Русский dropdown-ico

Инструкция обслуживания Audiovox 128-7404A

24 страниц 0.22 mb
Скачать

Перейти на страницу of 24

Summary
  • Audiovox 128-7404A - page 1

    128-7404A 1 of 24 Page 1 Model APS-998 Owner ’s Manual IMPORT ANT ! In order to provide you with the highest level of security to your vehicle, this system is equipped with selectable manual override circuitry . It is possible that you will need to override you security system if the transmitter becomes lost, or inoperative due to battery failure ...

  • Audiovox 128-7404A - page 2

    128-7404A 2 of 24 Page 2  Protected Push Button V alet/Override Switch  7-Function LED-Arm / Disarm / Zone 1 / Zone 2 / Zone 3 / V alet / Arming  Intrusion Alert With Memory  Instant Siren Activation  Starter Disable Output  Additional Engine Immobilizer Output, (Optional Relay Required)  True Last Door Arming (Hardwire Only) ? ...

  • Audiovox 128-7404A - page 3

    128-7404A 3 of 24 Page 3 known as a code grabber , which will receive and store the signal from your keychain transmitter and re-transmit at a later time to disarm your system. Y our Keeloq Code Hopping transmitters will change their signal every time the button is pressed, so when a thief grabs then re-transmits your signal, the alarm system will ...

  • Audiovox 128-7404A - page 4

    128-7404A 4 of 24 Page 4  The dash mounted LED begins to flash slowly .  Parking Lights flash one time.  Siren will not sound. If the siren "chirped" three times, sometime after arming, the exclusive delayed dome light learn circuit has been programmed and the system detected a open entry point after the learned delay expired. Cl ...

  • Audiovox 128-7404A - page 5

    128-7404A 5 of 24 Page 5  Any mild impact to the vehicle’s glass will cause the alarm to sound a short series of warning tones.  Any strong impact to the vehicle’s glass will cause the alarm to trigger for the full 30 second alarm cycle. NOTE: If the optional interior illumination circuit was installed, the interior light will flash as we ...

  • Audiovox 128-7404A - page 6

    128-7404A 6 of 24 Page 6  Parking Lights flash two times. If the parking lights flashed three times, then the alarm was triggered in your absence. Before turning the key on, examine the LED to identify which zone was triggered.  Siren will not sound. If the siren sounds 4 chirps, then the alarm was triggered in your absence. Before turning th ...

  • Audiovox 128-7404A - page 7

    128-7404A 7 of 24 Page 7 2. Press and hold the valet pushbutton switch until the dash mounted LED turns on solid. The system will remain in the valet mode. 3. T o return to normal operation, press and release the pushbutton switch any time the ignition is on. NOTE: Always remember to return the system to normal operation. This will ensure that the ...

  • Audiovox 128-7404A - page 8

    128-7404A 8 of 24 Page 8 Custom Code Programming Example: T o Change the code from the factory pre-assigned code of 1 1 to “52” you would do the following: 1. Disarm the system by use of the transmitter or by use of the emergency override sequence. 2. Turn the ignition switch to the on position. 3. Within 10 seconds, press and release the valet ...

  • Audiovox 128-7404A - page 9

    128-7404A 9 of 24 Page 9 1. Turn the ignition key on then off. 2. Within 10 seconds, press and release valet switch three times. 3. If the chirps were on before you started, then you will hear two chirps indicat- ing they have been turned off. If the chirps were off before you started, then you will hear one chirp indicating they have been turned o ...

  • Audiovox 128-7404A - page 10

    128-7404A 10 of 24 Page 10 4. S tage 3 (City Mode) In this mode, the pre-detect chirps will change from six pre-warning tones to a full 10 seconds of warning chirps. The full detect trigger duration will be reduced from 30 seconds to 15 seconds. NOTE: Setting the stage of the shock sensor will be effective for one arming cycle only . Once the syste ...

