Manual Campbell Hausfeld HS5500

24 pages 1.77 mb
Download

Go to site of 24

Summary
  • Campbell Hausfeld HS5500 - page 1

    Do not run unattended. Leaving compressor in AUTO position may allow it to turn on inadvertently. To prevent this and possible damage from power surge, turn to OFF position after each use. Since the air compressor and other components (filters, lubricators, hoses, etc.) used, make up a high pressure pumping system, the following safety precautions ...

  • Campbell Hausfeld HS5500 - page 2

    2 Oil-Lubricated Compressors General Safety Information (Continued) 2. Follow all local electrical and safety codes as well as in the US, National Electrical Code (NEC) and Occupational Safety and Health Act (OSHA). 3. Only persons well acquainted with these rules of safe operation should be allowed to use the compressor. 4. Keep visitors away and ...

  • Campbell Hausfeld HS5500 - page 3

    Exhaust Tube Handle Regulator Drain valve Figure 6 - Unit Identification Check Valve Safety Valve Pressure Switch (Auto/Off) 3 3. Repeat procedure with other side. LUBRICATION THIS UNIT IS SHIPPED WITHOUT OIL! Follow lubrication instructions before operating compressor. Use oil shipped with the compressor. Do not use regular automotive oil such as ...

  • Campbell Hausfeld HS5500 - page 4

    4 Operation •Pressu re S wi tch - Auto/Off Switch (Figure7) - In the AUTO position, the compressor shuts off automatically when tank pressure reaches the maximum preset pressure. In the OFF position, the compressor will not operate. This switch should be in the OFF position when connecting or disconnecting the power cord from the electrical outle ...

  • Campbell Hausfeld HS5500 - page 5

    5 3. The safety valve should automatically close at approximately 40-50 PSI. If the safety valve does not allow air to be released when you pull on the ring, or if it does not close automatically, it MUST be replaced. Safety valve must be replaced if it cannot be actuated or it leaks air after ring is released. PRESSURE GAUGES Gauge attached to reg ...

  • Campbell Hausfeld HS5500 - page 6

    6 T roubleshooting Chart Symptom Possible Cause(s) Corrective Action 1. Switch in OFF position 2. No electrical power at wall outlet 3. Compressor has reached automatic shutoff pressure 4. Motor overloaded 5. Pressure switch bad 1. Defective check valve 2. Defective unloader valve (on pressure switch) 3. Low voltage 4. Loose electrical connections ...

  • Campbell Hausfeld HS5500 - page 7

    7 T roubleshooting Chart (Continued) Symptom Possible Cause(s) Corrective Action 5. Broken valves 6. Piston ring worn 1. Excessive water in tank 2. High humidity 1. Defective pressure switch 2. Defective safety valve 1. Excessive condensation in tank 2. Loose connections at fittings, tubing, etc. 3. Tank leaks 1. Check valve stuck in open position ...

  • Campbell Hausfeld HS5500 - page 8

    8 Oil-Lubricated Compressors www.chpower.com Limited W arranty 1. DURATION: From the date of purchase by the original purchaser for: One Year. 2. WHO GIVES THIS WARRANTY (WARRANTOR): Campbell Hausfeld / Scott Fetzer Company, 100 Production Drive, Harrison, Ohio, 45030, Telephone: (800) 543-6400 3. WHO RECEIVES THIS WARRANTY (PURCHASER): The origina ...

  • Campbell Hausfeld HS5500 - page 9

    Ne Pas faire fonctionner sans supervision. Laisser le compresseur sur la position AUTO peut causer un démarrage accidentel. Pour éviter un démarrage accidentel et de possibles dommages par surtension, le mettre sur OFF après chaque utilisation. Puisque le compresseur d'air et les autres composants (filtres, lubrificateurs, tuyaux, etc.) ut ...

