Manual Lennox Hearth Products OASIS SERIES LSO-43

20 pages 0.57 mb
Download

Go to site of 20

Summary
  • Lennox Hearth Products OASIS SERIES LSO-43 - page 1

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 1 43" Wood Burning Outdoor Fireplace P/N 850,015M REV. C 03/2007 LSO-43 LSO-43-H MODELS RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE OASIS SERIES This installation manual will enable you to obtain a safe, efficient and dependable installation of your fireplace system. Please read and under- st ...

  • Lennox Hearth Products OASIS SERIES LSO-43 - page 2

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 2 TABLE OF CONTENTS Safety Rules .................................... page 2 Tools and Building Supplies ............ page 2 Precautions ..................................... page 2 Introduction ..................................... page 3 Clearances/Height Requirements ..... page 3 Chimney System .. ...

  • Lennox Hearth Products OASIS SERIES LSO-43 - page 3

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 3 Figure 1 TYPICAL FREE STANDING INSTALLATION (MUST BE A MINIMUM OF 10' AWAY FROM ANY BUILDING OR COMBUSTIBLE STRUCTURE) When complete, these fireplace systems con- sists of four basic “sub-systems”: 1. The Fireplace 2. The Chimney and Termination 3. Optional Glass Doors 4. Air Inlet CLEARAN ...

  • Lennox Hearth Products OASIS SERIES LSO-43 - page 4

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 4 Figure 3 Figure 2 When choosing a location, care must be taken to avoid places where flooding or running water may be a problem. Carefully consider the position of the fireplace opening with respect to the location of adjacent or nearby stairwells, doors, windows, walk- ways and over hanging trees, ...

  • Lennox Hearth Products OASIS SERIES LSO-43 - page 5

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 5 Figure 6 Figure 5 INSTALLING THE FIREPLACE Step 1. Slide the fireplace into prepared fram- ing or position fireplace in its final position and frame later. The fireplace may not be recessed into a com- bustible floor. Maintain the floor to hearth clearance established by the fireplace lower front f ...

  • Lennox Hearth Products OASIS SERIES LSO-43 - page 6

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 6 FIREPLACE SPECIFICATIONS Figure 9 Step 3. Refer to fireplace drawings and speci- fications on pages 6 and 7 for framing dimen- sions and details. Frame appliance enclosure as illustrated in Figures 10 through 13 on page 7. IMPORTANT: UNDER NO CIRCUMSTANCES CAN THE FIREPLACE TOP SPACERS ( FIGURE 9 ) ...

  • Lennox Hearth Products OASIS SERIES LSO-43 - page 7

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 7 Note: The framed depth, 25 ⁵⁄₈ " (651 mm) from a framed wall, must always be measured from a finished surface. If a wall covering such as drywall is to be attached to the rear wall, then the framed depth must be measured from the drywall surface. It is important that this dimension be ex ...

  • Lennox Hearth Products OASIS SERIES LSO-43 - page 8

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 8 Step 4. The fireplace should be secured to the side framing members through the nailing flange ( Figure 16 ). Figure 16 Note: The nailing flange and the area directly behind the nailing flange is exempt from the clearances described on the fireplace clear- ance label. Step 5. Connect the 6" (1 ...

  • Lennox Hearth Products OASIS SERIES LSO-43 - page 9

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 9 Figure 20 Figure 21 Figure 22 The outer chimney section installs the opposite way; the lanced end goes down and each new section installs OVER the outside of the previ- ous section ( Figure 23 ). Figure 23 Continue to assemble the chimney up through framed opening. Assemble just enough to pen- etra ...

  • Lennox Hearth Products OASIS SERIES LSO-43 - page 10

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 10 Note: If chimney extends more than 8' above roof surface, guy wires are also recommended. Use three (3) guy wires, attach to locking band assembly, extend and secure to roof in a triangular pattern (Figure 29 ). Guy wires are not supplied by the manufacturer. Step 7. The standard Security FTF ...

  • Lennox Hearth Products OASIS SERIES LSO-43 - page 11

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 11 MULTIPLE TERMINATIONS If more than one termination is located in the same chase or within the same general prox- imity, we suggest they should be separated in distance at least 24" horizontally from flue center to flue center and stacked or staggered vertically at least 18" apart, from t ...

  • Lennox Hearth Products OASIS SERIES LSO-43 - page 12

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 12 Figure 34 Figure 35 Return elbow support straps must be securely attached under tension (in shear) to structural framing members above. Do not substitute a FTF10-30 offset elbow in place of a FTF10-E30 return elbow. OFFSET CALCULATIONS Step 1. Use Offset Chart to determine amount of horizontal off ...

