-
Beko CFD 7914 - page 1
Frost Free Combi Fridge Freezer CFD 7914 ...
-
Beko CFD 7914 - page 2
Please read this manual first! Dear Customer , We hope that your product, which has been produced in moder n plants and checked under the most meticulous quality control procedures, will pr ovide you with years of good service. For this, we recommend you to carefully read the entire manual of your product before using it and keep it at hand for fut ...
-
Beko CFD 7914 - page 3
EN 2 1 Your refrigerator 3 2 Warnings 4 Electrical Requirements .....................5 Important! Fitting A Differ ent Plug .......5 Energy Saving Tips ............................6 3 Installation 7 TRANSPORT A TION INSTRUCTIONS .7 REVERSING THE DOORS ...............10 4 Before operating 12 Final Check .....................................12 5 Usin ...
-
Beko CFD 7914 - page 4
EN 3 1 Your refrigerator C Figures that take place in this instruction manual are schematic and may not correspond exactly with your product. If the subject parts are not included in the product you have pur chased, then it is valid for other models. 1 2 3 4 5 8 9 10 10 11 10 6 6 6 12 13 14 15 7 1. Door Shelves (Small bottles,cans, tubes) 2. Egg T ...
-
Beko CFD 7914 - page 5
EN 4 2 Warnings • Do not connect your appliance to the electricity supply until all packing and transit protectors have been r emoved. • Leave to stand for at least 4 hours before switching on to allow the system to settle if transported horizontally . • This appliance must only be used for its intended purpose, ie the storing and freezing of ...
-
Beko CFD 7914 - page 6
EN 5 Electrical Requirements Before you insert the plug into the wall socket make sure that the voltage and the frequency shown on the rating plate inside the appliance corresponds to your electricity supply . Rating label is on the left hand side of fridge inner liner . We recommend that this appliance be connected to the mains supply via a suitab ...
-
Beko CFD 7914 - page 7
EN 6 Energy Saving Tips 1- Ensure your appliance is installed in a well ventilated area. 2- Ensure the time between buying chilled/frozen food and placing them in your appliance is kept to a minimum, particularly in summer . We recommend you use a cool bag or a special carrier bag to carry frozen food. 3- Do not leave the door (s) of your appliance ...
-
Beko CFD 7914 - page 8
EN 7 3 Installation TRANSPORTATION INSTRUCTIONS 1 . The appliance should be transported only in a vertical upright position. The packing as supplied must be intact during transportation. 2. If during the course of transport the appliance has to be transported horizontally , it must only be laid on its right hand side when standing in the frontof th ...
-
Beko CFD 7914 - page 9
EN 8 BEKO declines to accept any liability should the instructions not be followed. INSTALLATION INSTRUCTIONS 1 .Fitted the two plastic wall spacers supplied onto the condenser at the back of the appliance by r otating 1/4 turn. adjustment of feet avoids excessive vibration and noise. 4 .A special r eceptacle is supplied to store the mains plug dur ...
-
Beko CFD 7914 - page 10
EN 9 REPLACING THE INTERIOR LIGHT BULB Should the light fail to work, proceed as follows. 1. Switch off at the socket outlet and pull out the mains plug. • Y ou may find it useful to r emove shelves for easy access. 2. Use a flat tipped screwdriver to remove the light dif fuser cover by inserting the blade in each of the two recesses to prise of ...
-
Beko CFD 7914 - page 11
EN 10 REVERSING THE DOORS 1- Switch off the appliance at the socket outlet and pull out the mains plug. 2- Remove all loose items and fittings and food, if any , from inside the appliance and door racks. 3- Unscrew the bolts and remove the middle hinge while holding doors. (1) 4- Remove the fridge door from the top hinge. (2) 5- Remove the freezer ...
-
Beko CFD 7914 - page 12
EN 11 2 5 2 4 1 6 3 1 7 1 8 7 9 1 0 2 3 2 2 2 2 2 4 5 4 2 6 1 9 1 6 18 0° 2 0 1 9 12 13 1 1 2 7 1 1 14 15 2 7 4 5 ° 8 2 1 ...
-
Beko CFD 7914 - page 13
EN 12 4 Before operating Final Check Before you start using the fridge/ freezer check that: 1. The feet have been adjusted for perfect levelling. 2. The interior is dry and air can circulate freely at the rear of the cabinet. 3. Clean the interior as r ecommended under “CLEANING AND CARE.” 4. Insert the plug into the wall socket and switch on t ...
-
Beko CFD 7914 - page 14
EN 13 TEMPERATURE CONTROL AND ADJUSTMENT Operating temperatures are controlled by the setting knob (see diagram) located on the ceiling of fridge compartment. Settings may be made from min, 1 ... 6, max, max being the coldest position. When the appliance is switched on for the first time, the setting knob should be adjusted so that after 24 hours, ...
