-
La Crosse Technology WS-7395U - page 1
WS-7395U Wireless 433 MHz Radio-controlled Weather Station Instruction Manual ...
-
La Crosse Technology WS-7395U - page 2
2 TABLE OF CONTENTS Topic Page Inventory of Contents/ Additional Equipm ent 3 About WWVB 3 Quick Set-Up Guide 4 Detailed Set-Up Guide Battery installation 5 Program Mode Program Sequence and Default Sett ings 6 Function Keys 6 Setting the LCD Contrast 6-7 Setting the Tim e Zone 7 Daylight Saving Ti me Sett ing 7 Radio-controlled Ti me Setti ng 7 12 ...
-
La Crosse Technology WS-7395U - page 3
3 INVENTORY OF CONTENTS 1. The WS-7395U weather station (Figure 1). 2. One TX8U remote tem perature/hum idity sensor (Figure 2). 3. One TX15U wind speed sensor (Figure 3). 4. Mounting hardware 5. Instruction m anual and warranty card. ADDITIONAL EQUIPMENT (not included) 1. Three fresh AA 1.5V batteries for the indoor weat her station. 2. Two fresh ...
-
La Crosse Technology WS-7395U - page 4
4 QUICK SET-UP GUIDE Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. 1. Have the indoor weather station, rem ote tem perature/humi dity sensor and wind speed sensor 3 to 5 feet apart . 2. Insert the telephone plug (RJ-11) from the wind speed sensor into the receptacle on the remote tem perature/humidity sensor. 3. Batter ...
-
La Crosse Technology WS-7395U - page 5
5 DETAILED SET-UP GUIDE BATTERY INSTALLATION The first step to powerin g up the weather station is to insert th e connector (RJ11) at the end of the wire attached to the wind speed sensor to the remote temperature/humidity se nsor. Please ensure when doing this that the connector is inse rted with the proper orientation. When seated properly you wi ...
-
La Crosse Technology WS-7395U - page 6
6 PROGRAM MODE Programming Note: If 30 seconds are allowed to pass, or the WIND/SNZ button is pressed during the program mi ng mode, the unit will confirm/set the last information en tered—the display will stop flashin g and return to normal time-date readings. If y ou don’t leave the program m ode during the program ming of sections IV through ...
-
La Crosse Technology WS-7395U - page 7
7 3. Press and release the ALM/+ button to select the le vel you desire. 4. Press and release the SET button to con f irm and ad vance to the Time Zone setting. IV. TIME ZONE SETTING 1. Press and hold the SET button for 5 seconds. 2. “LCD” will show in th e TIME LCD and the number setting will flash . 3. Press and release the SET button again. ...
-
La Crosse Technology WS-7395U - page 8
8 VII. 12 OR 24 HOUR TIME SETTING 1. Press and hold the SET button for 5 seconds. 2. “LCD” will show in th e TIME LCD and the number setting will flash . 3. Press and release the SET button four tim es. 4. “12h” or “24h” will flash in the DATE LCD. 5. Press and release the ALM/+ button to select 12 or 24-hour t ime form at. Note: When i ...
-
La Crosse Technology WS-7395U - page 9
9 IX. SETTING THE YEAR, DAY AND MONTH Note: Reception of the WWVB signal will al so set the date and day. The recep tion of the signal will override any programm ed date and day. 1. Press and hold the SET button for 5 seconds. 2. “LCD” will show in th e TIME LCD and the number setting will flash . 3. Press and release the SET button seven tim e ...
-
La Crosse Technology WS-7395U - page 10
10 XII. SETTING THE FORECAST SENSITIVITY Note: The forecast sensitivity can be adjusted to allo w for areas that have a higher or low er sensitivity to changing air pr essure (for example coastal areas have more pressure change than ar eas such as southern Arizona). The numbers correspond to the amount of air pressure change necessary to trigger a ...
-
La Crosse Technology WS-7395U - page 11
11 I. WEATHER FORECAST The weather forecasting feature is estimated to be 75% accurate and is for the next 12 to 24 hours. The weather forecast is based solely upon the change of air pressure over tim e. The WS-7395U averages past air-pressure readings to provide an accurate forecast—creating a necessity to disregard all weather forecasting for 1 ...
