English dropdown-ico

Manual Geratherm Desktop

17 pages Not applicable
Download

Go to site of 17

Summary
  • Geratherm Desktop - page 1

    GB Fully Fuzzy Auto Digital Blood Pressure Monitor INSTRUCTION MANUAL ...

  • Geratherm Desktop - page 2

    GB Information Y ou Should Know Before Opera- ting the Unit About the Unit ................................................. 25 Explanation of Displays ................................ 25 Preparation for Use Installing/Replacing Batteries ....................... 26 Attaching the Pressure Cuff ......................... 27 Measuring Posture ......... ...

  • Geratherm Desktop - page 3

    GB Information Y ou Should Know Before Operating the Unit 23 What is blood pressure? A force is created by the heart as the ventricle forcibly ejects blood into the blood vessels and through the transport system. Another force is cre- ated by the arteries as they resist the blood fl ow . Blood pressure is the result of these two forces. What are s ...

  • Geratherm Desktop - page 4

    GB 24 What about low blood pressure? In general, a lower blood pressure reading is better unless it causes some uncomfortable symptoms such as fainting and/or lightheadedness. Fluctuation and variation in blood pressure The following chart shows possible blood pressure fl uctuations during a 24hr period. The following factors will infl uence bloo ...

  • Geratherm Desktop - page 5

    GB About the Unit 25 The cuff is designed to fi t arm sizes between 22 and 32cm (8.7 to 12.6 inches.) Explanation of Displays Cuff On/Off Button Date/T ime LCD Display Memory Button Systolic Pulse Diastolic Low Battery Memory ...

  • Geratherm Desktop - page 6

    GB 26 Installing/Replacing Batteries 1. Insert the batteries into the battery compartment matching correct polarities „+“ and „-“. 2. Replace all batteries if the low battery indicator appears. 3. Remove the batteries if the unit will not be used- for a long period of time. 4. REMOVE all of the BA TTERIES when utilizing the optional AC adap ...

  • Geratherm Desktop - page 7

    GB Preparation for Use 27 Attaching the Pressure Cuff 1. Wrap the cuff around the left arm. The arm should be bare skin. 2. Fasten the cuff. Don‘t pull it strongly and make the cuff too tight. The cuff‘s edge should be ap- proximately 1 inch from crook of the arm. 3. Attach the cuff on the right hand as shown in the fi gure if it is not possib ...

  • Geratherm Desktop - page 8

    GB 28 Measuring Positure 1. Sit upright and ensure that the measuring site is at heart level. Relax and measure in a natural position. 2. Measure and record blood pressure at the same time every day to establish your blood pressure pattern. AC Adapter (optional accessory) It is possible to use a stabilized AC adapter (output 6 V DC/800 mA) to opera ...

  • Geratherm Desktop - page 9

    GB How to Operate the Unit 29 1.Setting the Clock T o adjust the clock Press the memory key to adjust the values of the ”month”, “date”, “hour”, and “minute” when they are blinking T o enter the setting mode by pressing and holding the memory key for over 3 seconds. The display will show a blinking year . Press the power key to adju ...

  • Geratherm Desktop - page 10

    GB 30 2. Measuring Blood pressure Press and release the POWER key to start measuring automatically When the measurement is fi nished, the display will show the measured blood pressure and pul- se value Press the power key to turn off the unit. Otherwise the unit will turn off automatically 150 seconds later . How to Operate the Unit  Initial di ...

  • Geratherm Desktop - page 11

    GB How to Operate the Unit 31 Note: If the symbol appears, it means the unit has detected irregular pulse during measurement. If the symbol appears regularly ple- ase consult a qualifi ed physician for professional advice. 3. Recalling Memories Press and release the MEMORY key to recall the last reading (Example: the no.7 memory). The dis- play wi ...

  • Geratherm Desktop - page 12

    GB 32 4. Erasing Memories Y ou may erase one or all records in memory . Delete one Record 1. Press and release MEMOR Y key to choose the record that you wish to delete 2. Press and hold the POWER key until the display shows “dEL”. 3. Press and release the power key again. After 3 beeps are heard, the unit erases the re- cord. Delete all records ...

  • Geratherm Desktop - page 13

    GB Care and Maintenance 33 Do not drop the unit. It is not shock-proof. Do not modify or disassemble the unit or the arm cuff. Do not twist the arm cuff. Use a cloth mois- tened with water or neutral detergent to clean the body of the unit and then wipe it dry . ...

  • Geratherm Desktop - page 14

    GB 34 Care and Maintenance Avoid thinner , benzi- ne, and other harsh cleaners. Keep the unit in a suitable place. Avoid high tempera- ture, direct sunlight, high moisture, and dust. Remove the batteries if the unit will not be used for a long time. Do not press the POWER button if the cuff has not been properly wrapped around the arm. ...

  • Geratherm Desktop - page 15

    GB Error Message 35 The pressure measu- red was lower than 20mmHg. Please measure again. The pressure measu- red was higher than 300mmHg. Please measure again. Pumping error . Please check cuff and try again The pressure can not be measured due to signal noise. Please measure again. Message Correction Low battery . Check and replace the 4 batteries ...

  • Geratherm Desktop - page 16

    GB 36 Display System Measuring Method Power Source Measuring Range Accuracy Infl ation Pressure Exhaust Memory Display Low Battery Indicator Auto Power-Off Battery Life Operating Environment Storage Environment Dimensions Weig ht Specifi cations Liquid Crystal Display Oscillometric 4 alkaline type „AA“ batteries (1.5V) or AC/DC adapter (optio ...

  • Geratherm Desktop - page 17

    GB Quality Standard 37 The device complies with the Council Directive 93/42/EEC of 14th June 1993 concerning medical devices. A Quality management system, certifi ed according to EN ISO 13485 guaranties the high quality standard of the product. The Blood pressure monitor conforms to EN 1060- 1 (Non invasive sphygmomanometers part 1: Ge- neral requ ...

Manufacturer Geratherm Category Sphygmomanometer

Documents that we receive from a manufacturer of a Geratherm Desktop can be divided into several groups. They are, among others:
- Geratherm technical drawings
- Desktop manuals
- Geratherm product data sheets
- information booklets
- or energy labels Geratherm Desktop
All of them are important, but the most important information from the point of view of use of the device are in the user manual Geratherm Desktop.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Geratherm Desktop, service manual, brief instructions and user manuals Geratherm Desktop. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Geratherm Desktop.

Similar manuals

A complete manual for the device Geratherm Desktop, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Geratherm Desktop by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Geratherm Desktop.

A complete Geratherm manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Geratherm Desktop - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Geratherm Desktop, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Geratherm Desktop, that we can find in the current document
3. Tips how to use the basic functions of the device Geratherm Desktop - which should help us in our first steps of using Geratherm Desktop
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Geratherm Desktop
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Geratherm Desktop in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Geratherm Desktop?

Use the form below

If you did not solve your problem by using a manual Geratherm Desktop, ask a question using the form below. If a user had a similar problem with Geratherm Desktop it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)