English dropdown-ico

Manual JVC SP-UXG200

28 pages 1.55 mb
Download

Go to site of 28

Summary
  • JVC SP-UXG200 - page 1

    MICRO COMPONENT SYSTEM UX-G200 —Consists of CA-UXG200 and SP-UXG200 INSTRUCTIONS LVT1956-005A [J] E n g l i s h For Customer Use: Enter belo w the Model No . and Serial No. w hich are located either on the rear , bottom or side of the cabinet. Retain inf or mation for future ref erence . Model No . Se r ia l No. this COVER_UX-G200[J].FM Page 1 We ...

  • JVC SP-UXG200 - page 2

    G-1 Warnings, Cautions and Others Mises en garde, précautions et indications diverses CAUTION To reduce the risk of electrical shocks, fire, etc.: 1. Do not remove screws, covers or cabinet. 2. Do not expose this appliance to rain or moisture. ATTENTION Afin d’éviter tout risque d’él ectrocution, d’incendie, etc.: 1. Ne pas enlever les vis ...

  • JVC SP-UXG200 - page 3

    G-2 IMPORTANT FOR LASER PRODUCTS 1. CLASS 1 LASER PRODUCT 2. CAUTION: Do not open the top cover or cabinet. There are no user serviceable par ts inside the unit; l eave all servicing to qualified service personnel. 3. CAUTION: Visible and/or in visible class 1M laser radiation when open. Do not view directly with optical instruments. 4. REPRODUCTIO ...

  • JVC SP-UXG200 - page 4

    1 Introduction Thank you for purchasing a JVC product. Please read all instructions c a refully before operation, to ensure your complete understa nding and to obtain the best possible performance from the unit. Precautions Installation • Install in a place whi ch is le vel, dry and neither too hot nor too cold—between 5°C (41°F) and 35°C (9 ...

  • JVC SP-UXG200 - page 5

    2 Contents Getting Started ...................... ...................... ....... 3 Step 1 : Unpack . ............ ........ ......... ............ ........ ......... ........ 3 Step 2 : Prepare the Remote Control ........... ......... ........... ... 3 Step 3 : Hook Up .............. ................................. ......... ........ 4 Before Oper ...

  • JVC SP-UXG200 - page 6

    3 Getting Started Step 1 : Unpack After unpacking, check to be sure that you have all the following items. The number in parentheses indicates the quantity of each piece supplied. • FM antenna (1) • AM loop antenna (1) • Remote control (1) • Batteries (2) If any item is missing, consul t your dealer immediately. Step 2 : Prepare the Remote ...

  • JVC SP-UXG200 - page 7

    4 Step 3 : Hook Up If you need more detailed information, see page 5. To a wall outlet Plug the AC power cord only after all connections are complete. FM antenna (supplied) Extend it so that you can obtain the best reception. Red Black AM loop antenna (supplied ) Turn it until the best reception is obtained. Turn the power off to all co mponents be ...

  • JVC SP-UXG200 - page 8

    5 To connect the A M loop antenna Make sure to connect the wire correctly. For better FM/AM reception • Make sure the antenna conductors do not touch any other terminals, connecting cords a nd the AC power cord. Also, keep the antenna away from meta llic parts of the System, connecting cords, and the AC power cord. This could cause poor reception ...

  • JVC SP-UXG200 - page 9

    6 Before Operating the System The indications on the display teach you a lot of things while you are oper ating the System. Before operating the Sy stem, be familiar with when and how the indicator ill uminates on the display. 1 TRACK indicator • Lights when a disc or USB ma ss storage class devi ce is played. 2 REPEAT mode indicators (REPEAT1/RE ...

  • JVC SP-UXG200 - page 10

    7 Daily Operations —Playback 1 Turn on the power. The STANDBY lamp on the main unit turns off. 2 Select the source. Playback automati cally starts if the sele cted source is ready to start. • If you select AUDIO IN, st art playback source on the external component. 3 Adjust the volume. 4 Operate the target source as explained later. To turn off ...

