English dropdown-ico

Manual Smeg CIR34XS

24 pages 1.69 mb
Download

Go to site of 24

Summary
  • Smeg CIR34XS - page 1

    Contents 3 1 INSTRUCTIONS FOR SAFE AND PROPER USE _____________________ 4 2 POSITIONING OF THE HOB _____________________________________ 6 3 GAS CONNECT ION ___________________________________________ 11 4 ELECTRICAL CO NNECTION ____________________________________ 12 5 ADAPTATION TO DIFFERENT TYPES OF GAS _____________________ 13 6 FINAL OPER ATIO ...

  • Smeg CIR34XS - page 2

    Introduction 4 1 INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WH OLE WORKING LIFE OF THE COOKING HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEF ORE USING THE COOKING HOB. ALSO KEEP THE SERIES OF NOZZLES SUP ...

  • Smeg CIR34XS - page 3

    Introduction 5 THE IDENTIFICATION PLATE, WITH TECHNICAL DATA, SERIAL NUMBER AND MARKING IS CLEARLY VISIBLE UNDER THE CASING. THE PLATE ON THE CASING MUST NOT BE REMOVED. BEFORE CONNECTING THE DEVICE, MAKE SURE THAT IT HAS BEEN REGULATED FOR THE TYPE OF GAS THAT WILL FEED IT, CHECKING THE LABEL UNDER THE CASING. DO NOT PUT PANS WITHOUT PERFECTLY SMO ...

  • Smeg CIR34XS - page 4

    Instructions for the installer 6 2 POSITIONING OF THE HOB It is the law that all gas a ppli ances are installed by authorised persons . Clearance around the applia nce must comply with the requirements of AS5601. The following operation requires build i ng and/or carpentry work so must be carried out by a competent tradesman. Installation c an be c ...

  • Smeg CIR34XS - page 5

    Instructions for the installer 7 Bracket ‘ A ’ in the 1st slot Bracket ‘ A ’ in the 2nd slot Bracket ‘ B ’ Short sides Long sides 2.2 Fixing 90 cm hobs on 60 cm base unit If a 90 cm hob is to be bracketed to a 60 cm base unit, the 2 central brackets “ A ” have to be used in ad dition to the side brackets “ B ” as shown in the dr ...

  • Smeg CIR34XS - page 6

    Instructions for the installer 8 60 cm 90 cm hob hob A 35 105 B 65 50 C 30 50 D 85 75 2.3 Clearance above and around domestic appliances Extract from AS560 1 ...

  • Smeg CIR34XS - page 7

    Instructions for the installer 9 REQUIREMENTS 1 Overhead clearances – (Measureme nt A ) Range hoods and exha ust fans shall be installed i n accordance with the manufacturer’s instructions. However, in no case shall the clearance between the highest part of the hob of the cooking appliance and a range hood be less than 600 mm or, for an overhea ...

  • Smeg CIR34XS - page 8

    Instructions for the installer 10 2.4 Room ventilation Caution – This hob may only be insta lled and operated in rooms permanently ventilated in accordance with current reg ulations. For proper operation of a gas ap pliance it is essential for the air nec essary for combustion of the gas to be able to flow natur ally into the room. Air must flow ...

  • Smeg CIR34XS - page 9

    Instructions for the installer 11 3 GAS CONNECTION This appliance is suitable for installation with Nat ural Gas or ULPG (propane). Refer to page 12 for the relevant burner pressure an d appropriate injector sizes. When the appliance is to be connected to Natural Gas then the pressure regulator su pplied must be fitted to the gas inlet. A test poin ...

  • Smeg CIR34XS - page 10

    Instructions for the installer 12 4 ELECTRICAL CONNECTION Make sure that the voltage and capacity of the pow er line conform to the data shown on the plate l ocated under the casing. Do not remove this plate for any reason. The plug on th e end of the supply cable and the wall sock et must be the same type and conform to the cu rrent electrical sys ...

  • Smeg CIR34XS - page 11

    Instructions for the installer 13 5 ADAPTATI ON TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the appliance from the electrical socket. The hob has been adjusted for natural gas at a pressure of 1.0 kPa. For functioning with other types of gas the nozzl es must be replaced and the primary air adjusted. To repl ...

  • Smeg CIR34XS - page 12

    Instructions for the installer 14 5.2 Removing the hob (models with built-i n control panel) 1. Remove the knobs, the gri ddles, the burner caps, the flam e caps and the two rear plugs; 2. Remove the screws “A” which fix the burner supports; 3. Raise the hob, sliding it off the ignition plugs and/ or the thermocouples and the gas tap rods; 5.3 ...

  • Smeg CIR34XS - page 13

    Instructions for the installer 15 5.4 Adjustment for natural gas The hob has been adjusted for natural gas at a pressure of 1.0kPa. To allow the unit to work back with this type of gas, after it has been adjusted for ULPG, perform the same operations described i n paragraph “5.3 Adjustment for ULPG”, but r efer to the following table for the pr ...

