English dropdown-ico

Manual Graco AA2000

20 pages 1.76 mb
Download

Go to site of 20

Summary
  • Graco AA2000 - page 1

    INSTRUCTIONS-PARTS LIST This manual contains important Model AA2000 High Efficiency Low Pressure” System Air-Assisted Airless Spray Gun Part Number 222-615, Series C 950 psi (66 bar) Maximum Working Fluid Pressure 100 psi (7 bar) Maximum Working Air Pressure * 10 psi (0.7 bar) Maximum Operating Air Pressure** * The Maximum Workina Air Pressurq in ...

  • Graco AA2000 - page 2

    Table of Contents SafetyWarnings ............................... 3 Installation Ventilate the Spray Booth ..................... 6 Required Accessories ........................ 6 Connect the Air Line ......................... 7 Connect the Fluid Line ....................... 7 Grounding .................................. 7 Operation How Air-Assisted ...

  • Graco AA2000 - page 3

    WARNINGS High Pressure Spray Can Cause Serious Injury. For Professional Use Only. Observe All Warnings. Read and understand all instruction manuals before operating equipment. FLUID INJECTION HAZARD General Safety This equipment generates very high fluid pressure. Spray from the gun, leaks or ruptured components can inject fluid through your skin a ...

  • Graco AA2000 - page 4

    Static electricity is created by the flow of fluid through the pump and hose. If every part of the equipment is not properly grounded, sparking may occur, and the system may become hazardous. Sparks can ignite fumes from solvents and the fluid being sprayed, dust particles and other flammable substances, whether you are pumping indoors or outdoors, ...

  • Graco AA2000 - page 5

    General Safety Any misuse of the equipment or accessories, such as overpressurizing, modifying parts, using incompatible chemicals and fluids, or using worn or damaged parts, can cause them to rupture and result in serious injury, including fluid injection and splashing fluid in the eyes or on the skin, or in fire, explosion or prop- erty damage. N ...

  • Graco AA2000 - page 6

    Installation KEY A Gun Air Inlet B Gun Fluid Inlet C Bleed-Type Master Air Valve D Main Air Supply Line E Pump Air Regulator F Gun Air Regulator, p/n 110-776, 10 psi (0.7 bar)Maximum Outlet Pressure G Pump Ground Wire H Air Line Filter J Fluid Drain Valve K Gun Air Hose L Gun Fluid Hose M Fluid Regulator Kit N Fluid Filter P Air Pressure Relief Val ...

  • Graco AA2000 - page 7

    Installation Connect the Air Line Install an air line filter (H) to ensure a clean, dry air supply to the gun. Dirt and moisture in the line can ruin the appearance of your finished piece. Install Air Pressure Regulator 1 lo-776 (F) to control the air pressure to the gun and limit it to 10 psi (0.7 bar) Maximum Operating Air Pressure. Install a ble ...

  • Graco AA2000 - page 8

    Operation Select a Spray Tip Use the Spray Tip Selection charts on page 18, as a guide for selecting an appropriate spray tip for your application. The fluid output and pattern width depend on the size of the spray tip, the fluid viscosity, and the fluid pressure. NOTE: When spraying very low viscosity fluids, use the optional fluid needle 220-413 ...

  • Graco AA2000 - page 9

    Operation Adjust the Spray Pattern & Apply the Fluid (Continued’ 1. Increase the fluid pressure just to the point where a further increase in fluid pressure does not sig- nificantly improve fluid atomization. Do not exceed 950 psi (66 bar) fluid pressure to the gun. 2. Close the pattern adjustment valve by turning the knob (see Fig. 3) counte ...

  • Graco AA2000 - page 10

    Operation Flush the Gun Daily WARNING Dressure Relief Procedure To reduce the risk of serious injury, including fluid njection, splashing in the eyes or on skin, or injury ‘ram moving parts, always follow this procedure Nhenever the pump is shut off, when checking or servicing any part of the system, when installing or :hanging spray tips and whe ...

  • Graco AA2000 - page 11

    Troubleshooting I WARNING To reduce the risk of serious injury, including fluid injection, splashing fluid or solvent in the eyes or on the skin, or injury from moving parts, always follow the Pressure Relief Procedure Warning on page 10 when- ever you shut off the pump, when checking or servicing any part of the spray system, when installing, clea ...

  • Graco AA2000 - page 12

    Service WARNING Fluid Packing Replacement To reduce the risk of serious injury, including fluid injection, and splashing in the eyes or on the skin, or injury from moving parts or electric shock, al- ways follow the Pressure Relief Procedure Warning on page 10 before servicing any part of the gun or system. 1. If leakage occurs at the back of the f ...

