English dropdown-ico

Manual Audiovox AA-RS5CS

16 pages 0.4 mb
Download

Go to site of 16

Summary
  • Audiovox AA-RS5CS - page 1

    Kit Contents AA-RS5 Control Module (2) - 2 Button High Frequency Transmitters (1) - 3 Channel Code Learning Receiver (1) - Multi Pin Input/Output Harness (1) - Six Pin Power Harness (1) - Two Pin I/O Harness Factory Alarm By-Pass & Diesel Wait To Start Input (1) - 2 Pin Door Lock Harness (2) - 30 Amp In-line Fuse Holders With Fuses (1) - Contro ...

  • Audiovox AA-RS5CS - page 2

    The AA-RS5 Remote Start/Keyless Entry System is designed to be used with Automatic Transmission Vehicles Only! The unit provides wait to start input for glow plug pre-heat which will be used for all diesel applications. If this wire is not connected, then the unit will remain in the Gasoline mode setting which will crank the car when the RF signal ...

  • Audiovox AA-RS5CS - page 3

    3 IMPORT ANT! DO NOT PLUG THE SIX PIN MAIN POWER HARNESS OR THE MUL TI PIN INPUT / OUTPUT HARNESS INTO THE CONTROL MODULE UNTIL ALL CONNECTIONS TO THE VEHICLE HA VE BEEN MADE. AFTER SELECTING YOUR T ARGET WIRES AS DEFINED BELOW , DISCONNECT THE NEGA TIVE BA TTER Y CABLE FROM THE VE- HICLE BA TTERY PRIOR T O MAKING ANY CONNECTIONS. WIRING THE 6 PIN ...

  • Audiovox AA-RS5CS - page 4

    SEE NEUTRAL ST ART SAFETY TEST FOR FURTHER DET AILS. BLUE Wire: Ignition 1 Output Connect this wire to the ignition 1 wire from the ignition switch. This wire will show +12 volts when the ignition key is turned to the to the "ON" or "RUN" and the "ST ART" or CRANK" positions, and will have 0 volts when the key is ...

  • Audiovox AA-RS5CS - page 5

    WIRING CONNECTIONS: 12 Pin Input / Output Harness Black Wire: Chassis Ground Source Connect the Black wire to a known vehicle ground source or to a solid clean metal part of the chassis. Be certain to remove any paint or grease and secure this wire with a self tapping screw and ring terminal. BLACK w/WHITE Tracer Wire: Control Switch The Black w/ W ...

  • Audiovox AA-RS5CS - page 6

    the Brown w/ Black trace wire to the output of the brake light switch. If the brake light switch in the vehicle switches ground , do not use the Brown w/ Black wire; see Grey w/ Black tracer wire. Brake Switch Positive Shutdown Detail YELLOW w/ BLACK Tracer Wire: + 12 Volt Alarm By - Pass Output NOTE: YOU MUST DISCONNECT THE IGNITION INPUT OF THE A ...

  • Audiovox AA-RS5CS - page 7

    LIGHT BLUE Wire: Ignition 3 / Shock Disable Output This wire provides a 300mA ground output that becomes active 3 seconds before the Remote Start Unit initializes, and remains grounded while running plus an additional 4 seconds after the Remote Start Unit turns off. In all of the applications described below , a relay will be required. The Light Bl ...

  • Audiovox AA-RS5CS - page 8

    DARK GREEN Wire: Tach Sensor Input This wire will continually monitor the engine tach rate while the unit is under power of the Remote Start module. This wire will be routed to the vehicle ECM tach input or through the firewall into the engine com- partment and connect to the negative side of the ignition coil. This Remote Start unit learns the tac ...

  • Audiovox AA-RS5CS - page 9

    3 Wire Positive Switched Door Locks: In this application, the Red wire of the two pin harness provides a + 12 volt pulse during the disarming sequence, or pulsed 12 volt unlock output. Connect the Red wire to the low current 12 volt signal wire from the factory door unlock switch to the factory door unlock relay . The Green wire of the two pin harn ...

