Manual Vermont Casting UE181L

14 pages 0.17 mb
Download

Go to site of 14

Summary
  • Vermont Casting UE181L - page 1

    Decorative Gas Appliance For Installation In Solid Fuel Burning Fireplaces 331 1243 7/04 Rev . 1 Certified to ANSI Z21.1 1.2A Standard D E S I G N C E R T I F I E D W ARNING If the information in this manual is not followed exactly , a fire or explosion may result causing property damage, personal injury or loss of life. Installation and Operating ...

  • Vermont Casting UE181L - page 2

    2 331 1243 A TTENTION This unvented gas log heater has been certified by CSA and tested to conform to ANSI Z21.1 1.2 Gas Fired Room Heaters. Check local codes before installing this log heater . In some areas of the country , unvented gas log heaters are restricted. The installation and provision for combustion and ventilation air must conform with ...

  • Vermont Casting UE181L - page 3

    3 331 1243 CARBON MONOXIDE POISONING MA Y LEAD TO DEA TH When used without fresh air , vent free gas logs may give off carbon monoxide, an odorless, poisonous gas. Some people such as pregnant women, people with heart or lung disease and persons at high altitudes are more affected by carbon monoxide than others. Early signs of carbon monoxide poiso ...

  • Vermont Casting UE181L - page 4

    4 331 1243 Provisions for Adequate Combustion and V entilation Air This heater shall not be installed in a “ CONFINED SP ACE” or unusually tight construction unless provi- sions are provided for adequate combustion and ventilation air . The NA TIONAL FUEL GAS CODE, ANSI Z223.1/NFP A 54 defines a “CONFINED SP ACE” as a space whose volume is ...

  • Vermont Casting UE181L - page 5

    5 331 1243 Fireplace Spacing Requirements The illustration in Figure 2 shows spacing requirements for your room with a hood installed (not included). W ithout a hood, you must maintain a minimum of 32” between the top opening of the firebox and the bottom of a mantel which protrudes out 12”. If you do not have at least 32” between the two, a ...

  • Vermont Casting UE181L - page 6

    6 331 1243 A TTENTION: This heater is clean burning. It requires no outside venting. There is no heat loss out a vent or up a chimney . Heat is generated by realistic flames. This heater is designed for vent-free operation with flue damper closed. State and local codes in some areas prohibit the use of vent-free heaters. NOTE: Where listed vented d ...

  • Vermont Casting UE181L - page 7

    7 331 1243 • If the fireplace has glass doors, remove the glass doors and frame assembly or the upper door track. • If the upper door track has been removed, follow the instructions for Figure 3. If the upper door track remains, skip Figure 3 and follow the instructions for Figure 4. 2. If the upper door track has been removed, hold the adjusta ...

  • Vermont Casting UE181L - page 8

    8 331 1243 Connection to Gas Supply 1. Place the burner assembly (grate and control package) in the fireplace. Center the assembly front to back and side to side. 2. Install the gas supply fitting to the gas supply pipe. Use pipe thread sealing compound, or T eflon tape, on the iron pipe threads only . Do not use on flared threads. 3. Connect the b ...

  • Vermont Casting UE181L - page 9

    9 331 1243 Guidelines After your installer does the test burn, the log set should be operated either with the chimney open or , in the absence of a chimney , with a window open approxi- mately 1-2 inches. This operation should last for about 2-3 hours to cure the logs and dissipate any residual fumes from the new unit. This unvented gas log heater ...

  • Vermont Casting UE181L - page 10

    10 331 1243 Thermostatic Control The thermostat control knob can be set to any comfort level between “HI” and “LO”. The thermostat will gradually modulate the heat output and flame height from higher to lower settings in order to maintain the comfort level you select. The ideal comfort setting will vary by household depending upon the amoun ...

  • Vermont Casting UE181L - page 11

    11 331 1243 Oxygen Depletion System For your safety , this appliance is equipped with an oxygen depletion system. This system senses the oxygen in the firebox and switches off the gas supply before the amount of oxygen falls below safe levels. (Fig. 12) Pilot ODS Sensor Flame Thermocouple Piezo Ignitor FP1505 Fig. 12 Pilot. Maintenance To clean the ...

  • Vermont Casting UE181L - page 12

    12 331 1243 UC/UE181, UC/UE241 Series Unvented Gas Log Heaters Ref. Description UC/UE181 UC/UE241 1a. Log Assembly - 2 Larger Bottom Logs 4312759 4312760 1b. Log Åssembly - 3 Smaller T op Logs 4312761 4312762 2. Bag of Lava Rock (2 lbs.) (2 per Heater) 20000198 20000198 3. Flexline Gas Connector 3304177 3304177 4. Damper Clamp Assembly 7540310 754 ...

  • Vermont Casting UE181L - page 13

    13 331 1243 Failure to follow all instructions in this owner ’s manual will also void this warranty . CFM Home Products will not be liable for incidental or consequential damages. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above exclusion or limitation may not apply to you. This warranty gi ...

  • Vermont Casting UE181L - page 14

    2695 Meadowvale Blvd. • Mississauga, Ontario, Canada L5N 8A3 800-668-5323 CFM Home Products ...

Manufacturer Vermont Casting Category Fan

Documents that we receive from a manufacturer of a Vermont Casting UE181L can be divided into several groups. They are, among others:
- Vermont Casting technical drawings
- UE181L manuals
- Vermont Casting product data sheets
- information booklets
- or energy labels Vermont Casting UE181L
All of them are important, but the most important information from the point of view of use of the device are in the user manual Vermont Casting UE181L.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Vermont Casting UE181L, service manual, brief instructions and user manuals Vermont Casting UE181L. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Vermont Casting UE181L.

A complete manual for the device Vermont Casting UE181L, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Vermont Casting UE181L by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Vermont Casting UE181L.

A complete Vermont Casting manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Vermont Casting UE181L - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Vermont Casting UE181L, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Vermont Casting UE181L, that we can find in the current document
3. Tips how to use the basic functions of the device Vermont Casting UE181L - which should help us in our first steps of using Vermont Casting UE181L
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Vermont Casting UE181L
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Vermont Casting UE181L in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Vermont Casting UE181L?

Use the form below

If you did not solve your problem by using a manual Vermont Casting UE181L, ask a question using the form below. If a user had a similar problem with Vermont Casting UE181L it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)