English dropdown-ico

Manual Nilfisk-ALTO 878B

17 pages 0.55 mb
Download

Go to site of 17

Summary
  • Nilfisk-ALTO 878B - page 1

    1 822 2718-000 9905 Edition NA1 HEP A FIL TERED WET & DR Y V ACUUM CLEANER UZ 877 UZ 878 ...

  • Nilfisk-ALTO 878B - page 2

    2 A TTENTION Le filre Hepa Doit être en place quand on travaille avec des substances dangereuses.Si l'on n'utilise pas le filtre, les personnes se trouvant sur le lieu de travail ou à proximité sont exposées aux substances dangereuses et donc à de graves risques de santé. VIDAGE Si cet aspirateur est utilisé pour ramasser des subst ...

  • Nilfisk-ALTO 878B - page 3

    3 *Use only as described in this manual and only with manufacturer s recommended attachments. *The use of the HEP A-filter when picking up hazardous materials has not been evaluated by Underwriters Laboratories. * The use of this machine in conjunction with the pick-up of hazardous materials has not been investigated by UL. *Do not use unless fi ...

  • Nilfisk-ALTO 878B - page 4

    4 SERVICE INFORMA TION T o obtain consistent performance over the life of your vacuum, read through these instructions and keep them handy for future reference. If you require service, contact the dealer from whom the vacuum was purchased, or the local authorized Service S tation. Always refer to your Service S tation for complete service informati ...

  • Nilfisk-ALTO 878B - page 5

    5 Description UZ 877 and UZ 878 are a series of wet and dry suction cleaners wherein the model designation is determined by the capacity of the container - 1 1 and 15 gallons resepectively . The cleaners are electrically grounded. The cleaners are designed for wet and dry cleaning. 1. Motor housing with float. (Suction cuts off when maximum water l ...

  • Nilfisk-ALTO 878B - page 6

    6 Assembly 1. UZ 877- The ends of the handle are inserted into the holes in the base and secured by two socket head capscrews from below . The cont ainer is than placed on the base as in figure 1. UZ 878- The container is placed on the base as in figure 2. 2. The motor housing is placed on the container and secured with snapfasteners. 3.The hose is ...

  • Nilfisk-ALTO 878B - page 7

    7 Filter The machines are fitted with three filters: 1.Pre-filter , traps coarse waste p articles, the pre-filter should be changed regularly . 2. Micro filter , can be cleaned and re-used. 3. HEP A-filter , captures 99.97% of all dust particles 0.3 microns in size or larger . The pre-filter and micro filter are designed for use in both wet pick-up ...

  • Nilfisk-ALTO 878B - page 8

    8 Liner bags Poly liner bags are avaliable and one is supplied with each new machine. These are for the collection of dust. They are resistant to water and make emtying easier . These liners must be gathered together at the neck on removal. For wet pick-up only , liners are not recommended. Fitting 1.Switch the cleaner off and withdraw the plug. 2. ...

  • Nilfisk-ALTO 878B - page 9

    9 T o empty 1. Switch the cleaner off and pull the plug out. 2. Disconnect the hose 3. Remove the motor housing. The cleaner can now be emptied in various ways depending on the type of base fitted. Alt. 1. See Figure 1 (UZ 878 only). Alt. 2. See Figure 2. Alt. 3. Wet pick-up only . The cont ainer can be emptied by opening the draincock at the bot- ...

  • Nilfisk-ALTO 878B - page 10

    10 L'utilisation d'un appareil électrique dem- ande certaines précautions: LIRETOUTES LES INSTRUCTIONS A V ANT DE F AIRE FONCTIONNER CET AP P AREIL A VERTISSEMENT ! Pour réduire les risques de choc électrique ne pas utiliser à l'extérieur et na pas aspirerde matières humides. Cet aspirateurpout être utilisé en toute sécurit ...

