-
Jura Capresso 13709 - page 1
IMPRESSA F70/F7/F707 Instructions for use 4/05 Art. Nr. 65391 ...
-
Jura Capresso 13709 - page 2
JURA IMPRESSA JURA Elektroapparate AG, CH-4626 Niederbuchsiten, Internet http://www.jura.com Legend: DISPLAY: serves as information. DISPLAY: please follow the instructions shown. = Note = Important = Tip ...
-
Jura Capresso 13709 - page 3
Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 6 Fig. 7 Fig. 9 Fig. 10 Fig. 11 Fig. 12 Fig. 13 Fig. 14 Fig. 16 1 2 3 Fig. 5 B A Fig. 8 B Fig. 15 Fig. 17 ...
-
Jura Capresso 13709 - page 4
Control elements 1. Rotary Switch 2. Illuminated ring 3. ON / OFF symbol 4. 1 LARGE CUP symbol 5. 1 COFFEE symbol 6. 1 ESPRESSO symbol 7. MAINTENANCE symbol 8. START symbol 9. Display dialog system 10. Water tank with handle 11. Filler funnel for pre-ground coffee 12. Bean tank cover 13. Aroma preservation cover 14. Steam / hot water draw-off tap 1 ...
-
Jura Capresso 13709 - page 5
5 Contents 1. Safety information .......................................... page 6 1.1 Warning .............................................. page 6 1.2 Precautions .......................................... page 6 2. Preparing the IMPRESSA ................................ page 6 2.1 Check supply voltage .............................. page 6 2.2 Ch ...
-
Jura Capresso 13709 - page 6
6 Introduction Thank you for purchasing the IMPRESSA. To ensure perfect func- tioning of your IMPRESSA, carefully read this operating manual and keep it for future reference. Should you need more information or if you encounter particular problems not specified in these operating instructions in sufficient detail, either contact us directly or cont ...
-
Jura Capresso 13709 - page 7
7 Then fill the water tank and reinstall it. Make sure to install the tank properly, it must engage audibly. 2.4 Fill coffee beans To ensure that your machine will work perfectly for a long time and to avoid damage, please note that the grinding gear of your JURA coffee machine is not suitable for coffee beans which were treated, during or afte ...
-
Jura Capresso 13709 - page 8
8 Close the steam / hot water draw-off tap (14). FILLING SYSTEM HEATING PRESS MAINT. Touch the symbol (7). Machine carries out a rinsing operation. RINSING READY If BEANS FILL is displayed, press the coffee draw-off key again. Machine not filled with coffee beans yet. To get an excellent froth, adjust the coffee spou ...
-
Jura Capresso 13709 - page 9
9 5. Installation of Claris plus filter cartridges If the Claris plus filter cartridge is installed properly, de- scaling of the coffee machine is no longer required. For more information on the Claris plus filter cartridge refer to brochure «Claris plus. Hard on limescale. Gentle on your coffee machine.» 5.1 Installing the filter Draw off 1/2 li ...
-
Jura Capresso 13709 - page 10
10 Place a sufficiently large jug (approx 1 litre) under the replace- able hot water nozzle (16) and open the steam/hot water tap (14) (Fig. 12). RINSING FILTER CLOSE TAP Open the steam / hot water draw-off tap (14) (Fig. 12). HEATING UP READY 5.3 Changing the filter without display request Press the Rotary Switch (1) un ...
-
Jura Capresso 13709 - page 11
11 9. Making 2 cups of coffee You cannot choose the strength of the coffee when making 2 cups. The machine automatically makes 2 mild cups of coffee. You can set the amount of water you want with the Rotary Switch (1) prior to drawing off coffee Touch the (8) symbol to stop drawing off coffee pre- maturely. The amount of coffee water you used last ...
-
Jura Capresso 13709 - page 12
12 10. Drawing off pre-ground coffee Never use instant coffee or quick-coffee. We recommend that you always use powder from fresh coffee beans or, pre- ground, vacuum-packed coffee. Never fill in more than 2 portions of powder. The pre-ground coffee tank is no storage tank. Make sure that the pre-ground you use is not too fine. This may cause block ...
-
Jura Capresso 13709 - page 13
13 CLOSE TAP Close the steam / hot water draw-off tap (14). READY Before CLOSE TAP water may still escape the system. 12. Drawing off steam To ensure perfect operation, clean the 2-stage frothing jet (15) regularly. Screw the nozzle off as described in. Hold the nozzle at the top and at the bottom end and screw it apart (Fig. 16). Thoro ...
-
Jura Capresso 13709 - page 14
14 13.1 Attaching the Professional-Cappuccino Frother or the Easy-Cappuccino Frother to the IMPRESSA Remove either the hot water nozzle (Fig.5) or the 2-stage froth- ing jet (Fig. 6). Now attach the Professional-Cappuccino Frother or the Easy- Cappuccino Frother (Fig.7). Connect the milk tube with the Professional-Cappuccino Frother or ...
