-
Vulcan-Hart ECO4D ML-52502 - page 1
ECO4D FORM 30932 Rev. C (2-99) MODEL ECO4S ML-52501 ECO4D ML-52502 ECO4C ML-52503 ECO6D ML-52504 ECO6C ML-52505 ECO SERIES ELECTRIC CONVECTION OVENS INST ALLA TION & OPERA TION MANUAL VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201-0696, TEL. (502) 778-2791 ...
-
Vulcan-Hart ECO4D ML-52502 - page 2
– 2 – T ABLE OF CONTENTS GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...
-
Vulcan-Hart ECO4D ML-52502 - page 3
– 3 – Installation, Operation And Care Of ECO SERIES ELECTRIC CONVECTION OVENS KEEP THESE INSTRUCTIONS FOR FUTURE USE Your Vulcan Electric Convection Oven is produced with quality workmanship and material. Proper installation, usage and maintenance of your oven will result in many years of satisfactory performance. The manufacturer suggests tha ...
-
Vulcan-Hart ECO4D ML-52502 - page 4
– 4 – INST ALLA TION UNPACKING Immediately after unpacking the oven, check for possible shipping damage. If this oven is found to be damaged, save the packaging material and contact the carrier within 15 days of delivery. Prior to installation, verify that the electrical service agrees with the specifications on the oven data plate, located on ...
-
Vulcan-Hart ECO4D ML-52502 - page 5
– 5 – 3. Mount the oven on top of the stand or cabinet (Fig. 1). Assembling the Chimney and Flue Extension Remove the oven chimney and flue extension from the rear of the oven (motor compartment) and use the screws provided to fasten the chimney to the top rear of the oven. The flanges on the chimney are to be positioned under the top cover. Al ...
-
Vulcan-Hart ECO4D ML-52502 - page 6
– 6 – CASTERS If the oven is to be installed on casters, assemble the casters to the legs provided. Place the locking casters on the front legs and non-locking casters on the rear legs. ASSEMBLING STACKED OVENS 1. Unpack the ovens and stack kit. Position one oven on its back for access to the oven bottom, taking care not to scratch or damage it ...
-
Vulcan-Hart ECO4D ML-52502 - page 7
– 7 – Electrical Connections WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL ELECTRICAL CODES. WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE DISCONNECT SWITCH TO INDICATE THAT YOU ARE WORKING ON THE CIRCUIT. Ensure that the electrical ...
-
Vulcan-Hart ECO4D ML-52502 - page 8
– 8 – PL-51827 O FF O N TURN GAS VALVE "ON" PUSH MASTER SWITCH TO "ON" POSTION. IF OVEN DISCONNECT SUPPLY BEFORE CHANGING FUSES, CLEANING OR ANY OTHER SERVICE 15 AMP CLASS G FUSES WARNING O N O FF O N O FF O FF TH E RM O S T AT P UL L TO O P EN V EN T H I LO W O VE N C O O L 2 SP EE D M O TO R O V EN LA M P S M AS TE R SW IT ...
-
Vulcan-Hart ECO4D ML-52502 - page 9
– 9 – 2-SPEED MOTOR — LO / HI — Adjusts air velocity in the oven. Use the HI setting as the usual operating speed and the LO setting for delicate product like meringue which might be blown around in the oven. FUSE HOLDERS — Replace fuses with appropriate type described on control panel. MOISTURE VENT DAMPER — Located to the upper left o ...
-
Vulcan-Hart ECO4D ML-52502 - page 10
– 10 – PL-51829 TURN GAS VALVE "ON" PUSH MASTER SWITCH TO "ON" POSTION. IF OVEN DISCONNECT SUPPLY BEFORE CHANGING FUSES, CLEANING OR ANY OTHER SERVICE 15 AMP CLASS G FUSES WARNING HEAT HOLD ROAST READY BAKE TIME H I LO W OFF ON POWER OVEN DOWN TIME TIME TIME TIME TEMPERA TURE GENTLE STAR T STOP FAN SPE ED LIGHTS OFF ON THERM ...
-
Vulcan-Hart ECO4D ML-52502 - page 11
– 11 – Temperature Knob (When Not Timing Product) 1. Sets the roast temperature when the Roast Button light is lit. The Roast Button light can be turned on by pressing the Roast Button. 2. Sets the hold temperature when the Hold Button light is lit. The Hold Button light can be turned on by pressing the Hold Button. Temperature Knob (When Timin ...
