English dropdown-ico

Manual Haier HA1000TE

18 pages 0.72 mb
Download

Go to site of 18

Summary
  • Haier HA1000TE - page 1

    Automatic Drum W ashing Machine HA1000TE HA800TE HA600TE T able of Contents Before using Names of Parts---------------------------------inside front cover Matters Needing Attention-------------------------------------1-3 Installation---------------------------------------------------------4-5 Control Panel------------------------------------------- ...

  • Haier HA1000TE - page 2

    Names of Parts T able Cover Program Knob Operation Button Drainage hose clip Back plate Packing bolt (3) W ashing Allocating box W ash Door Observing Glass Window Drainage hose Earth terminal Power supply cable Back plate screw (3) Caution and W arning symbols For your safety and to prevent damages to the washing machine, any instructions in this m ...

  • Haier HA1000TE - page 3

    Safety 1. A separate earthed socket is required for the power supply . After installation of the washing machine,the power plug should be accessible during the normal wash. 3. Fuses in the power circuit should be rated for 15A. Refer to a washing machine techni- cian or a Haier designated service point for power cable replacement. 5. Do not use fla ...

  • Haier HA1000TE - page 4

    Matters Needing Attention 2 Use ƽ ...

  • Haier HA1000TE - page 5

    9. Keep the door slightly open when the washing machine is not being used. Never cover the machine with a plastic sheet. 4. Do not wash foam rubber or similar sponge materials. 5. Before washing, do up zippers, buttons , laces and repair damaged areas,under- wear or small articals should be placed in the laundry bag or a pillowslip. Do not wash clo ...

  • Haier HA1000TE - page 6

    As shown in figure1 remove all the packing materials (including the foam base). Fig 1 Check attachments and materials. 3 Name Qty Model Operational manual Quality certificate Wa t e r hose Drainage holder Plastic plugs 1 1 1 HA1000TE HA800TE HA600TE 1 Remove the packing screws as shown in figure 2. The packing bolts protect the appliance from shock ...

  • Haier HA1000TE - page 7

    Connection of water inlet hose and washing machine W a t e rd r a i n a g eh o s e Connection of power supply The height of the terminal of the water drainage hose should be between 80cm-100cm, the water drainage hose must be securely placed on the clip on the back of the washing machine. Use the water drainage support supplied as an accessory for ...

  • Haier HA1000TE - page 8

    6 Control Panel T urn the knob at "0", then turn of f the power and turn the program knob for setting desired wash program. The program knob will not rotate with the programmed washing process. 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 90 80 70 60 50 40 30 14 15 1 2 3 8 12 13 11 10 9 7 6 5 4 0 90 80 70 60 50 40 30 H ...

  • Haier HA1000TE - page 9

    7 Operational Functions Economic W ash button Note: Select this function when "Cotton" "Synthetics", "Wool" or "Silk" (programs 1-12) is selected.  Soak Button F or th e syn t h e ti cs cy cl e a n d th e w o o l cy cl e , p u sh th e b ut t on d ow n , t h e a nt i c re as e f u nt i on wil l b e s k i pe ...

  • Haier HA1000TE - page 10

    Program Selection 8 Intense Prewash Normal Middle Delicate Normal Middle Delicate Normal Delicate Normal Delicate Silk 8 9 10 11 12 13 14 15 0 1 2 3 4 5 6 7 V ery heavy soil Non-fade heavily soiled woolen fabrics Fading and medium soiled woolen fabrics Non-fade heavily soiled silk fabrics Fading and medium soiled silk fabrics End Spin Rinse Quick M ...

  • Haier HA1000TE - page 11

    1. Power supply Plug in the power supply 220V~240V/50Hz. 3. Laundry treament 5.W ash Load 2. W ater supply T urn on the tap ensure that the water is clear . Caution: Before staring the washing machine turn on the water faucrt to ensure that the water faucet and the water inlet hose are connected correctly and do not leak. sort out clothes according ...

