English dropdown-ico

Manual Philips CRV 1997-2003

14 pages 1.62 mb
Download

Go to site of 14

Summary
  • Philips CRV 1997-2003 - page 1

    Signa l ® Mirror Installation Instructions Honda CRV 1997-2003 THE safety accessory of the 21 st Century. ™ P/N 210-0032-0 Rev B2 (6-26-04), GG © 2003 Muth Mirror Systems, LLC. ® ...

  • Philips CRV 1997-2003 - page 2

    INCLUDED ITEMS: 1 left and 1 right Signal ® mirror 1 left and 1 right wire harness 2 rubber tubes 2 rubber grommet s 2 wire taps 1 ring connector 1 instruction manual REQUIRED TOOLS: Ratchet with extension or ratcheting screwdriver 8mm socket, 10mm socket Small Philips screwdriver Medium Philips screwdriver Small pry bar Small utility knife Power ...

  • Philips CRV 1997-2003 - page 3

    1 2 3 4. Open door and low er window. 5. Remove screw and plastic grommet o n inside corner of door. 6. Remove plastic cover from corner of door. 1 3 2 1. Open door and low er window. 2. Remove plastic cover from corner of door. 3. Pop-out and rem ove plastic inserts. 1997-2001 Honda CRV 2002-2003 Honda CRV D oor Panel & Mirror Housing Removal ...

  • Philips CRV 1997-2003 - page 4

    D oor Panel & M irror H ousing R emoval Continued 4. Disconnect the m irror wire harness. 5. Remove three mirror mounti ng n ut s . 6. Remove m irror housi ng assembly from door. 4 5 6 - 2 - 1997-2001 Honda CRV 2002-2003 Honda CRV 4. Remove do or han dl e pl ast i c cover. 5. Unscrew the (2) screws revealed by the removal of the door handle cov ...

  • Philips CRV 1997-2003 - page 5

    This section intentionally left blank. D oor Panel & Mirror Housing Removal Continued 1997-2001 Honda CRV 2002-2003 Honda CRV 7. Remove the (2) screws beneath arm rest. 8. Lift up and pull door pan e l out slightly as show n. Disconnect any wiring connection behind door panel. Rem ove door panel from doo r. 9. Unscrew the (3) nuts holding the m ...

  • Philips CRV 1997-2003 - page 6

    M irror R eplacement While using st urdy glo ves, insert a sm all pry bar underneath t he mirror at t he bottom edge of the mirror housing. Lift up on the bo ttom of the mirror to release it from the snaps. Pivot the m irror upward on its top edge a nd lift t he mirror out of the mirror h ousing. Carefully remove the foam insulation from the mirror ...

  • Philips CRV 1997-2003 - page 7

    Using the sho rter of the tw o wires from the kit, starting from the inside of the mirro r housing, g uide the end without the mating connector down alongside the ex istin g factory mirror harness. Leave about 7 inches of wi re exposed i n the mirror housing. Guide the wire harness through the mirror bracket and re move any slac k. Replace the thre ...

  • Philips CRV 1997-2003 - page 8

    - 4 - Wire Routing 1. Pull out a portion of the rubber door insu latio n above the mirror m ount. 2. Drill a 5/16" hole leading into the m irror mount area. 3. Remove a ny debris a nd insert one of the included rubber grommets into the drilled hole. 1997-2001 Honda CRV 2002-2003 Honda CRV 1. Mount the mirror hou sing back onto the door frame u ...

  • Philips CRV 1997-2003 - page 9

    Wire Routing Continued 4. Pass the Si gnal ® m irror wire harness into the mirror mounting a rea and up through the rub ber gromm et. Remove any slack. 5. Bolt the m irror housi ng on the door using the three mirror m ounting nuts. 6. Reconnect the factory mirror wire ha rness. 1997-2001 Honda CRV 2002-2003 Honda CRV 4 5 6 3 4 5 3. Remove the foot ...

  • Philips CRV 1997-2003 - page 10

    7 8 9 7. Cut a small slit in the rubber door insulation, level with the rubber boot, between th e door and door frame. 8. Guide the Si gnal ® mi rror wire harness into the preexisting slit (u nd er the rubber door insulation) above the mi rror mount. 9. Pass the wire harness down through the rubber door insulation and ou t of the hole created in s ...

  • Philips CRV 1997-2003 - page 11

    10 11 12 10. Rem ove the footrest on the driver side floo rboar d by removing t he two bolts. 11. Rem ove the plastic grommet in the upper right corner of the plastic trim in the corner of the door. 12. Dislo dge the plasti c grommet from the center of the plastic trim and remove the trim from the corner of the door. Wire Routing Continued 1997-200 ...

  • Philips CRV 1997-2003 - page 12

    - 6 - 13 14 13. Slide the provi ded rubber tubing over th e w ire harness and gu ide 1 inch of tubing into the rubber door insulation. 14. There is a sm all hole in the top corne r of the plasti c trim piece along the door frame. Guide the wire harness and ru bber tubi ng into the hole an d pass the wire harness into the vehicle. Wire Routing Conti ...

  • Philips CRV 1997-2003 - page 13

    6 16 3 Wi r e Identification 15. Repeat all of the previous steps to replace the factory mirror on the passenger side door with the n ew Signal ® mirror. The vehicle's electrical wiring is located underneath the dash behind the fuse block assembly. Guide the new wire harnesses fr om both sides of the vehicle to the electrical wiring. Locate t ...

  • Philips CRV 1997-2003 - page 14

    - 7 - USE THE INCLUDED WIRE TAP S AND FO LLOW THE FOUR STEPS ABOVE TO SPLICE INTO THE TURN INDICATOR WIRES 7. Make sure the harnesses are routed securely under neath the dash and enough sl ack is left for splicing. 8. Splice the RED wire from the driver side harness into the green with red stripe and single gray ring wire previously labeled ‘driv ...

Manufacturer Philips Category Automobile Accessories

Documents that we receive from a manufacturer of a Philips CRV 1997-2003 can be divided into several groups. They are, among others:
- Philips technical drawings
- CRV 1997-2003 manuals
- Philips product data sheets
- information booklets
- or energy labels Philips CRV 1997-2003
All of them are important, but the most important information from the point of view of use of the device are in the user manual Philips CRV 1997-2003.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Philips CRV 1997-2003, service manual, brief instructions and user manuals Philips CRV 1997-2003. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Philips CRV 1997-2003.

Similar manuals

A complete manual for the device Philips CRV 1997-2003, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Philips CRV 1997-2003 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Philips CRV 1997-2003.

A complete Philips manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Philips CRV 1997-2003 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Philips CRV 1997-2003, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Philips CRV 1997-2003, that we can find in the current document
3. Tips how to use the basic functions of the device Philips CRV 1997-2003 - which should help us in our first steps of using Philips CRV 1997-2003
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Philips CRV 1997-2003
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Philips CRV 1997-2003 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Philips CRV 1997-2003?

Use the form below

If you did not solve your problem by using a manual Philips CRV 1997-2003, ask a question using the form below. If a user had a similar problem with Philips CRV 1997-2003 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (1)

Angelo19832204

Mi si forma sempre del ghiaccio nel congelatore. Lo smonto lo pulisco dal ghiaccio pulisco il canale di scolo del ghiaccio ma dopo tre giorni o anche prima si riforma e reinizia a perdere acqua da sotto la porta del congelatore