-
Philco PSF 341 - page 1
FREEZER USER'S MANU AL PSF 341 ...
-
Philco PSF 341 - page 2
Dear customer , Thank you f or buying a PHIL CO br and produc t. So that your applianc e serves you well , please read all the instructions in this user's manual. ...
-
Philco PSF 341 - page 3
EN - 1 07/2011 Copyright © 2011, Fast ČR, a. s. C ONTENTS P ART 1: BEFORE PUT TING INT O OPERA TION ................................................................................................. 2 Safety notice ............................................................................................................................... ...
-
Philco PSF 341 - page 4
EN - 2 07/2011 Copyright © 2011, Fast ČR, a. s. P ART 1: BEFORE PUT TING INT O OPER A TION Safety notice Symbols: General advice for the optimal operation of the appliance General dangers Hot surfaces Before you put the applianc e into operation • Carefully study the user's manual and installation instructions before installing and using t ...
-
Philco PSF 341 - page 5
EN - 3 07/2011 Copyright © 2011, Fast ČR, a. s. Do not place food inside the freez er containing ammable propulsion gases (e.g. spray s) and no explosive, contaminating or v olatile substances. There is a danger of explosion! Do not store liquids inside bottles and cans (especially bev erages containing carbon dioxide) inside the freezer comp ...
-
Philco PSF 341 - page 6
EN - 4 07/2011 Copyright © 2011, Fast ČR, a. s. T echnical safety The appliance c ontains a cooling gas, ISOBUTHAN (R600a). Only transport or move the appliance with the utmost care, prev ent excessive impacts and shaking to prevent damaging the appliance. If the cooling circuit becomes damaged and the cooling gas ma y be escaping, there is a ris ...
-
Philco PSF 341 - page 7
EN - 5 07/2011 Copyright © 2011, Fast ČR, a. s. P ART 2: PRODUC T DESCRIPTION 1 2 3 4 5 1. Shelf 2. T emperature thermostat (at the rear side of the freez er) 3. Levelling feet 4. Hinge cover 5. Seal ...
-
Philco PSF 341 - page 8
EN - 6 07/2011 Copyright © 2011, Fast ČR, a. s. P ART 3: INST ALLA TION T ranspor t and unpacking If the appliance is transported in a horizontal position the oil from the compressor may leak into the cooling circuit. F or this reason, allow the appliance to rest in a vertical position for 12 hours before turning it on, so that the oil ows ba ...
-
Philco PSF 341 - page 9
EN - 7 07/2011 Copyright © 2011, Fast ČR, a. s. Location The location for the placement of the applianc e must meet the requirements in the par agraph "Operating conditions" and must have a stable oor with a load bearing capacity corresponding to the weight of the appliance. F urthermore you must maintain distances and dimensions of ...
-
Philco PSF 341 - page 10
EN - 8 07/2011 Copyright © 2011, Fast ČR, a. s. Cleaning before use Check that you have r emoved from the applianc e all adhesive tape used to hold accessories . Then clean all the inside parts using lukewarm water with a neutral cleaning agent, vinegar or sodium carbonate – in this way you will remov e the characteristic odour of new parts – ...
-
Philco PSF 341 - page 11
EN - 9 07/2011 Copyright © 2011, Fast ČR, a. s. Proc edure for switching the door opening direction The freezer is assembled with the door hinges on the right hand side . If you wish to change the door opening direction, follow the instructions below: 1. First r emove the top hinge co ver (6). 2. Remov e t wo screws (1) fastening the t op hinge ( ...
-
Philco PSF 341 - page 12
EN - 10 07/2011 Copyright © 2011, Fast ČR, a. s. P ART 4: SET TING THE TEMPERA TURE Set the temperature in the freezer using the temperatur e control knob. The thermostat control module is connected to the compressor . Turn the temperatur e control knob upwards or downwar ds and set the temperature inside the freez er . T emperature set to the lo ...
