-
Husqvarna 323RJ, 325RJX-Series - page 1
E E E E n n n n g g g g l l l l i i i i s s s s h h h h 323RJ 325RJ X-series Oper ator’ s manual (EP A) Please read the operator’ s man ual carefully and mak e sure you understand the instructions before using the machine. ...
-
Husqvarna 323RJ, 325RJX-Series - page 2
2 – English KEY T O SYMBOLS Symbols W ARNING! Clear ing saws , brushcutters and trimmers can be dangerous! Careless or incorrect use can result in serious or fatal injur y to the operator or others. Please read the operator’ s manual carefully and make sure y ou understand the instructions before using the machine . Alwa ys wear : • A protect ...
-
Husqvarna 323RJ, 325RJX-Series - page 3
English – 3 CONTENTS Contents Note the f ollowing bef ore star ting: Husqvarna AB has a policy of continuous product de velopment and theref ore reser ves the right to modify the design and appearance of products without prior notice. Maintenance, replacement, or repair of the emission control de vices and system ma y be performed by an y nonroad ...
-
Husqvarna 323RJ, 325RJX-Series - page 4
4 – English SAFETY INSTR UCTIONS P ersonal pr otective equipment GLO VES Gloves should be w orn when necessar y , e.g., when fitting cutting attachments. HEARING PRO TECTION W ear hearing protection that provides adequate noise reduction. EYE PRO TECTION Alwa ys wear appro ved e ye protection. If you use a visor then y ou must also wear approv e ...
-
Husqvarna 323RJ, 325RJX-Series - page 5
English – 5 SAFETY INSTR UCTIONS Vibration damping system Y our machine is equipped with a vibration damping system that is designed to minimize vibration and mak e operation easier . Use of incorrectly wound cord or an incorrect cutting attachment increases the le vel of vibr ation. The machine ′ s vibration damping system reduces the transf e ...
-
Husqvarna 323RJ, 325RJX-Series - page 6
6 – English SAFETY INSTR UCTIONS Chec king, maintaining and servicing the machine ′′ ′ ′ s safety equipment Throttle loc k • Make sure the throttle control is loc ked at the idle setting when the throttle lock is released. • Press the throttle lock and mak e sure it retur ns to its original position when you release it. • Check that ...
-
Husqvarna 323RJ, 325RJX-Series - page 7
English – 7 SAFETY INSTR UCTIONS • Regularly check that the muffler is securely attached to the machine. • If the muffler on y our machine is fitted with a spark arrestor mesh then it should be cleaned regularly . A bloc ked mesh causes the engine to ov erheat, which can lead to serious damage. Nev er use a muffler with a def ective spark ...
-
Husqvarna 323RJ, 325RJX-Series - page 8
8 – English SAFETY INSTR UCTIONS Cutting equipment Sharpening grass cutters and grass blades • See the cutting attachment packaging f or correct shar pening instructions. • Shar pen blades and cutters using a single-cut flat file . • Shar pen all edges equally to maintain the balance of the blade . T rimmer head • Only use the recommend ...
-
Husqvarna 323RJ, 325RJX-Series - page 9
English – 9 SAFETY INSTR UCTIONS General safety precautions Starting • The complete clutch cov er and shaft must be fitted before the machine is star ted, otherwise the clutch can come loose and cause personal injur y . • Ne ver start the machine indoors. Exhaust fumes can be dangerous if inhaled. • Obser ve y our surroundings and make sur ...
-
Husqvarna 323RJ, 325RJX-Series - page 10
10 – English SAFETY INSTR UCTIONS • The transpor t guard must alwa ys be fitted to the cutting attachment when the machine is being transpor ted or in storage. General w orking instructions Basic safety rules 1 Look around you: • T o ensure that people, animals or other things cannot aff ect your control of the machine . • T o ensure that ...
-
Husqvarna 323RJ, 325RJX-Series - page 11
English – 11 SAFETY INSTR UCTIONS Grass trimming using a trimmer head and plastic blades T rimming • Hold the trimmer head just above the g round at an angle. It is the end of the cord that does the work. Let the cord work at its own pace. Nev er press the cord into the area to be cut. • The cord can easily remov e grass and weeds up against ...