-
Beko CFD 7914 - page 15
EN 14 FRİDGE COMPARTMENT STORAGE ADVİCE Fruit & vegetables Don’t store bananas.Don’t stor e melon - it can be chilled for short periods as long as it is wrapped to avoid it flavouring other food. Wrap food affected by temperatures near 0°C (pineapples, cucumbers,tomatoes etc.) in polythene bags. Meat & poultry Store raw meat and poul ...
-
Beko CFD 7914 - page 16
EN 15 Freezing fresh food T ake special care not to mix with already fr ozen food. Always choose high quality fresh food and be sure it is thor oughly clean. Prepar e fresh food in small portions to ensure rapid fr eezing. Do not fr eeze too large a quantity at any one time. The quality is best pr eserved when the food is fr ozen right thr ough to ...
-
Beko CFD 7914 - page 17
EN 16 DEFROSTING A) FRIDGE COMPARTMENT The fridge compartment defrosts automatically . The defrosting water runs to the drain tube via a collection container at the back of the appliance (1). (see diagram) During defrosting water droplets may form at the back of the fridge compartment where concealed evaporator is located. Some droplets may r emain ...
-
Beko CFD 7914 - page 18
EN 17 Water dispenser W ater dispenser is a very useful feature to obtain chilled water without opening the door of your fridge. Since you do not have to open the door of your fridge fr equently , you also save on electricitiy . Using the water dispenser Push in the lever of the water dispenser with your glass. By releasing the lever , you cut off ...
-
Beko CFD 7914 - page 19
EN 18 tank. Clean the water tank with warm clean water , reinstall the top cover mechanism and fasten the latches. When installing the water tank, make sure that hooks behind it fits securely into the hangers on the door . Make sure that parts removed during cleaning (if any) are installed correctly into their original locations. Otherwise, water m ...
-
Beko CFD 7914 - page 20
EN 19 Icematic and ice storage container Using the Icematic * Fill the Icematic with water and place it into its seat. Y our ice will be r eady approximately in two hours. Do not remove the Icematic from its seating to take ice. * T ur n the knobs on it clockwise by 90 degrees. Ice cubes in the cells will fall down into the ice storage container be ...
-
Beko CFD 7914 - page 21
EN 20 6 Maintenance and cleaning ** We recommend that you switch off the appliance at the socket outlet and pull out the mains plug before cleaning. ** Never use any sharp abrasive instrument, soap, household cleaner , detergent and wax polish for cleaning. ** Use luke warm water to clean the cabinet of the appliance and wipe it dry . ** Use a damp ...
-
Beko CFD 7914 - page 22
EN 21 7 Do's and Don'ts Do- Clean your appliance regularly (See “Cleaning and Care”) Do- Keep raw meat and poultry below cooked food and dairy products. Do- T ake off any unusable leaves on vegetables and wipe off any soil. Do- Leave lettuce, cabbage, parsley and cauliflower on the stem. Do- Wrap cheese firstly in gr easeproof paper a ...
-
Beko CFD 7914 - page 23
EN 22 Don’t- Exceed the maximum fr eezing loads (6 kg in any 24 hours) when freezing fr esh food. Don’t- Give childr en ice-cream and water ices direct fr om the freezer . The low temperature may cause ‘freezer burns’ on lips. Don’t- Fr eeze fizzy drinks. Don’t- T ry to keep frozen food which has thawed, it should be eaten within 24 hou ...
-
Beko CFD 7914 - page 24
EN 23 GUARANTEE DETAILS Your ne w Beko p roduct i s guaran teed aga inst the cost of breakdo wn repai r for twelve months from the date of the original purchase. What is covered? • Repairs necessary as a result of faulty materials, defective components or manufacturing defect. • The cost of functional replacement parts, but excluding consumable ...
-
Beko CFD 7914 - page 25
EN 24 HOW TO OBTAIN SERVICE Please keep your purchase receipt or other proof of purchase in a safe pla ce; you wil l n eed to hav e it sh ould the pro duc t re qui re a tte ntio n u nde r guarantee. You should also complete the details below; it will help us assist you when requ esti ng se rvic e. ( The model num ber is pr inte d on the Instr ucti ...
-
Beko CFD 7914 - page 26
48 7474 0003/AB Printed in Turkey Part no: Revision no: BEKO plc Beko House Caxton Way Watford Hertfordshire WD18 8UF T el: 0845 6004911 Fax: 0845 6004922 e-mail: service@beko.co.uk website: www .beko.co.uk AG 48 9051 0000 ...
Do you have a question concerning Beko CFD 7914?
Use the form below
If you did not solve your problem by using a manual Beko CFD 7914, ask a question using the form below. If a user had a similar problem with Beko CFD 7914 it is likely that he will want to share the way to solve it.