-
AB Soft TDW-33 - page 1
TDW-33 DIN-r ail T ele V .90 modem www .w estermo .com REV .A 6619-2202 2008.05 Mälar tryck AB, Eskilstuna, Sweden © W estermo T eleindustri AB User Guide 6619-2202 ...
-
AB Soft TDW-33 - page 2
2 6619-2202 Legal information The contents of this document are provided “as is”. Except as required by applicable law , no warranties of any kind, either express or implied, including, but not limited to, the implied warranties of merchantability a ...
-
AB Soft TDW-33 - page 3
3 6619-2202 Safety Befor e installation: This modem is for restricted access area use only . Read this manual completely and gather all information on the unit. Make sure that you understand it fully . Check that your application does not exceed the? ...
-
AB Soft TDW-33 - page 4
4 6619-2202 Agency appr o vals and standards compliance T ype Appr o val / Compliance EMC EN 61000-6-2, Immunity industrial environm EN 55024, Immunity IT equipment EN 61000-6-3, Emission residential envir onments FCC part 15 Class B EN 50121-4, Railwa y signalling and te ...
-
AB Soft TDW-33 - page 5
5 6619-2202 If trouble is experienced with this equipment TD W -33, for repair or warranty information, please contact W estermo Data Communication,Inc. 11200 W estheimer ,Suit 900. Houston,TX,,77042. Phone number : 713-240-0367. If the equipment is causing? ...
-
AB Soft TDW-33 - page 6
6 6619-2201 Declaration of Conformity W este rmo Teleindu stri AB Declara tion o f conf ormit y Org.nr/ Postadress/Po stal addres s Tel. Tele fax Pos tgi ro Bankgiro Corp. ide ntity number Register ed office S-640 40 Stora Sundby 016-428000 016-428001 52 72 79-4 5671-5550 556361-2604 Eskilstuna Sweden Int+46 16428000 Int+46 16428001 The manuf ...
-
AB Soft TDW-33 - page 7
7 6619-2201 T ype tests and envir onmental conditions Electromagnetic Compatibility Phenomena T est Description T est levels ESD EN 61000-4-2 Enclosure contact ± 6 kV Enclosure air ± 8 kV RF field AM modulated IEC 61000-4-3 Enclosure 20 V/m 80% AM (1 kHz), 80 – 2000 MHz ...
-
AB Soft TDW-33 - page 8
8 6619-2202 Description The TD W -33 is designed to function reliably within industrial environments and in areas of high level interference. The modem has an RS-232 interface suppor ting terminal data rates up to 115 kbit/s. The TD W -33 is a V .90 m ...
-
AB Soft TDW-33 - page 9
9 6619-2202 Interface specifications ** T o minim ise the risk of int erf er ence, a shie lded cable is r ecom mend ed when the cabl e is locat ed insi de 3 m boun dary to the rai ls and con nect ed to this port. The cable shield should be pro perl y conn ecte ...
-
AB Soft TDW-33 - page 10
P osition RJ-11C Direction* Description Product marking PSTN a Not Connected b Not Connected c In/Out PSTN T ransmit/ Receive d In/Out PSTN T ransmit/ Receive e Not Connected f Not Connected P osition Scre w terminal* Direction* Description – Not Connected Data Carrier Direct (DCD) No. 2 Out Rec ...
-
AB Soft TDW-33 - page 11
11 6619-2202 LED Indicators LED Status Description TD T ransmit data OFF No data ON / FLASH The modem receiving data on the DTE interface RD Receive data OFF No data ON / FLASH The modem transmitting data on the DTE interface R TS Request to send OFF R TS signal i ...
-
AB Soft TDW-33 - page 12
12 6619-2202 Cooling This unit uses convection cooling. T o a void obstructing the air - flow around the unit, use the following spacing rules. Minimum spacing 25 mm (1.0 inch) above /below and 10 mm (0.4 inches) left /right the unit. Spacing is re ...
-
AB Soft TDW-33 - page 13
13 6619-2202 Windo ws configuration tool TD-T ool The TD-T ool is a PC – application program with a graphical interface for easy configuration of the complex functions found on the encolsed CD or at the W estermo website. Please ref er to TD-T ool for ...
-
AB Soft TDW-33 - page 14
14 6619-2202 PSTN Network Application examples … TD W -33 connected to TD W -33 with DTR signal call DTR DSR DCD Rela y External application 10 kohm Ma y be required in harsh environments. Configure the units A T&F Set the unit to factory default A T&W Store default ...
-
AB Soft TDW-33 - page 15
15 6619-2202 … Fr equently used settings for PLC-systems Most PLC-systems and other industrial applications where modems are used requir e the same changes to the standard settings. The most commonly encountered problems concern speed, parity and contro ...
-
AB Soft TDW-33 - page 16
16 6619-2202 … TD W -33 – Secure Call-back The TD W -33 is connected to a PLC which one want to restrict access to. The TD W -33 can support access control through the Secure Callback function. In this example pass- wor d and callback to a? ...
-
AB Soft TDW-33 - page 17
17 6619-2202 Configure the TD-36 Set up the connection A T&F Set the unit to factory default A T+IPR=9600 DTE baudrate 9600 A T+ICF=3,4 Character framing 8 data, 1 stop, parity none A TS0=1 Auto answer after first ring A T&W Store default settings The dialling? ...
-
AB Soft TDW-33 - page 18
18 6619-2202 … TD W -33 – Silent answering on predefined number The TD W -33 is connected to a power meter which is remotely monitored. The TD W -33 shares the PSTN line with normal telephones which is preferr ed not to give a ring signal w ...
-
AB Soft TDW-33 - page 19
...
-
AB Soft TDW-33 - page 20
REV .A 6619-2202 2008.05 Mälar tryck AB, Eskilstuna, Sweden W estermo T eleindustri AB • SE-640 40 Stora Sundby , Sweden Phone +46 16 42 80 00 Fax +46 16 42 80 01 E-mail: info@westermo .se W estermo W eb site: www .w estermo .com W estermo T eleindu ...
Do you have a question concerning AB Soft TDW-33?
Use the form below
If you did not solve your problem by using a manual AB Soft TDW-33, ask a question using the form below. If a user had a similar problem with AB Soft TDW-33 it is likely that he will want to share the way to solve it.