-
La Crosse Technology WS-9016U - page 1
WS-9016U Wireless 433 MHz Radio-controlled Sun/Moon Weather Station Instruction Manual ...
-
La Crosse Technology WS-9016U - page 2
2 Topic Page Inventory of Contents/ Additional Equipm ent 3 About WWVB 4 Quick Set-Up Guide 5 Detailed Set-Up Guide Battery Installation 6 Program Mode Function Keys 7-8 LCD Screen 9 Manual Settings Sequence 9 LCD Contrast Setting 10 City Location Setting 10 Time Zone Sett ing 11 Daylight Saving Ti me (DST) Sett ing 11 WWVB O n/Off Setting 12 12/24 ...
-
La Crosse Technology WS-9016U - page 3
3 INVENTORY OF CONTENTS 1. The indoor weather station (Fi gure 1). 2. One TX6U remote tem perature sensor with m ounting bracket (Figure 2). 3. Three each, ½” Philips screws. 4. One strip double-sided adhesive t ape. 5. Instruction m anual and warranty card. ADDITIONAL EQUIPMENT (not included) 1. Two, fresh AA 1.5V batteries for indoor weather s ...
-
La Crosse Technology WS-9016U - page 4
4 ABOUT WWVB (Radio Controlled Time) The NIST (National Institute of Sta ndards and Technology—Time and Frequency Division) WW VB radio station is located in Ft. Collins, Co lorado and transmits the exact time signal conti nuously throughout the Unite d States at 60 kHz. The signal can be received up to 2, 000 miles away th rough the internal ant ...
-
La Crosse Technology WS-9016U - page 5
5 QUICK SET-UP GUIDE Hint: Use good quality Alkaline Batteri es and avoid rechargeable batteries. 1. Have the indoor weather station and rem ote tem perature sensor 3 to 5 feet apart. 2. Batteries should be out of both units for 10 m inutes. 3. Place the batteries into the remote temperature sensor first then into the indoor weather station . (All ...
-
La Crosse Technology WS-9016U - page 6
6 DETAILED SET-UP GUIDE I. Battery Installation A. Remote Temperature Sensor 1. Remove the mounting bracket. The bracket snaps on and off easily. 2. Remove the battery cover, by sliding the cover down. 3. Observing the co rrect p olarity install 2 AA batteries. The batteries will fit tigh tly (to avoid start-up problem s make sure they do not sprin ...
-
La Crosse Technology WS-9016U - page 7
7 II. Program Mode Programming Note: If 30 seconds are allowed to pass or ei ther the IN or the OUT button is pressed during p r o gramming modes, the un it will set the last inform a tion entered—the display will stop flashing and return to normal time-date readings. A. Function Keys Weather Station: The Weather Station has 8 easy to use functi ...
-
La Crosse Technology WS-9016U - page 8
8 3. MINUS (-) button • Decrease value in all setting modes • Decrease the digits • Stop the alarm duri ng alarm ringi ng 4. SUN/MOON button • Enter the sun/moon setting mode • Start the sun/moon t ime calcula tion of the selected city • Stop the alarm duri ng alarm ringi ng 5. ALARM SET button • Enter the alarm setting mode • Stop ...
-
La Crosse Technology WS-9016U - page 9
9 B. LCD Screen The LCD screen is split into 5 sections displaying th e in formation for time and date, sun/moon data, indoor data, weather forecast and outdoor data. C. Manual Setting Sequence The following ma nual settings can be changed when pressing the “SET” button: • LCD contrast setting • City location setting • Time zone sett ing ...
-
La Crosse Technology WS-9016U - page 10
10 LCD Contrast Setting The LCD contrast can be set with in 8 levels, from LCD 0 to LCD7 (the default setting is LCD 5 ): 1. Press and hold the “SET” button until the d ig it starts flash ing in the LCD. 2. Press and release the PLUS (+) or MI NUS (-) button to view all levels of contrast. 3. Select the desired LCD contrast. 4. Press and releas ...