  • Campbell Hausfeld HS5500 - page 10

    10 Fr Compresseur Graissé par l'Huile 2. Suivre tous les codes de sécurité locaux ainsi que les National Electrical Codes (NEC) and Occupational Safety and Health Act (OSHA) des É-U. 3. Seules les personnes bien familiarisées avec ces règles d’utilisation doivent être autorisées à se servir du compresseur. 4. Garder les visiteurs à ...

  • Campbell Hausfeld HS5500 - page 11

    Les articles portant un astérisque (*) ont été expédiés desserrés avec l'appareil. 1. La roue a un moyeu décentré. Avec le moyeu décentré face au fer d’essieu, placer le boulon d’essieu à travers les trous de la roue et du fer d’essieu. 2. Placer la rondelle plate et la rondelle de blocage sur le boulon de l'axe. Bien res ...

  • Campbell Hausfeld HS5500 - page 12

    • Poignée - Conçue pour le déplacement du compresseur. Ne jamais utiliser la poignée sur les modèles avec roues pour soulever le modèle. • Robinet de Purge - Cette soupape est située sur la base du réservoir. Utiliser cette soupape pour purger l’humidité du réservoir quotidiennement afin de réduire le risque de corrosion. Baisser l ...

  • Campbell Hausfeld HS5500 - page 13

    13 Fr Vérifier la soupape de sûreté de la manière suivante : 1. Brancher le compresseur et le faire fonctionner jusqu'à ce qu'il atteigne la pression d'arrêt (voir procédure de fonctionnement). 2. Porter des lunettes de sécurité, tirer l'anneau sur la soupape de sûreté (voir les Figures 6 et 8) pour dégager la pressi ...

  • Campbell Hausfeld HS5500 - page 14

    14 Fr Guide De Dépannage Symptôme Cause(s) Possible(s) Mesures Correctives Compresseur Graissé par l'Huile 1. Interrupteur à la position OFF (arrêt) 2. Aucun courant à la prise. 3. Le compresseur a atteint la pression d'arrêt automatique 4. Moteur surchargé 5. Pressostat défectueux 1. Clapet de non-retour défectueux 2. Clapet de ...

  • Campbell Hausfeld HS5500 - page 15

    15 Fr Guide De Dépannage (Suite) Symptôme Cause(s) Possible(s) Mesures Correctives 1. Robinet de vidange desserré 2. Connexions desserrées aux raccords, tubes, etc. 3. Fuite du réservoir 1. Utilisation d'air excessive, compresseur trop petit 2. Filtre d'aspiration bloqué 3. Connexions desserrées aux raccords, tubes, etc. 4. Fuites ...

  • Campbell Hausfeld HS5500 - page 16

    16 Fr Compresseur Graissé par l'Huile Garantie Limitée 1. DURÉE: À partir de la date d’achat par l’acheteur original comme suit : Un An. 2. GARANTIE ACCORDÉE PAR (GARANT) : Campbell Hausfeld/Scott Fetzer Company, 100 Production Drive, Harrison, Ohio, 45030, Téléphone: (800) 543-6400. 3. BÉNÉFICIAIRE DE CETTE GARANTIE (ACHETEUR): L ...

  • Campbell Hausfeld HS5500 - page 17

    No debe utilizar la unidad si se ha dañado durante el envío, manejo o uso. Los daños podrían ocasionar una explosión y ócasionarle heridas o daños a su propiedad. No lo haga funcionar sin supervisión El dejar el compresor en la posición AUTO puede causar que se encienda inadvertidamente. Para prevenir que eso ocurra y posibles daños por u ...

  • Campbell Hausfeld HS5500 - page 18

    18 Sp Compresor lubricado con aceite 1. Lea con cuidado todos los manuales incluídos con este producto. Familiarícese con los controles y el uso adecuado del equipo. 2. Siga todos los códigos de seguridad laboral y electricidad establecidos en su país, por ejemplo los de la NEC y OSHA en EUA. 3. Este compresor sólo debe ser usado por personas ...

