English dropdown-ico

Manual New Buck Corporation Heater Model 80

27 pages 0.53 mb
Download

Go to site of 27

Summary
  • New Buck Corporation Heater Model 80 - page 1

    BUCK ST OVE “MEETS PHASE II EP A ST ANDARDS” MODEL 80 HEA TER FEA TURES PREP ARA TION INST ALLA TION OPERA TION MA INTENANCE SAFETY SAFETY NOTICE If this heater is not pr operly installed, a house fir e may result. For your safety, follow the installati on directions. Contact local b uilding or fi re offici als about restrict ions and i nstalla ...

  • New Buck Corporation Heater Model 80 - page 2

    ...

  • New Buck Corporation Heater Model 80 - page 3

    TABLE OF CONTENTS SECTION I Room Heater Features ................................................................................................... 3 Important Stat ements ..................................................................................................... 5-6 SECTION II Masonry Insert In stallation ............................... ...

  • New Buck Corporation Heater Model 80 - page 4

    2 ...

  • New Buck Corporation Heater Model 80 - page 5

    SECTION I The New Buck Corporat ion room heat er Model 80 is one of the sa fest and most effici ent heating systems available when installed and ope rated as specified in thes e instructions and as stipul ated on the operation and installation labels affixed to the unit. The unit is d esigned to burn wood fuel only. Please read this entire manual b ...

  • New Buck Corporation Heater Model 80 - page 6

    11 1 4 5 7 3 2 8 3A 6 12 9 10 13 32 15 31 30 26 22 24 27 23 25 28 18 1. By Pass Damper & Brass Spring Handle 2. Blower Control (Rheostat) 3. Primary Air Control (Right Side) 3a. Primary Air Control (Left Side) 4. Warm Air Outlets 5. Baffles (Interior of Stove) 6. Air Inlet 7. Door 8. Hearth Extension 9. Power Cord 10. Catalyst (interior firebox ...

  • New Buck Corporation Heater Model 80 - page 7

    EP A COMPLIANCE ST A T US This manual d escribes the inst allation and operation of t he New Buc k Corporatio n, Model 80 wood heater. These heaters meet the U.S. Envi ronmental Pr otection Agency’s Emission li mits for wood heaters sold after July 1, 199 2. Under specific test conditions this h eater has been shown to deliver heat at rates rangi ...

  • New Buck Corporation Heater Model 80 - page 8

    ACHIEVING CA T AL YTIC LIGHT -OFF WHEN REFUELING During the refueling and r ekindling of a cool fire, or a fire that h as burned do wn to th e charcoal phase, operate the stove at a medium to high firing rate for about 15 minutes t o ensure that the catalyst reaches ap proximately 600 o F. CA T AL YST MONITORING It is important to periodically moni ...

  • New Buck Corporation Heater Model 80 - page 9

    SECTION II MASONR Y INSER T INST ALLA TION INSTALLATION PRECAUTIONS It is not necessary to direct c onnect this unit, but testing has shown t hat it is necessary for best performance in a poorly dra wing flue, oversized flue liner or a short chim ney. Use the following to complete the installation of the unit as an insert: Kit # PA FP80 Note: Clear ...

  • New Buck Corporation Heater Model 80 - page 10

    POSSIBLE TO OLS NEEDED FOR INST ALLA TION If you decide to install your own stov e, there are several hand tools you may need to do the job. If you do not already have them, they are readily available at most hardwa re stores. Caulkin g gun Larg e adjusta ble wren ch (may no t be need ed) Drop cloths or newspapers Vacuum cleaner or whisk broom Flas ...

  • New Buck Corporation Heater Model 80 - page 11

    MOUNTING THE TRIM P ANELS After the unit is positioned, as shown in Figure 2, mark the mounting position of the trim panels as follows: 1. Set the side trim panels in place, flat a gainst the face of t he fireplace. Mark down the insi de edge of the trim panel to make a vertical refe rence line. 2. Set the top (long) trim panel in place on top of t ...

  • New Buck Corporation Heater Model 80 - page 12

    11. Pull th e unit back out of the fireplace and remov e the brass and top trim panel to facilitate the installation of the direct connect or positive connect. 12. Now, follow the installation procedures in the listed di rect or positive connect kit you are using and install the heater and connector kit in the fire place. 13. Reinstall th e top tri ...

  • New Buck Corporation Heater Model 80 - page 13

    SECTION III RESIDENTIAL FREEST ANDING ROOM HEA TER INST ALLA TION INST ALLA TION PRECAUTION Extensive fiel d and labora tory testing has shown t hat catalyt ic stoves perform best as free standing st oves when vented into a mason ry chimney that include the following: 1. A rain cap is installed on th e chimney. 2. Height of chim ney is at least 15 ...

  • New Buck Corporation Heater Model 80 - page 14

    MODEL 80 Minimum Clearances The New Buck Corporation Mod el 80 must be installed in compliance with the instruction s contained in this manual. Clearance from combustible walls and ceilings. (Using single wall chimney connector) The minimum lateral distance between an y part of the room heater and combustible wall is shown in Figures 6 and 7. FLOOR ...

  • New Buck Corporation Heater Model 80 - page 15

    Preparing The Stove for Installation 1. Inspect the uni t for any obvious phy sical dam age. 2. Check the primary air draft cont rols to ensure that they slide freely. 3. Check the operatio n of the bypass damper control to ensure that it will open and clo se properly. 4. Remove any ite ms from within the firebox. Spread the drop cloth on the floor ...

  • New Buck Corporation Heater Model 80 - page 16

    3. Now connect the stove to t he ceiling s upport box by using #24 ga. minim um blued or black steel chim ney pipe. (Do not use gal vanized pipe.) Co nnect each sec tion so the crim pled end f aces downward, and secure each section to each other using at least three (3 ) sheet m etal screws or rivets. (See Figure 8) 5. Connect the chim ney collar t ...