  • Audiovox 128-7404A - page 11

    128-7404A 11 of 24 Page 11 W ARNING! Be certain that the vehicle is outdoors before using this or any remote vehicle starting device. A running engine produces dangerous carbon monoxide fumes which can be harmful or fatal if prolonged exposure occurs. DO NOT remote start the vehicle if it is garaged. T o Remote S tart The V ehicle: Press and releas ...

  • Audiovox 128-7404A - page 12

    128-7404A 12 of 24 Page 12 3. Within 10 seconds of step 2, activate the RF start command two times. (Push the second channel button of your keychain transmitter 4 times). The parking lights will flash and the siren will chirp 4 times indicating the timed start mode is activated. CANCELING THE AUTOMA TIC ST ART UP TIMER T o cancel the automatic star ...

  • Audiovox 128-7404A - page 13

    128-7404A 13 of 24 Page 13 This security system has an additional feature that can be connected to a number of different optional accessories. Some of the more common uses for this channel are:  Remote Car S tarter  Remote Window Closure  Remote Garage Door Interface T o remotely operate the device indicated, momentarily press, or press an ...

  • Audiovox 128-7404A - page 14

    128-7404A 14 of 24 Page 14 every time the vehicle's engine is turned off. This feature requires the system to be set up for turbo timer during installation. Consult with your installation center to be certain this feature was activated and how long the vehicle will continue to run, 3, 5, or 10 minutes after the ignition switch is turned off. T ...

  • Audiovox 128-7404A - page 15

    128-7404A 15 of 24 Page 15 will indicate count down timer based on the 5, 10, 15, or 20 minute run time set up by your installation center . When the unit shuts off the exhaust indication will turn off and the transmitter will play a melody . If text mode was selected, the screen will scroll the words Engine Running. Note Engine can be started in m ...

  • Audiovox 128-7404A - page 16

    128-7404A 16 of 24 Page 16 true if the transmitter is set for vibrate mode. When the vehicle is armed, and a door is opened, or ajar , the transmitter will chirp 3 times, the lights will flash, and the dis- play will indicate a door trigger as shown on the previous page. In the text mode the word Armed, Door Opened will appear . When the door is cl ...

  • Audiovox 128-7404A - page 17

    128-7404A 17 of 24 Page 17 ADDITIONAL REMOTE FEA TURES: The two way remote control unit allows you to access status information from the vehicle, check temperature, light the display , toggle the transmitter from beep tones to vibrate mode, initiate daily start timer , and temperature start. Selection of these and other features are shown below: NO ...

  • Audiovox 128-7404A - page 18

    128-7404A 18 of 24 Page 18 the transmitter will emit a tone confirming the feature is active. Note: the unit will start once and run for the prescribed time. If you require more frequent starting please refer to auto start up timer mode shown earlier in this guide. NOTE: T o insure accurate 24 Hour S tart up, it is advisable to reset the start time ...

  • Audiovox 128-7404A - page 19

    128-7404A 19 of 24 Page 19 NOTE: Y our system is shipped with two transmitters, 1 two way , shown on the left and the one way transmitter , shown right. The one and two way transmitters are programmed from the factory with separate lock & unlock buttons, the trunk/ key icon button operates remote start and remote trunk release where appli- cabl ...

  • Audiovox 128-7404A - page 20

    128-7404A 20 of 24 Page 20 (j) Y ou can set the Countdow n T imer (k) Y ou can set the Alarm Clock (l) Y ou can set the Clock Y our transmitter has a battery indicator that is shown in the upper right corner of the screen as shown left. This icon indicates a new battery shown with 3 bars. As the battery deteriorates, the bars will disappear . 1 bar ...

  • Audiovox 128-7404A - page 21

    128-7404A 21 of 24 Page 21 Throughout this manual you will find screen shots where they apply if using the two way transmitter . If using the one way transmitter while the two way transmitter is within range of the vehicle, the two way transmitter will update it's screen. Parking Meter Count Down T imer . The transmitter has a built in timer t ...