-
La Crosse Technology WS-9016U - page 11
11 Flashing Time Zone Setting The default (factory set) ti me zone of the indoor weather st ation is EST –5 (the default time zone for the default city, W ashington D.C.). To set a different time zone: 1. The current time zone value starts flashing on the LCD. 2. Press and release PLUS (+) or MINUS (-) button to set the time zone. 3. The range ru ...
-
La Crosse Technology WS-9016U - page 12
12 Digits flashing Tower icon flashing Flashing WWVB ON/OFF Setting In areas where reception of the WWVB time is not possible the WW VB time reception function can be turned OFF. The clock will then work as a normal Quartz clock. (the default sett ing is ON). 1. The digit “ON” will start flash in g on the LCD. 2. Press and release the PLUS (+) ...
-
La Crosse Technology WS-9016U - page 13
13 Manual Time Setting In case the indoor weather station cannot det ect the WWVB signal (for example due to disturbances, transmitting d istan ce, etc.), th e time can be manually set. The clock will then work as a n ormal Quartz clock. 1. The hour digit will start flashing on the LCD. 2. Press and release the PLUS (+) or MINUS (-) button to set t ...
-
La Crosse Technology WS-9016U - page 14
14 Calendar Setting The default (factory set) date of the indoor weather station is 1. 1. in the year 2001. Once the radio-controlled time signal is recei ved the date is automatically updated. If the signals are not received the date can also be set manually. 1. The year starts flashing in the LCD. 2. Press and release the PLUS (+) or MINUS (-) bu ...
-
La Crosse Technology WS-9016U - page 15
15 Digit flashing Snooze Setting The snooze time can be set from OFF to a m aximum time of 30 mi nutes. The default (factory) setti ng is OFF. 1. The digits “OFF” will start flashing in the LCD. 2. Press and release the PLUS (+) or MINUS (-) button to set the snooze t ime. Each pressing of the button will incr ease or decrease the snooze time b ...
-
La Crosse Technology WS-9016U - page 16
16 Weather Forecast Icon Sensitivity Setting For locations with rapid changes of weat he r conditions, the weather ic ons can be set to a different level for fast er display of weather condit ions. 1. The current sensitivity valu e will start flashing. 2. Press and release the PLUS (+) or MINUS (-) button to set the weather sensitivity level. 3. Th ...
-
La Crosse Technology WS-9016U - page 17
17 6. Press and release the PLUS (+) or MI NUS (-) button to set the alarm mi nute. 7. Press and release the “SET” button to confirm and exit the Alarm setting . Note: The maxim um alarm ring duration is 3 m inutes . The alarm setting can be activated or deactivated by pressing the “ALARM ON/OFF” button. The alarm icon will b e displayed on ...
-
La Crosse Technology WS-9016U - page 18
18 Note: It will take a few seconds until the s un/moon data will be displayed. The display will return after 3 minutes to nor mal mode. The “CH” butt on can also be used to return im mediately to the normal display mode. If onl y a specific data is changed, e.g. only a different city is selected, the “SUN/MOON” button can be pressed to sta ...
-
La Crosse Technology WS-9016U - page 19
19 WEATHER FORECASTING ICONS: Note: The weather forecast icons of this i ndoor weather station are a prediction of what the weather is going t o do in the next 12 to 20 hours. These are not indications of the current weat her. Weather icons in the fourth section of LCD can be displ ayed in any of the foll owing combinations: Sunny Cloudy with sunny ...
-
La Crosse Technology WS-9016U - page 20
20 indoor weather station will be more accurate com pared to use in areas where the weather is stagnant m ost of th e time (for exam ple mostly sunny). If the indoor weather stati on is moved to another l ocation significant ly higher or lower than its initial standing point (for example from the ground floor to the upper floors of a house), disreg ...
-
La Crosse Technology WS-9016U - page 21
21 TOGGLING AND RESETTING THE OUTDOOR RECORDINGS: 1. To toggle between the outdoor current, m axim um and m inimum temperature data and the times they were recorded press and release the “MAX/MIN R” button: • Once to show the maxim um outdoor t emperature data wi th the recorded time and date. • Twice to show the mi nimum outdoor te mperatu ...
