt to operate it for the fi rst time. Y ou are the only person who is responsible for the safe operation of your radio-con trol led model. Y oung people should only be permitted to build and fl y these mod els un ...

  • Fuego T0375 - page 5

    5 Wichtige Sicherheitshinweise V or dem V ersuch der ersten Inbetriebnahme muß die gesamte Betriebs- und Montageanleitung sorgfältig gelesen werden. Sie allein sind verantwortlich für den sicheren Betrieb Ihres RC-Flugmodells. Bei Jugendlichen muß der Bau und Betrieb von einem Erwachsenen, der mit den Gegebenheiten und möglichen Gefahren eines ...

  • Fuego T0375 - page 6

    6 Installing the ailerons / Montage van de r olroer en Montierung des Querrudern / Montage des ailerons Put a little bit of cyanoacrylate on one side of the hinge and check the aileron to make sur e that it moves freely . Repeat these steps for the other side of the hinge. Follow the same procedur e for the right wing panel. Fig. 1-2-3 Doe een beet ...

  • Fuego T0375 - page 7

    7 Installing the ailerons servos / Montage van de servo's voor de r olroer en Montierung des Servos für die Querrudern / Montage des servos d'aileron Remove the covering in the hole of the hatch so that the servoarms can pass. Position the servo and the 2 wooden supports (the direction of the woodfibres should be crosswise with the dir e ...

  • Fuego T0375 - page 8

    8 Installing the ailerons servos / Montage van de servo's voor de r olroer en Montierung des Servos für die Querrudern / Montage des servos d'aileron Connect the servo lead of the servo in the ailerons with an ex- tensionlead (PL013.25) of 25cm. Secure the leads with some tape. Connect the extension lead with the nylon thread in the wing ...

  • Fuego T0375 - page 9

    9 Installing the rudder horns on the ailerons / Montage van de roerhoornen op de rolr oeren Montierung von die Horner auf die Querruder n / Installation des guignols d'aileron Connect the push rod with the clevise. Connect the control horn to the clevis and secure with the rubber band. Connect the push rod to the servo arm. Position the contro ...

  • Fuego T0375 - page 10

    10 Assembling the wings / Samenstellen van de vleugel Zusammenstellen des Flugelfl ächen / Assemblage des ailes Apply wood glue into the holes of the wing joiner and also on the wing joiner . Assemble the two wingparts and keep them during the hardening of the glue. Fig. 16. Doe een beetje houtlijm in de ga- ten en op de vleugelbevestiger . Duw d ...

  • Fuego T0375 - page 11

    11 Install the wing / Installeren van de vleugel Anbringen vom Flugel / Installation de l'aile Fig. 17 Screw the 2 scr ews for the fi xa- tion of the wing on the fuselage. Fig. 17. Put a pin in the middle of the backside of the fuselage. Fig. 18. Align the wing and the fuselage. Fig. 19. Mark the centre of the wing on the fuselage. Fig. 20. P ...

  • Fuego T0375 - page 12

    12 Belly pan / Bodemdeksel Abdeckungsplatte / Capot d'aile Remove the belly pan covering in the 2 holes to pass the wing screws. Fig. 26. Put some glue on the inside of the edge of the belly pan. Fix the belly pan on the fuselage and hold it during the hardening of the glue. Fig. 28. After drying, dismount the belly pan by unscrewing the 2 scr ...

  • Fuego T0375 - page 13

    13 Align the stabilizer / Uitlijnen van het hoogteroer Ausrichten vom Höhenruder / Alignement du stabilisateur Put some glue on the hinges of the elevator . Fig. 30. Remove the covering in the slot of the fuselage. Fig. 31. Slide the stabilizer in the fuselage and align with the fuselage and wing. Mark the fuselage on the stabilizer and remove the ...

  • Fuego T0375 - page 14

    14 Installing the rudder / Montage van het richtingsroer Montierung des Seitenruders / Montage de la gouverne de direction Remove the covering in the slots of the vertical fi n as shown on Fig. 40. Install the vertical fi n on the fuse- lage and mark the fuselage on the vertical fi n. Fig. 41. Remove the covering on both sides of the vertical ? ...

  • Fuego T0375 - page 15

    15 Installing the control horns / Installeren van de r oerhoornen Montierung von Hörner / Installation des guignols Screw the nylon clevises on the push rods. Connect the clevises with the control horns. Place them on the rudders, Fig. 53. Fix the control horns with the delivered screws and nylon supports. Fig. 54. Schrauben Sie die Nylon Ga- belk ...

  • Fuego T0375 - page 16

    16 Installing the canopy / Monteren van het cockpitvenster Montierung des Kabinenhaube / Installation de la verrière de cabine Cut out the canopy on the marks. Check the position of the canopy on the fuselage en glue the metal rod on the canopy . Make sure the metal rod passes the canopy by 5mm. Fig. 57. Glue the wooden block with hook. Fig. 58. C ...

  • Fuego T0375 - page 17

    17 Installing the receiver / Installer en van de ontvanger Montierung von den Empfänger / Installation du récepteur Fit the receiver in the fuselage and protect it with some foam. Fit the battery in place and secure it with some foam. Drill a little hole in the fuselage to pass the antenna and fi x the antenna with tape to the back of the fusela ...

  • Fuego T0375 - page 18

    18 Wing span: 1510 mm Length: 1 130 mm Wing area: 28,3 dm 2 Flying weight: 980 g Line up products / Ander e produkten Unsere Pr oduktwahl / Autres modèles Wing span: 1300 mm Length: 1200 mm Wing area: 29,8 dm 2 Flying weight: 1980 g T0372 T0385 ...

  • Fuego T0375 - page 19

    19 Wing span: 1080 mm Length: 1000 mm Wing area: 18,1 dm 2 Flying weight: 1300 g Line up products / Ander e produkten Unsere Pr oduktwahl / Autres modèles T0369 T0373 Wing span: 1255 mm Length: 1125 mm Wing area: 49,0 dm 2 Flying weight: 2980 g ...

  • Fuego T0375 - page 20

    All you need is inside … The PROTECH CA T ALOG 144 Full colour pages Ask your local R/C model shop PROTECH ® is a register ed trademark P .O.-Box 60 • B-2250 Olen T el.: +32 (0)14 25 92 83 Fax: +32 (0)14 25 92 89 info@protech.be http://www .protech.be ...

Manufacturer Fuego Category Model Vehicle

Documents that we receive from a manufacturer of a Fuego T0375 can be divided into several groups. They are, among others:
- Fuego technical drawings
- T0375 manuals
- Fuego product data sheets
- information booklets
- or energy labels Fuego T0375
All of them are important, but the most important information from the point of view of use of the device are in the user manual Fuego T0375.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Fuego T0375, service manual, brief instructions and user manuals Fuego T0375. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Fuego T0375.

Similar manuals

A complete manual for the device Fuego T0375, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Fuego T0375 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Fuego T0375.

A complete Fuego manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Fuego T0375 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Fuego T0375, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Fuego T0375, that we can find in the current document
3. Tips how to use the basic functions of the device Fuego T0375 - which should help us in our first steps of using Fuego T0375
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Fuego T0375
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Fuego T0375 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Fuego T0375?

Use the form below

If you did not solve your problem by using a manual Fuego T0375, ask a question using the form below. If a user had a similar problem with Fuego T0375 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)