English dropdown-ico

Manual Meade TE653ELW-M

24 pages 0.74 mb
Download

Go to site of 24

Summary
  • Meade TE653ELW-M - page 1

    TE653ELW-M Complete Weather Forecaster with Indoor/ Outdoor Temperature and Humidity USER MANUAL MADE IN CHINA ...

  • Meade TE653ELW-M - page 2

    INTRODUCTION Thank you for selecting a Meade Instruments W eather Forecaster . This device combines precise time keeping, monitoring and displaying of current temperature data from up to three remote locations (additional sensors are required). Meade Instruments is the world’ s leading designer and manufacturer of telescopes for professional and ...

  • Meade TE653ELW-M - page 3

    INST ALLA TION Communications between the main unit (receiver) and the remote sensor (transmitter) is wireless. This allows you to greater flexibility in choosing the location of remote sensor . The remote transmits data up to 164 feet (50 meters) over an open, unobstructed area. The remote sensor can be located either indoors or outdoors, allowing ...

  • Meade TE653ELW-M - page 4

    4 REMOTE SENSOR FEATURES • Remote temperature transmission to the main unit via 433 MHz signal • Case can be wall mounted using built-in hanger • 164 feet transmission range without interference • Selection of the temperature display in Celsius or Fahrenheit • LCD display of measured temperature and humidity • 3 channel selection • Te ...

  • Meade TE653ELW-M - page 5

    PLACEMENT • The remote sensor should be placed under eaves or a similar location with free air circulation, sheltered from direct sunlight and extreme weather . • Ideally , place the remote sensor over soil, rather than asphalt, which would cause false readings. • A void placing the remote sensor near sources of heat, such as chimneys or hot ...

  • Meade TE653ELW-M - page 6

    FRONT REAR 6 MADE IN CHINA A H G F E B L I D J K C M N O ...

  • Meade TE653ELW-M - page 7

    A. WEA THER FORECAST/ PRESSURE window B. TEMPERA TURE/ HUMIDITY window C. CLOCK window D. DOWN button • Select the next available mode • Press and hold for 2 seconds to search for wireless signal from remote sensor . • Decrease parameters. E. ALARM button • When time mode has been selected, press once to display the alarm time of weekday al ...

  • Meade TE653ELW-M - page 8

    BA TTERY INST ALLA TION • Remove the battery door located at the back of the main unit. • Insert two (2) AA batteries and replace the battery compartment door . PLACEMENT • Make sure that the main unit is locating within the operating range of all remote sensors. • Ideally the main unit should be placed within line of sight of remote sensor ...

  • Meade TE653ELW-M - page 9

    PRESSURE OPERA TION The pressure window displays: current barometric pressure, sea level pressure, and weather forecast. The information contains a number of historical statistics: pressure/ temperature/ humidity history bar -chart for the past 24 hours. Pressure can be measured in inHg, hPa/mBar or mmHg, and altitude is determined in either meters ...

  • Meade TE653ELW-M - page 10

    New Moon W aning Crescent First Quarter W axing Gibbous Full Moon W aning Gibbous Last Quarter W aning Crescent CHANGING PRESSURE AND ALTITUDE UNITS • Press MODE as needed, until “LOCAL” pressure is displayed. • Press and hold HISTOR Y , until the pressure unit is flashing. • Change local or sea level pressure units by pressing the UP (? ...

  • Meade TE653ELW-M - page 11

    Icon Status Searching for the signals from the remote sensor Corresponding remote sensor signal received successfully No signals received for over 1 hour REMOTE SENSORS ST A TUS The wave icon above the current channel icon shows the connection status of the corresponding remote sensor: SEARCH FOR REMOTE SENSORS • The main unit can be manually act ...

  • Meade TE653ELW-M - page 12

    VIEWING MAX/MIN AND MINIMUM READINNGS Press the MEMORY button recalling: • Current temperature and humidity • Minimum temperature and humidity • Maximum temperature and humidity at the remote location. Indicator displayed COM WET DRY T emperature Range Humidity Range Shows current condition 20°C to 25°C (68°F to 77°F) 40%RH- 70%RH Ideal r ...

  • Meade TE653ELW-M - page 13

    ICON Atomic Time Reception Strength Undefined data (Flashing) No Reception for the past 24 hours W eak signal, but can be decoded Strong signal • The atomic clock receiver is programmed that it will search for the atomic time signal daily for 0:00, 3:00, 6:00, and 12:00 am. • T o enable or disable the atomic time receiver , press and hold UP (? ...

  • Meade TE653ELW-M - page 14

    CLOCK ALARMS There are two time alarms – Weekday alarm ( W ) and Single day alarm ( S ) - and one Ice Warning Alarm ( PRE-AL ). • If Weekday (W) alarm is activated, it will sound at the set time and the alarm icon will flash Mondays through Fridays • If Single (S) day alarm is activated, it will sound at the set time and the alarm icon will f ...

