-
Belling BE817 - page 1
BE817 Frost Free Fridge Freezer INST ALLA TION AND USER INSTRUCTIONS Y ou must read these instructions prior to using the appliance and retain them for future reference. ...
-
Belling BE817 - page 2
1 Contents Introduction & safety warnings ...........................................................................2 Electrical requirements ......................................................................................3 T ransportation instructions ................................................................................. 4 In ...
-
Belling BE817 - page 3
2 Congratulations on your choice of a Belling quality Appliance which has been designed to give you service for many years. W ARNING ! IMPORT ANT ! DO NOT connect your appliance to the electricity supply until all packing and transit protectors have been removed. • Leave to stand for at least 4 hours before switching on to allow compressor oil to ...
-
Belling BE817 - page 4
3 ELECTRICAL REQUIREMENTS Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the rating plate inside the appliance corresponds to your electricity supply . Rating label is on the left hand side of freezer inner liner . We recommend that this appliance is connected to the mains supply via a suitable ...
-
Belling BE817 - page 5
TRANSPORT A TION INSTRUCTIONS 1. The appliance should be transported only in a vertical upright position. The packing as supplied must be intact during transportation. 2. If during the course of transport the appliance has to be transported horizontally , it must only be laid on its left hand side when standing in the front of the appliance. After ...
-
Belling BE817 - page 6
5 4. Do not place the appliance near cookers, radiators or in direct sunlight as this will cause your appliance to work harder . If installed next to a source of heat or freezer , maintain the following minimum side clearances: From Cookers 50 mm (2") From Radiators 300 mm (12") From Freezers 25 mm (1") A special receptacle is suppli ...
-
Belling BE817 - page 7
6 Getting to know your appliance WINE RACK DEFROST W A TER COLLECTION CHANNEL EGG TRA Y SALAD CRISPER CABINET SHEL VES THERMOST A T KNOB INTERIOR LIGHT BOTTLE SHELF FROZEN FOOD COMP ARTMENTS F AST FREEZE COMP ARTMENT DAIRY COMP ARTMENT DOOR SHELF ...
-
Belling BE817 - page 8
Arrangement Examples (See diagram) 1. Baked, chilled cooked food, dairy products, cans. 2. Wine, 3. Meat, sausages, cold cuts. 4. Fruit, vegetables, salads. 5. Frozen food and freezing of fresh food. 6. Frozen food. 7. Butter , cheese. 8. Small bottles, cans, tubes. 9. Eggs. 10. T all, large bottles, beverages. SUGGESTED ARRANGEMENT OF FOOD IN THE ...
-
Belling BE817 - page 9
TEMPERA TURE CONTROL AND ADJUSTMENT Operating temperatures are controlled by the thermostat knob (see diagram) located on the ceiling of fridge compartment. Settings may be made from 1 to 5, 5 being the coldest position. When the appliance is switched on for the first time, the thermostat should be adjusted so that after 24 hours, the average fridg ...
-
Belling BE817 - page 10
STORING FROZEN FOOD Prepacked commercially frozen food should be stored in accordance with the frozen food manufacturer's instructions for a frozen food storage compartment. T o ensure that the high quality achieved by the frozen food manufacturer and the food retailer is maintained, the following should be remembered: 1. Put packets in the fr ...
-
Belling BE817 - page 11
MAKING ICE CUBES Fill the ice - cube tray 3/4 full with water . Loosen frozen trays with the handle of a spoon, never use sharp edged objects such as knives, forks. Note: If freshly made ice cubes are not consumed for several weeks, they will slowly reduce in size and eventually disappear completely . FREEZING FRESH FOOD Please observe the followin ...
-
Belling BE817 - page 12
DEFROSTING A) FRIDGE COMP ARTMENT The fridge compartment defrosts automatically . The defrosting water runs to the drain tube via a collection container at the back of the appliance (1). (see diagram) During defrosting water droplets may form at the back of the fridge compartment where concealed evaporator is located. Some droplets may remain on th ...
-
Belling BE817 - page 13
12 CLEANING AND CARE ** We recommend that you switch of f the appliance at the socket outlet and pull out the mains plug before cleaning. ** Never use any sharp abrasive instrument, soap, household cleaner , detergent and wax polish for cleaning. ** Use luke warm water to clean the cabinet of the appliance and wipe it dry . ** Use a damp cloth wrun ...