-
Vulcan-Hart ECO4D ML-52502 - page 12
– 12 – Thermometer Button When pressed, causes actual cavity temperature to display for about 8 seconds, then display returns to set temperature. Heat Light When lit, indicates that power is being supplied to the heating elements. Ready Light Will be lit any time the actual temperature is within +/- 5 ° F (+/- 2.7 ° C) of the set temperature ...
-
Vulcan-Hart ECO4D ML-52502 - page 13
– 13 – Gentle Bake Button Selects the gentle bake time setting. A roast time must be set first. The gentle bake time can then be set equal to or less than the roast time. The gentle bake time will be the portion of roast time to operate in the gentle bake mode. Gentle bake mode will start first. When gentle bake time elapses, the remainder of t ...
-
Vulcan-Hart ECO4D ML-52502 - page 14
– 14 – BEFORE FIRST USE Before using the oven for the first time, it must be "burned in" to release any odors that might result from heating the new surfaces in the chamber. 1. Using a clean damp cloth, wipe the inside of the oven, including the racks. 2. Close the oven doors, push the On/Off/Oven Cool switch to the ON position, turn ...
-
Vulcan-Hart ECO4D ML-52502 - page 15
– 15 – Cooking 1. Open doors and load the product into the oven. Place pans in the center of the racks. Close doors. 2. Set Roast temperature and time. Set Hold temperature and Gentle Bake time, if desired. Gentle Bake time may not be more than roast time. Gentle Bake will cycle the fan during the set time at the beginning of the cooking cycle. ...
-
Vulcan-Hart ECO4D ML-52502 - page 16
– 16 – 400 º F 300 º F 200 º F 100 º F ROAST AND HOLD DIAGRAM - Time vs. Temperature SHORT BEEP. TIMER DISPLAY FLASHES 00:00. ROAST THERMOSTAT OFF. HEATERS OFF UNTIL HOLD TEMPERATURE IS REACHED. LONG BEEP (20 SEC.) HEATERS MAINTAIN HOLD TEMPERATURE. TIMER DISPLAY COUNTS UP HOLD TIME AND FLASHES "HOLD." OVEN TEMPERATURE TIMER DISPL ...
-
Vulcan-Hart ECO4D ML-52502 - page 17
– 17 – COOKING GUIDELINES — MODELS ECO4S AND ECO4D/ECO6D OVENS PRODUCT TEMPERATURE TIME NUMBER OF RACKS ° F ( ° C) (MIN.) BREAD PRODUCTS Bread (24, 1-lb. loaves) (454 gr.) 340 (171) 30 3 (every other rack starting with bottom rack) Hamburger Rolls 300 (149) 15 5 Corn Bread 335 (168) 25 5 Yeast Rolls 325 (163) 25 5 Baking Soda Biscuits 400 ( ...
-
Vulcan-Hart ECO4D ML-52502 - page 18
– 18 – TIMER SETTINGS FOR ROLLED BEEF ROASTS — MODEL ECO4C/ECO6C OVENS ROAST TEMPERATURE 200 ° F (93 ° C) 250 ° F (121 ° C) 300 ° F (149 ° C) HOLD TEMPERATURE 140 ° F (60 ° C) DONENESS RARE MEDIUM RARE MEDIUM RARE MEDIUM WEIGHT OF ROAST POUNDS HOURS:MINUTES 8 2:40 3:45 1:45 2:20 1:20 1:40 9 2:50 3:58 1:50 2:25 1:25 1:50 10 3:00 4:15 2 ...
-
Vulcan-Hart ECO4D ML-52502 - page 19
– 19 – POWER OUTAGE In case of a power outage, the oven will automatically shut down. When power is restored to the lines, the oven will resume its normal operation. However, if the oven is to be left unattended during a power outage, push the master switch to the OFF position. When power is restored to the lines, push master switch to the ON p ...
-
Vulcan-Hart ECO4D ML-52502 - page 20
– 20 – FORM 30932 Rev. C (2-99) PRINTED IN U.S.A. MAINTENANCE WARNING: TURN OVEN OFF AND UNPLUG POWER SUPPLY CORD BEFORE PERFORMING ANY MAINTENANCE. The fan motor comes with sealed bearings and requires no lubrication. Annually check the flue, when cool, to be sure it is free of obstructions. REPLACING LAMPS • Allow oven to cool. • Remove a ...
У вас вопрос, касающийся Vulcan-Hart ECO4D ML-52502?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Vulcan-Hart ECO4D ML-52502, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Vulcan-Hart ECO4D ML-52502 со всей вероятностью он захочет поделиться методом ее решения.