-
Auto Page RS-622 - page 1
1 RS - 622 PROFESSIONAL 2 - WAY AM/AM REMOTE CAR STARTER & KEYLESS ENTRY SYSTEM OPERATIONS MANUAL Please register your product at www.autopageusa.com THIS PRODUCT IS DESIGNED FOR PROFESSIONAL INSTALLATION ONLY ...
-
Auto Page RS-622 - page 2
2 SYSTEM OPERATIONS: WARNINGS: As with any product that performs automatic functions, there are certain safety precautions that you must practice and be aware of. 1. Keep the transmitter out of children’s reach. 2. Do not leave anyone in the vehicle while the vehicle is running on remote control. 3. Alert servicing personnel that the vehicle can ...
-
Auto Page RS-622 - page 3
3 CHANGING THE B ATTERY IN YOUR TRANSMITTERS XT - 33: This transmitter uses two (2) 3 - volt lithium ion batteries (#CR2016) that are sandwiched together with the (+) side facing upward. To replace the battery, you will need to use a small flat blade screwdriver. Locate the small notch on the lower right side of the transmitter case next to the key ...
-
Auto Page RS-622 - page 4
4 unlock and dome lights will turn on for 30 seconds. PATHWAY ILLUMINATION This feature turns the parking light “ON” for 30 seconds upon a unlock signal and for 10 seconds upon the lock signal. (Programmable) TWO STEPS DOOR UNLOCK: This feature will i ndependently unlock the driver door only when deactivating the system. Pushing the button a se ...
-
Auto Page RS-622 - page 5
5 Enter Valet Mode: 1. From the Unlo ck condition, turn the ignition to “ON” position. 2. Push and hold valet switch for 2 seconds until the LED turns on. The LED will remain on as long as the system is in ‘valet mode’. Exit Valet Mode: 1. Return to normal operation, turn ignition ‘on’. 2. P ush and hold valet switch for 2 seconds, The ...
-
Auto Page RS-622 - page 6
6 REMOTE START OPERATION: WARNINGS: As with any product that performs automat ic functions, there are certain safety precautions that you must practice and be aware of. 1. Keep the transmitter out of children’s reach. 2. Do not leave anyone in the vehicle while running on remote control. 3. Alert servicing personnel that the vehicle can be starte ...
-
Auto Page RS-622 - page 7
7 2. Move the optional remote start enable toggle switch to OFF position. (If installed) 3. Press the brake pedal, the vehicle will shut down and turn off the parking light to indicate engine stoppe d. TO OVERRIDE VEHICLE FROM REMOTE START CONTROL: To operate the vehicle while it is running from the remote start: 1. Insert the ignition key and turn ...
-
Auto Page RS-622 - page 8
8 Exit the timer start: Timer start can be exited manually as follows: 1. Repeat the Ente r Steps from above. Or 1. Make sure the remote start system is not operating the engine. 2. Turn the ignition on. The LED and parking light will flash (4) times. The siren chirps (4) times. SHUTDOWN INPUT FOR REMOTE STARTER: If any of the following cond itions ...
-
Auto Page RS-622 - page 9
9 BATTERY REPLACEMENT: A 1. 5V type AAA Alkaline battery powers the Remote Transmitter. When the power of the battery weakens a icon shall be displayed on the LCD screen. When the old battery is replaced with a new one, there will be beep sounds indicate the power is up. Note: Pre ss the button two times when the battery compartment is empty, and t ...
-
Auto Page RS-622 - page 10
10 Remote Transmission You are transmitting the signal to control unit In – Range Indicator You are within the remote control range. Trunk Release Trunk open. Trunk symbol only. Low Battery You have to replace the battery of remote control. Vibration Mode Remote Control vibrates when the system is triggered Ignition On Power Save Mode Save the ba ...
-
Auto Page RS-622 - page 11
11 For R egular R emote Control T ransmitter : 1. Prior to pushing any button on the transmitter. Press the Select II button first on the standard transmitter. 2. Once II button is pressed the LED on the transmitter will illuminate for 3.5 seconds . While the LED is illuminated, press the button for the function you want to operate on the standard ...
-
Auto Page RS-622 - page 12
12 1. Press and hold all four remote control buttons simultaneously un til one long beep is heard. Programming has now been entered. 2 . Within 5 seconds, p ress the button to select the mode of vibration or melody, the icon will displayed on the LCD screen to show the LCD remote transceiver is in vibration mode. 3. To exit programming mode, take n ...
-
Auto Page RS-622 - page 13
13 LIMITED LIFETIME WARRANTY PROVISIONS ( U.S. ,Continental U.S. and Canada Only) 1. Auto Page, Inc. WARRANTS th at this new unit has been thoroughly inspected and tested at the factory prior to delivery. Your Auto Page equipment is guaranteed for “life” to the original purchaser/user of the equipment and the original vehicle in which it was in ...
-
Auto Page RS-622 - page 14
14 replacement and labor of which shall be borne by the pu rchaser even if occurring during the WARRANTY period. 4. Any equipment or parts which are claimed to be defective under this WARRANTY must be sent to the Auto Page Service center with “proof of purchase” at the purchaser’s expense prior to such return, a Ret urn Authorization Number s ...
-
Auto Page RS-622 - page 15
15 Please go to the customer service tab and select product registration. It is the purchaser’s responsibility to register this product for any future warranty service. Warning: Some batteries may contain Perchlorate What is Perchlorate? Perchlo rate is both a naturally occurring and manmade contaminant increasingly found in groundwater, surface ...
-
Auto Page RS-622 - page 16
16 For more information, go to http://www.dtsc.ca.gov/hazardouswaste/perchlorate/ ...
-
Auto Page RS-622 - page 17
17 960 Knox Street Unit B, Torrance, CA 90502 Tel: (310) 323 - 1800 or (800) 262 - 2527 www.autopageusa.com ...
Do you have a question concerning Auto Page RS-622?
Use the form below
If you did not solve your problem by using a manual Auto Page RS-622, ask a question using the form below. If a user had a similar problem with Auto Page RS-622 it is likely that he will want to share the way to solve it.