-
Kenwood SW-505D - page 1
PO WERED SUBWOOFER INSTR UCTION MANU AL SW -305 ➔ PA G E 2 SW -505D ➔ PA G E 1 3 B61-1073-00 (EN) KENW OOD CORPORA TION ...
-
Kenwood SW-505D - page 2
2 SW-305 [EN] Before applying power Units are designed for operation as follows. U.S.A. and Canada ................................................................... AC 120 V only Caution : Read this page carefully to ensure safe operation. Europe and U.K. ........................................................................ AC 230 V only Safet ...
-
Kenwood SW-505D - page 3
3 SW-305 [EN] Unpacking Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost. Examine the unit for any possibility of shipping damage. If your unit is damaged or fails to operate, notify your dealer immediately. If your unit was shipped to you directly, notify the shipping company without delay. Only t ...
-
Kenwood SW-505D - page 4
4 SW-305 [EN] IMPORT ANT SAFEGUARDS 6. Temperature – The appliance may not function properly if used at extremely low, or freezing temperatures. The ideal ambient temperature is above +5°C (41°F). 7. Heat – The appliance should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances (including amplifi ...
-
Kenwood SW-505D - page 5
5 SW-305 [EN] IMPORTANT SAFEGUARDS Caution : Read this page carefully to ensure safe operation. 1 3 . Lightning – For added protection for this appliance during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage t ...
-
Kenwood SW-505D - page 6
6 SW-305 [EN] Installation The Subwoofer is a virtually omnidirectional speaker, so it can be installed in almost any location. For example, the Subwoofer can be installed next to the component system (consisting of an amplifier, tuner, cassette deck, etc.), or in a corner of the room, etc. The Subwoofer’s deep-bass reproduction characteristics a ...
-
Kenwood SW-505D - page 7
7 SW-305 [EN] Before connection: Set the POWER switches of the amplifier and Subwoofer to OFF. If they are connected with the POWER switch(es) left ON, one or both components may be damaged. If the amplifier is equipped with a Subwoofer Pre-Out jack –+ –+ LINE (MONO) FROM AMPLIFIER INPUT INPUT TO SPEAKERS OUTPUT + R - + R - R + - + - R L L L R ...
-
Kenwood SW-505D - page 8
8 SW-305 [EN] Speaker cords are not supplied, Please use a speaker cords with thick conductor. FRONT SPEAKERS CENTER SPEAKERS – + LINE (MONO) FROM AMPLIFIER INPUT INPUT TO SPEAKERS OUTPUT + R - + R - R + - + - R L L L R R R LINE (MONO) FROM AMPLIFIER INPUT INPUT TO SPEAKERS OUTPUT + R - + R - R + - + - R L L L R R R FROM AMPLIFIER INPUT TO SPEAKE ...
-
Kenwood SW-505D - page 9
9 SW-305 [EN] –+ –+ LINE (MONO) FROM AMPLIFIER INPUT INPUT TO SPEAKERS OUTPUT + R - + R - R + - + - R L L L R R R LINE (MONO) INPUT R L FRONT SPEAKERS CENTER SPEAKERS – + L R PRE OUT LINE (MONO) FROM AMPLIFIER INPUT INPUT TO SPEAKERS OUTPUT + R - + R - R + - + - R L L L R R R LINE (MONO) INPUT R L LINE (MONO) FROM AMPLIFIER INPUT INPUT TO SPE ...
-
Kenwood SW-505D - page 10
10 SW-305 [EN] Controls and indicators CROSSOVER 60Hz 200Hz VOLUME CONTROL POWER ON/STANDBY MIN - ON – OFF PHASE – NORMAL - REVERSE MAX 1. Do not increase the output of the amplifier to a high level while the low-frequency level is enhanced by the amplifier’s tone control or loudness control. 2. When operating the amplifier switches or when p ...
-
Kenwood SW-505D - page 11
11 SW-305 [EN] In case of difficulty Sound adjustment Depending on the listening room condition and the front speaker characteristics, other adjustment setting than the examples shown above may provide more natural bass sound and more effective bass reproduction. Try various adjustment settings to select the optimum one for your listening room. How ...
-
Kenwood SW-505D - page 12
12 SW-305 [EN] Specifications Type .................................................... Subwoofer system with built-in amplifier (Magnetically shielded) [Amplifier] Rated Output Power ........................ 100 W RMS 30 Hz ~ 200 Hz, 4 Ω Phase Switching ............................... NORMAL, REVERSE Input Sensitivity & Input Impedance RCA-t ...
-
Kenwood SW-505D - page 13
PO WERED SUBWOOFER INSTR UCTION MANU AL SW -505D B61-1183-00 (EN) KENW OOD CORPORA TION ...
