-
CDA WF140 - page 1
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshir e • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www .cda.eu Passionate about style WF1 40 F r eestanding Dish w asher Manual for Inst allation, Use and Maintenanc e ...
-
CDA WF140 - page 2
Important The CDA Gr oup Ltd cannot be held r esponsible for injuries or losses caused by incorr ect use or installation of this product. Please note that CDA reserv e the right to invalidate the guarant ee supplied with this product following incorr ect installation or misuse of the appliance. This appliance is not designed to be used by people (i ...
-
CDA WF140 - page 3
Rec omendations • T o reduce ener gy and water consumption, remov e all dirt residues fr om the dishes prior to loading the dishw • • Only run the dishwasher only when fully loaded. • Place hollow items (bowls, glasses and pans) fac e down in the basket. Befor e first use • Set the water softener lev el as requir ed by the water har dnes ...
-
CDA WF140 - page 4
Contr ol Panel Starting a pr ogramme • Pr ess the P ower button (1) t o switch the dish washer on. • T urn the Pr ogramme Selection Dial (2) until the r equired pr ogramme is indicated. • If r equired, pr ess the Delay Timer button (3) r epeatedly to set the pr ogramme. • If r equired, pr ess the Prewash button (4). • Ensur e the dishwash ...
-
CDA WF140 - page 5
Deter gent T o fill the detergent c ompartment 1 . Push the latch t o open the compartment. 2. Ad d t he re qui r ed a mou nt of det er gent. Th e m ain de ter gent co mpa rtm ent (b in figure 1) has lines to allow for specific amounts of det ergent. These are marked at either 1 5 cm 3 or 25 cm 3 , depending on how dirty the dishes are. If your ...
-
CDA WF140 - page 6
Soft ener adjustment The efficiency of your dishwasher depends on the softness of the t ap water . T o ensure best efficiency , the dishwasher is equipped with a system that r educes the har dness in the mains water supply. The efficiency will incr ease when the system is corr ectly set. T o find out the water har dness level of your water supp ...
-
CDA WF140 - page 7
Rinse Aid T o fill the rinse aid c ompartment 1. Open the rinse aid com partment by turning and r emoving the cap as shown in figur e 4. 2. Fill the rinse aid co mpartment until the rinse aid indicat or goes dark, as shown in figur e 5 (wher e a indicates the com partment is empty , and “b” indicates the c ompartment is full). 3. Replac e th ...
-
CDA WF140 - page 8
Dishw asher Baskets T o adjust the height of the upper basket: 1. Open the basket r etaining clips, as shown in gure 7 , but turning them to the side. 2. Remove the upper bask et, and relocate the alt ernate set of wheels on the runner , as shown in figure 8, pushing the basket bac k into place. 3. Close the basket r etaining clips. The images ...
-
CDA WF140 - page 9
St andar d loading and T est Data Capacity • Upper and lower baskets: 1 2 place settings. • The upper basket should be adjusted to high position. • Cups should be placed on to the dish r ack pins. Deter gent / Rinse aid • 5 + 25 cm 3 , in accor dance with EN50242-DIN 44990 IEC 436 (international norms) / Rinse aid dosage adjustment: 4. Prog ...
-
CDA WF140 - page 10
Pr ogr amme Listing Progr amme names and temper atures Prew ash No heat Quick 40 O wash Economic 50 O wash Normal 55 O wash Intensiv e 65 O wash Extra intensiv e (Prew ash and intensiv e T ype of food wast e Pre-wash t o rinse and loosen residue-aw aiting full load-then select a progr amme Coffee, milk, tea, cold meats, vegatables, not kept for lon ...
-
CDA WF140 - page 11
Car e and Maintenanc e Bef or e beginn ing any car e or main tena nce, yo u should alw ays discon nect the appliance fr om the electricity supply , and also turn off the water supply. Door seals Wipe the dishw asher door seals regularly with a damp cloth to r emove any r esidues. Filter s Y ou should clean the filters at least once a month. 1. Rem ...
-
CDA WF140 - page 12
Failur e Codes and T r oubleshooting The progr amme indicators also serv e as a diagnostic display to help in the event of a pr oblem with the appliance. Error c ode Error description Advice W ash Rinse Dry End S tart/ Pause In ade qu at e water supply Ma ke su re the wa te r inl et t ap is fu lly op en. C los e th e w ate r ta p, se par ate th e w ...
-
CDA WF140 - page 13
Failur e Code and T r oubleshooting Problem P ossible cause The progr amme will not start Check the plug, fuse and circuit br eakers of the mains supply The water tap is turned off The dishwasher door is not fully closed The water inlet filter or the mac hine filters ar e blocked W ater remains inside the dishwasher at the end of the progr amme T ...
-
CDA WF140 - page 14
Electrical information W arning! This appliance must be earthed. The mains lea d of this appli anc e has bee n fitt ed wit h a BS 1 363A 1 3 amp fus ed plu g. T o ch ang e a fus e in this type of plu g, follow the steps below: 1. Remove the fuse cov er and fuse. 2. Fit replac ement 1 3A fuse, AST A approved to BS 1 362 type, into the fuse cover . ...
-
CDA WF140 - page 15
Installation • Do not install this appliance if it is damaged in any way . Installing a damaged appliance may in validate the warr anty. • The water supply tap should be located in an adjacent cupboar d so that it can be accessed after inst allation. • Ensure the appliance is level by adjusting the feet as nec essary. • Only use the water i ...
-
CDA WF140 - page 16
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshir e • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www .cda.eu Passionate about style T o contact our Customer Car e Department, or for Service, please contact us on the det ails below . ...
Do you have a question concerning CDA WF140?
Use the form below
If you did not solve your problem by using a manual CDA WF140, ask a question using the form below. If a user had a similar problem with CDA WF140 it is likely that he will want to share the way to solve it.