  • Audiovox AA-RS5CS - page 10

    10 1. RF Programmable Features: Feature Selection 1 Flash 2 Flash 3 Flash 4 Flash Default 1 Run Time 5 Min. 10 Min. 15 Min. 20 Min. 10 Min. 2 Ign. 2 During Crank Off On On 3 Light Output During Run Steady Flash Steady 4 Tach Mode NA Tach Tach 5 NA NA NA NA NA NA 6 Trouble Shooting Off On Off 7 Door Locks 1 Sec/1 Sec 3.5 Sec/3.5 Sec 1 Sec/Dbl 1 Sec ...

  • Audiovox AA-RS5CS - page 11

    11 Multi Coil Pack Adaptor: (Optional) The multi coil pack adaptor , (P/N 136B1400), is designed for use with vehicles having multiple ignition coils where a single point tach signal is unavailable. T o use the adaptor , the Green/Black wires must connect to the negative side of the ignition coil(s). 1. For vehicles utilizing independent coils per ...

  • Audiovox AA-RS5CS - page 12

    DO NOT RELEASE THIS VEHICLE TO THE CONSUMER UNTIL YOU CONFIRM THE OPERA TION OF THE MANUAL SHUT DOWN / ENABLE FEA TURE. NEUTRAL ST ART SAFETY TEST : The intent of the neutral start switch is to prevent the vehicle from starting while the gear selector is in any position other than Park, or Neutral. When installing a Remote Start Device, it is imper ...

  • Audiovox AA-RS5CS - page 13

    13 3. Connect the Anode, (Non Striped) end, of the diode to one side of the Remote Starts enable switch. 4. Connect the other side of the enable switch to the Black/White enable input wire of the Remote Start unit. The reference diagram below shows a typical GM B Body ECM reference wire and how it is to be connected to the Remote Start Unit. KEY IN ...

  • Audiovox AA-RS5CS - page 14

    14 Circuits may be used only if the above circuit is not available. T o connect to the key in sensor as shown in method 1: A. Locate the control wire that connects the drivers door pin switch to the key in sensor switch. B. Cut this wire and connect the ignition cylinder side to chassis ground. C. Locate the key in sensor switch wire that connects ...

  • Audiovox AA-RS5CS - page 15

    15 NOTE: A second 4002 series diode may be required to maintain the integrity of the hood open, shut down circuit. If this is the case, it must be installed as shown in the diagram above. The anode (Non Striped) side must be connected to the Gray/Black wire of the Remote Start Unit. The cathode (Striped) side must be connected to the hood pin switc ...

  • Audiovox AA-RS5CS - page 16

    WIRING DIAGRAM © 2000 Audiovox Electronics Corp., Hauppauge, NY 1 1788 128-5864A ...

Manufacturer Audiovox Category Automobile Electronics

Documents that we receive from a manufacturer of a Audiovox AA-RS5CS can be divided into several groups. They are, among others:
- Audiovox technical drawings
- AA-RS5CS manuals
- Audiovox product data sheets
- information booklets
- or energy labels Audiovox AA-RS5CS
All of them are important, but the most important information from the point of view of use of the device are in the user manual Audiovox AA-RS5CS.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Audiovox AA-RS5CS, service manual, brief instructions and user manuals Audiovox AA-RS5CS. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Audiovox AA-RS5CS.

Similar manuals

A complete manual for the device Audiovox AA-RS5CS, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Audiovox AA-RS5CS by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Audiovox AA-RS5CS.

A complete Audiovox manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Audiovox AA-RS5CS - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Audiovox AA-RS5CS, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Audiovox AA-RS5CS, that we can find in the current document
3. Tips how to use the basic functions of the device Audiovox AA-RS5CS - which should help us in our first steps of using Audiovox AA-RS5CS
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Audiovox AA-RS5CS
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Audiovox AA-RS5CS in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Audiovox AA-RS5CS?

Use the form below

If you did not solve your problem by using a manual Audiovox AA-RS5CS, ask a question using the form below. If a user had a similar problem with Audiovox AA-RS5CS it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (1)

manuel

al poner cualquier programa de lavado, empieza y al rato se para y todas las luces .se encienden parpadeando