  • Smeg CIR34XS - page 14

    Instructions for the installer 16 6 FINAL OPERATIONS Having carried out the ab ove adjustments, reassemble the ap pliance following, backwards, the instructions in par agraph “ 5.1 Removing the control pane l / 5.2 Removing the hob”. 6.1 Adjustment of minimum for natural gas Light the burner and take it to the minimum . Remove the gas tap knob ...

  • Smeg CIR34XS - page 15

    Instructions for the installer 17 6.2 Arrangement of burners on the hob (hobs with separable control panel). 60 cm hobs BURNERS 1. Auxiliary 2. Semirapid r 3. Semirapid l 4. Rapid large 5. Wok 90 cm hobs BURNERS 1. Auxiliary 2. Semirapid 3. Rapid 4. Fish burner 5. Wok ...

  • Smeg CIR34XS - page 16

    Instructions for the installer 18 6.3 Arrangement of bur ners on the hob (hobs with built- in control panel). 60 cm hobs BURNERS 1. Auxiliary 2. Semirapid r 3. Semirapid l 4. Rapid 5. Wok 6.4 Lubrication of gas taps With time it may happen that the gas taps get blocked and hard to turn. Clean them inside and r e-grease them. This operation must be ...

  • Smeg CIR34XS - page 17

    Instructions for the user 19 7 USING THE HOB Before turning on the burners, make sure that the burn er rings, caps and grids have been fitted correctly. In the wok burner, notch A must be aligned with pin B . Grid C provided is intended for use with wok s (Chinese pans). Adapter D com es only with open grids models and is intended for use with smal ...

  • Smeg CIR34XS - page 18

    Instructions for the user 20 7.3 Diameter of containers Burners Ø min. and max . (en cm.) Auxiliary 12-14 Semirapid 16-20 Rapid 22-26 Rapid large 22-26 Wok 22-34 Fish burner Special oval-shaped vessels 7.4 Electric elements 7.4.1 Turning on electric elements Hobs may be fitted with an electric element of various diameter. The electric elemen t is ...

  • Smeg CIR34XS - page 19

    Instructions for the user 21 WARNING When switching on the electric element for the first time, or if the electric element has not been used for a long time, to remove any humidity from the insulating material it should be d ried out by placing the electric element on p osition 1 for 30 minutes. To use correctly remember to: • Switch the electric ...

  • Smeg CIR34XS - page 20

    Instructions for the user 22 8 CLEANING AND MAINTENANCE Before any intervention, disc onnect the power supply of the device. 8.1 Cleaning Clean the cooking top regularl y every time you use it, obviously after it has cooled. 8.1.1 Regular daily cleaning of the hob In order to clean an d preserve the surface, a lways use specific products only, whic ...

  • Smeg CIR34XS - page 21

    Instructions for the user 23 8.2.2 The electric element After use, to make sure that the surf aces are clean and long lasting, the electric element must be treat ed with specific cleaning pr oducts which are available on the m arket. This necessary operati on prevents oxidisation (rust formation). 8.2.3 The cover Clean the glass or steel c over, wh ...

  • Smeg CIR34XS - page 22

    Instructions for the user 24 9 PROBLEMS AND CAUSES Each of the following cases is caus ed by a n abnormal operation of the appliance and shoul d be dealt with by a authorised persons: ple ase contact your local dea ler or Service Center in cas e you detect any of these malfunctioning. PROBLEM CAUSE WHAT TO DO The flame is very lo ng with bright yel ...

  • Smeg CIR34XS - page 23

    ...

  • Smeg CIR34XS - page 24

    914771851/ C ...

Manufacturer Smeg Category Cooktop

Documents that we receive from a manufacturer of a Smeg CIR34XS can be divided into several groups. They are, among others:
- Smeg technical drawings
- CIR34XS manuals
- Smeg product data sheets
- information booklets
- or energy labels Smeg CIR34XS
All of them are important, but the most important information from the point of view of use of the device are in the user manual Smeg CIR34XS.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Smeg CIR34XS, service manual, brief instructions and user manuals Smeg CIR34XS. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Smeg CIR34XS.

Similar manuals

A complete manual for the device Smeg CIR34XS, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Smeg CIR34XS by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Smeg CIR34XS.

A complete Smeg manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Smeg CIR34XS - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Smeg CIR34XS, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Smeg CIR34XS, that we can find in the current document
3. Tips how to use the basic functions of the device Smeg CIR34XS - which should help us in our first steps of using Smeg CIR34XS
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Smeg CIR34XS
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Smeg CIR34XS in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Smeg CIR34XS?

Use the form below

If you did not solve your problem by using a manual Smeg CIR34XS, ask a question using the form below. If a user had a similar problem with Smeg CIR34XS it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)