-
Black Box MDS932AE-10BT - page 1
User Manual MDS932AE-10BT STANDALONE MDS932AE-FXO STANDALONE MDS932AE-FXS STANDALONE MDS933AE-10BT STANDALONE MDS932C-10BT RACK-CARD MDS933C-10BT RACK-CARD G.SHDSL Modem USER MANUAL Version 1.2 Revision 26 January 2004 Document name MDS933AE-v1.2.doc ...
-
Black Box MDS932AE-10BT - page 2
...
-
Black Box MDS932AE-10BT - page 3
User Manual VERSION CONTROL .......................................................................................................... 5 1 GENERAL INFORMATION........................................................................................ 6 ORDER INFORMATION ................................................................................... ...
-
Black Box MDS932AE-10BT - page 4
User Manual 8.4 Line1 and Line2 Connector ............................................................................. 24 9 DESCRIPTION OF INTERFACE CABLES .............................................................. 25 9.1 Ethernet cable ................................................................................................. 25 9.2 DSL ...
-
Black Box MDS932AE-10BT - page 5
User Manual VERSION CONTROL Version Date Major changes to previous version 1.0 31.12.2001 Initial version of the manual corresponding to version 1.2 of the device micro program 1.1 23.10.2003 New function description corresponding to software release V1.6 Corrected Connecter description 9.1 Changed DSL cable to twisted type 10.2 1.2 26.1.2004 Manua ...
-
Black Box MDS932AE-10BT - page 6
User Manual 1 GENERAL INFORMA TION • High-speed symmetrical data transmission over one physical copper twisted pair with the 135 Ohm impedance according to ETSI TS 101 135. • ITU-T G.991.2 (G.shdsl) line encoding. • Line rate in the range from 72 Kbit/s to 2320 Kbit/s in 2 wire mode Line rate in the range from 144 Kbit/s to 4624 Kbit/s in 4 w ...
-
Black Box MDS932AE-10BT - page 7
User Manual ORDER INFORMA TION MDS932AE-10BT Modem AccessDSL Discovery, G.shdsl, 10/100Ba se-T Bridge, VLAN, Adapter 220 Vac MDS933AE-10BT Modem AccessDSL Discovery, G.shd sl, 1 or 2 pairs, up to 4.6Mbps, 10/100Base-T Bridge, VLAN, Adapter 220 Vac MDS932AE-FXS Modem AccessDSL Discovery, G.shdsl, 10/100Ba se-T Bridge, VLAN, Adapter 220 Vac, with FXS ...
-
Black Box MDS932AE-10BT - page 8
User Manual 2 DESCRIPTION OF THE DEVICE 2.1 Exterior design Desktop models The front panel of the device has 3 LEDs: LOCAL informs the user about the status of the local device. The following four statuses are possible «blinking red» informs the user about malfunctioning of the modem’s hardware and software. In this case, the modem is out of or ...
-
Black Box MDS932AE-10BT - page 9
User Manual The back panel of the MDS932AE-10BT and MDS933AE-10BT modem has: • The grounding bolt of the modem (option); • The “AC12V” power connector. The connection of the modem to the 220 V power supply is implemented using an external power supply unit; • the “Monitor” connector to control the modem and store statistics; • “PC ...
-
Black Box MDS932AE-10BT - page 10
User Manual 2.2 Exterior design rack card models ...
-
Black Box MDS932AE-10BT - page 11
User Manual Status(L) informs the user about the status of the local device. The following four statuses are possible «blinking red» informs the user about malfunctioning of the modem’s hardware and software. In this case, the modem is out of order and should be submitted to the service center for being repaired. «red» informs the user about ...
-
Black Box MDS932AE-10BT - page 12
User Manual 3 RULES OF SWITCHING 3.1 The standalone delivery set The delivery set includes: • the subscriber access dev ice (a modem) • the power supply source (an AC adapter) • the cables for the line connections 3.2 The rack-card delivery set The delivery set includes: • the subscriber access dev ice (a modul) • the cables for the line ...
-
Black Box MDS932AE-10BT - page 13
User Manual To update the information on the screen use the “Enter” key. The following menu will appear on the screen. Input Password: Please enter your programmed password. The unit will be delivered with the default password “admin” After entering the password the following menu will appear. Discovery G.SHDSL Ethernet Monitor V1.7 +------ ...
-
Black Box MDS932AE-10BT - page 14
User Manual 4 THE COMMAND SYSTEM 4.1 Basic rules After the command is typed, press <enter>. The <Backspace> key is used to edit commands. It is necessary to input item number, for choising menu item, You can use “PageUP”, “PageDown” and “Space” keys , for scrolling list of available value of parameters, The “Esc” key is ...
-
Black Box MDS932AE-10BT - page 15
User Manual 4.3 Performance management submenu Upon activation of the performance management submenu the following message will be displayed. Performance Management 1.Loop Status... 4.EtherNet Status... Select item number or ESC to Upper level menu>> 4.3.1 Loop Status submenu Upon activation of the performance management submenu the following ...
