-
Air Health AH-1 - page 1
A A I I R R + + H H E E A A L L T T H H ™ ™ A A I I R R P P U U R R I I F F Y Y I I N N G G S S Y Y S S T T E E M M Model: AH-1 This product is not sold as a medical device and is not for the purpose of diagnosis of any disease or condition nor for use in the mitigati on, treatment, or prevention of any disease or condition. READ THESE INSTRUCT ...
-
Air Health AH-1 - page 2
Page 2 SAFETY CONSIDERATIONS WARNING: Never expo se eyes or skin to UVC light from any source. • Looking directly at the UVC light may c ause permanent eye damage or blindness. • Never operate the Air+Health™ Air Purifying Sy stem out of the plenum . • Designed for a closed duct system. Do n ot mount near a supply or a return air openin g. ...
-
Air Health AH-1 - page 3
Page 3 Square Footage Air+Health™ (For ducts at least 16” wide) Volts Watts Amps Hz Up to 2000 1 120 30 .5 60 4000 2 120 30 .5 60 Notes: • For homes with multiple systems, we re commend one unit per sy stem. • For homes with larger appli cations, multiple units are recommended. Contact technical support at 1-866-765-1587 for sizin g. Figure ...
-
Air Health AH-1 - page 4
Page 4 8. Wipe off the bulb glass with the sup plied alcohol wipe. Then insert the bulb through the center hole of the mounting base. (See Figure 5) The power cord must be 90° to the view port hole on the mounting base. 9. With the ballast p ressed against the mounting base, rotate th e ballast clockwise 90°. 10. Plug the po wer supply cord into ...
-
Air Health AH-1 - page 5
Page 5 10. After replacing lamp, make sure a new Lam p Replacement Label (supplied with lamp re placement) is applied to the housing and dated with the date of inst allation. NOTE: If blue light leak s through any p ortion of plenum and/or around mounting plate , unplug power supply cord immediately and seal affected areas an d/or rotate ballast an ...
-
Air Health AH-1 - page 6
Page 6 P P U U R R I I F F I I C C A A T T E E U U R R D D ’ ’ A A I I R R A A I I R R + + H H E E A A L L T T H H ™ ™ ™ ™ Modèle : AH-1 Le purificateur d’air Air+Health™™ émet un puissant rayonnement ultraviolet qui stérilise les micr o-organismes en suspension et en réduit la concentration dans l es systè mes de chauffage o ...
-
Air Health AH-1 - page 7
Page 7 Superficie (en pi 2 ) Purificateur Aur+Health (conduits d’au mois 16 po de large) Volts Watt s Ampère s Hz jusqu'à 2000 1 120 30 0,5 60 4000 2 120 30 0,5 60 REMARQUES : • Pour les maisons comprenant plusieurs systèm es nous recommandons l’ut ilisation d’un appareil par système. • Pour les maisons avec d es systèmes plu s ...
-
Air Health AH-1 - page 8
Page 8 Figure 4 7. Installer le tube sur le ballast. Ne pas manipuler le tube à mains nue s. Les huiles sur les mains tenden t à raccourcir l' intensité d'a mpoule. (Voir la Figure 4) 8. Essuyer le tube avec le chiffon imbibé d’alco ol, inclus dans l’emballag e. Puis insérer le tube au travers du trou central du supp ort de monta ...
-
Air Health AH-1 - page 9
Page 9 7. Introduire le tube dans l’orifice ce ntral du support de montage. (V oir la Figure 5) 8. Tourner le ballast au maximum dans le sens horaire en le maintenant appuyé contre le support. (Voir la F igure 8) 9. Une fois l’ensemble fermement en pl ace, brancher le cordon d’alimentation dan s une prise électrique standard. Vérifier le f ...
-
Air Health AH-1 - page 10
Page 10 S S I I S S T T E E M M A A D D E E P P U U R R I I F F I I C C A A C C I I Ó Ó N N D D E E A A I I R R E E A A I I R R + + H H E E A A L L T T H H ™ ™ Modelo: AH-1 La unidad Air+Health™ está diseñad a para emitir potentes rayos de lu z ultravioleta que e sterilizan y reducen los microorganismos en el aire al pa sar por el si stem ...
-
Air Health AH-1 - page 11
Page 11 Pies cuadrados (metros cuadrados) Air+Health™ (Para conductos por lo menos de 16 pulg. [406 mm de ancho]) Voltios Vatios Amperio s Hz hasta 2000 1 120 30 0.5 60 4000 2 120 30 0.5 60 Notas: • Para los hogares con vari os sistemas, se reco mienda el uso de una unid ad por cada sistema. • Para los hogares con apli caciones grandes, se re ...
-
Air Health AH-1 - page 12
Page 12 7. Instale la bombilla en el reacto r. No toque la bombilla con l as manos. Los aceites e n las manos tienden para acortar inte nsidad del bulbo. (Co nsulte la figura 4) 8. Limpie el cristal de la bombilla con el paño impregnado del alcohol proporcionado. Luego, introduzca la bombilla en el ag ujero central e n la base de montaje. (Consult ...
-
Air Health AH-1 - page 13
Page 13 BOMBILLA (Número de pieza Home Health Products) 46444900 8. Presione el reactor contra la base de montaje y gire el en samblado del re actor hacia la derecha, hasta que se detenga. (Consult e la figura 8.) 9. Después de que el ensa mblado esté firmemente e n su sitio, enchufe el cabl e en una toma de corriente estándar. Revise el func i ...
-
Air Health AH-1 - page 14
Page 14 WARRANTY INFORMATION 1 YEAR LIMITE D WARRANTY O N UNIT, 30 DAY LI MITED WARRANTY O N UV LAMP The products of Home Health Products, LLC are wa rranted to be fr ee from defects in material and workmanship under normal use fo r 1 year (90 days on UV lamp) from date of purchase. In the event of malf unction or fail ure of this product, th e pur ...
-
Air Health AH-1 - page 15
Page 15 ...
-
Air Health AH-1 - page 16
Page 16 1. Richard Riley, M.D. “Airborne Infection: The American Journal of Medici ne, September 1 974, Vol. 57 – 5/1 6/01 P/N 46445200 Rev C 06/05 PMB 322, 9702 Gayton Road, Richmond, VA 23238-4907 1-866-765-1587 • www.airhealth.com ...
Do you have a question concerning Air Health AH-1?
Use the form below
If you did not solve your problem by using a manual Air Health AH-1, ask a question using the form below. If a user had a similar problem with Air Health AH-1 it is likely that he will want to share the way to solve it.