  • Haier HA1000TE - page 12

    1. Laundry loading Evenly load the laundry in the washing machine and then tightly close the door of the washing machine Note: 1) When first using the washing machine, let it run un- loaded for one program to pre- vent the laundry from being tainted by oil or dirty water from the washing machine. 2) Do not overload the washing machine. 2. Use of de ...

  • Haier HA1000TE - page 13

    11 7. End W ait 2-3 minutes after the washing process is finished , press the power button again to cut off the power supply . Open the door to take out the laundry . T urn off the tap and unplug the washing machine. 5. Selecting the function button Select function buttons as required (refer to the directions printed on the control panel) , otherwi ...

  • Haier HA1000TE - page 14

    Other Functions 1. Power-off memory funtion: This machine has a power-off menmory funtion. In case of abrupt power failure or the power must be cut off during a program cycle, the present settings will be saved, and operation will resume when the power is switched on again. 2. T rouble messages: judge the malfunctions from door lock light Error 1: ...

  • Haier HA1000TE - page 15

    Insert the bolts. 5. If the machine is to be moved a distance location, replace the vibration mounting locks which were re- moved during installation as shown below. 1. T urn of the water and electricity supply af- ter every wash. Open the door to prevent the formation of moisture and odors. If the wash- ing machine is left idle for a long period, ...

  • Haier HA1000TE - page 16

    The following circumstances do not constitute problems. Do not contact the maintenance service until the problem has been confirmed. Problem Possible Cause The washing machine fails to operate Poor connection to power supply Power failure Door is not properly closed Machine has not been switched on W ashing machine does not fill with water Water is ...

  • Haier HA1000TE - page 17

    Maximum power (W) Model Maximum working current (A) W ater pressure (MPa) W ashing power (W) Spinning power (W) Max. washing load (kg) Spinning speed (r/min) Size (mm) W eight (kg) HA1000TE 220V~240V/50Hz 15 0.03 P 1 230 400 5 15 2000 65 1000 850x520x595 Item Power supply W ashing program T echnical Specification HA 8 00TE 220V~240V/50Hz 15 0.03 P ...

  • Haier HA1000TE - page 18

    W iring Circuit 16 Motor R S T M1 M2 M3 M5 M7 M8 CN1-2 CN2-1 CN1-3 CN1-1 CN3-3 CN3-1 CN2-2 CON3 CN2-3 CN2-4 CN2-5 CN2-6 CON3 CN3-3 CN3-4 CON2 CON1 CN6-3 CN6-4 PCB NTC SW N G L FA MRN MRL MRC MR EVF EVP PS EVC R 12 13 14 11 P PCB-Printed Circuit Board Motor-Motor MR-Door Lock R-Heating Element PS-Drain Pump P-Pressure Switch EVP ,EVF-Cold water V al ...

Manufacturer Haier Category Washer

Documents that we receive from a manufacturer of a Haier HA1000TE can be divided into several groups. They are, among others:
- Haier technical drawings
- HA1000TE manuals
- Haier product data sheets
- information booklets
- or energy labels Haier HA1000TE
All of them are important, but the most important information from the point of view of use of the device are in the user manual Haier HA1000TE.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Haier HA1000TE, service manual, brief instructions and user manuals Haier HA1000TE. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Haier HA1000TE.

Similar manuals

A complete manual for the device Haier HA1000TE, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Haier HA1000TE by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Haier HA1000TE.

A complete Haier manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Haier HA1000TE - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Haier HA1000TE, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Haier HA1000TE, that we can find in the current document
3. Tips how to use the basic functions of the device Haier HA1000TE - which should help us in our first steps of using Haier HA1000TE
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Haier HA1000TE
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Haier HA1000TE in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Haier HA1000TE?

Use the form below

If you did not solve your problem by using a manual Haier HA1000TE, ask a question using the form below. If a user had a similar problem with Haier HA1000TE it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)