Инструкция обслуживания Wayne-Dalton 347610

22 страниц 8.11 mb
Скачать

Перейти на страницу of 22

Summary
  • Wayne-Dalton 347610 - page 1

    GARAGE DOORS & OPENERS Part No. IMPORT ANT NO TICES! Wayne-Dalton highly recommends that you read and fully under - stand the Installation Instructions and Owner’ s Manual before you attempt this installation. T o avoid possible injur y , read the enclosed instructions carefully before installing and operating the garage door . Pay close atte ...

  • Wayne-Dalton 347610 - page 2

    2 Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com A. TRACK ROLLERS (AS REQUIRED): A1. Short Stem T rack Rollers A2. Long Stem T rack Rollers A3. Sh ...

  • Wayne-Dalton 347610 - page 3

    I m p o r t a n t S a f e t y I n s t r u c t i o n s DEFINITION OF KEY WORDS USED IN THIS MANUAL: W ARNING W ARNING INDICA TES A POTENTIALL Y HAZARDOUS SITUA TION WHICH; IF NOT AVOIDED , COULD RESUL T IN SEVERE OR FA T AL INJURY . CAUTION: PROPER TY DAMAGE OR INJURY CAN RESUL T FROM FAILURE TO FOLLOW INSTRUCTIONS. IMPORT ANT : REQUIRED STEP FOR SA ...

  • Wayne-Dalton 347610 - page 4

    Cable drums RH/LH Torsion springs RH/LH End bearing brackets RH/LH (as required) End bearing brackets RH/LH (as required) Cotter pin (as required) 5/16” x 1-1/4” Clevis pin (as required) Center bearing bracket assembly (as required) Center bracket bushing assembly (as required) Hinges Half Center hinges (as required) Strut clips (as required) S ...

  • Wayne-Dalton 347610 - page 5

    rail of the bottom section. Long Strut(s) are typically installed along the top and or bottom rails of sections. Measure the height of the long strut(s) to determine if you have 2” or 3”. NOTE: Some struts also may or may not have holes in them. If they don’t, then prior to installing the strut and hinge to the section surface, you may have t ...

  • Wayne-Dalton 347610 - page 6

    Weatherstrips Level header Finished Door width Jambs Backroom Plumb jambs Finished Door Height Nail Headroom Header board 2”x 6” lumber preferred Suitable mounting surface 2”x 6” lumber minimum Weather- strips Jamb 1/8” to 1/4” Min. side room clearance for 2” track is 3-1/2” (89 mm). Min. side room clearance for 3” track is 4-1/2? ...

  • Wayne-Dalton 347610 - page 7

    INST ALLA TION Before installing your door , be certain that you have read and followed all of the instruc- tions covered in the pre-installation section of this manual. Failure to do so may result in an improperly installed door . IMPORT ANT : WOOD DOORS MUST BE COMPLETEL Y FINISHED (3 TOT AL COATS, INCLUDING PRIMER COA T) PRIOR TO INST ALLA TION, ...

  • Wayne-Dalton 347610 - page 8

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com with the left bottom edge of the bottom section. Attach the bottom corner bracket to the bot- tom s ...

  • Wayne-Dalton 347610 - page 9

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com (3) 1/4” - 14 x 1” Lag screws 2” Long strut T ypical section shown. Center hinge FOR 3” LON ...

  • Wayne-Dalton 347610 - page 10

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Lay a short strut onto the top rail of the top section. Position the top of the strut 3/4” down f ...

  • Wayne-Dalton 347610 - page 11

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com screws. Repeat same process for other inner upper hinge leafs. 2” Long strut T ypical section sho ...

  • Wayne-Dalton 347610 - page 12

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com adjusted for each side. Starting on the left hand side, vertically align the top section of the doo ...

  • Wayne-Dalton 347610 - page 13

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com IMPORT ANT : THE CENTER BRACKET BUSHING OR CENTER BEARING AND TORSION SPRINGS, MUST BE POSITIONED, ...

  • Wayne-Dalton 347610 - page 14

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Center bearing Coupler assembly Center bearing bracket(s) T orsion keyed shaft Center bearing insid ...

  • Wayne-Dalton 347610 - page 15

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Winding Springs T ools: Step Ladder , Approved winding bars, 3/8” Wrench 23 Position a ladder sli ...

  • Wayne-Dalton 347610 - page 16

    Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Vice clamp Horizontal tracks 2nd T rack roller Vice clamp 5/16”-18 x 1-1/4” Hex bolts must exte ...

  • Wayne-Dalton 347610 - page 17

    Door Arm Hookup T ools: Needle nose pliers At the center of the top section, measure horizontally from the top of center hinge to the bottom of strut. Using that dimension, measure and cut (2) pieces of perforated angles. Assemble the (2) pieces together using (2) 3/8” bolts and nuts (supplied by others). Now, secure to the top section using carr ...