  • Audiovox 128-7404A - page 22

    128-7404A 22 of 24 Page 22 THIS P AGE LEFT BLANK INTENTIONALL Y ...

  • Audiovox 128-7404A - page 23

    128-7404A 23 of 24 Page 23 APS 998 SYSTEM FUNCTIONS A T A GLANCE DASH LED INDICA TORS RAPID FLASHING = P ASSIVE ARMING/ACTIVE REARMING SLOW FLASHING = ARMED OF F = DISARMED ON SOLID = V ALET MODE 3 FLASH...P AUSE = INT RUSI ON ZON E 3 2 FLASH...P AUSE = INT RUSI ON ZON E 2 1 FLASH...P AUSE = INT RUSI ON ZON E 1 SIREN CHIRP INDICA TORS 1 CHIRP * = A ...

  • Audiovox 128-7404A - page 24

    128-7404A 24 of 24 Page 24 © 2006 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788 128-7404A ...

Производитель Audiovox Категория Remote Starter

Документы, которые мы получаем от производителя устройства Audiovox 128-7404A мы можем разделить на несколько групп. Это в частности:
- технические чертежи Audiovox
- инструкции обслуживания 128-7404A
- паспорта изделия Audiovox
- информационные брошюры
- энергетические этикетки Audiovox 128-7404A
Все из них важны, однако самую важную информацию с точки зрения пользователя мы найдем в инструкции обслуживания Audiovox 128-7404A.

Группа документов, определяемая как инструкции обслуживания, делится также на более подробные типы, такие как: Инструкции монтажа Audiovox 128-7404A, инструкции обслуживания, короткие инструкции или инструкции пользователя Audiovox 128-7404A. В зависимости от потребностей, Вам необходимо поискать требуемый документ. На нашем сайте Вы можете просмотреть самую популярную инструкцию использования изделия Audiovox 128-7404A.

Похожие инструкции обслуживания

Полная инструкция обслуживания устройства Audiovox 128-7404A, как должна выглядеть?
Инструкция обслуживания, определяемая также как пособие пользователя, или просто "руководство" - это технический документ, цель которого заключается в использовании Audiovox 128-7404A пользователями. Инструкции пишет, как правило технический писатель, языком, доступным для всех пользователей Audiovox 128-7404A.

Полная инструкция обслуживания Audiovox, должна заключать несколько основных элементов. Часть из них менее важная, как например: обложка / титульный лист или авторские страницы. Однако остальная часть, должна дать нам важную с точки зрения пользователя информацию.

1. Вступление и рекомендации, как пользоваться инструкцией Audiovox 128-7404A - В начале каждой инструкции, необходимо найти указания, как пользоваться данным пособием. Здесь должна находится информация, касающаяся местонахождения содержания Audiovox 128-7404A, FAQ и самых распространенных проблем - то есть мест, которые чаще всего ищут пользователи в каждой инструкции обслуживания
2. Содержание - индекс всех советов, касающихся Audiovox 128-7404A, которое найдем в данном документе
3. Советы по использованию основных функций устройства Audiovox 128-7404A - которые должны облегчить нам первые шаги во время использования Audiovox 128-7404A
4. Troubleshooting - систематизированный ряд действия, который поможет нам диагностировать а в дальнейшем очередность решения важнейших проблем Audiovox 128-7404A
5. FAQ - чаще всего задаваемые вопросы
6. Контактные данные Информация о том, где искать контактные данные производителя / сервисного центра Audiovox 128-7404A в данной стране, если самостоятельно не получится решить проблему.

У вас вопрос, касающийся Audiovox 128-7404A?

Воспользуйтесь формуляром, находящимся ниже

Если с помощью найденной инструкции Вы не решили свою проблему с Audiovox 128-7404A, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Audiovox 128-7404A со всей вероятностью он захочет поделиться методом ее решения.

Перепишите текст с картинки

Captcha
Новая картинка

Комментарии (0)