Manual Toshiba EX500

20 pages 2.95 mb
Download

Go to site of 20

Summary
  • Toshiba EX500 - page 1

    In Touch with Tomorrow TOSHIBA EX250/500 PROGRAMMABLE CONTROLLERS Y30 ~ t_[Xw01 R30 4 ~ Z 0 • ~ High Speed Scanning • ~ On Line Programming (111111111 Binary B ; thmwhl t data BINDAT BIN D100 ( Enhanced Features • ~ On Line Program Saving • ~ Optional Clock-Calendar r- ,, Indr Max Min Max Min Pressr Pressr Float Flo . Switch Switch Switch S ...

  • Toshiba EX500 - page 2

    FEATURES Fast Scan Time The EX250/500 uses a 16 bit microprocessor and custom Toshiba integrated circuits to significantly reduce program scan time . TWO CPU TYPES The only difference between the EX250 and the EX500 is the CPU card Advanced Instruction Set There are 15 basic relay ladder instructions and 64 special function block instructions . The ...

  • Toshiba EX500 - page 3

    The compact modular structure of the EX250/500 is designed for easy installation . Diagnostic LEDs are immediately visible, and components can be readily removed and replaced . CONTROLLER UNIT The only difference between the EX250 controller and the EX500 controller is the CPU card . The controller unit consists of- • ~ CPU which contains 1 . CPU ...

  • Toshiba EX500 - page 4

    I/O EXPANSION CAPABILITY EX250 One (1) expansion unit can be connected to each EX250 controller . A total of 16 I/O slots are available . If 32 point I/O modules are used, all the discrete I/O can be located on the controller leaving the expansion unit available for register type I/O (Analog, PID, BCD, etc .) Local I/O • ~ 256 points or • ~ 32 ...

  • Toshiba EX500 - page 5

    NETWORKING TOSLINE-30/300P TOSLINE-30 is an N-to-N data link system dedicated to the EX-series of programmable controllers . The TOSLINE-30 data communication modules allow EX250/500's to be set-up in a peer-to-peer configuration, master-to-slave configuration, or to use remote I/O . Controller Station (wire) (MSE-5626) Remote I/O Station (wir ...

  • Toshiba EX500 - page 6

    i 11 Computer Link The optional computer link card allows up to 8 EX250/500's to be networked on one RS422 serial link back to a personal computer, cell controller, or other higher level computer . The computer can run Toshiba's EXPDD programming software, various graphics display and data acquisition software, or user designed custom sof ...

  • Toshiba EX500 - page 7

    PERIPHERALS Floppy Disk (3 .5", 2DD) Floppy Disk Unit ~ (- (FD 110) Standard Printer Cassette tape louder " 0" EX-PDD software (AP1/AP2) > - / ~ (AP1/AP2) ~ t I Graphic Programmer (GPI10/110AP1/110AP2) Handy Programmer (HP100) Mini Programmer (M P 100) D Data Access Panel (DP 100) O O O U PROM Writer (PR100) (for PROM Module) EX25 ...

  • Toshiba EX500 - page 8

    Data Access Panel DP 100 The DP 100 is used primarily for viewing and changing timers, counters and data register values . It does not allow modification of the program logic . The DP 100 can also display user defined ASCII diagnostic messages and list their order of occurrence . The display is backlit for easy viewing in dark areas . The DP 100 ca ...

  • Toshiba EX500 - page 9

    EX Program Development & Documentation (EX-PDDTM) Naturally it is possible to write and save EX250/500 programs on a personal computer . The EX Program Development and Documentation software (EX-PDD) runs on any IBM®-PC, XT, AT, PS/2 personal computer and most IBM-PC compatibles such as Toshiba's laptop computers . Offline File Name : EX- ...

  • Toshiba EX500 - page 10

    SPECIFICATIONS Toshiba's many years of experience in semiconductor technology and solid-state electronics have resulted in the production of versatile, highly efficient programmable controllers . General Specifications External Dimensions • ~ Basic unit 4-06 • ~ Expansion unit w/ power supply rv . . 39 mm ( 1 5 .5 in) 161 mm (6 .3 in) • ...

  • Toshiba EX500 - page 11

    Functional Specifications Item EX250 EX500 Control method Stored program cyclic scan Input/output control Batch I/O (immediate I/O instruction is also available) Programming Ladder network with relay symbols and function blocks t, Program capacity 4K steps 8K steps 0 E Memory type CMOS RAM (with battery backup)/EPROM/EPROM (ROMs are option) Battery ...

  • Toshiba EX500 - page 12

    PROGRAMMING Toshiba's experience in industrial controls (robotics, process computers, etc .) has resulted in a very wide range of programming instructions available on the EX250/500 . There are 15 basic instructions, contacts, coils, timers, counters, etc . for standard relay ladder logic . There are also 64 special functions such as word logi ...

