English dropdown-ico

Manual Meco 2410

26 pages 2.06 mb
Download

Go to site of 26

Summary
  • Meco 2410 - page 1

    FOR YOUR SAFETY If you smell gas: 1. Do not attempt to light appliance. 2. Extinguish any open flame. 3. Disconnect from fuel supply . FOR YOUR SAFETY 1. Do not store or use gasoline or other flammable vapors and liquids within 25 feet (7.62m) of this or any other appliance. 2. An LP cylinder not connected for use shall not be stored within 10 feet ...

  • Meco 2410 - page 2

    I. Assembly Instructions.......................................................2 A) Parts Illustrations...........................................................3 B) Parts List........................................................................4 C) Setting up Y our Grill.......................................................5 1) S t anding Gri ...

  • Meco 2410 - page 3

    3 Part s Replacement Illustrations 1 2 26 10 9 7 35 36 23 8 14 3 5 6 12 15 13 38 19 20 25 27 28 31 34 40 41 42 29 37 30 33 24 11 4 32 39 16 21 17 22 18 ...

  • Meco 2410 - page 4

    PA RTS LIST ITEM DESCRIPT ION PA RT # 1 Owner's Manual 03.6506.00 11111 2 Hood w/Hinges 03.6506.01 11111 3 Screw, M6x9 Shoulder (Hood Hinge) 03.6506.02 22222 4 Hinge, Hood 03.6506.03 11111 5 Screw, M5x10mm (Hood Hinge Brack et ) 03.6237.00 33333 6 Nut, M5 Hex W asher Head (Hood Hinge) 03.6506.04 33333 7 Screw, M5x 15 (Hood Handle) 03.6506.05 2 ...

  • Meco 2410 - page 5

    PA RTS LIST (CONT'D) ITEM DESCRIPTION PA RT # 29 Heat Shield 03.6506.27 1 1 1 1 1 30 Screw, ST3.8x6mm ( Heat Shield) 03.6506.28 2 2 2 2 2 31 Guide Brack et , Main Burner 03.6506.29 1 1 1 1 1 32 Screw, M4x 10mm ( M. Burner/S. Burner Elect rode) 03.6506.30 4 4 4 4 4 33 Main Burner 03.6506.31 1 1 1 1 1 34 W ir e, Main Burner G r ound 03.6506.32 1 ...

  • Meco 2410 - page 6

    6 FIG . 2B STEP 2) Lift grill up at one leg mount. Release the spring lever at each leg foot. (FIG . 2A) Swing each leg all the way out one at a time, and let it rest on the floor . (FIG . 2B, 2C & 2D) The last leg will allow the grill to stand by it self. This is the lower height for use. STEP 3) T o use the grill at the full height, slide the ...

  • Meco 2410 - page 7

    Insert the tubular collar into the left leg PT O TM (Propane T ake-Off TM ) opening of the grill until the Side T able rests snugly against the grill body . ( FIG . 4A & 4B) Rotate the Side T able back and forth slightly to make sure it is resting solidly . Do not apply excessive force. FIG . 4A Insert Collar into PTO TM STEP 1) T urn Side Burn ...

  • Meco 2410 - page 8

    STEP 3) Hook Side Burner Grid into far left hole in side t able and lower two wires into the other two holes. (FIG . 5E) FIG . 5E STEP 4) Y our Side Burner can be used as a Side T able when not using the Side Burner . Locate the 3-hooks of the polyethylene Side Burner Cover over the 3-slots on the side burner edge. (FIG . 5F) Push the 3-hooks into ...

  • Meco 2410 - page 9

    STEP 5) Port able Use of Lantern: Lantern can be connected to a 1 lb. cylinder for use as a portable light. (FIG . 7G) Hold the Lantern with one hand. Insert the LP cylinder into the Lantern nozzle with other hand. T urn LP cylinder until snug. Follow leak test procedure on page 12 before using. FIG . 7G INST ALL GREASE CONT AINER T o reduce the ri ...

  • Meco 2410 - page 10

    10 · If the hose and regulator assembly is not working properly and you need a replacement, contact the manufacturer (1-800-251-7558). Be sure to specify your grill model. HOSES AND REGULA TOR T o reduce the risk of serious bodily injury or death: · Use only the hose and regulator assembly that have been supplied with this gas grill. Do not use h ...

  • Meco 2410 - page 11

    11 FIG . 10B FIG . 10E FIG . 10C FIG . 10D · T o avoid gas in your face and eyes, do not hold an LP cylinder connection toward you when disconnecting. STEP 3) Connect 1 pound Cylinder to Grill and Accessories: Grasp the regulator to the grill (FIG . 10B) , Side burner hose coupling (FIG . 10C) , or Lantern gas supply tube (FIG . 10D) with one hand ...

  • Meco 2410 - page 12

    12 How to perform a leak test: Supplies Needed for a Leak T est: Clean paint brush, water , and dish washing liquid. 1) Use a 1 pound disposable LP Cylinder . 2) Make sure the control knobs to grill and accessories are turned to the “off” position. 4) Mix one part of water with one p art of dish washing liquid. 5) Connect LP cylinders to the ma ...

  • Meco 2410 - page 13

    1. Open the Hood. Make sure LP cylinders are installed. 2. Import ant: Make sure main grill control knob is turned “Off” first. 3. Push the control knob in and turn to the “High” position. (FIG . 13A) 4. Push the Ignitor button in several times to light the burner . Listen for the sp ark ignition and look to make sure the burner is lit. If ...

