-
Tote Vision LCD-1700VRQ - page 1
...
-
Tote Vision LCD-1700VRQ - page 2
...
-
Tote Vision LCD-1700VRQ - page 3
17” Quad display LCD monitor ______________________ 1 CHAPT ER 1 I NTRODUCTION BEFORE INSTALLING YO UR MONITOR READ THIS MANUAL COV ER TO COVER. PAY ATTENTION to all WARNING and CAUTIONS DO NOT use computer components not recommend by the manufacture Do not attempt to service the monitor your self. If a problem occu rs, contact the manufacture&ap ...
-
Tote Vision LCD-1700VRQ - page 4
________________________ 17” Qua d display LCD monitor 2 FACTORY - PRESET MODES Table 1 shows standard video mode setting that have been pre - adjusted at the factory for accurate video display. These setting are stored in the monitor's memory Table 1. Factory - Preset Modes Mode Resolution H - Freq.(KHz) V - Freq(Hz) NEC 640x400 24.83 56.4 ...
-
Tote Vision LCD-1700VRQ - page 5
17” Quad display LCD monitor ______________________ 3 S PECIFICATIONS l LCD - 1700VR Q 17” LCD Monitor Overall Dimension (HxWxD): 483 x 354 x 50.3 mm Shipping Weight (G/W): 9 Kg Effective Display area (H/V): 337.92 x 270.34 mm Display colors: 16.7M colors Scan Frequencies: Horizontal 31.47K to 80KHz Vertical 60Hz to 75Hz Numb er of Pixels: 1280 ...
-
Tote Vision LCD-1700VRQ - page 6
________________________ 17” Qua d display LCD monitor 4 Compatibility: IBM and compatibl e, Apple Macintosh, NEC Environmental Limits: Operating Temp 32 ° to 104 ° F ( 0 ° to 40 ° C ) Storage Temp. - 4 ° to 140 ° F ( - 20 ° to 60 ° C ) Operating Humidity 10 to 85% without condensation Storage Humidity 10 to 95% without Condensation Agenc ...
-
Tote Vision LCD-1700VRQ - page 7
17” Quad display LCD monitor ______________________ 5 Chapter 2 P RODUCT P ACKAGE Open the shipping carton and check the contents. If any items are missing or damaged, contact your dealer immediately. The package should include the following items l 8U 17” Color TF T LCD Monitor l Accessory Box: 1. VGA cable x 1 2. AC to DC adapter x 1 3. Power ...
-
Tote Vision LCD-1700VRQ - page 8
________________________ 17” Qua d display LCD monitor 6 FOLLOW THESE STEPS T O INSTALL THE MONITOR 1. Before you connect the cables, make sure that the monitor and the system unit power switches are OFF 2. Plug one end of the 15pin signal cable to the monitor and the other end to the video signal connector at the rear of the system. Tighten the ...
-
Tote Vision LCD-1700VRQ - page 9
17” Quad display LCD monitor ______________________ 7 C ONTROL F UNCTIONS The OSD control functions of 17” Quad display LCD monitor are located on the lower side. They are shown in the figur e below and described in the following paragraphs. Menu ∇ ∆ - + AV/PC Menu ?/CH1 ?/CH2 - /CH3 +/CH4 = / A U T O X The first line is used for RGB OSD ...
-
Tote Vision LCD-1700VRQ - page 10
________________________ 17” Qua d display LCD monitor 8 Chapter 3 A DJUSTING THE PC MONITOR The LCD monitor is designed to work with a range of compatible video adapters on the market. Due to the possible deviations between these video adapters, you may make some adjustment to fit the monitor for adapter used. ADJUSTMENT PROCEDURE 1. First, you ...
-
Tote Vision LCD-1700VRQ - page 11
17” Quad display LCD monitor ______________________ 9 We had two pages OSD screens; the screens are shown in OSD screen 1 and 2, if you choose the source to video not RGB, please see the next chapter. OSD SCREEN1 1024x768 48KHz 60Hz AUTO ADJUSTMENT S H - POSITION ------------ @ 3 V - POSITION ------------ B PIXEL CLOCK ----------- H H ...
