-
Haier XPB50-AS - page 1
XPB50-AS XPB50-BS(with pump Air BubbleT win-tub Washing Machine Names of the parts.............the 2 nd cover Safety precautions ...............................1 Installation and adjustment ..................3 Introduction of the major functions .......5 Preparation before washing ................6 The musts in washing .........................7 Us ...
-
Haier XPB50-AS - page 2
Before Using Before Using Names of the par ts Buzzer Water-filling entrance Water inlet selector handle Wash selector Wash timer Control panel Overflow filter Quick water-filling entrance Cascade outlet Water level adjusting lever Lint filter Valve cover Pulsator Wash tub Drain hose Base frame Outer cover of the spin tub Inner cover of the spin tub ...
-
Haier XPB50-AS - page 3
Before Using Before Using Safety precautions If the power cord is bad, to avoid risk it is required to replace it by the technicians of our special shop or the after-sale service department. Keep the pin of the power plug clean. Be sure to use three-phase receptacle. Earth the earthing terminal of the receptacle reliably. Do not put the machine at ...
-
Haier XPB50-AS - page 4
Before Using Before Using Do not stretch hands into the working machine. It is dangerous even if the rotation is slow. T ake special care of the children. Handicapped or children without care shall not use the machine. Do not put any hot or heavy items ( such as the kettle with hot water ) on the washing machine. Do not decompose, repair or alter t ...
-
Haier XPB50-AS - page 5
Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Usage of the drain hose(Only for XPB50-BS The drainage shall be smooth with the drain hose. 1.The height of the drain hose shall be less than 10cm , or the drainage will not be smooth enough and ...
-
Haier XPB50-AS - page 6
Extend the drain hose from the rear side How to change the direction of the drain hoses Figure 1 indicates the ex factory installation position of the drain hose. Put soft items on the ground. Lean the machine down gently with the front surface facing the ground. T ake off the drain hose from the cabinet. T ake the hose out of the fixing groove. (S ...
-
Haier XPB50-AS - page 7
Using process Using process Intr oduction of the major function The machine has good comprehensive performance, and nice appearance. In the respect of increasing the clean rate, it creates the air suction washing method. The spinning of the pulsator automatically produces large quantity of bubbles, which can strengthen the activity of the detergent ...
-
Haier XPB50-AS - page 8
Confirm if there's special requirement for the laundries. Clear the pocket. T ake out the coins , sand, hairpins etc. Fasten the buttons and zippers. When the pulsator is running , the buttons of the laundries may cause noise. For the sake of discretion,please put the laundries with buttons into other laundries. Preparation before washing 1.Co ...
-
Haier XPB50-AS - page 9
Reference weight of the laundries Working suit up,down Jeans about 800g The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition that can be washed or spinned in one time. Laundries quantity in one washing cycle shall be lower than the rated capacity. The largest capacity of this ...
-
Haier XPB50-AS - page 10
Selection of the quantity of the washing powder list 1 Selection of the current , water level and washing time list 2 How to use the washing powder How to use the whitener Fill water to decided level. Dilute the whitener with container. Pour it slowly into the washing tub. Avoid using whitener on laundries with color or pattern as they are prone to ...
-
Haier XPB50-AS - page 11
OFF OFF OFF OFF DRAIN STRONG SOFT MAX Washing sequence Figure 1 Figure 2 Figure 3 Figure 4 Figure 5 WOOL WOOL WOOL Spin timer SPIN TIMER SPIN WASH Wash timer WASH TIMER WASH TIMER WASH SELECTOR Wash selector Buzzer BUZZER Water-filling entrance (T o set to below 2 minute, first set to 5 minute then turn it back. it can increase the service life of ...
-
Haier XPB50-AS - page 12
Midway spinning 1. 2. 3. Put the laundries into the spin tub evenly and smoothly . Spin Run the foam-removing spinning. Push Push Proper Proper Outer cover of The spin tub Inner cover of The spin tub The laundries are slanting Gland No gland Using process Using process (1) Put the gland in properly. Please put in the gland properly even if the laun ...
-
Haier XPB50-AS - page 13
Rinse with stored water Rinse with water-filing 1. Put the laundries into the wash tub. Select suitable current according to the laundries. 2. Fill water to preset water level. 3. Rinse Adjust the wash timer to 2-3 minutes to do rinsing. When the laundries quantity is below 2.4kg, please use "Standard" current. If you use "Strong&quo ...
-
Haier XPB50-AS - page 14
Selection of the spin time list 3 Laundries Spin time (minutes) About 4~5 Bed sheet or blanket About 2~4 Underwear (knitwear) Swear (chemical fiber) About 1~2 Within 1 minute Blending thin laundries Using process Using process 1. Put the laundries into the spin tub evenly and smoothly. 2. Press the gland in the tub properly. Close the inner and out ...
-
Haier XPB50-AS - page 15
After using, please clean the lint and foreign materials of the lint filter and overflow filter in time. Otherwise it may influence your using the machine. Please first pull off the power plug from the receptacle before cleaning. Figure 2 Figure 3 Figure 1 1. T ake off the lint filter Put hand at the indicated position. Push down to take it off. ( ...
-
Haier XPB50-AS - page 16
Wipe the complete unit with soft cloth twisted dry. Wipe with neutral detergent if too dirty Do not wash it directly by water Using process Using process Cleaning the overflow filter 2. T ake off the corrugation pipe. Dismantle the upper part of the corrugation pipe inside the overflow filter ( as indicated in Figure 1). 3. Cleaning the overflow fi ...
-
Haier XPB50-AS - page 17
2~3L T rouble-shooting Answer to question Below 50 When the remained water is frozen Prevent the freezing (be sure to discharge the water completely after using) After complete draining, set the "W ASH SELECTOR" at "STRONG" or "ST ANDARD". If it is set at "DRAIN", it will be rather difficult for the frozen wa ...
-
Haier XPB50-AS - page 18
T rouble-shooting Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do n ...
-
Haier XPB50-AS - page 19
User's manual One One One One One Water inlet hose Water-filling jointer Gland Twin-tub washing machine Packing list Lint filter One Quantity Inside the document bag Storage position Name Inside the document bag Inside the accessory bag Inside theaccessory bag Inside the accessory bag ...
-
Haier XPB50-AS - page 20
Air bubble twin-tub Air bubble twin-tub wash- washing machine ing machine with pump XPB50-AS XPB50-BS V~, 0Hz High/43L Medium/36L Low/30L 5.0 5 Wash 360 Spin 160 Wash 360 Spin 160 L740 W428 H 90 New current + bubble 26 28 0.02MPa~0.2MPa Rated voltage 115 Rated frequency 6 .0 8 Specification Type Model Power source Water level Water quantity about R ...
У вас вопрос, касающийся Haier XPB50-AS?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Haier XPB50-AS, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Haier XPB50-AS со всей вероятностью он захочет поделиться методом ее решения.