  • Nilfisk-ALTO 878B - page 11

    11 INSTRUCTIONS VISANT LA MISE À LA TERRE Pour les machines avec une fiche avec trois conducteurs. Cet appareil doit être mis à la terre. En cas de défaillance ou de panne éventuelles, la mise à la terre fournit au courant un chemin de moindre résistance qui réduit le risque de choc électrique. Cet appareil est pourvu d'un cordon muni ...

  • Nilfisk-ALTO 878B - page 12

    12 Description UZ 877 et UZ 878 constituent une série daspirateurs seaux eau et poussière. La dénomination du modèle est déterminée par la capacité de la cuve de 1 1 ou 15 gallons. Les aspirateurs sont mis à la terre et sont destinés au nettoyage à sec et avec eau. 1. Couvercle moteur et flotteur (laspirateur sarrête de fonction ...

  • Nilfisk-ALTO 878B - page 13

    13 Mont age 1. UZ 877- La poignée sintroduit dans les trous prévus du chariot, voir fig.1. La fixation seffectue de lintérieur grâce à deux vis hexagonales. Le réservoir peut ensuite être monté sur le chariot comme le montre la fig.2. UZ 878- Le reservoir est placé sur le chariot comme le montre la fig.1. 2. Le couvercle moteur es ...

  • Nilfisk-ALTO 878B - page 14

    14 Filtre Les machines sont équipées de trois différents filtres : 1. Le préfiltre dont la fonction est darrêter les particules les plus grosses. Le préfiltre doit être changé régulièrement. 2. Le microfiltre qui peut être nettoyé et réutilisé. 3. Le filtre HEP A qui arrête 99,97% de toutes les particules de poussière de 0,3 micr ...

  • Nilfisk-ALTO 878B - page 15

    15 Sacs Des sacs Poly sont disponibles et chaque nouvelle machine est livrée avec un sac. Ces sacs sont prévus pour le ramassage de la poussière. Ils sont résistants à leau et faciles à remplacer . Ils doivent être retroussés au niveau du col lors de leur changement. Il nest pas recommandé dutiliser ces sacs pour la seule aspirati ...

  • Nilfisk-ALTO 878B - page 16

    Vidage 1. Arrêter laspirateur et débrancher la prise de courant. 2. Enlever le tuyau aspirateur . 3. Enlever la tête daspiration. Les aspirateurs peuvent être vidés de différentes façons, en function de leur chariot. Alternative 1, voir fig. 1. Alternative 2, voir fig. 2. Alternative 3, Seulement lors daspiration de surfaces humides ...

  • Nilfisk-ALTO 878B - page 17

    16 ...

Manufacturer Nilfisk-ALTO Category Vacuum Cleaner

Documents that we receive from a manufacturer of a Nilfisk-ALTO 878B can be divided into several groups. They are, among others:
- Nilfisk-ALTO technical drawings
- 878B manuals
- Nilfisk-ALTO product data sheets
- information booklets
- or energy labels Nilfisk-ALTO 878B
All of them are important, but the most important information from the point of view of use of the device are in the user manual Nilfisk-ALTO 878B.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Nilfisk-ALTO 878B, service manual, brief instructions and user manuals Nilfisk-ALTO 878B. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Nilfisk-ALTO 878B.

Similar manuals

A complete manual for the device Nilfisk-ALTO 878B, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Nilfisk-ALTO 878B by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Nilfisk-ALTO 878B.

A complete Nilfisk-ALTO manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Nilfisk-ALTO 878B - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Nilfisk-ALTO 878B, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Nilfisk-ALTO 878B, that we can find in the current document
3. Tips how to use the basic functions of the device Nilfisk-ALTO 878B - which should help us in our first steps of using Nilfisk-ALTO 878B
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Nilfisk-ALTO 878B
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Nilfisk-ALTO 878B in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Nilfisk-ALTO 878B?

Use the form below

If you did not solve your problem by using a manual Nilfisk-ALTO 878B, ask a question using the form below. If a user had a similar problem with Nilfisk-ALTO 878B it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)