-
Husqvarna 323RJ, 325RJX-Series - page 12
12 – English WHA T IS WHA T? What is what on the trimmer? 28 29 27 23 20 24 1 T r immer head 2 Grease filler cap , be v el gear 3 Be vel gear 4 Cutting attachment guard 5 Shaft 6 Loop handle 7 Throttle control 8 Stop s witch 9 Throttle lock 10 Cylinder cov er 11 Star ter handle 12 Fuel tank 13 Choke control 14 Air purge 15 Air filter cov er 16 ...
-
Husqvarna 323RJ, 325RJX-Series - page 13
English – 13 ASSEMBL Y Fitting the J-handle • Clip the loop handle onto the shaft. Note that the loop handle must be fitted between the arro ws on the shaft. • Slide the spacer into the slot in the loop handle. • Fit the nut, knob and scre w . Do not overtighten. • Attach the J-handle to the loop handle using the three screws , as shown. ...
-
Husqvarna 323RJ, 325RJX-Series - page 14
14 – English ASSEMBL Y Fitting the blade guar d/combination guar d, grass blade and grass cutter • Hook the blade guard/combination guard (A) onto the fitting on the shaft and secure with the bolt. CA UTION! Use the recommended blade guard. See the T echnical data section. • Fit the drive disc (B) on the output shaft. • T ur n the blade sh ...
-
Husqvarna 323RJ, 325RJX-Series - page 15
English – 15 FUEL HANDLING Fuel CA UTION! The machine is equipped with a two-strok e engine and must alwa ys been run using a mixture of gasoline and two-strok e engine oil. It is impor tant to accurately measure the amount of oil to be mix ed to ensure that the correct mixture is obtained. When mixing small amounts of fuel, e ven small inaccurac ...
-
Husqvarna 323RJ, 325RJX-Series - page 16
16 – English FUEL HANDLING Fuelling • Clean the area around the fuel cap . Contamination in the tank can cause operating prob lems. • Ensure that the fuel is well mix ed by shaking the container bef ore filling the tank. ! W ARNING! T aking the following precautions, will lessen the risk of fire: Do not smoke or place hot objects near fuel. ...
-
Husqvarna 323RJ, 325RJX-Series - page 17
English – 17 ST AR TING AND ST OPPING Chec k bef ore star ting F or saf ety reasons follo w these recommendations! • Check the b lade to ensure that no cracks hav e formed at the bottom of the teeth or by the centre hole . The most common reason wh y crac ks are formed is that sharp corners have been f or med at the bottom of the teeth while sh ...
-
Husqvarna 323RJ, 325RJX-Series - page 18
18 – English ST AR TING AND ST OPPING Hold the body of the machine on the ground using y our left hand (CA UTION! Not with your f oot!). Grip the star ter handle, slowly pull out the cord with y our right hand until you f eel some resistance (the star ter pawls grip), now quic kly and powerfully pull the cord. Never wrap the starter cord around y ...
-
Husqvarna 323RJ, 325RJX-Series - page 19
English – 19 MAINTENANCE Carb urettor Y our Husqv arna product has been designed and manuf actured to specifications that reduce har mful emissions. After the engine has used 8-10 tanks of fuel the engine will be run-in. T o ensure that it continues to run at peak perf ormance and to minimise har mful exhaust emissions after the running-in per i ...
-
Husqvarna 323RJ, 325RJX-Series - page 20
20 – English MAINTENANCE Fine adjustment of the idle speed T Adjust the idle speed using the idle adjustment screw T , if it is necessar y to readjust. First tur n the idle adjustment screw T clockwise until the cutting attachment starts to rotate. Then turn the screw anticlockwise until the cutting attachment stops. The idle speed is correctly a ...
-
Husqvarna 323RJ, 325RJX-Series - page 21
English – 21 MAINTENANCE Cooling system T o keep the working temperature as low as possib le the machine is equipped with a cooling system. The cooling system consists of: 1 Air intake on the starter . 2 Fins on the flywheel. 3 Cooling fins on the cylinder . 4 Cylinder cov er (directs cold air over the cylinder). Clean the cooling system with a ...