  • Meade TE653ELW-M - page 15

    Issue Main unit Radio Controlled T ime signal is not received Cannot locate remote sensor Cannot change the channel Data does not match data on the main unit Place unit by the window and keep it there overnight Check batteries Check location Press and hold DOWN ( ? ) button on the main unit to search for the signal form the remote sensor Press “R ...

  • Meade TE653ELW-M - page 16

    BA TTERY INST ALLA TION • Remove the battery door located at the back of the main unit. • Insert two (2) AA batteries and replace the battery compartment door . PLACEMENT • Make sure that the main unit is locating within the operating range of all remote sensors. • Ideally the main unit should be placed within line of sight of remote sensor ...

  • Meade TE653ELW-M - page 17

    PRESSURE OPERA TION The pressure window displays: current barometric pressure, sea level pressure, and weather forecast. The information contains a number of historical statistics: pressure/ temperature/ humidity history bar -chart for the past 24 hours. Pressure can be measured in inHg, hPa/mBar or mmHg, and altitude is determined in either meters ...

  • Meade TE653ELW-M - page 18

    New Moon W aning Crescent First Quarter W axing Gibbous Full Moon W aning Gibbous Last Quarter W aning Crescent CHANGING PRESSURE AND ALTITUDE UNITS • Press MODE as needed, until “LOCAL” pressure is displayed. • Press and hold HISTOR Y , until the pressure unit is flashing. • Change local or sea level pressure units by pressing the UP (? ...

  • Meade TE653ELW-M - page 19

    Icon Status Searching for the signals from the remote sensor Corresponding remote sensor signal received successfully No signals received for over 1 hour REMOTE SENSORS ST A TUS The wave icon above the current channel icon shows the connection status of the corresponding remote sensor: SEARCH FOR REMOTE SENSORS • The main unit can be manually act ...

  • Meade TE653ELW-M - page 20

    VIEWING MAX/MIN AND MINIMUM READINNGS Press the MEMORY button recalling: • Current temperature and humidity • Minimum temperature and humidity • Maximum temperature and humidity at the remote location. Indicator displayed COM WET DRY T emperature Range Humidity Range Shows current condition 20°C to 25°C (68°F to 77°F) 40%RH- 70%RH Ideal r ...

  • Meade TE653ELW-M - page 21

    ICON Atomic Time Reception Strength Undefined data (Flashing) No Reception for the past 24 hours W eak signal, but can be decoded Strong signal • The atomic clock receiver is programmed that it will search for the atomic time signal daily for 0:00, 3:00, 6:00, and 12:00 am. • T o enable or disable the atomic time receiver , press and hold UP (? ...

  • Meade TE653ELW-M - page 22

    CLOCK ALARMS There are two time alarms – Weekday alarm ( W ) and Single day alarm ( S ) - and one Ice Warning Alarm ( PRE-AL ). • If Weekday (W) alarm is activated, it will sound at the set time and the alarm icon will flash Mondays through Fridays • If Single (S) day alarm is activated, it will sound at the set time and the alarm icon will f ...

  • Meade TE653ELW-M - page 23

    Issue Main unit Radio Controlled T ime signal is not received Cannot locate remote sensor Cannot change the channel Data does not match data on the main unit Place unit by the window and keep it there overnight Check batteries Check location Press and hold DOWN ( ? ) button on the main unit to search for the signal form the remote sensor Press “R ...

  • Meade TE653ELW-M - page 24

    MADE IN CHINA Meade Instruments Corp. 27 Hubble Irvine, CA 92618 U.S.A. ©201 1 Meade Instruments Corp. All Rights Reserved. All user manual contents and information are subject to change. ...

Manufacturer Meade Category Weather Radio

Documents that we receive from a manufacturer of a Meade TE653ELW-M can be divided into several groups. They are, among others:
- Meade technical drawings
- TE653ELW-M manuals
- Meade product data sheets
- information booklets
- or energy labels Meade TE653ELW-M
All of them are important, but the most important information from the point of view of use of the device are in the user manual Meade TE653ELW-M.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Meade TE653ELW-M, service manual, brief instructions and user manuals Meade TE653ELW-M. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Meade TE653ELW-M.

Similar manuals

A complete manual for the device Meade TE653ELW-M, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Meade TE653ELW-M by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Meade TE653ELW-M.

A complete Meade manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Meade TE653ELW-M - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Meade TE653ELW-M, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Meade TE653ELW-M, that we can find in the current document
3. Tips how to use the basic functions of the device Meade TE653ELW-M - which should help us in our first steps of using Meade TE653ELW-M
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Meade TE653ELW-M
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Meade TE653ELW-M in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Meade TE653ELW-M?

Use the form below

If you did not solve your problem by using a manual Meade TE653ELW-M, ask a question using the form below. If a user had a similar problem with Meade TE653ELW-M it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)