-
Craftsman 79834 - page 1
IMPORTANT MANUAL Do Not Throw Away SE_/ RS Operator's Manual Model No. 358.798340 WARNING READ THE OPERATOR'S MANUAL AND FOLLOWALL WARNINGS AND SAFETY INSTRUCTIONS. FAILURE TO DO SO CAN RESULT IN SERIOUS INJURY. Always Wear Eye Protection . CRRFTSMRN ° 855 riP MOTOR PH Air Velocity ELECTRIC BLOWER/VAC DOUBLE INSULATED • Assembly • Op ...
-
Craftsman 79834 - page 2
I lilt i iii i i i ii i i i i IMPORTANT WARNINGS & SAFETY INSTRUCTIONS i i iii ii ibm iii i iii WARNING _The warnings and safety instructions in this manual must be followed to reduce the risk of electric fire, shock, or injury, and to provide reasonable safety and efficiency in using this unit. The operator is responsible for following the war ...
-
Craftsman 79834 - page 3
i i ! i i,ir ,A IMPORTANT WARNINGS & SAFETY INSTRUCTIONS UNIf SAFETY o inspect the entire unit before each use for worn, loose, missing, or damaged parts. Do not use until the unit is in proper working order. • Have all internal service performed by qualified ser- vice repair personnel to avoid creating a hazard or voiding your warranty. - Ne ...
-
Craftsman 79834 - page 4
CONGRATULATIONS on your purchase of a Sears Craftsman Electric Blower/vac. It has been designed, engineered and manufactured to give you the best possible dependability and performance. Should you experience any problems you cannot easily remedy, please contact your nearest Sears Service Center/Department. Sears has competent, well trained technici ...
-
Craftsman 79834 - page 5
III III I • I IIIII I I II III I IIIII III I IIIIIHIN II TABLE OF CONTENTS IHI I IIIIIlll I I I"11 I'111 III! I LJ IIII I I IIII II IIII II Safety Instructions ............................. 2 Product Specifications .......................... 4 Customer Responsibilities .................... 4,13 Warranty ................................. ...
-
Craftsman 79834 - page 6
ii i iin nl iiiiiiiiiiiiinnmmllln HARDWARE CONTENTS PARTS PACKED SEPARATELY IN CARTON NOT SHOWN ACTUAL SIZE Operator's Manual Blower Tube Upper Vacuum Tube Concentrator Nozzle Lower Vacuum Tube Collection Bag i rl i iill ml i i i iii ASSEMBLY iiiii i 111111111111 ii i iiii iii REMOVE BLOWER FROM CARTON • Remove leose parts included with Blew ...
-
Craftsman 79834 - page 7
===H H= , =11 H= ASSEMBLY HoW TO AssEMBLE YOuR UNIT AS A ..... VACUUM (Fig. 4 ) VACUUM Figure 4 If your unit is configured in the blower mode, stop the unit, and remove the blower tubes and nozzle. REMOVING THE INLET RESTRICTOR (Fig. WARNING STOP THE UNIT AND DISCONNECT IT FROM THE POWER SOURCE BEFORE OPENING THE INLET COVER OR ATTEMPTING TO INSERT ...
-
Craftsman 79834 - page 8
H,n = n,,,,, ====r= =n = =,,=, ATTAC'HING COLLECTION BAG (Fig. 9 ) • Slide the opening of the collection bag over the blower outlet. Pull the strap with Velcro tightly th rough the buckle and secure the Velcro tabs. NOTE: Make sure the strap with Velcro is located on the housin,q as shown. Strap Collection Bag .._ Blower Outlet Figure 9 ADJU ...
-
Craftsman 79834 - page 9
=n = = = ASSEMBLY i i i CHECK LIST = Check all fasteners. Make sure they are tight and there are no loose parts. • Make sure the blower tube is firmly seated in the blower outlet• • If you are using the unit as a blower, make sure the inlet cover is latched_ = In blower mode. check to insure the nozzle is securely seated in the blower tube. ? ...
-
Craftsman 79834 - page 10
KNOW YOUR ELECTRIC BLOWER READ THIS OPERATOR'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR ELECTRIC BLOWER. Compare the ilfustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference. CONCENTRATOR NOZZLE TOP HANDLE AIR VENTS | ON/OFF SWITCH VACUUM TUBES ...
-
Craftsman 79834 - page 11
_l, ................. = ='=!=r =1= H - SAFETY ,,,, =,H 0 OPERATION = = ,, =, OPERATOR SAFETY (Fig. 14 ) WARNING DO NOT ASSEMBLE OR DISASSEMBLETHE VACUUM TUBES WHILE THE UNIT IS RUNNING. INSERTING OR REMOVING THE VACUUM TUBES WHILE THE UNIT IS RUNNING CAN RESULT IN SERIOUS INJURY. ALWAYSSTOP THE UNIT AND DISCONNECT THE POWER SOURCE BEFORE UNCLO ...
-
Craftsman 79834 - page 12
STOPPING YOUR UNIT • Slide the switch to the OFF position. STARTING YOUR UNIT • Slide the switch to the LOW or HIGH position. OPERATING YOUR UNIT & WARNING DO NOT USE THE UNIT WITHOUT THE BLOWER TUBES PROPERLY AT- TACHED TO AVOID FLYING DEBRIS AND/OR IMPELLER CONTACT WHICH CAN CAUSE SERIOUS INJURY. ALWAYS WEAR EYE PROTECTION TO PREVENT ROCK ...
-
Craftsman 79834 - page 13
CUSTOMER RESPONSIBILITIES = = H= MAINTENANCE SCHEDULE Fill in dates as you complete regular service. Check for damaged or worn parts. C_ean unit and labels. Check for loose fasteners and parts. Clean collection bag. Before Use ,, ,,, ,,,,,,,,,,, After Use Yearly Service Dates GENERAL RECOMMENDATIONS The warranty on this unit does not cover items th ...
-
Craftsman 79834 - page 14
i mill I I I I I i1,11|,1, i i SERVICE AND ADJUSTMENTS ii ii iiiiiiiii1|111 i iii ii iiiiiiiiiiiii ii HOW TO REMOVE AN OBJECT FROM THE AIR INTAKE (Fig. 17 ) If an object is drawn into the unit through the air intake, do the following: • Push the switch to the OFF position and disconnect cord from the power source, • Remove the vacuum tubes. Rel ...
-
Craftsman 79834 - page 15
NOTES ...
-
Craftsman 79834 - page 16
Operator's Manual Model No. 358.798340 IF YOU NEED REPAIR SERVICE OR PARTS: REPAIR SERVICE 1-800-4-REPAIR (1-800-473-7247) ORDERING PARTS 1-800-WON-PART (1-800-366-7278) ASSISTANCE 1-800-235-5878 J HOURS (CST) Mon° - Sat. 7 a,m. - 7 p,m. Sun. 10 a.rn. - 7 p.m. CRRFTSMRN o 8.5 AMP MOTOR 150 MPH Air Velocity ELECTRIC BLOWER/VAC Each Electric Bl ...
У вас вопрос, касающийся Craftsman 79834?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Craftsman 79834, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Craftsman 79834 со всей вероятностью он захочет поделиться методом ее решения.