-
Jura Capresso 13709 - page 15
15 Fill water into a container (approx. 1/2 litre) and immerse the milk tube in it. Place a sufficiently large vessel under the Professional-Cappuc- cino Frother or the Easy-Cappuccino Frother. Draw steam until the water from the Professional-Cappuccino Frother or the Easy-Cappuccino Frother runs clean. The Professional-Cappuccino Froth ...
-
Jura Capresso 13709 - page 16
16 Press the Rotary Switch (1) RINSE Turn the Rotary Switch (1) until the required program item ap- pears on the display (9). e.g. RINSE, CLEAN, FILTER, DE-SCALE or EXIT e.g. CLEAN Press the Rotary Switch (1) The cleaning program starts. EMPTY TRAY Continue with Chapter 17 Cleaning, from point 3 EMPTY TRAY 15.4 P ...
-
Jura Capresso 13709 - page 17
17 The illuminated ring (2) is active. Turn the Rotary Switch (1) until TIME is displayed. TIME Now press the Rotary Switch (1) to start programming the time. --:-- Turn the rotary Switch (1) to adjust the hours.. 12:-- Press the Rotary Switch (1) to confirm the hour settings and to activate the minutes. 12:-- ? ...
-
Jura Capresso 13709 - page 18
18 OFF AFT. HR Now press the Rotary Switch (1) to start programming the switch-off time. Switch-off time OFF AFT. HR 5.0 HR Turn the Rotary Switch (1) to adjust the hours. 1.0 HR Press the Rotary Switch (1) to save the setting. OFF AFT. HR Turn the Rotary Switch (1) until EXIT appears Press the Rotary Switch (1) ...
-
Jura Capresso 13709 - page 19
19 LANGUAGE Turn the Rotary Switch (1) until EXIT appears Press the Rotary Switch (1) to leave the programming mode. READY 15.11 Programming Display 24H/AM/PM READY Press the Rotary Switch (1) until FILTER – / appears The illuminated ring (2) is active. Turn the Rotary Switch (1) until DISPLAY appears Press ...
-
Jura Capresso 13709 - page 20
20 16. Maintenance 16.1 Filling in water FILL WATER If this information is displayed, drawing off products is no longer possible. Refill water as described in Chapter 2.3. READY The water tank should be rinsed daily and refilled with fresh water. Only fill in fresh, cold water. Never fill in milk, mineral water or other liquids. 16.2 Emptyi ...
-
Jura Capresso 13709 - page 21
21 16.6 Cleaning the IMPRESSA After 200 draw-off operations or after 80 rinsing operations, the IMPRESSA must be cleaned. A message appears on the display, telling you to start the cleaning programme. You can still draw off coffee or hot water/steam. However, we recommend that you should clean the machine (Chapter 17) within the next few days. ...
-
Jura Capresso 13709 - page 22
22 READY CLEAN Touch the symbol (7). EMPTY TRAY Empty the tray (20). NO TRAY Insert the tray (20) again. Remove the drip grate (19). Put a container (1 l, Fig. 11) under the adjustable coffee spout (17). PRESS MAINT. Touch the symbol (7). CLEANING FILL TABLET Fill in the tablet (see Fig. 14) P ...
-
Jura Capresso 13709 - page 23
23 When using the de-scaling agent, immediately remove any splashes or drips from sensitive surfaces, i.e. natural stone and wooden surfaces, or take appropriate precautions. In any case wait until the de-scaling agent is used up and the tank is empty. Never refill de-scaling agent. MACHINE CALCIFIED / MACHINE READY Remove hot water nozzle ...
-
Jura Capresso 13709 - page 24
24 18.1 Decalcifying without display request Decalcifying without display request is only possible if the Claris plus filter is NOT programmed. Press the Rotary Switch (1) until FILTER – appears. Turn the Rotary Switch (1) until MAINTENANCE appears. Press the Rotary Switch (1) to confirm. RINSE Turn the Rotary Switch (1) until ...
-
Jura Capresso 13709 - page 25
25 21. Messages Cause Remedy FILL WATER Water tank is empty. Refill water Float defective Rinse or de-scale water tank FILL BEANS Bean tank is empty. Refill beans Although you have refilled beans, the Draw off a cup of coffee. The message will message still appears. disappear only after you have drawn off a cup of coffee EMPTY GROUNDS Coffee ground ...
-
Jura Capresso 13709 - page 26
26 22. Problems Problem Cause Remedy Very loud noise coming from the Foreign body in grinding gear Drawing off pre-ground coffee still possible grinding gear Have IMPRESSA checked by JURA Service Too little froth when 2-stage frothing jet blocked clean 2-stage frothing jet frothing milk 2-stage frothing jet in wrong position Draw off steam (Chapter ...
-
Jura Capresso 13709 - page 27
27 23. Legal information These operating instructions contain all the information required for using, operating and maintaining the machine properly. Knowledge of and compliance with the specifications contained in these operating instructions is required for using the machine safely as well as for operational safety and safety during maintenance. ...
У вас вопрос, касающийся Jura Capresso 13709?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Jura Capresso 13709, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Jura Capresso 13709 со всей вероятностью он захочет поделиться методом ее решения.