-
Tote Vision LCD-1700VRQ - page 12
________________________ 17” Qua d display LCD monitor 10 OSD SCREEN2 1024x768 48KHz 60Hz PREVIOUS PAGE --- Z Brightness -------------- L RED -------------- R GREEN ---------- G BLUE ------------- B Contrast --------------- M RED -------------- R 0 255 GREEN ---------- G BLUE ------------ B 128 720/640 selection ---- P OSD transpa ren ...
-
Tote Vision LCD-1700VRQ - page 13
17” Quad display LCD monitor ______________________ 11 Adjustment Icon : S Auto - adjustment Automatically adjust the pixel clock, H/V position and fine tune the screen to get bette r visual quality. @ H - position Adjusts the screen's width. The range is from 0 - 255. B V - Position Adjusts the screen's height. The Range is fr ...
-
Tote Vision LCD-1700VRQ - page 14
________________________ 17” Qua d display LCD monitor 12 F OSD V - position Change the OSD Vertical Display location in the screen Y Move to the next OSD screen Z Move to the previous OSD screen [ OSD transparency setting To set the OSD display transparency mode. Load default ] OSD time out timer setting VERTICAL & HORIZO ...
-
Tote Vision LCD-1700VRQ - page 15
17” Quad display LCD monitor ______________________ 13 BRIGHTNESS ADJUSTMEN T 1. Use the ∇ & ∆ key to move the 3 to the L icon, then press ﹣ & + to get the best brightness optimization. Note : We provide another easily method to do the brightness adjustment. You don’t need to activate the OSD screen, just pressing the ﹣ or + ...
-
Tote Vision LCD-1700VRQ - page 16
________________________ 17” Qua d display LCD monitor 14 HOW TO RESTORE THE P RE - DEFINE VALUE R estore your previous define setting 1. Use the ∇ & ∆ key to move the 3 t o t h e icon, then press “ - ” will automatically load the pre - define value for each item. 2. Use this function only if you want to discard your new setting. ...
-
Tote Vision LCD-1700VRQ - page 17
17” Quad display LCD monitor ______________________ 15 CHAPTER 4 ADJUSTING THE SECURI TY SCREEN SETTING The LCD monitor is designed to work with a range of compatible video display on the market. Due to the possible deviations between these video source, you may make some adjustment to fit the monitor for video usage. ADJUSTMENT PROCEDURE 1. Firs ...
-
Tote Vision LCD-1700VRQ - page 18
________________________ 17” Qua d display LCD monitor 16 Security OSD menu setting When your screen is in AV mode, pressing MENU key to enter into OSD set up menu, you will see the following screen SETUP MENU SYSTEM CAMERA ALARM PLAYBACK VERSIO N You can use ?or ? key to move the highlight bar to the desired item, then press = to enter into the ...
-
Tote Vision LCD-1700VRQ - page 19
17” Quad display LCD monitor ______________________ 17 The sub - menu of camera is below CAMERA SETUP CAMERA CAM1 BRIGHTENSS 10 CONTRAST 22 SHARPNESS 55 SAT U 99 SAT V 82 HUE 01 LOAD DEFAULT You can set up each camera brightness, contrast, sharpness, sat U, Sat V and hue setting to the better visual quality. The sub - menu of alarm is below ALARM ...
-
Tote Vision LCD-1700VRQ - page 20
________________________ 17” Qua d display LCD monitor 18 P r e ss i ng t o l e t sc r een t o d i s p l a y 4 c hanne l quad d i s p l a y . X Recording the screen will always set as quad display, When you playback the screen, we offered one hot key to let user to see the full channel # display. For example, if you want to see the playback ch ...
-
Tote Vision LCD-1700VRQ - page 21
17” Quad display LCD monitor ______________________ 19 APPENDIX S IGNAL C ONNECTOR P IN - OUT Power Connector Pin 1 Ground Pin 2 +12V output RGB SIGNAL CONNECT OR Pin 1 Analog Red Input Pin 2 Analog Green Input Pin 3 Analog Blue Input Pin 4 Ground Pin 5 Digital Ground Pin 6 Analog Red Gro und Pin 7 Analog Green Ground Pin 8 Analog Blue Ground Pin ...
У вас вопрос, касающийся Tote Vision LCD-1700VRQ?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Tote Vision LCD-1700VRQ, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Tote Vision LCD-1700VRQ со всей вероятностью он захочет поделиться методом ее решения.