  • Campbell Hausfeld HS5500 - page 19

    19 Sp El juego del ensamble de la rueda incluye: - 2 ruedas* - 2 pernos de eje* - 2 arandelas de presión* - 2 arandelas* - 2 tuercas* Los artículos marcados con asterisco (*) se despacharon sueltos con la unidad. 1. La rueda tiene un cubo descentrado. Con el cubo descentrado hacia el hierro del eje, ensamble los pernos del eje a través de los or ...

  • Campbell Hausfeld HS5500 - page 20

    20 Sp Funcionamiento • Presostato - Automático (Figura7) - En la posición AUTO el compresor se apaga automáticamente cuando la presión del tanque alcanza el nivel máximo fijado en la fábrica. En la posición OFF , el compresor no funcionará. El presostato debe colocarse en OFF para conectar o desconectar el cordón eléctrico del tomacorri ...

  • Campbell Hausfeld HS5500 - page 21

    21 Sp 2. Usando gafas de protección, tire del anillo de la válvula de seguridad (vea las Figuras 6 y 8) para liberar la presión del tanque del compresor. Use su otra mano para desviar el aire que se mueve a gran velocidad y evitar que le dé en el rostro. 3. Esta válvula de seguridad debería cerrarse automáticamente a 2,76 bar - 3,45 bar. Si ...

  • Campbell Hausfeld HS5500 - page 22

    22 Sp Compresor lubricado con aceite Guía de diagnóstico de averías Problema Posible(s) Causa(s) Acción a tomar 1. El interruptor está en la posición OFF (apagado) 2. No hay corriente eléctrica en el tomacorriente de la pared 3. El compresor alcanzó la presión de corte automático 4. Motor sobrecargado 5. Interruptor de presión defectuoso ...

  • Campbell Hausfeld HS5500 - page 23

    23 Sp Guía de diagnóstico de averías (Continuación) Problema Posible(s) Causa(s) Acción a tomar 1. Válvula de drenaje floja 2. Conexiones flojas en los accesorios, tubería, etc. 3. Fugas del tanque 1. Uso excesivo de aire, el compresor es demasiado pequeño 2. Filtro de entrada obstruido 3. Conexiones flojas en los accesorios, tubería, etc. ...

  • Campbell Hausfeld HS5500 - page 24

    Garantía Limitada 1. DURACIÓN: A partir de la fecha de compra por el comprador original tal como se especifica a continuación: Un año. 2. QUIEN OTORGA ESTA GARANTÍA (EL GARANTE: Campbell Hausfeld / The Scott Fetzer Company 100 Production Drive, Harrison, Ohio 45030 Teléfono: (800) 543-6400 3. QUIEN RECIBE ESTA GARANTÍA (EL COMPRADOR): El com ...

Manufacturer Campbell Hausfeld Category Air Compressor

Documents that we receive from a manufacturer of a Campbell Hausfeld HS5500 can be divided into several groups. They are, among others:
- Campbell Hausfeld technical drawings
- HS5500 manuals
- Campbell Hausfeld product data sheets
- information booklets
- or energy labels Campbell Hausfeld HS5500
All of them are important, but the most important information from the point of view of use of the device are in the user manual Campbell Hausfeld HS5500.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Campbell Hausfeld HS5500, service manual, brief instructions and user manuals Campbell Hausfeld HS5500. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Campbell Hausfeld HS5500.

A complete manual for the device Campbell Hausfeld HS5500, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Campbell Hausfeld HS5500 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Campbell Hausfeld HS5500.

A complete Campbell Hausfeld manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Campbell Hausfeld HS5500 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Campbell Hausfeld HS5500, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Campbell Hausfeld HS5500, that we can find in the current document
3. Tips how to use the basic functions of the device Campbell Hausfeld HS5500 - which should help us in our first steps of using Campbell Hausfeld HS5500
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Campbell Hausfeld HS5500
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Campbell Hausfeld HS5500 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Campbell Hausfeld HS5500?

Use the form below

If you did not solve your problem by using a manual Campbell Hausfeld HS5500, ask a question using the form below. If a user had a similar problem with Campbell Hausfeld HS5500 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)