English dropdown-ico

Manual Campbell Hausfeld PW2002

20 pages 1.43 mb
Download

Go to site of 20

Summary
  • Campbell Hausfeld PW2002 - page 1

    BUILT TO LAST Gasoline Power ed Pr essur e W ashers Product Manual PW2002 and PW2102 Carefully read and understand these instructions before operating your pressure washer . © 2007 Campbell Hausfeld/Scott Fetzer IN466900A V 5/07 Frequently Asked Questions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety an ...

  • Campbell Hausfeld PW2002 - page 2

    Pressur e W ashers www .chpower .com Fr equently Asked Questions How do I start my pr essure washer? 1. Make sure you have gas and oil in the engine. 2. T urn the water on, then trigger the gun to make sure the water will flow smoothly out of the nozzle. 3. Put the engine throttle control in the “Fast/Start” position. Set the shut of f switch t ...

  • Campbell Hausfeld PW2002 - page 3

    • Always engage the trigger safety latch in the safe position when spraying is stopped even if only for a few moments. • Always follow detergent manufacturer’ s label recommendations for proper use of detergents. Always protect eyes, skin, and respiratory system from detergent use. Do not use pressur e that exceeds the operating pressur e of ...

  • Campbell Hausfeld PW2002 - page 4

    2. a. For model PW2002: Attach wire holders to handle and frame as shown in figure 2 using a 3/8" or adjustable wrench. b. For model PW2102: Attach detergent tank to backside of handle. Use the 4 hex bolts with flat washer under hex head and 4 nuts provided. 3. a. Model PW2002: Slide clear plastic hose onto chemical injector hose barb (Figure ...

  • Campbell Hausfeld PW2002 - page 5

    TRIGGER SAFETY LA TCH In the engaged position, the trigger safety latch prevents the gun from being triggered accidentally . Push the latch fully down to engage it (See Figure 10 and 11). Always engage the trigger safety latch when the unit is not in use. 4. Brass Swivel Adaptor (See Figure 4). If it’ s not already attached to the pump inlet, ass ...

  • Campbell Hausfeld PW2002 - page 6

    The following cleaning procedure will help you organize your cleaning task and ensures that you will achieve the best results in the shortest amount of time. Remember to use the spraying / cleaning techniques mentioned in the following section. Before starting a pressure washer cleaning job, prepare the surface you intend to clean. Clear furniture ...

  • Campbell Hausfeld PW2002 - page 7

    Pressur e W ashers Spray the cleaning surface with water to clear off any dirt or grime that may have collected on the surface. Doing so allows the detergent to attack the deep down dirt that has worked its way into the cleaning surface. Before triggering the gun, adjust the nozzle to a wide fan pattern and slowly adjust it to the desired spray pat ...

  • Campbell Hausfeld PW2002 - page 8

    www .chpower .com Pressur e W ashers Operation (Continued) TURBO LANCE (NOT INCLUDED WITH ALL MODELS) A turbo lance is equipped with a permanently attached nozzle . This nozzle, sometimes referred to as a rotary nozzle, can significantly reduce cleaning time. The turbo nozzle combines the power of a narrow high impact stream with the efficiency of ...

  • Campbell Hausfeld PW2002 - page 9

    Pressur e W ashers 9 Operation (Continued) 2. The easiest way to regulate the cleaning power of your pressure washer is by changing the distance from the surface you are cleaning. Begin spraying with a wide fan pattern while standing several feet from the surface. Slowly move closer to the object you are cleaning, adjusting the spray pattern as nec ...

  • Campbell Hausfeld PW2002 - page 10

    10 Pressur e W ashers Observe regular maintenance intervals to ensure maximum performance and life from the pressure washer . Refer to the schedule for recommended maintenance. If you operate the pressure washer in dusty conditions, perform maintenance checks more often. ENGINE OIL CHANGING INSTRUCTIONS Before tipping the engine or equipment to dra ...

  • Campbell Hausfeld PW2002 - page 11

    11 Pressur e W ashers Maintenance (Continued) Service Recor d Date Maintenance performed Replacement components requir ed www .chpower .com ...

  • Campbell Hausfeld PW2002 - page 12

    12 Pressur e W ashers Ref. Part Kit Part or Kit Qty per No. Description Name Number Kit For Replacement Parts, Call 1-800-330-0712 Please provide following information: - Model number - Serial number (if any) - Part description and number as shown in parts list Address parts correspondence to: Campbell Hausfeld Attn: Customer Service 100 Production ...

