-
Sunfire HRS-SAT4 - page 1
User's Manual High Resolution Series Satellite and Center Loudspeakers HRS-SA T4 and HRS-SA T4C HRS-SA T4 HRS-SA T4C ...
-
Sunfire HRS-SAT4 - page 2
User's Manual 2 Important Safety Instructions W ARNING: THIS LOUDSPEAKER IS CAP ABLE OF PRO- DUCING VERY HIGH SOUND PRESSURE LEVELS. YOU MUST T AKE EVERY PRECAUTION TO PROTECT YOUR HEARING FROM PERMANENT DAMAGE. 1. Read Instructions. 2. Keep these Instructions. 3. Heed all W arnings. 4. Follow all Instructions. 5. Do not use this apparatus nea ...
-
Sunfire HRS-SAT4 - page 3
User's Manual 3 Introduction Features Location Installation Features • Perfectly matched to the HRS subwoofers to form a complete system • HRS-SA T4 can be wall-mounted, or stand on a cabinet or shelf. It can be used for left, right, surround, and sur- round-back applications • HRS-SA T4C can be wall-mounted, or stand on a TV cabinet or ...
-
Sunfire HRS-SAT4 - page 4
User's Manual 4 Overview The HRS-SA T4 and HRS-SA T4C are high performance loudspeakers, speci - cally designed to provide high output and high performance for your home theater . Y ears of research and decades of ex- perience have gone into these amazing loudspeakers. Sunre created the category of small- box, high-power subwoofers more ...
-
Sunfire HRS-SAT4 - page 5
User's Manual 5 1. Mounting Brackets The satellite loudspeaker has one keyhole bracket that allows for wall mounting and tting onto the optional stand. The center channel loudspeaker has two keyhole brackets, and can be mounted horizontally or vertically . 2. Binding Posts The loudspeakers each have a pair of 5-way binding posts, that accep ...
-
Sunfire HRS-SAT4 - page 6
User's Manual 6 The details below show various sys- tems incorporating the loudspeakers, with a subwoofer to handle the low frequency range. Ideally , all of the surround loudspeak- ers in a home theater system should be of the same make and model, and positioned at similar heights to produce a smooth and continuous soundeld. Front Left/Rig ...
-
Sunfire HRS-SAT4 - page 7
User's Manual 7 above or below the display , as long as it is located on the centerline and not off to one side. If possible, have the center , left and right loudspeakers at the same height (within two feet). This will help give a smooth transition when sound effects move from loudspeaker to loudspeaker . 5.1 Conguration Place each surroun ...
-
Sunfire HRS-SAT4 - page 8
User's Manual 8 Subwoofer Location The best location for a single subwoofer can be found by following these steps: 1. Place the subwoofer on your couch or favorite easy-listening chair . 2. Y ou can then either run a calibra- tion (noise) signal through it, or play some of your favorite music samples with heavy bass. 3. W alk around the room, ...
-
Sunfire HRS-SAT4 - page 9
User's Manual 9 Read the details on page 6 and 7 to help determine the best position for your loudspeaker . The loudspeaker can be wall-mounted, or simply placed on bookshelves or on top of TV cabinets. If you are not wall-mounting the loudspeaker , then we recommend that you add the supplied anti-vibration pads to the bottom surface. T o wall ...
-
Sunfire HRS-SAT4 - page 10
User's Manual 10 9. Connect your speaker wires to the back of the loudspeaker , making sure of the correct polarity . Gently pull on the wires to make sure of a good connection. Secure the wires so their weight is not pulling against the terminals. Note that banana or dual-banana plugs will not work when wall-mounting the loudspeak- er , or wh ...
-
Sunfire HRS-SAT4 - page 11
User's Manual 1 1 The HRS-SA T4 satellite loudspeaker has an optional stand that allows it to be installed neatly in your room. The base of the stand can be tted with four spikes, or four rubber-tipped spikes if you have hardwood oors etc. T ools required: • Allen wrench (supplied with stand) Preliminary steps: • Run the speaker cabl ...
-
Sunfire HRS-SAT4 - page 12
User's Manual 12 5. Pass the large screw through the hole in the rear side of the column, and into the threaded hole in the rear of the loudspeaker . Be careful not to pinch or cut the speaker wires with the screw , or jam the wires between the loudspeaker and the top of the column. T ighten the screw until the loudspeaker is secured ush wi ...
-
Sunfire HRS-SAT4 - page 13
User's Manual 13 Specications Design 2 way , High Pressure Drive Units HF: 1-inch ring radiating tweeter LF: 4.5-inch High Back-emf Frequency Response 95 Hz to 30 kHz Crossover Frequency 1.5 kHz Maximum Power 200 watts Minimum Power 25 watts Sensitivity (2.83 V/1 meter) 88 dB Maximum Output 1 1 1 dB Impedance 6 ohms nominal Connections 1 pa ...
-
Sunfire HRS-SAT4 - page 14
User's Manual 14 T roubleshooting The HRS-SA T4 and HRS-SA T4C loudspeakers are designed and built to provide years of trouble-free perfor- mance. Most problems that occur can usually be solved by checking your setup, or by making sure all components are fully operational. The following information will help you deal with common problems you m ...
-
Sunfire HRS-SAT4 - page 15
User's Manual 15 Limited W arranty Sunre, LLC is proud of its products that have been built with care using advanced technology and premium com- ponent parts. Y our unit has been crafted to perform properly for many years. Sunre offers the following W arranty to you, the owner of a new Sunre product: The Sunre W arranty for the HRS ...
-
Sunfire HRS-SAT4 - page 16
High Resolution Series Satellite and Center Loudspeakers HRS-SA T4 and HRS-SA T4C HRS-SA T4 HRS-SA T4C Manual 913-150-00 Rev A ...
Do you have a question concerning Sunfire HRS-SAT4?
Use the form below
If you did not solve your problem by using a manual Sunfire HRS-SAT4, ask a question using the form below. If a user had a similar problem with Sunfire HRS-SAT4 it is likely that he will want to share the way to solve it.