  • New Buck Corporation Heater Model 80 - page 17

    2. On ce the through-the-wall thimble codes are met , simply connect the chimney pipe to the wall pass- through conne ctor using #24 ga. minim um, blued or black ste el pipe as follows: (a) Maintain 1/4" rise per fo ot (horizontal lengt h) from t he appliance to the chimney. (b) Each section of pipe sho uld fit into the section below or into t ...

  • New Buck Corporation Heater Model 80 - page 18

    ALTERNATIVES FOR WALL PROTECTION Example: The rear clea rance for th e Model 80 from page 12 is 26". (Measurement A.) This clearance may be reduced by 6 6% by usin g either of t he wall prot ection devi ces mentioned below. Tested and Listed Wall Protector Clearances to combustibles may be reduced if a tested and listed wall protector is insta ...

  • New Buck Corporation Heater Model 80 - page 19

    3. Open the prim ary air draft s and damper bypass. 4. Plug the power cord into a 115 VAC outlet. 5. Place crumpled pieces of newspaper in th e stove. Light and close the door. Make sure that stove draws properly through th e primary drafts. 6. Check for smoke l eaks around the door. 7. Open the doo r and check for sm oke escaping from the front of ...

  • New Buck Corporation Heater Model 80 - page 20

    SECTION IV WOOD HEA TER SAFETY Certain safety hazards are inherent in a ny wood heater inst allation. You should be awa re of these so that a safe and proper instal lation can be made. 1. FAULTY CHIMNE Y: An older masonry chimney should b e thoroughly checked to be su re there are no holes or weak spots which could allow spa rks or hot gases to esc ...

  • New Buck Corporation Heater Model 80 - page 21

    SECTION V OPERATION This section of the manual is to help you get maxi mu m efficiency and maxim um smoke (particulate) reduction from your Model 80 heater. If you should exper ience any difficulty or hav e questions concerning your heater, contact your Model 80 dealer for assistance. Manufacturer’s recommendation for peak performance and long ca ...

  • New Buck Corporation Heater Model 80 - page 22

    Building a Fire: 1. By-pass damper mus t be open (pulled out) whe n starting fire or adding w ood to fire. 2. Open the door. 3. While lookin g inside the fi rebox, ope rate the dam per bypass d oor in and o ut observi ng the movem ent. If t he door does not operate fr eely and seal to the door opening, then the door has jumped out of its track duri ...

  • New Buck Corporation Heater Model 80 - page 23

    SECTION VI PREVENTIVE MAINTENANCE / P AR TS REPLACEMENT Disassembly Inspection and Catalytic Replacement The catalysts in your stove are designed for many years of us e. If after several years of use, the efficien cy of the stove decrease s or if a nota ble amount of s moke is observ ed, the catalysts m ay need to be repl aced. See the Catalyst War ...

  • New Buck Corporation Heater Model 80 - page 24

    22 ...

  • New Buck Corporation Heater Model 80 - page 25

    TROUBLESHOOTING Operation of any wood heater can cr eate problems. While the us e of a catalytic-combustor equ ipped stove will substantial ly lessen s ome of these problem s-such as c reosote fo rmation-other traditional wood he ater problem s may remain. The following guidelines apply to op eration of all wood heat ers with problems related to ca ...

  • New Buck Corporation Heater Model 80 - page 26

    Problem 3. Backpuffin g 4. Smoke Rollout when heater door is opened 5. Low Catalytic Temperature 1. Pluggin g 2. Catalyst Peeling 3. Catalyst Masking P ossible Cause 1. Gusts of wind 2. Hot combust or (Above 1400 o F) 1. Bypass damper i s closed, or combustor i s in operat ing position 2. Wind gusts blowi ng down chimney 3. Open ing heater door too ...

  • New Buck Corporation Heater Model 80 - page 27

    NEW BUCK CORPOR ATION (NBC) “LIMITED WARRAN TY” FOR NBC RELATED PRODUCTS PLEASE READ THIS WARRANTY CAREFULLY PRODUCTS COVERE D This warranty covers the new heating unit so long as it is owned by the ori ginal purchaser, including opti onal and standard accessories purchased at the sam e time, subject to terms, limitations, and co nditions herei ...

Manufacturer New Buck Corporation Category Fan

Documents that we receive from a manufacturer of a New Buck Corporation Heater Model 80 can be divided into several groups. They are, among others:
- New Buck Corporation technical drawings
- Heater Model 80 manuals
- New Buck Corporation product data sheets
- information booklets
- or energy labels New Buck Corporation Heater Model 80
All of them are important, but the most important information from the point of view of use of the device are in the user manual New Buck Corporation Heater Model 80.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals New Buck Corporation Heater Model 80, service manual, brief instructions and user manuals New Buck Corporation Heater Model 80. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product New Buck Corporation Heater Model 80.

Similar manuals

A complete manual for the device New Buck Corporation Heater Model 80, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use New Buck Corporation Heater Model 80 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of New Buck Corporation Heater Model 80.

A complete New Buck Corporation manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual New Buck Corporation Heater Model 80 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the New Buck Corporation Heater Model 80, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the New Buck Corporation Heater Model 80, that we can find in the current document
3. Tips how to use the basic functions of the device New Buck Corporation Heater Model 80 - which should help us in our first steps of using New Buck Corporation Heater Model 80
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with New Buck Corporation Heater Model 80
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of New Buck Corporation Heater Model 80 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning New Buck Corporation Heater Model 80?

Use the form below

If you did not solve your problem by using a manual New Buck Corporation Heater Model 80, ask a question using the form below. If a user had a similar problem with New Buck Corporation Heater Model 80 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)