-
Kenwood SW-505D - page 14
14 FRANÇAIS DEUTSCH NEDERLANDS IT ALIANO ESP AÑOL SW-505D (EN) Before applying power Units are designed for operation as follows. U.S.A. and Canada ................................................................... AC 120 V only Caution : Read this page carefully to ensure safe operation. Europe .................................................. ...
-
Kenwood SW-505D - page 15
15 FRANÇAIS DEUTSCH NEDERLANDS IT ALIANO ESP AÑOL SW-505D (EN) Unpacking Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost. Examine the unit for any possibility of shipping damage. If your unit is damaged or fails to operate, notify your dealer immediately. If your unit was shipped to you directly ...
-
Kenwood SW-505D - page 16
16 FRANÇAIS DEUTSCH NEDERLANDS IT ALIANO ESP AÑOL SW-505D (EN) Installation The Subwoofer is a virtually omnidirectional speaker, so it can be installed in almost any location. For example, the Subwoofer can be installed next to the component system (consisting of an amplifier, tuner, cassette deck, etc.), or in a corner of the room, etc. The Sub ...
-
Kenwood SW-505D - page 17
17 FRANÇAIS DEUTSCH NEDERLANDS IT ALIANO ESP AÑOL SW-505D (EN) Before connection: Set the POWER switches of the amplifier and Subwoofer to OFF. If they are connected with the POWER switch(es) left ON, one or both components may be damaged. If the amplifier is equipped with a Subwoofer Pre-Out jack –+ –+ SUB WOOFER REC OUT CD2/ TAPE2 MONITOR F ...
-
Kenwood SW-505D - page 18
18 FRANÇAIS DEUTSCH NEDERLANDS IT ALIANO ESP AÑOL SW-505D (EN) If the amplifier is not equipped with a Subwoofer Pre-Out jack or if two subwoofers are to be used When the amplifier has two stereo speaker output circuits which can output signals simultaneously, the front speakers do not have to be connected through the subwoofer(s) but can be conn ...
-
Kenwood SW-505D - page 19
19 FRANÇAIS DEUTSCH NEDERLANDS IT ALIANO ESP AÑOL SW-505D (EN) L R PRE OUT LINE (MONO) FROM AMPLIFIER INPUT OUTPUT TO SPEAKERS + R - - L + + R - - L + L R L L R R L R LINE L R L R (MONO) –+ –+ (6 — 16‰) B L R A R L FRONT SPEAKERS – + The subwoofer(s) can also be connected to the REC OUT or LINE OUT jacks of the amplifier in the same way ...
-
Kenwood SW-505D - page 20
20 FRANÇAIS DEUTSCH NEDERLANDS IT ALIANO ESP AÑOL SW-505D (EN) Controls and indicators VOLUME CONTROL POWER ON/STANDBY PEAK INDICATOR MODE PHASE MUSIC NORMAL CINEMA MIN - ON – OFF SLOPE CROSSOVER 12dB 24dB 60Hz 200Hz MAX REVERSE 0 1. Do not increase the output of the amplifier to a high level while the low-frequency level is enhanced by the amp ...
-
Kenwood SW-505D - page 21
21 FRANÇAIS DEUTSCH NEDERLANDS IT ALIANO ESP AÑOL SW-505D (EN) POWER VOLUME PHASE MUSIC/CINEMA REMOTE CONTROL UNIT RC-W0502 How to operate Operation range Plug in the power supply plug of the Subwoofer to the AC outlet and press the POWER switch on the Subwoofer to turn ON. When power is ON : Remote control operation is immediately available. In ...
-
Kenwood SW-505D - page 22
22 FRANÇAIS DEUTSCH NEDERLANDS IT ALIANO ESP AÑOL SW-505D (EN) In case of difficulty Sound adjustment 2 Crossover slope adjustment (SLOPE selector switch) Front speaker Bass-reflex type Depending on the listening room condition and the front speaker characteristics, other adjustment setting than the examples shown above may provide more natural b ...
-
Kenwood SW-505D - page 23
23 FRANÇAIS DEUTSCH NEDERLANDS IT ALIANO ESP AÑOL SW-505D (EN) Specifications Type .................................................... Subwoofer system with built-in amplifier (Magnetically shielded) [Amplifier] Rated Output Power ........................ 1 5 0 W RMS 30 Hz ~ 200 Hz, 4 Ω Phase Switching ............................... NORMAL, R ...
-
Kenwood SW-505D - page 24
24 FRANÇAIS DEUTSCH NEDERLANDS IT ALIANO ESP AÑOL SW-505D (EN) For your records Record the serial number , found on the bac k of the unit, in the spaces designated on the warranty card, and in the space provided belo w . Re- fer to the model and serial numbers whenever you call upon your dealer for information or service on this product. Model __ ...
У вас вопрос, касающийся Kenwood SW-505D?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Kenwood SW-505D, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Kenwood SW-505D со всей вероятностью он захочет поделиться методом ее решения.