  • Lennox Hearth Products OASIS SERIES LSO-43 - page 13

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 13 FTF10 VERTICAL ELEVATION CHART 11 0 11 1 0 0 279 0.28 17 1 5 0 1 0 432 0.43 21 ¹⁄₄ 19 ¹⁄₄ 2 0 0 540 0.54 27 ¹⁄₄ 23 ¹⁄₄ 1 1 0 692 0.69 33 ¹⁄₄ 29 ¹⁄₄ 0 2 0 845 0.85 35 2 11 0 0 1 889 0.89 37 ¹⁄₄ 31 ¹⁄₄ 2 1 0 946 0.95 43 ¹⁄₄ 37 ¹⁄₄ 1 2 0 1099 1.10 51 ...

  • Lennox Hearth Products OASIS SERIES LSO-43 - page 14

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 14 Figure 36 Figure 37 INSTALLING OFFSETS First, review the Offset Elevation Chart and Figure 37 for reference. Step 1. Determine the offset distance where chimney is to pass through the first ceiling- dimension “A.” To find this point on your ceil- ing, first determine the center point for a ver ...

  • Lennox Hearth Products OASIS SERIES LSO-43 - page 15

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 15 Note: See Framing and Dimension Chart for the sizes of the ceiling and roof openings. The size of the roof opening varies with the degree of pitch of the roof. Offset Elbow Assembly Offset elbows install the same as chimney sections. First, snap the inner section INTO the preceding inner section o ...

  • Lennox Hearth Products OASIS SERIES LSO-43 - page 16

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 16 Figure 41 A B D C C Figure 40 Hearth Extension Dimensions Opening Width 43" A 20" (508 mm) B 43" (1092 mm) C 12" (305 mm) D 62" (1575 mm) Finished Wall Header Noncombustible Wall Covering Fireplace Opening U.S. Installation 12" Min. Combustible Mantel Spacer * A 1 ¹? ...

  • Lennox Hearth Products OASIS SERIES LSO-43 - page 17

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 17 Figure 42 Side Wall cannot be Closer than 12" (305mm) under any Circumstances A B C C D Wall Shield Calculating Minimum Thickness if Multiple Materials are Used At times it is important to know what combination of materials are acceptable for use as floor protection. The “R values” are us ...

  • Lennox Hearth Products OASIS SERIES LSO-43 - page 18

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 18 Storm Collar 63L59 FSC Locking Band 63L60 FLB Figure 44 FINISH TO YOUR TASTE There are a wide variety of “finished looks” for these fireplaces, from formal wall decor with elaborate mantels to rustic wood paneling or warm brick facings. Only noncombustible materials like stone, tile, brick, et ...

  • Lennox Hearth Products OASIS SERIES LSO-43 - page 19

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 19 63L16 FTF10-12 63L17 FTF10-18 Chimney Section 63L18 FTF10-36 63L40 F10F6 Flashing 63L41 F10F12 Round Termination 63L43 FTF10-CTD Chase Termination (Square) 63L49 FTF10-CT1 Firestop Spacer (Flat) 63L36 F10FS-2 Chase Termination (Round) 63L46 FTF10-CTDT Chase Termination (Square) 63L52 FTF10-CT2 Sta ...

  • Lennox Hearth Products OASIS SERIES LSO-43 - page 20

    NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 20 LENNOX reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. Printed in U.S.A. © 2002 by LENNOX P/N 850,015M REV. C 03/2007 11 ...

Manufacturer Lennox Hearth Products Category Outdoor Fireplace

Documents that we receive from a manufacturer of a Lennox Hearth Products OASIS SERIES LSO-43 can be divided into several groups. They are, among others:
- Lennox Hearth Products technical drawings
- OASIS SERIES LSO-43 manuals
- Lennox Hearth Products product data sheets
- information booklets
- or energy labels Lennox Hearth Products OASIS SERIES LSO-43
All of them are important, but the most important information from the point of view of use of the device are in the user manual Lennox Hearth Products OASIS SERIES LSO-43.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Lennox Hearth Products OASIS SERIES LSO-43, service manual, brief instructions and user manuals Lennox Hearth Products OASIS SERIES LSO-43. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Lennox Hearth Products OASIS SERIES LSO-43.

A complete manual for the device Lennox Hearth Products OASIS SERIES LSO-43, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Lennox Hearth Products OASIS SERIES LSO-43 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Lennox Hearth Products OASIS SERIES LSO-43.

A complete Lennox Hearth Products manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Lennox Hearth Products OASIS SERIES LSO-43 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Lennox Hearth Products OASIS SERIES LSO-43, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Lennox Hearth Products OASIS SERIES LSO-43, that we can find in the current document
3. Tips how to use the basic functions of the device Lennox Hearth Products OASIS SERIES LSO-43 - which should help us in our first steps of using Lennox Hearth Products OASIS SERIES LSO-43
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Lennox Hearth Products OASIS SERIES LSO-43
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Lennox Hearth Products OASIS SERIES LSO-43 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Lennox Hearth Products OASIS SERIES LSO-43?

Use the form below

If you did not solve your problem by using a manual Lennox Hearth Products OASIS SERIES LSO-43, ask a question using the form below. If a user had a similar problem with Lennox Hearth Products OASIS SERIES LSO-43 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)