  • Graco AA2000 - page 13

    Service 27 SERVICE NOTES: A Gasket (33) must be replaced if fluid connector (67 or l-see page 14) is removed or replaced. A Fluid leakage into air chambers may result if new gasket is not installed. Lubricate threads An/ . A Apply anaerobic pipe sealant to threads A Apply high strength sealant to threads A Thread nut to bottom thread of needle A U- ...

  • Graco AA2000 - page 14

    26 28 32 18 For Direct Hose Connection (Paris shipped unassembled) A 3 67 A SERVICE NOTES (See Fig. 7 for additional Informatlon): A Gasket (33) must be replaced if fluid connector (67 or 1) is removed or replaced. Fluid leakage into air chambers may result if new gasket is not installed. A Lubricate threads A Torque to 23-27 ft-lb (31-37 Nom) A ...

  • Graco AA2000 - page 15

    Ref. No. Part No. 1 178-415 2 106-917 3 178-454 5*A 217-488 7 217-489 10* 106-903 11 178-408 18 203-953 19 160-217 20 222-616 21* 177-528 24*& 109-022 25 217-526 26* 107-079 27 222-608 28 182-XXX Use Only Genuine Grace Parts and Accessories. Description Qty- CONNECTOR, fluid (not assembled) 1 ADAPTER, air 1 TRIGGER, gun 1 NEEDLE, fluid 1 VALVE, ...

  • Graco AA2000 - page 16

    Accessories Use Only Genuine Grace Parts and Accessories Fluid Filters 3000 psi (207 bar) Maximum Working Pressure 214-570 with carbon steel bowl and support. 218-029 with aluminum bowl and support. Stainless Steel Screens 167- 024 595 micron (30 mesh) 167-025 250 micron (60 mesh) 167-026 149 micron (100 mesh) 167-027 74 micron (200 mesh) In-line F ...

  • Graco AA2000 - page 17

    Accessories Use Only Genuine Grace Parts and Accessories Air Pressure Verification Kit 224-250 For use in checking air cap pressure at various gun inlet pressures. Do not use the air cap for spraying. Assemble the kit as shown in the drawing below. Install the air cap on the gun. Turn on the air to the gun, then actuate the gun and read the resulti ...

  • Graco AA2000 - page 18

    Spray Tip Selection STANDARD SPRAY TIPS *Light to Inches Medlum *Heavy Orlflce Fan Wldth Vlscoslty vlscoslty Size at 12” A oz/mln fl oz/mln Part Inches) (300 mm) (Ilters/mln) (Iiterslmln) No. 0.007 2-4(50-100) (04; 182-107 4-6(1W-150) 182-207 S-8(150-200) 182-307 8-10(2W-250) 182-407 0.009 4-6(1W-150) S-8(150-200) (:; 182-20s 182-30s 6-10(200-250 ...

  • Graco AA2000 - page 19

    Technical Data Maximum Working Fluid Pressure . . . 950 psi (66 bar) *Maximum Working Air Pressure . . . . . . . 100 psi (7 bar) **Maximum Operating Air Pressure . . . . . 10 psi (0.7 bar) Weight (less filter) . . . . . . . . . . . . . . . . . . 1.2 lb (0.55 Kg) Wetted Parts . . . . . . . Stainless Steel, Carbide, Ultra High Molecular Weight Polyet ...

  • Graco AA2000 - page 20

    The Grace Warranty and Disclaimers WARRANTY Waco warrants all equipment manufactured by it and bearing its name to be free from defects in material and workmanship on the date of sale by an authorized Grace distributor to the original purchaser for use. As purchaser’s sole remedy for breach of this war- ranty, Grace will, for a period of twelve m ...

Manufacturer Graco Category Paint Sprayer

Documents that we receive from a manufacturer of a Graco AA2000 can be divided into several groups. They are, among others:
- Graco technical drawings
- AA2000 manuals
- Graco product data sheets
- information booklets
- or energy labels Graco AA2000
All of them are important, but the most important information from the point of view of use of the device are in the user manual Graco AA2000.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Graco AA2000, service manual, brief instructions and user manuals Graco AA2000. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Graco AA2000.

Similar manuals

A complete manual for the device Graco AA2000, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Graco AA2000 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Graco AA2000.

A complete Graco manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Graco AA2000 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Graco AA2000, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Graco AA2000, that we can find in the current document
3. Tips how to use the basic functions of the device Graco AA2000 - which should help us in our first steps of using Graco AA2000
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Graco AA2000
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Graco AA2000 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Graco AA2000?

Use the form below

If you did not solve your problem by using a manual Graco AA2000, ask a question using the form below. If a user had a similar problem with Graco AA2000 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)