  • JVC SP-UXG200 - page 11

    8 Listening to the Radio To select the band (FM or AM) From the remote control: On the main unit: To tune in to a station While FM or AM is sele cted... Station searching starts and th e frequency indication starts changing on the display. When a station (frequency) with sufficient signal strength is tuned in, the searching will stop. To stop searc ...

  • JVC SP-UXG200 - page 12

    9 Playable Media and Files This System can play back fo llowing types of discs/files. • Audio CD • MP3/WMA files on a CD-R, CD-RW, or USB mass storage class device • This System may not play back some files even though their formats ar e listed above. • In this manual, “file” and “t rack” are used interchangeably for MP3 and WMA ope ...

  • JVC SP-UXG200 - page 13

    10 Playing Back Discs/Files To select a track/g roup To select a track: To select a group (MP3/WMA only): To locate a particular portion While playing a disc, press and hold until the portion you want is reached. To locate a track directly and start play • When you play back an MP3/WMA file, you can only select the tracks of the current group. To ...

  • JVC SP-UXG200 - page 14

    11 Daily Operations —Sound & Other Adjustments Adjusting the Volume You can adjust the volume le vel from level 0 (“VOL MIN”) to level 31 (“VOL MAX”). To drop the volume in a moment Adjusting the Sound To reinforce the bass so und—HBS You can enjoy powerful bass sound with the Hyper-Bass Sound effect. To select Sound Mode You can se ...

  • JVC SP-UXG200 - page 15

    12 Setting the Clock Set the clock before using th e Daily Timer (see page 16). • You can set the clock only when the System is turned off (on standby). 1 Turn off (standby) the System. 2 Activate the clock setting mode. 3 Adjust the hour. 4 Adjust the minute. The built-in clock starts working. To check the curre nt time during play The time is d ...

  • JVC SP-UXG200 - page 16

    13 Advanced Disc/USB Mass Stor age Class Device Operations Programming the Playing Order— Program Play You can arrange the playing order of the tracks (up to 32) before you start playback. • You can repeat the progra mmed tracks by pressing REPEAT. 1 Select the so urce. 2 Before starting playback , activate Program Play. 3 Select tracks you wan ...

  • JVC SP-UXG200 - page 17

    14 (2) Select a track. 4 Confirm the selecti on. Next program step is indicated. 5 Repeat steps 3 and 4 to program the other tracks. 6 Start playback. The tracks you have selected are played back in the order you have programmed. • You cannot select the track wi th the number buttons during Program Play. To check the program med contents While th ...

  • JVC SP-UXG200 - page 18

    15 Playing at Random—R andom Play You can play back all the tracks at random. 1 Select the sour ce. 2 Start Random Play. Playback starts in the random order. Random Play ends when all tracks are played. • You cannot select the track with the number buttons during Random Play. To exit from Random Pl ay • You can also exit from Random Play by p ...

  • JVC SP-UXG200 - page 19

    16 Daily Timer Operations Setting the Daily Timer Using the Daily Timer, you ca n wake up with music, etc. • Set the clock before setting th e Dail y Timer. (See page 12.) • To exit from the timer setti ng, press STOP 7 as required. 1 Activate the Daily Timer setting. 2 Set the On Time. (1) Set the hour. (2) Set the minutes as the hour setting ...

  • JVC SP-UXG200 - page 20

    17 (2) Set the hour. (3) Set the minutes as the hour setting above. You cannot set On time and Of f time on th e same time setting. 4 Select the playb ack source. (1) Proceed to the playback source setting. (2) Select the playback source; “ CD,” “ USB,” or “ TUNER”. When you select “TUNER” –1 Press 4 / x to select “AM PRE” or ...

  • JVC SP-UXG200 - page 21

    18 Additional Information Learning More about This System Daily Operations—Playback (see pages 7 to 10) Listening to the Radio: • If you store a new station into an occupied preset number, the previously stored station in that number will be erased. • When you unplug the AC power cord or if a power failure occurs, the preset stations will be ...