-
Belling BE817 - page 14
REPLACING THE INTERIOR LIGHT BULB (See diagram) Should the light fail to work, proceed as follows. 1. Switch off at the socket outlet and pull out the mains plug. • Y ou may find it useful to remove shelves for easy access. 2. Use a flat tipped screwdriver to remove the light diffuser cover by inserting the blade in the centre between diffuser an ...
-
Belling BE817 - page 15
DO'S AND DON'TS Do- Clean and defrost your appliance regularly (See "Defrosting") Do- Keep raw meat and poultry below cooked food and dairy products. Do- T ake of f any unusable leaves on vegetables and wipe off any soil. Do- Leave lettuce, cabbage, parsley and cauliflower on the stem. Do- Wrap cheese firstly in greaseproof pape ...
-
Belling BE817 - page 16
15 ENERGY SA VING TIPS 1- Ensure your appliance is installed in a well ventilated area. If the ambient temperature is low (but in no case lower than 5 degrees C), then the energy saving will be more. In this case, check temperatures of fridge and freezer compartments with an accurate thermometer and lower the thermostat setting (towards 1) if neces ...
-
Belling BE817 - page 17
16 REVERSING THE DOORS T op Door 1. Unscrew top hinge (4). 2. Carefully remove the top door . 3. Unscrew lower hinge (6) 4. Remove plastic plugs (10 &1 1). 5. Refit top hinge (4) as lower hinge (14) on the left hand side. 6. Replace top door 7. Refit lower hinge (6) as top hinge (16) on the left hand side. Lower door 1. Unscrew top hinge (7) 2. ...
-
Belling BE817 - page 18
17 REVERSING THE DOORS 1 2 3 4 5 10 6 7 8 9 13 1 1 12 16 17 15 18 22 14 21 20 23 19 ...
-
Belling BE817 - page 19
18 INST ALLA TION INSTRUCTIONS (All dimensions are in mm) 1 3 3 2 2 45 ° FRONT FEET 45 ° ...
-
Belling BE817 - page 20
19 4 5 REAR FEET 45 ° ...
-
Belling BE817 - page 21
20 min. 550 min. 35 mm min. 200 cm 2 min. 5 60 1812 848 28 1812 758 848 86.5 91 535 540 min. 200 cm 2 100 100 60 60 ...
-
Belling BE817 - page 22
21 86.5 91 200 cm 2 200 cm 2 min.35 mm 758 848 ...
-
Belling BE817 - page 23
22 90 o 9 10 8 1 1 6 7 6 ...
-
Belling BE817 - page 24
23 15 14 16 17 14 90 o 18 mm + 1 _ 15 18 12 13 1 mm ...
-
Belling BE817 - page 25
24 Ensure 2 mm gaps are obtained, adjust if necessary . 2 mm 2 mm 2 mm ...
-
Belling BE817 - page 26
25 GUARANTEE DET AILS Y our new Belling product is guaranteed against the cost of breakdown repairs for twelve months from the date of the original purchase. What is covered? • Repairs necessary as a result of faulty materials, defective components or manufacturing defect. • The cost of functional replacement parts, but excluding consumable ite ...
-
Belling BE817 - page 27
26 Recycling This product bears the selective sorting symbol for waste electrical and electronic equipment (WEEE). This means that this product must be handled pursuant to European Directive 2002/96/EC in order to be recycled or dismantled to minimize its impact on the environment. For further information, please contact your local or regional auth ...
-
Belling BE817 - page 28
PERFORMANCE Energy efficiency class Energy consumption - Kwh/year Net storage - vol fresh food ltrs (cu.ft.) T otal net vol - ltrs (cu.ft.) Frozen food compartment rating Conservation time from failure Freezing capacity fresh food - kg (lb) / 24 hrs. Climate class Operating noise level dB(A) Net storage - vol frozen food ltrs (cu.ft.) Frost Free Fr ...
-
Belling BE817 - page 29
28 WIRING DIAGRAM ...
-
Belling BE817 - page 30
48 61 19 00 00 In case of dif ficulty within the UK, please call Belling Customer Care Centre Helpline on 08 44 815 3746 When you dial this number you will hear a recorde d message and be given a number of options. This indicates that your call has been accepte d and is being held in a queue. Calls are answered in strict rotation as our Custo mer C ...
У вас вопрос, касающийся Belling BE817?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Belling BE817, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Belling BE817 со всей вероятностью он захочет поделиться методом ее решения.