  • Meco 2410 - page 14

    IGNITION LIGHTING THE SIDE BURNER 1. Remove Side Burner Cover if on. 2. Import ant: Make sure Side Burner Control Knob is turned “Off” first. 3. T urn Side Burner Control Knob on by rotating counter clockwise. (FIG . 14A) 4. Push the Ignitor button in several times to light the burner . Listen for the sp ark ignition and look to make sure the b ...

  • Meco 2410 - page 15

    IGNITION LIGHTING THE LANTERN 1. Check to make sure lantern p arts are int act and not disrupted and cylinder is properly connected. 2. Import ant: Make sure Lantern Control Knob is turned “Off” first. 3. T urn the Control Knob to the ‘On” position until it stop s. (FIG . 15A) 4. Push the Ignitor button in several times to light. Listen for ...

  • Meco 2410 - page 16

    16 OPERA TING THE LP GAS GRILL T o reduce the risk of serious bodily injury or death: · Never use charcoal in your LP gas grill. Do not use aerosols or store flammable liquids or materials near this gas grill. · Keep regulator hose away from any heated surfaces. · Check the LP gas grill for gas leaks and Burner obstructions before each use. · T ...

  • Meco 2410 - page 17

    1) When you have finished using your grill, turn the grill Control Knob clockwise to the “Off” position. Make sure there are no open flames nearby , 2) Disconnect the LP cylinder from the Grill Burner , Side table Burner and the Lantern. Remove the Lantern and gas tube from the grill. S tore them in a safe place. 3) W ait until the grill is coo ...

  • Meco 2410 - page 18

    FIG . 18E FIG . 18F Side Burner Inlet Hole Clear Clogged Port Holes with small nail or Wire FIG . 18D Main Burner Inlet Hole Clear Clogged Port Holes with small nail or Wire 18 FIG . 18C Main Burner screw FIG . 18G f) If grill is to be stored, coat Burner lightly with cooking oil and wrap in a protective cover to keep insects out. B) Lantern Burner ...

  • Meco 2410 - page 19

    19 FIG . 19B Store Side T able or Side Burner on Cooking Grid Collar is toward the front T uck hose loop into flange FIG . 19A FIG . 19C Main Grill Regulator must be tucked between legs without interference with folding and snapping into leg spring clip. LP Cylinder stored in leg. 1) Disconnect LP gas cylinders from Main Grill, Side Burner and Lant ...

  • Meco 2410 - page 20

    20 LP gas cylinder is empty Replace 1 pound disposable cylinder . Make sure gas Collector , Ignitor and electrodes are tight. Make sure electrode wires and ground wire are connected to Ignitor . 1 lb. Cylinder Coupling Nut not fully connected LP Excess flow valve tripped in regulator T ighten 1 pound Cylinder or coupling nut by hand. Do not use too ...

  • Meco 2410 - page 21

    21 Persistent grease fire Grease trapped around burner system T urn control knob “Off”. Open hood carefully and let fire burn out. After the grill cools, remove and clean all p arts. Check and clean Grease Cup. Flare up Grease build up Excessive fat in meat Clean the grill. T rim fat from meat before grilling. Humming or whistling from the regu ...

  • Meco 2410 - page 22

    MECO CORPORA TION LIMITED W ARRANTY This product is warranted to the original consumer purchaser against defects in material and workman- ship under normal outdoor household use and correct assembly (if assembled by the consumer-purchas- er). Burner and Cooking Grid are warranted for a period of one (1) year from the date of purchase. All other par ...

  • Meco 2410 - page 23

    23 ...

  • Meco 2410 - page 24

    24 P/N 03.6506.00 REV . 04/06 Aussie Adventurer TM ...

  • Meco 2410 - page 25

    T o reduce the risk of a cut or pinching injury: · Wear protective gloves when handling p art s that have sharp edges. · When opening legs, keep hands and fingers away from the three body leg mount areas to avoid pinching. OPENING LEGS-As you open the legs in Step 2 on p age 6, notice the new leg lock assembly that will automatically lock in the ...

  • Meco 2410 - page 26

    Instructions for Locking/UnLocking Legs Note: Use these step s af ter Step 2 of Owner ’ s Manual. After setting the grill up on all three legs, grab the rod hanging down near each leg. Push the “L” shaped end into the Leg Lock Clip recess to lock. ROD ROT A TED BACK INTO GRILL BODY CA VITY NOTE: Before folding the legs for storage or transpor ...

Manufacturer Meco Category Gas Grill

Documents that we receive from a manufacturer of a Meco 2410 can be divided into several groups. They are, among others:
- Meco technical drawings
- 2410 manuals
- Meco product data sheets
- information booklets
- or energy labels Meco 2410
All of them are important, but the most important information from the point of view of use of the device are in the user manual Meco 2410.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Meco 2410, service manual, brief instructions and user manuals Meco 2410. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Meco 2410.

Similar manuals

A complete manual for the device Meco 2410, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Meco 2410 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Meco 2410.

A complete Meco manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Meco 2410 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Meco 2410, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Meco 2410, that we can find in the current document
3. Tips how to use the basic functions of the device Meco 2410 - which should help us in our first steps of using Meco 2410
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Meco 2410
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Meco 2410 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Meco 2410?

Use the form below

If you did not solve your problem by using a manual Meco 2410, ask a question using the form below. If a user had a similar problem with Meco 2410 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)