  • JVC SP-UXG200 - page 22

    19 Daily Operations—Sound & Other Adjustments (see pages 11 and 12) Adjusting the Volume: • Be sure to turn down the volume before connecting or putting the headphones. Adjusting the Sound: • This function also affects the sound through the headphones. Setting the Clock: • “AM 12:00” flashes on the display until you set the clock. ? ...

  • JVC SP-UXG200 - page 23

    20 Disc Operations: The disc does not play. ] The disc is placed upside down. Place the disc with the label side up. The disc sound is dis continuous. ] The disc is scra tched or dirty . Daily Timer Operations: The Daily Timer does not work. ] The System has been turned on when the on-time comes. The Daily T imer starts working only when the System ...

  • JVC SP-UXG200 - page 24

    21 Specifications Amplifier section Output Power: 8 W per channel, min. RMS, driven into 4 Ω at 1 kHz with no more than 10% total harmonic distortion. Speakers/Imped ance: 4 Ω – 8 Ω Terminals AUDIO IN: Input sensitivity/Impedance: 250 mV/50 k Ω USB MEMORY: USB specification Compatible with USB 2.0 Full- Speed Compatible device: Mass stora ...

  • JVC SP-UXG200 - page 25

    22 Parts Index Refer to the pages to see how to use the buttons and controls. Remote control AUDIO IN USB MEMORY 16, 17 12 7, 8, 10 7, 9, 13 - 15, 17 10, 12 - 17 8, 10, 13 15 11 11 7, 12, 17 8, 10, 13, 14 7, 8, 10, 17 7, 9, 13 - 15, 17 9, 13 - 16 11 15 7, 11 Main unit 9 6 16, 17 12 8, 10, 13, 14 7, 9, 13, 14, 17 7, 12, 17 7, 9, 13, 14, 17 8, 10, 13 ...

  • JVC SP-UXG200 - page 26

    BT-51018-5 ( 0306 ) TO OUR VALUED CUSTOMER IS HERE T O HELP! Do not attempt to service the product yourself Caution To prevent electrical shock, do not open the cabinet. There are no user serviceable parts inside. Please refer to qualified service personnel for repairs. NEED HELP ON HO W T O HOOK UP? NEED ASSIST ANCE ON HO W T O OPERA TE? NEED T O ...

  • JVC SP-UXG200 - page 27

    JVC Americas Cor p. (JVC) warrants this product and all parts thereof, except as set forth below ONLY TO THE ORIGINAL RETAIL PURCHASER to be FREE FROM DEFECTIVE MATERIALS AND WORKMANSHIP from the date of original purchase for the period shown below. ("The Warranty Period") THIS LIMITED WARRANTY IS VALID ONLY IN THE FIFTY (50) UNITED STATE ...

  • JVC SP-UXG200 - page 28

    1208YAMMDWMTS EN © 2008 Victor Company of Japan, Limited UX-G200 MICRO COMPONENT SYSTEM COVER_UX-G200[J].FM Page 2 We dnesday, November 5, 20 08 3:08 PM ...

Manufacturer JVC Category Stereo System

Documents that we receive from a manufacturer of a JVC SP-UXG200 can be divided into several groups. They are, among others:
- JVC technical drawings
- SP-UXG200 manuals
- JVC product data sheets
- information booklets
- or energy labels JVC SP-UXG200
All of them are important, but the most important information from the point of view of use of the device are in the user manual JVC SP-UXG200.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals JVC SP-UXG200, service manual, brief instructions and user manuals JVC SP-UXG200. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product JVC SP-UXG200.

Similar manuals

A complete manual for the device JVC SP-UXG200, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use JVC SP-UXG200 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of JVC SP-UXG200.

A complete JVC manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual JVC SP-UXG200 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the JVC SP-UXG200, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the JVC SP-UXG200, that we can find in the current document
3. Tips how to use the basic functions of the device JVC SP-UXG200 - which should help us in our first steps of using JVC SP-UXG200
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with JVC SP-UXG200
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of JVC SP-UXG200 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning JVC SP-UXG200?

Use the form below

If you did not solve your problem by using a manual JVC SP-UXG200, ask a question using the form below. If a user had a similar problem with JVC SP-UXG200 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)