-
Black Box MDS932AE-10BT - page 16
User Manual 4.3.2 Ethernet Status submenu Upon activation of the performance management submenu the following message will be displayed. Performance Management->EtherNet Status Link:Link down Link Speed:---- Link Duplex:---- Used Entries:0 Tx Packets:0 Rx Packets:0 Fwd Packets:0 Drop Packets:0 Speed:Auto Duplex:Auto MAC Address:00-00-00-00-00-00 ...
-
Black Box MDS932AE-10BT - page 17
User Manual 4.4.1 DSL Setup In this menu you can setup the DSL link. When you have selected that menu, the following will appear: Configuration Management->DSL Setup 1.[Loop 1 Operation Mode]:Slave 2.[Loop 1 Auto/Fixed]:Fixed 5.[Loop 1 Fixed Connection Speed]:2312K(36N) 6.[Loop 1 Annex]:A/B 7.[Loop 1 Tx Level Adjustment]:0 dB 18.[2W/4W]:2W Selec ...
-
Black Box MDS932AE-10BT - page 18
User Manual 4.4.1.4 Fixed Connection Speed (only if Fixed is selected) • In the Fixed Connection Speed menu, you can specify your desired speed in the range of 72 kbps to 2312 kbps for 2wire units and 144 kbp s to 4624 kbps for 4wire models 4.4.1.5 Annex • With the Appendix menu you can choose between A, B, A / B. If you don’t know what Annex ...
-
Black Box MDS932AE-10BT - page 19
User Manual 4.4.2 Ethernet Setup submenu Configuration Management->EtherNet Setup 1.[Speed]:Auto 2.[Duplex Mode]:Auto 3.[Disable Mac Filter]:No 4.IP Address>>192.168.5.105 5.Subnet Mask>>255.255.255.0 6.Gateway Address>>192.168.5.1 Select item number or ESC to Upper level menu>> • In the Speed menu, you can setup the Et ...
-
Black Box MDS932AE-10BT - page 20
User Manual 5 TECHNICAL SPECIFICA TIONS The main technical specifications of modems of the Black Box family are presented below in the table. Line interface. Standard ETSI 101 135 Number of pairs 1 Line rate 2 wire models 4 wire models 72 – 2312 Kbit/s 144 – 4624 Kbit/s Communication range for cables with the wire diameter of 144 Kbit/s 2320 Kb ...
-
Black Box MDS932AE-10BT - page 21
User Manual 6 ST ORAGE CONDITIONS The equipment of the Black Box family while being packed should withstand all means of transport at a temperature in the range form -50 о С to +50 о С and the relative humidity of air up to 100% at 25 о С . The equipment can also withstand air-transport at a low air pressure of 12 kPa (90 Torr) at -50 о С . ...
-
Black Box MDS932AE-10BT - page 22
User Manual 7 TERMS TO TRANSPORT The equipment of the Black Box family should be packed and transported by: • motor transport with an enclosed truck body; • enclosed railroad cars; • unpressurized airplanes and helicopters (up to 10000 m at an air pressure of 170 Torr); • river transport (in holds). The equipment of the Black Box family sho ...
-
Black Box MDS932AE-10BT - page 23
User Manual 8 CONNECT OR’S DESCRIPTION 8.1 DSL Connector Type: RJ-45, 8 pin Number Signal Assignment 1,2 NC - 3 LB,a Ttp (4W model only) 4 LA,a tip 5 LA,b ring 6 LB,b ring (4W model only) 7,8 NC - RJ-45 1 8 8.2 Monitor Connector Type: Sub-D9, female Number Signal Assignm ent 1 NC - 2 TXD Transmit data 3 RXD Receive data 4 DTR Data terminal ready ...
-
Black Box MDS932AE-10BT - page 24
User Manual 8.3 PC and Hub Connectors Type: RJ-45 Number PC assignment HUB assignment 1 Tx+ Rx+ 2 Tx- Rx- 3 Rx+ Tx+ 4 NC NC 5 NC NC 6 Rx- Tx- 7 NC NC 8 NC NC 18 RJ-45 8.4 Line1 and Line2 Connector Type: RJ-11, 4 pin Number Signal Assignment 1 NC - 2 LA,a tip 3 LA,b ring 4 NC - RJ-11 1 4 Version: 1.2 Page. 24 of 25 ...
-
Black Box MDS932AE-10BT - page 25
User Manual Version: 1.2 Page. 25 of 25 9 DESCRIPTION OF INTERF ACE CABLES 9.1 Ethernet cable Side А Color of wire Side B 1 white/green 1 2 green/white 2 3 white/orange 3 4 blue/white 4 5 white/blue 5 6 orange/white 6 7 white/brown. 7 8 brown/white 8 9.2 DSL cable Side А Color of wire Side B 1 white/green 1 2 green/white 2 3 white/orange 3 4 blue ...
Do you have a question concerning Black Box MDS932AE-10BT?
Use the form below
If you did not solve your problem by using a manual Black Box MDS932AE-10BT, ask a question using the form below. If a user had a similar problem with Black Box MDS932AE-10BT it is likely that he will want to share the way to solve it.