-
Husqvarna 323RJ, 325RJX-Series - page 22
22 – English MAINTENANCE Bevel gear The be vel gear is filled with the right quantity of grease at the f actor y . Howe ver , before using the machine y ou should check that the be vel gear is filled three-quarters full with grease. Use HUSQV ARNA special grease. The grease in the be vel gear does not normally need to be changed e xcept if repa ...
-
Husqvarna 323RJ, 325RJX-Series - page 23
English – 23 TECHNICAL D A T A T echnical data NO TE! Noise pressure at the user’s ear and vibr ation on the handles are measured with all the machine’ s approved cutting equipment fitted. The table indicates the highest and lowest v alues. Note 1: Equivalent noise pressure le v el is calculated as the time-weighted energy total f or noise p ...
-
Husqvarna 323RJ, 325RJX-Series - page 24
24 – English FEDERAL EMISSION CONTR OL W ARRANTY ST A TEMENT Y OUR W ARRANTY RIGHTS AND OBLIGA TIONS The EP A (The US Environmental Protection Agency), Environment Canada and Husqv ar na Forest & Garden are pleased to e xplain the emissions control system warranty on your 2001 and later small nonroad engine . In U .S. and Canada, new small no ...
-
Husqvarna 323RJ, 325RJX-Series - page 25
1 Super Auto II Super Auto II 1 2 3 4 5 6 7 8 9 10 4,0 m 13' 2,4 mm .095" ~2,0 m 6,5 ' 6 " 6 " " 15 cm 15 cm ...
-
Husqvarna 323RJ, 325RJX-Series - page 26
...
-
Husqvarna 323RJ, 325RJX-Series - page 27
1 T rimmy H II 2 3 4 5 6 7 8 9 7,5 m 25' 2,0-2,4 mm .080-.095" 1 2 15 cm 6" ~ 3,7 m 12' 15 cm 6" ...
-
Husqvarna 323RJ, 325RJX-Series - page 28
1 T rimmy Hit 23 4 5 6 7 8 9 10 11 “Click” “Click” 7,0 m 23' " 12 cm 5" ~ 3,5 m 1 1' 15 cm 6 " " 2,0-2,4 mm .080-.095 ~ 15 cm 6 ...
-
Husqvarna 323RJ, 325RJX-Series - page 29
1 T rimmy Hit Pro 2 5 6 7 8 9 10 12 “Click” 3 4 7,5 m 25' 2,0-2,4 mm .080-.095" 15 cm 6" ~ 3,7 m 12' 1.) 2.) 11 15 cm 6" 15 cm 6" ...
-
Husqvarna 323RJ, 325RJX-Series - page 30
"Clic" 1 2 3 5 6 7 10 11 8,5 m 28' 4 8 4,2 m 14' 2,4-2,7 mm .095-.106" 10 cm 4" 6" 15 cm S35 ...
-
Husqvarna 323RJ, 325RJX-Series - page 31
1 2 4 3 2,4-2,7 mm .095-.106" 4,25 m 14' 4,25 m 14' B 6" 15 cm A 6" 15 cm S35 5 ...
-
Husqvarna 323RJ, 325RJX-Series - page 32
T35 "Clic" 1 2 3 5 6 7 9 8,5 m 28' 4 8 4,3 m 14' 2,4-2,7 mm .095-.106" 10 cm 4" 6" 15 cm ...
-
Husqvarna 323RJ, 325RJX-Series - page 33
...
-
Husqvarna 323RJ, 325RJX-Series - page 34
´®z+H;)¶5|¨ ´®z+H;)¶5|¨ ...
-
Husqvarna 323RJ, 325RJX-Series - page 35
...
-
Husqvarna 323RJ, 325RJX-Series - page 36
´®z+H;)¶5|¨ 2004-03-25 ´®z+H;)¶5|¨ 1140270-95 ...
У вас вопрос, касающийся Husqvarna 323RJ, 325RJX-Series?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Husqvarna 323RJ, 325RJX-Series, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Husqvarna 323RJ, 325RJX-Series со всей вероятностью он захочет поделиться методом ее решения.