English dropdown-ico

Manual Subaru H7110LS200

8 pages 2.92 mb
Download

Go to site of 8

Summary
  • Subaru H7110LS200 - page 1

    1 INST ALLA TION INSTR UCTIONS SECURITY SYSTEM UPGRADE LEGA CY P/N: H7110LS200 Kit Contents: 1 Security Control Module w/Integral Brack et 1 Starter Interrupt/Horn Relays w/Integral Brack et 1 Horn w/Integral Brack et 1 Security Radio Mounting Bracket 2 Pan Head Scre ws (M5 × 8mm) 2 M6 Nuts 2 W indow Decals 1 Installation Manual T ools Required: # ...

  • Subaru H7110LS200 - page 2

    2 Figure 1 Figure 2 Figure 3 A. Pre-Installation Notes B. Security Module Installation 1. V ehicle Preparation a. Lo wer the driv er’ s side window to a void inadv ertently locking the keys in the v ehicle dur- ing installation. b . Disconnect negati ve battery terminal to pre vent accidental shorting of an y power circuits. 2. System Preparation ...

  • Subaru H7110LS200 - page 3

    3 Figure 4 Figure 5 Figure 6 4. Lift the center console co ver by carefully pulling outward in areas indicated by arro ws in Figure 4. 5. Remove the six scre ws indicated by the arro ws in Figure 5. Do not disconnect any connectors. Pull the unit out just far enough to access the passenger side of the unit. See Figure 6. NO T E: While the HV A C un ...

  • Subaru H7110LS200 - page 4

    4 C. Starter Interrupt and Horn Relay Installation 1. Remov e the screw indicated by the arro w in Figure 1 and disengage the two plastic scre ws indicated by arro ws in Figure 2, then remov e the dash panel. 2 . Locate the starter interrupt 6-pin (white housing) connector located to the left side of the steering col- umn behind the remov ed lower ...

  • Subaru H7110LS200 - page 5

    5 E. Prior to System T est W ARNING! Do not allow terminals of radio connectors to come in contact with any metal from vehicle due to +12 v olts being present at these terminals. 1. Reconnect negati ve battery terminal. D. Horn Installation 1. Locate the A T resistor in the engine compartment. 2 . Remov e the bolt (M8) indicated by arrow A in Figur ...

  • Subaru H7110LS200 - page 6

    6 G. V alet Mode T est 1. Open the dri ver’ s door and then depress and hold the UNLOCK/DISARM button on the remote for more than two seconds and the follo wing should be observed: a. The status indicator (LED) will begin flashing 2x per second indicating that the alarm is in the v alet mode. 2. Close all doors. 3. Depress the LOCK/ARM button on ...

  • Subaru H7110LS200 - page 7

    7 I. Notes on System Operation 1. If the alarm is not deacti vated within 30 seconds of triggering, the system will automatically reset. 2. The hood is not protected as a part of this system and therefore will not cause a triggering of the alarm when opened unless suf ficient force is used in which case the shock sensor will trig- ger the alarm. 3. ...

  • Subaru H7110LS200 - page 8

    8 K. Finishing the Installation 1. Re verse steps 1 through 10 in section B. Installation Preparation, to reassemble radio, radio trim bezel, cup holder , ashtray , gear shift cov er and parking brake trim. 2. Replace the lo wer dash panel below the steering column. 3. Place the windo w decals on the inside of the rear passenger windows at the lo w ...

Manufacturer Subaru Category Automobile Alarm

Documents that we receive from a manufacturer of a Subaru H7110LS200 can be divided into several groups. They are, among others:
- Subaru technical drawings
- H7110LS200 manuals
- Subaru product data sheets
- information booklets
- or energy labels Subaru H7110LS200
All of them are important, but the most important information from the point of view of use of the device are in the user manual Subaru H7110LS200.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Subaru H7110LS200, service manual, brief instructions and user manuals Subaru H7110LS200. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Subaru H7110LS200.

Similar manuals

A complete manual for the device Subaru H7110LS200, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Subaru H7110LS200 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Subaru H7110LS200.

A complete Subaru manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Subaru H7110LS200 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Subaru H7110LS200, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Subaru H7110LS200, that we can find in the current document
3. Tips how to use the basic functions of the device Subaru H7110LS200 - which should help us in our first steps of using Subaru H7110LS200
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Subaru H7110LS200
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Subaru H7110LS200 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Subaru H7110LS200?

Use the form below

If you did not solve your problem by using a manual Subaru H7110LS200, ask a question using the form below. If a user had a similar problem with Subaru H7110LS200 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (1)

Новосёлов Валерий

Вопрос. У меня Alesis QuadraVerb А как его подключить к пульту чтоб добавить эффект на канал.. гитары..вокала.. немного на клавиши.. это как сделать?