-
Philco PSF 341 - page 13
EN - 11 07/2011 Copyright © 2011, Fast ČR, a. s. P ART 5: ARR ANGEMENT OF FOOD Appropriate wrapping materials f or food are plastic containers , aluminium foil, poly ethylene freezing bags, etc. Always allow hot dishes to c ool down before placing them into the fr eezer . Open the door only for a short time so that the inside ...
-
Philco PSF 341 - page 14
EN - 12 07/2011 Copyright © 2011, Fast ČR, a. s. Push all air out of the packages. T o close the packages use rubber bands, plastic clips, tie wire or adhesive tape r esistant to cold. Plastic bags and tubes can also be closed using a food sealing appliance. On the closed package write down the contents, weight and dat ...
-
Philco PSF 341 - page 15
EN - 13 07/2011 Copyright © 2011, Fast ČR, a. s. P ART 6: DEFROSTING Disconnect the power cord fr om the power socket. Open the doors and take out all the food and plac e it in a cool place. Using the plastic scraper r emove the ice fr om the walls of the freezer or allow the ice t o naturally melt away . T hen wipe out the remaining ice and wate ...
-
Philco PSF 341 - page 16
EN - 14 07/2011 Copyright © 2011, Fast ČR, a. s. P ART 7: REGUL AR MAINTENANCE Cleaning the freezer Before starting to clean the freezer disconnect it from the po wer source . Use a clean sponge or a soft cloth and a gentle washing detergent dissolved in warm water . Do not use coarse or abrasive cleaning products. W ash the freezer well and wipe ...
-
Philco PSF 341 - page 17
EN - 15 07/2011 Copyright © 2011, Fast ČR, a. s. Please be aware: Compressor The compressor is contr olled by the thermostat, which is set by the temperature dial , and turns itself on automatically when temperatures inside the appliance is ex ceeded and then turns itself o as soon as it again reaches this temperature . When any compressor – ...
-
Philco PSF 341 - page 18
EN - 16 07/2011 Copyright © 2011, Fast ČR, a. s. P ART 8: WHA T SHOULD I DO WHEN... a) T he appliance is not w orking. Please check the following: Is the power plug in good condition and pr operly plugged into the power socket? Is there electricity owing into the power cord? (Check this possibility by connecting a small applianc ...
-
Philco PSF 341 - page 19
EN - 17 07/2011 Copyright © 2011, Fast ČR, a. s. e) T he appliance is too loud. Is the appliance standing rmly on the oor , is the operation of the appliance causing vibrations of nearby furniture or other objects? Check that all the parts mounted on the rear wall can vibrate freely . Carefully mov e the contact par t away o ...
-
Philco PSF 341 - page 20
EN - 18 07/2011 Copyright © 2011, Fast ČR, a. s. P ART 9: R A TING LABEL /TECHNICAL SPECIFICA TIONS The rating label with all the technical speci cations is located on the side of the inside wall or on the rear side of the appliance. T echnical speci cations Model PSF 341 Climatic class N Net volume 34 l Operating voltage 220 – 240 V ~ 50 ...
-
Philco PSF 341 - page 21
EN - 19 07/2011 Copyright © 2011, Fast ČR, a. s. INSTRUCTIONS AND INFORMA TION REGARDING THE DISPOSAL OF USED P A CKAGING MA TERIALS Dispose of packaging material at a public waste disposal site. DISPOSAL OF USED ELECTRICAL AND ELEC TRONIC APPLIANCES The meaning of the symbol on the product, its accessory or packaging indicates that this product ...
-
Philco PSF 341 - page 22
EN - 20 07/2011 Copyright © 2011, Fast ČR, a. s. NO TES ...
-
Philco PSF 341 - page 23
EN - 21 07/2011 Copyright © 2011, Fast ČR, a. s. NO TES ...
-
Philco PSF 341 - page 24
EN - 22 07/2011 Copyright © 2011, Fast ČR, a. s. ...
У вас вопрос, касающийся Philco PSF 341?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Philco PSF 341, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Philco PSF 341 со всей вероятностью он захочет поделиться методом ее решения.