  • Toshiba EX500 - page 13

    INSTRUCTIONS No . step" step . Instruction Symbol and Description of No . Instruction Symbol and Description or Memory Memory 43 RTL -[O RTL ~ Rotate bits left 4 Function Generator (FUN036) (given A, solve for AND Logical AND FG QA], where f[A] is in- 3 44 (FUN040) -[~ ~ 0~©] - AND . ~ register-to-constant 4/5 60 (FUN065) -[® FG [nn] ~ terpo ...

  • Toshiba EX500 - page 14

    1/O MODULES Digital Input Digital Output Item ACO-6264 ACO-6274 ACO-6269 Output voltage 85 - 132 Vac 170 - 250 Vac 24 - 250 Vac (+ 10/-15%) Load current 2 A/pnt, 5 A/common 0 .5 A/pnt, 3 .2 A/common, 5 A (total) Output points 16 pts (8 pts common) 32 pts (16 pts common) ON delay Less than 2 ms Less than I ms OFF delay Less than 12 ms Less than 1/2 ...

  • Toshiba EX500 - page 15

    Analog Input Analog Output RTD Input High-speed Pulse Counter Thermocouple Input Item PI-6246A Item PI-6246A Counting speed 50 kpps (max) Functions 1 . Quadrature counter 2 . Up/down counter 3 . Speed counter Input voltage 5/12 Vdc Input channels I channel (phase A, B, M) Count value range 0 - 65535 Consumed current Less than 500 mA (5 V) Compariso ...

  • Toshiba EX500 - page 16

    INTELLIGENT I/0 MODULES PID Control Module ASCII/BASIC Module Motion Control Module Driver J Item MC-6243 No . of axis I axis Speed (pulse rate) Max . 200 kpps Positionning range ± 1000000 pulses Positionning system Absolute/increment Point data capacity 511 points Basic parameters Acceleration/deceleration : 0 - 27 sec Backlash compensation : 0 ...

  • Toshiba EX500 - page 17

    Specifications of Peripheral Devices Item GPI10AP2 GPI10API GPIIO HP100 MP100 DP100 Power supply voltage 100 - 240 Vac (+ 10/- 15%) - 50/60 Hz 5 Vdc (supplied from PC) Power consumption Less than 20 VA 0 .2 A 0 .3 A 0 .4 A Operating temperature 0 - 40°C (32 - 104°F) Storage temperature -20 - 75°C (-48 - 167°F) Humidity 20 - 90% RH Approx . weig ...

  • Toshiba EX500 - page 18

    ORDERING INFORMATION Item Description Part number Controllers and Expansion Units Controller Options I/O Modules ... ... ... MEMO SOONER . . . . . . . . . . . . . . . .H 16 points, 12 - 24 Vdc EX25MDI*6261 DC Input Module 32 points, 12 - 24 Vdc EX25MDI*6271 32 points, 12 - 24 Vdc, quick response EX25MDI*6271H 64 points (dynamic scan), 12 - 24 Vdc E ...

  • Toshiba EX500 - page 19

    Item Description Part number I/O Modules (cont'd) TOSLINE-30 Stations Peripherals Note : UL listed types are also available . Graphic Programmer (5 m cable attached) Standard GP 110 EX25UGP* 110 Stand-alone, Documentation GP110AP1 EX25UGP*110*API For EX2000 GP110AP2 EX25UGP*110*AP2 Handy Programmer 2 m cable attached HP100 EX25UHP*100 Mini Pro ...

  • Toshiba EX500 - page 20

    TOSHIBA TOSHIBA INTERNATIONAL CORPORATION TOSHIBA CORPORATION Industrial Equipment Department Industrial Equipment Division 13131 West Little York Road Houston, TX . 77041 ~ U .S .A . Tel : 713-466-0277 Fax : 713-466-8773 E_ m ail : plc@tic .toshiba .co m 1-1, Shibaura 1-chome, Minato-ku Tokyo 105, JAPAN Tel : 03-3457-4900 Cable : Toshiba Tokyo E_ ...

Manufacturer Toshiba Category Network Card

Documents that we receive from a manufacturer of a Toshiba EX500 can be divided into several groups. They are, among others:
- Toshiba technical drawings
- EX500 manuals
- Toshiba product data sheets
- information booklets
- or energy labels Toshiba EX500
All of them are important, but the most important information from the point of view of use of the device are in the user manual Toshiba EX500.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Toshiba EX500, service manual, brief instructions and user manuals Toshiba EX500. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Toshiba EX500.

A complete manual for the device Toshiba EX500, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Toshiba EX500 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Toshiba EX500.

A complete Toshiba manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Toshiba EX500 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Toshiba EX500, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Toshiba EX500, that we can find in the current document
3. Tips how to use the basic functions of the device Toshiba EX500 - which should help us in our first steps of using Toshiba EX500
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Toshiba EX500
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Toshiba EX500 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Toshiba EX500?

Use the form below

If you did not solve your problem by using a manual Toshiba EX500, ask a question using the form below. If a user had a similar problem with Toshiba EX500 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)