-
La Crosse Technology WS-7395U - page 12
12 2. Press and release the IN/HR button again (once w hile “MAX” is still displayed, twice oth erwise). “MIN” appears to the right of the indoor tem perature, indicati ng that the mini mum t emperature (along with the humidity measured at that tim e) and the time and date of occurrence are displayed. 3. While “MIN” is still displayed p ...
-
La Crosse Technology WS-7395U - page 13
13 V. MOON PHASE There are 12 moon phases shown on the indoor weather st ation; the black port ion signifies the porti on of the moon visibl e in the sky. Thus, when the moon i con is all black, i t is a full m oon. VI. VIEWING THE CURRENT, MAXIMUM AND MINUMUM DEW POINT To view the current dew p oint: 1. Press and hold the OUT/MIN but ton for 5 sec ...
-
La Crosse Technology WS-7395U - page 14
14 To view the current wind chill: 1. Press and release the WIND/SNZ button. 2. The wind chill v alu e will display at the bottom of th e WIND SPEED LCD. To view the maximum and minimum wind/wind chill values: 1. Press and hold the WIND/SNZ button for 3 seconds. 2. The WIND SPEED LCD w ill now show the maximum wind. 3. Press and release the WIND/SN ...
-
La Crosse Technology WS-7395U - page 15
15 mph km/hr knots 0 <1 <1 <1 Calm Still, calm air, smoke will rise vertically . Water is mirror-like. 1 1-3 mph 1-5 kph 1-3 knots Light Air Rising smoke drifts, wind vane is inactive. Small ripples appear on water surface. 2 4-7 mph 6-11 kph 4-6 knots Light Breeze Leaves rustle, can feel wind on your face, wind vanes begin to move. Small ...
-
La Crosse Technology WS-7395U - page 16
16 High waves (6 meters), rolling seas, dense foam, Blowing spray reduces visibility. 10 55-63 mph 89-102 kph 48-55 knots Whole Gale or Storm Trees are broken or uprooted, building damage is considerable. Large waves (6-9 meters), overhanging crests, sea becomes white with foam, heavy rolling, reduced visibility. 11 64-72 mph 103-117 kph 56-63 knot ...
-
La Crosse Technology WS-7395U - page 17
17 Note: Before permanently mounting ensure that the indoor weather station is able to receive WWVB signals from the desired location. Also, extreme and sudde n changes in temperature w ill decrease the accuracy of th e indoor weather station, and changes in elevation will result with inaccurate weather forecasting for the ne xt 12 to 24 hours. The ...
-
La Crosse Technology WS-7395U - page 18
18 II. THE REMOTE WIND SPEED SENSOR The remote wind speed sensor can be m ounted two ways: • With the use o f screws • Using nylon straps A. MOUNTING WITH SCREWS 1) Unlock the mounti ng bracket from the rem ote wind speed sensor leaving t he wire going through the bracket. 2) Place the mounting bracket over the desired location. 3) Through the ...
-
La Crosse Technology WS-7395U - page 19
19 TROUBLESHOOTING NOTE: For problems not solved, please cont act La Crosse Technology. Problem: No reception of WWVB time signal. Solution: 1) Wait overnight for signal. 2) Be sure indoor weather station is at least 6 feet from any electrical devices, such as t elevisions, com puters, or other radi o- controlled clocks. 3) Remove batteri es for fi ...
-
La Crosse Technology WS-7395U - page 20
20 displayed if out side range Indoor relative hum idity measuring range: 1% to 99% with 1 % resolution (“- -” displayed if out side this range Outdoor relative hum idity measuring range: 1% to 99% with 1% resolution (“- - “ displayed if out side this range Wind speed measuring range: 0 to 111.8 mph (0 to 50 m /s) Weather data checking inte ...
-
La Crosse Technology WS-7395U - page 21
21 performance of repairs or alterations by someone other than an authorized La Crosse Technology, Ltd authorized service center; (6) units used for other than home use (7) applic ations and uses that this product was not intended or (8) the products inability t o receive a signal due to any source of interference.. This warranty cove rs only actua ...
У вас вопрос, касающийся La Crosse Technology WS-7395U?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с La Crosse Technology WS-7395U, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с La Crosse Technology WS-7395U со всей вероятностью он захочет поделиться методом ее решения.