  • Wayne-Dalton 347610 - page 18

    Cleaning Y our Garage Door IMPORT ANT : DO NOT USE A PRESSURE W ASHER ON YOUR GARAGE DOOR! An annual inspection of all the surfaces of your garage door(s) will reveal the extent of weather - ing and the possible need for refinishing. When the finish becomes eroded or thin, clean and prime any areas showing deterioration. Then completely refinish ...

  • Wayne-Dalton 347610 - page 19

    3. Lubrication: The door should open and close smoothly. Ensure the door track rollers are rotating freely when opening and closing the door . If track rollers do not rotate freely, clean the door tracks, removing dirt and any foreign substances. Clean and lubricate (use a non-silicon based lubricant) graduated end hinges, steel track rollers, spri ...

  • Wayne-Dalton 347610 - page 20

    Limited warranty Model 7000 and 7400 Series Subject to the terms and conditions contained in this Limited Warranty , Wayne-Dalton (“Manufacturer”) warrants the sections of the door , against defects in material and workmanship, for a period of ONE (1) YEAR from the time of delivery provided: i) (i) The interior and exterior surfaces, as well as ...

  • Wayne-Dalton 347610 - page 21

    ...

  • Wayne-Dalton 347610 - page 22

    AFTER INST ALLA TION IS COMPLETE, F ASTEN THIS MANUAL NEAR THE GARAGE DOOR. Please Do Not Return This Product T o The Store Thank you for your pur chase. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pa ges business listings or go to the Find a Dealer section online at www .Wayne-Dalt ...

Производитель Wayne-Dalton Категория Garage Door Opener

Документы, которые мы получаем от производителя устройства Wayne-Dalton 347610 мы можем разделить на несколько групп. Это в частности:
- технические чертежи Wayne-Dalton
- инструкции обслуживания 347610
- паспорта изделия Wayne-Dalton
- информационные брошюры
- энергетические этикетки Wayne-Dalton 347610
Все из них важны, однако самую важную информацию с точки зрения пользователя мы найдем в инструкции обслуживания Wayne-Dalton 347610.

Группа документов, определяемая как инструкции обслуживания, делится также на более подробные типы, такие как: Инструкции монтажа Wayne-Dalton 347610, инструкции обслуживания, короткие инструкции или инструкции пользователя Wayne-Dalton 347610. В зависимости от потребностей, Вам необходимо поискать требуемый документ. На нашем сайте Вы можете просмотреть самую популярную инструкцию использования изделия Wayne-Dalton 347610.

Похожие инструкции обслуживания

Полная инструкция обслуживания устройства Wayne-Dalton 347610, как должна выглядеть?
Инструкция обслуживания, определяемая также как пособие пользователя, или просто "руководство" - это технический документ, цель которого заключается в использовании Wayne-Dalton 347610 пользователями. Инструкции пишет, как правило технический писатель, языком, доступным для всех пользователей Wayne-Dalton 347610.

Полная инструкция обслуживания Wayne-Dalton, должна заключать несколько основных элементов. Часть из них менее важная, как например: обложка / титульный лист или авторские страницы. Однако остальная часть, должна дать нам важную с точки зрения пользователя информацию.

1. Вступление и рекомендации, как пользоваться инструкцией Wayne-Dalton 347610 - В начале каждой инструкции, необходимо найти указания, как пользоваться данным пособием. Здесь должна находится информация, касающаяся местонахождения содержания Wayne-Dalton 347610, FAQ и самых распространенных проблем - то есть мест, которые чаще всего ищут пользователи в каждой инструкции обслуживания
2. Содержание - индекс всех советов, касающихся Wayne-Dalton 347610, которое найдем в данном документе
3. Советы по использованию основных функций устройства Wayne-Dalton 347610 - которые должны облегчить нам первые шаги во время использования Wayne-Dalton 347610
4. Troubleshooting - систематизированный ряд действия, который поможет нам диагностировать а в дальнейшем очередность решения важнейших проблем Wayne-Dalton 347610
5. FAQ - чаще всего задаваемые вопросы
6. Контактные данные Информация о том, где искать контактные данные производителя / сервисного центра Wayne-Dalton 347610 в данной стране, если самостоятельно не получится решить проблему.

У вас вопрос, касающийся Wayne-Dalton 347610?

Воспользуйтесь формуляром, находящимся ниже

Если с помощью найденной инструкции Вы не решили свою проблему с Wayne-Dalton 347610, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Wayne-Dalton 347610 со всей вероятностью он захочет поделиться методом ее решения.

Перепишите текст с картинки

Комментарии (0)