  • Campbell Hausfeld PW2002 - page 13

    Pressur e W ashers 13 Replacement Parts List — V ertical Shaft Pressur e W asher Ref Description Product PW2002 PW2102 No. Number QTY QTY 1 Handle tube, no tank PM345104BH 1 -- 2 * 1/4” - 20 bolt (handle) PM001902A V 2 2 3 * Flat washer PM002000A V 14 18 4 * 1/4” - 20 nylon lock nut ST073808A V 7 7 5 * 1/4” - 20 bolt (base) PM001902A V 3 3 ...

  • Campbell Hausfeld PW2002 - page 14

    Pressur e W ashers 14 www .chpower .com High Pressur e Soap Lance Safety Section This manual contains information that is very important to know and understand. This information is provided for SAFETY and to PREVENT EQUIPMENT PROBLEMS. T o help recognize this information, observe the following symbols. W ar ning indicates a potentially hazardous si ...

  • Campbell Hausfeld PW2002 - page 15

    Pressur e W ashers 15 1 Injector Lance PM268500A V 1 2 Lance T ank PM268012A V 1 3 O-ring MJ106515A V 1 4 Suction T ube PM268405A V 1 5 Inner Cap PM268302AV 1 6 Outer Cap PM268312A V 1 7 Screw MJ106100AV 1 8 O-ring MJ106511A V 3 9 Connector T ube PM268450A V 1 10 Check V alve Kit PM342400SV 1 11 Suction tube weight PM342405A V 1 12 Clip PM342410A V ...

  • Campbell Hausfeld PW2002 - page 16

    Pressur e W ashers T roubleshooting Chart - Gasoline Power ed Pressur e W ashers Only Symptom Possible Cause(s) Corrective Action(s) Engine will not start or is hard to start Engine misses or lacks power Low pressure and/or pump runs rough Water leakage from under pump manifold Water in pump crankcase (milky oil) Frequent or premature failure of th ...

  • Campbell Hausfeld PW2002 - page 17

    Pressur e W ashers 17 T roubleshooting Chart - Gasoline Power ed Pressur e W ashers Only (Continued) Symptom Possible Cause(s) Corrective Action(s) Pressure drops after period of normal use Pump noisy / pump runs rough Pressure washer will not spray detergent 1. W orn pump water seals 2. Nozzle worn 3. V alve worn, dirty or stuck 4. Unloader valve ...

  • Campbell Hausfeld PW2002 - page 18

    Pressur e W ashers 18 www .chpower .com Notes ...

  • Campbell Hausfeld PW2002 - page 19

    Pressur e W ashers 19 www .chpower .com Notes ...

  • Campbell Hausfeld PW2002 - page 20

    Pressur e W ashers Limited W arranty 1. DURA TION: From the date of purchase by the original purchaser as follows: One Y ear 2. WHO GIVES THIS WARRANTY (WARRANTOR): Campbell Hausfeld / Scott Fetzer Company , 100 Production Drive, Harrison, OH 45030, T elephone: (800) 330-0712 3. WHO RECEIVES THIS WARRANTY (PURCHASER): The original purchaser (other ...

Manufacturer Campbell Hausfeld Category Pressure Washer

Documents that we receive from a manufacturer of a Campbell Hausfeld PW2002 can be divided into several groups. They are, among others:
- Campbell Hausfeld technical drawings
- PW2002 manuals
- Campbell Hausfeld product data sheets
- information booklets
- or energy labels Campbell Hausfeld PW2002
All of them are important, but the most important information from the point of view of use of the device are in the user manual Campbell Hausfeld PW2002.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Campbell Hausfeld PW2002, service manual, brief instructions and user manuals Campbell Hausfeld PW2002. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Campbell Hausfeld PW2002.

Similar manuals

A complete manual for the device Campbell Hausfeld PW2002, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Campbell Hausfeld PW2002 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Campbell Hausfeld PW2002.

A complete Campbell Hausfeld manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Campbell Hausfeld PW2002 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Campbell Hausfeld PW2002, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Campbell Hausfeld PW2002, that we can find in the current document
3. Tips how to use the basic functions of the device Campbell Hausfeld PW2002 - which should help us in our first steps of using Campbell Hausfeld PW2002
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Campbell Hausfeld PW2002
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Campbell Hausfeld PW2002 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Campbell Hausfeld PW2002?

Use the form below

If you did not solve your problem by using a manual Campbell Hausfeld PW2002, ask a question using the form below. If a user had a similar problem with Campbell Hausfeld PW2002 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)