Manual Haier AU222XFERA

18 pages 0.57 mb
Download

Go to site of 18

Summary
  • Haier AU222XFERA - page 1

    AU182XFERA R410A MUL TI SPLIT SERIES ROOM AIR CONDITIONER OUTDOOR UNIT INST ALLA TION MANUAL AU222XFERA Please read this manual carefully before installing the units. Please keep this manual safely for future use. NO.0010576791B ...

  • Haier AU222XFERA - page 2

    Cautions ....................................................................................................................... Safety precautions........................................................................................................ Installation accessories.......................................................................... ...

  • Haier AU222XFERA - page 3

    Cautions 1 Disposal of the old air conditioner Before disposing an old air conditioner that goes out of use, please make sure it's inoperative and safe. Unplug the air conditioner in order to avoid the risk of child entrapment. It must be noticed that air conditioner system contains refrigerants, which require specialized waste disposal. The v ...

  • Haier AU222XFERA - page 4

    4. The wiring method should be in line with the local wiring standard. 5. The power cable and connecting cable are self- provided. The requirement of the power cable to the outdoor unit: H05RN-F 3G 4.0mm 2 All the cables shall have got the local authentication certificate. 6. The breaker of the air conditioner should be all- pole switch; and the di ...

  • Haier AU222XFERA - page 5

    3 Safety pr ecautions All units shall be earthed. The earth must not be connected to a gas pipe, water pipe, or telephone line. Poor earthing could cause electric shock. Be sure to install a circuit breaker to avoid electric shock. Arrange water drainage according to this manual. Cover pipe with insulation materials to prevent condensation occuring ...

  • Haier AU222XFERA - page 6

    4 (c) Where there is strong radiation. It will affect the unit's control system, causing malfunction of the unit. (d) Where there are flammable gas, dirt, and volatile matter (thinner , gasoline) exist, these items will cause a fire risk. The following accessories are supplied together with the outdoor unit. 113.5 583 319.5 680 113.5 Installat ...

  • Haier AU222XFERA - page 7

    5 1. Do not connected the embedded branch piping and the outdoor unit when only carrying out piping work without connecting the indoor unit in ordor to add another indoor unit later . Make sure no dirt or mositure gets into eigher side of the embedded branch piping. 2.It is impossible to connect the indoor unit for one room only . Be sure to connec ...

  • Haier AU222XFERA - page 8

    6 Matching of the indoor and outdoor units Before inserting power plug into receptacle, check the voltage without fail. The power source is the same as the corresponded name plate. Install an exclusive branch circuit of the power . A receptacle shall be set up in a distance where the power cable can be reached. Do not extend the cable by cutting it ...

  • Haier AU222XFERA - page 9

    7 L1 L2 L3 h H + A B C H - The piping length information, please refer the following table. Descriptions Standard A, B, Cliquid pipe A, B, C Gas pipe mm Item Maximum Unit L1 (one way) L2 (one way) L3 (one way) h H + H - mm m m m m m m Size of the liquid side connection pipe Pipe length when the compressor connects with two indoor units Drop between ...

  • Haier AU222XFERA - page 10

    8 Refrigerant piping work Forced fastening without careful centering may damage the threads and cause a leakage of gas. Pipe Diameter ( ) Fastening T orque Liquid Side 6.35mm (1/4'') 18N.m Gas Side 9.52mm (3/8'') 50N.m 3. Attaching Drain-Elbow Drain elbow Hose If the drain-elbow is used, please attach it as figure. Flare nut Hal ...

  • Haier AU222XFERA - page 11

    9 4.Cutting and Flaring work of piping Pipe cutting is carried out with a pipe cutter and burs must be removed. After inserting the flare nut, flaring work is carried out. Less than 5cm It becomes high midway . The end is immersed in water It waves. It gap with the ground ts too small. There is the bad smell from a ditch. Please pour water in the d ...

  • Haier AU222XFERA - page 12

    10 In case of gas leakage, tighten parts of pipe connection. If leakage stops, then proceed 6 steps. Purging method: to use vacuum pump 2 way valve 3 way valve 90 0 Service port 90 0 for 6 sec. 6 .Detach the charge hose from the service port, open 2- way valve and 3-way . T urn the valve rod anticlockwise until hitting lightly . Liquid stop valve 2 ...

  • Haier AU222XFERA - page 13

    1. Electric wiring Note: The air conditioner must use special circuit , and wiring by the qualified electrician according to the wiring rules specified in national standard. The grounding wire and the neutral wire shall be strictly separated. Connect the neutral wire with grounding wire is incorrect. The electric leakage breaker must be installed. ...

  • Haier AU222XFERA - page 14

    12 3. W iring method of outdoor unit: Loosen wire cover and connect the power line and communication wire of indoor unit to the terminal correspondingly . Note: When connecting power line to power supply terminal, please pay attention to the following items: Do not connect the power line with different dimensions to the same connection wire end. Im ...

  • Haier AU222XFERA - page 15

    13 The distance between the signal wires and the power cabes should be at least 50mm. C B A Q P 1(L) 2(N) 5. Example wiring diagram. Please refer to the indoor unit installation manual to find detailly how to set and check the communication address. Incorrect address setting will cause abnormal to the system. 6. After installation, please fill in t ...

  • Haier AU222XFERA - page 16

    14 Items to confirm T est running Before starting the test running, please confirm the following works have been done successfully . 1) Correct piping work; 2) Correct wiring work; 3) Correct match of indoor and outdoor unit; 4) Proper recharge of refrigerant if needed; 5)Correct indoor unit addresses setting. Make sure that all the stop valves are ...

  • Haier AU222XFERA - page 17

    15 F AILURE CODE ST A TE OF LED 5-4-3-2-1 TROUBLE SHOOTING POSSIBLE REASONS 1 Faulty defrost sensor T e Sensor disconnected, or broken, or short circuit Faulty sensor T ao Sensor disconnected, or broken, or short circuit Faulty sensor T s Sensor disconnected, or broken, or short circuit Faulty sensor Td Sensor disconnected, or broken, or short circ ...

  • Haier AU222XFERA - page 18

    HAIER GROUP Qingdao Haier Air Conditioner Electric Co., Ltd. Address: Haier Garden, Qianwangang Road, Economic Development Zone, Qingdao, Shandong 266500, P .R.China W eb Site: http://www .haier .com ...

Manufacturer Haier Category Air Conditioner

Documents that we receive from a manufacturer of a Haier AU222XFERA can be divided into several groups. They are, among others:
- Haier technical drawings
- AU222XFERA manuals
- Haier product data sheets
- information booklets
- or energy labels Haier AU222XFERA
All of them are important, but the most important information from the point of view of use of the device are in the user manual Haier AU222XFERA.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Haier AU222XFERA, service manual, brief instructions and user manuals Haier AU222XFERA. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Haier AU222XFERA.

Similar manuals

A complete manual for the device Haier AU222XFERA, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Haier AU222XFERA by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Haier AU222XFERA.

A complete Haier manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Haier AU222XFERA - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Haier AU222XFERA, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Haier AU222XFERA, that we can find in the current document
3. Tips how to use the basic functions of the device Haier AU222XFERA - which should help us in our first steps of using Haier AU222XFERA
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Haier AU222XFERA
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Haier AU222XFERA in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Haier AU222XFERA?

Use the form below

If you did not solve your problem by using a manual Haier AU222XFERA, ask a question using the form below. If a user had a similar problem with Haier AU222XFERA it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)