-
La Crosse Technology WS-9016U - page 22
22 if this is not done correctly and if the total time for set-up exceeds 6 minutes. SET-UP OF MULTIPLE UNITS 1. It is necessary to remove the batteries from all units cu rrently in operation. 2. Remove the battery covers to all remote temperature senso r units. 3. Place all remote temperature sensor units in a num eric sequential order. 4. In sequ ...
-
La Crosse Technology WS-9016U - page 23
23 THE REMOTE TEMPERATURE SENSOR The remote tem perature sensor can be mounted i n two ways: • with the use of screw s • using the adhesive tape A. MOUNTING WITH SCREWS 1. Remove the mounting bracket from the remote temperature sensor. 2. Place the mounting bracket ove r the desired location. 3. Through the three screw holes of the bracket , ma ...
-
La Crosse Technology WS-9016U - page 24
24 THE INDOOR TEMPERATURE STATION The indoor temperature st ation can be mounted i n two ways: • with the table stand • on the wall with the use of a wall hanging screw (not included) A. USING THE TABLE STAND The indoor temperature stati on comes wi th the table stand already mount ed. If you wish to use the table-stand all that is required is ...
-
La Crosse Technology WS-9016U - page 25
25 City Listing (In order as they appear on left side of unit) Montgomery, Alabama Little Rock, Arkansas Phoenix, Arizona Los Angeles, California San Francisco, California Denver, Colorado Washington D.C. Jacksonville, Florid a Miami, Florida Atlanta, Georgia Des Moines, Iowa Boise, Idaho Chicago, Illinois Kansas City, Kansas New Orleans, Louisiana ...
-
La Crosse Technology WS-9016U - page 26
26 Problem: No reception of WWVB time signal Solution : 1) Wait overnight for signal. 2) Be sure indoor weather station is at least 6 feet from any electrical devices, such as televisions, computers, or other radi o-controlled clocks. 3) Remove batteri es for five minute s, reinsert and leave alone without pressi ng buttons overnight. 4) If there a ...
-
La Crosse Technology WS-9016U - page 27
27 MAINTENANCE AND CARE INSTRUCTIONS • Extreme tem peratures, vibration and shock shoul d be avoided to prevent damage to the units. • Clean displays and units with a soft, dam p cloth. Do not use sol vents or scouring agents. They m ay mark the di splays and casings. • Do not submerge in wat er. • Immediately rem ove all low powered batter ...
-
La Crosse Technology WS-9016U - page 28
28 SPECIFICATIONS Temperature measuring range: Indoor: 32 ° F to 140 ° F with 0.1 ° F resolution. (0 ° C to 60 ° C with 0.1 ° C resolution) “OF” displayed if out side this range Outdoor: -21.8 ° F to 157.8 ° F with 0.2 ° F resolution. (-29.9 ° C to 69.9 ° C with 0.1 ° C resolu tion) “OF” displayed if out side this range Indoor r ...
-
La Crosse Technology WS-9016U - page 29
29 WA RRA NTY INFORMATION La Crosse Technology, Ltd provides a 1-y ear limited w arranty on this product against manufacturing defects in ma terials and workmanship. This limited warranty begins on the original dat e of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. To rec ...
-
La Crosse Technology WS-9016U - page 30
30 PUBLIC INFORMATION. THIS PRO DUCT IS NOT A T OY. KEEP OUT OF CHILDREN’S REACH. This warranty gives y ou specific legal rights. You may also have other rights specific to your State. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to y ou. For warranty work, ...
-
La Crosse Technology WS-9016U - page 31
WS-9016U Cities List Montgomery, Alabama Little Rock, Arkansas Phoenix, Arizona Los Angeles, California San Francisco, California Denver, Colorado Washington D.C. Jacksonville, Florida Miami, Florida Atlanta, Georgia Des Moines, Iowa Boise, Idaho Chicago, Illinois Kansas City, Kansas New Orleans, Louisi ana Boston, Massachusetts Portland, Maine Det ...
У вас вопрос, касающийся La Crosse Technology WS-9016U?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с La Crosse Technology WS-9016U, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с La Crosse Technology WS-9016U со всей вероятностью он захочет поделиться методом ее решения.