English dropdown-ico

Manual Dansons Group CAN/CSA B365

12 pages 0.47 mb
Download

Go to site of 12

Summary
  • Dansons Group CAN/CSA B365 - page 1

    PELLET STOVE OPERATIONS GUIDE CAN/CSA B365 Installation Code For Solid-Fuel-Burning Appliances and Equipment in Canada and NFPA 211 Chimney, Fireplaces, Vents and Solid Fuel Burning Appliances in the USA Manufactured by READ THIS ENTIRE MANUAL BEFORE INSTALLING YOUR PELLET STOVE/HEATER/INSERT. FAILURE TO FOLLOW INSTRUCTIONS MAY RESULT IN PROPERTY D ...

  • Dansons Group CAN/CSA B365 - page 2

    Dear Pellet Appliance Owner, UPDATES Updated manuals, product registration and warranty information can be found on our website: Thank you for selecting our wood pellet stove! 2 Sincerely, Dansons Group Inc. and Canadian Comfort Industries www.dansons.com/support FOREWORD TO NEW OWNERS Congratulations on the purchase of your wood pellet appliance. ...

  • Dansons Group CAN/CSA B365 - page 3

    LIGHTING PROCEDURE STARTUP CHECKLIST 2 A B C D 1 3 The COMBUSTION FAN (exhaust) will start and operate at full speed for 60 seconds, then will slow to match the startup rate On a primed auger system , pellets will begin to fall into the BURN GRATE, and the igniter will automatically ignite pellets in approximately 3 to 7 minutes. During first-time ...

  • Dansons Group CAN/CSA B365 - page 4

    INITIAL SETUP 1 2 Slide open or close the damper as needed to obtain a fire that is brisk enough to carry ash out of the grate, but not so brisk that it carries whole pellets out as well; this is known as popcorning . Normally, you should find that the damper will need to be 1/4” to 1/2” open. This may vary with length of vent run, pellet quali ...

  • Dansons Group CAN/CSA B365 - page 5

    3 A B FINE TUNING YOUR STOVE FUEL FEED RATE SETTING #1 (LOW) FUEL FEED RATE SETTING #4 (HIGH) INCREASES feed rate DECREASES feed rate Do NOT use a metal object to adjust your trim pods. Try using a plastic non-metallc object (eg. insulated shaft screwdriver, pen cap, etc.) Fuel feed rate at the lowest (#1) and highest (#4) settings can be changed b ...

  • Dansons Group CAN/CSA B365 - page 6

    The performance of your pellet appliance is greatly affected by the type and quality of wood pellets burned. As the heat output of various brands of pellets differs, so will the performance and heat output of your appliance. We recommend the use of screened pellet fuel in order to reduce the amount of fines your stove will have to cope with. PELLET ...

  • Dansons Group CAN/CSA B365 - page 7

    NOTE: It is much easier to remove fines from pellets before they are placed in the stove than it is to service your stove for a plugged hopper, jammed auger or plugged exhaust system. Pellets with excessive sawdust may be screened to remove most of the fines. Pellet screeners may be built or purchased from most pellet stove dealers. NOTE: Because D ...

  • Dansons Group CAN/CSA B365 - page 8

    ASH TRAPS - Remove the rear burn plate from the firebox area. This will expose the 2 ash traps and the pellet fuel drop chute. Fly ash may be removed by vacuuming inside the trap area with an approved ash vacuum ( A HOME SHOP VAC MAY BE USED TO REMOVE ASH FROM YOUR STOVE *ONLY* WHEN THE ASHES HAVE COOLED ). A bottle cleaning brush can help remove b ...

  • Dansons Group CAN/CSA B365 - page 9

    INSPECT AND CLEAN VENTING - Fly ash will collect in the exhaust venting system and restrict the flow of flue gases. Check the clean out tees and elbows in the system periodically to determine the required schedule of cleaning. To remove dust from the vent pipe, lightly tap on the pipe to dislodge loose ash. Open the bottom of the tee to dump the as ...

  • Dansons Group CAN/CSA B365 - page 10

    GUIDE TO TROUBLESHOOTING Proper cleaning, maintenance and use of quality pellets will prevent common operational issues with your pellet stove. However, when your appliance is simply operating poorly or not at all, the following troubleshooting tips may be helpful. Orange, lazy flame - clean out burn grate and burn pot - examine ash traps, clean as ...

  • Dansons Group CAN/CSA B365 - page 11

    LIMITED WARRANTY CANADIAN COMFORT INDUSTRIES (CCI) LIMITED WARRANTY CCI wood pellet and corn appliances carry a one (1) year - parts only - on electrical components and a five (5) year limited warranty from the date of sale to the original owner against defects and workmanship on all steel parts (excluding the burn grate and the heat tube scraper / ...

  • Dansons Group CAN/CSA B365 - page 12

    COPYRIGHT Copyright 2006, Canadian Comfort Industries. All rights reserved. No part of this manual may be copied, transmitted, transcribed, stored in a retrieval system in any form or by any means without the expressed written permission of: Canadian Comfort Industries 26319 Twp Rd 531 Acheson, AB Canada T7X 5A3 1-877-303-3134 To register your purc ...

Manufacturer Dansons Group Category Stove

Documents that we receive from a manufacturer of a Dansons Group CAN/CSA B365 can be divided into several groups. They are, among others:
- Dansons Group technical drawings
- CAN/CSA B365 manuals
- Dansons Group product data sheets
- information booklets
- or energy labels Dansons Group CAN/CSA B365
All of them are important, but the most important information from the point of view of use of the device are in the user manual Dansons Group CAN/CSA B365.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Dansons Group CAN/CSA B365, service manual, brief instructions and user manuals Dansons Group CAN/CSA B365. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Dansons Group CAN/CSA B365.

Similar manuals

A complete manual for the device Dansons Group CAN/CSA B365, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Dansons Group CAN/CSA B365 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Dansons Group CAN/CSA B365.

A complete Dansons Group manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Dansons Group CAN/CSA B365 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Dansons Group CAN/CSA B365, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Dansons Group CAN/CSA B365, that we can find in the current document
3. Tips how to use the basic functions of the device Dansons Group CAN/CSA B365 - which should help us in our first steps of using Dansons Group CAN/CSA B365
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Dansons Group CAN/CSA B365
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Dansons Group CAN/CSA B365 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Dansons Group CAN/CSA B365?

Use the form below

If you did not solve your problem by using a manual Dansons Group CAN/CSA B365, ask a question using the form below. If a user had a similar problem with Dansons Group CAN/CSA B365 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)