-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 1
...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 2
Fig. 6 Fig. 8 Fig. 7 OPERA TION SWING TIMER 7 6 5 1 4 8 Fig. 5 Fig. 1 Fig. 2 Fig. 3 Fig. 4 ^ $ # @ % 0 - 9 ! = ~ 3 SLEEP TIMER MASTER CONTROL SET TEMP. SET TIME FAN CONTROL START/STOP SWING LOUVER CLOCK CLOCK TIMER RESET AM PM PM OFF ON HM COOL DRY FAN AUTO HIGH MED LOW QUIET AUTO F SLEEP ON OFF LOW HIGH ACL OPEN & * ( ) _ + £ ¡ ¢ ∞ § • ...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 3
En-1 CONTENTS SAFETY PRECAUTIONS .................................... En-1 FEATURES AND FUNCTIONS ........................... En-4 NAME OF PARTS ............................................... En-5 PREPARATION .................................................... En-6 OPERATION ........................................................ En-7 TIMER OPER ...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 4
En-2 Do not stay in direct cooling airflow for long periods. ¶ Excessive direct exposure to chilled air could be bad for your health. ¶ Be especially careful when going to bed, and in rooms where infants, aged, or sick people are staying. Do not insert fingers or objects into the outlet port or intake grilles. ¶ A fan operates at high speed insi ...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 5
En-3 PRECAUTIONS CAUTION Check the condition of the installation for damage. ¶ After lengthy use, arrange for visit by authorized ser- vice personnel to check installation condition. Always turn off power whenever cleaning the air conditioner or changing the air fil- ter. ¶ A fan operates at high speed inside the unit, and per- sonal injury could ...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 6
En-4 FEATURES AND FUNCTIONS AUTOMATIC OPERATION Merely press the START/STOP button, and the unit will be- gin automatic operation in either the Heating, Cooling, Dry, or Monitor modes as appropriate, in accordance with the thermostat setting and the actual temperature of the room. SLEEP TIMER When the SLEEP timer button is pressed during cooling mo ...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 7
En-5 NAME OF PARTS Fig. 6 Remote Control Unit & SLEEP button * MASTER CONTROL button ( SET TEMP. /SET TIME button ( / ) ) Signal Transmitter _ TIMER button + FAN CONTROL button ¡ START / STOP button ™ AIR FLOW DIRECTION button £ SWING LOUVER button Rear side (Fig. 7) ¢ TIME ADJUST button ∞ ACL button (located inside battery compartment) ...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 8
En-6 Turn on the Power In the case of a direct line connection, turn on the circuit breaker. Load Batteries (AAA x 2) Press and slide the battery compartment lid on the reverse side to open it. Slide in the direction of the arrow while pressing the mark. Insert batteries. Be sure to align the battery polarities ( ª / · ) correctly. Close the batt ...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 9
En-7 SLEEP TIMER MASTER CONTROL SET TEMP. SET TIME FAN CONTROL START/STOP COOL SLEEP TIMER MASTER CONTROL SET TEMP. SET TIME FAN CONTROL AUTO SLEEP TIMER MASTER CONTROL SET TEMP. SET TIME FAN CONTROL START/STOP F OPERATION To Select Mode Operation Press the START/STOP button (Fig. 6 ¡ ). The Indoor Unit’s OPERATION Indicator Lamp (red) (Fig.3 5 ...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 10
En-8 MASTER CONTROL SET TEMP. SET TIME FAN CONTROL LOW HIGH MASTER CONTROL SET TEMP. SET TIME FAN CONTROL AUTO OPERATION Press the MASTER CONTROL button to select AUTO. The operating mode “AUTO” will appear alone in the display. The transmit indica- tor will flash to indicate the command has been sent, and about three seconds later the entire d ...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 11
En-9 To Cancel the Timer Use the TIMER button to select “TIMER RESET.” The air conditioner will return to normal operation. To Change the Timer Setting 1 . Follow the instructions given in the section “To Use the ON Timer or OFF Timer” to select the timer setting you wish to change. 2. Press the TIMER button to select either OFF = ON or OFF ...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 12
En-10 SLEEP TIMER OPERATION Unlike other timer functions, the SLEEP timer is used to set the length of time until air conditioner operation is stopped. To Use the SLEEP Timer While the air conditioner is operating or stopped, press the SLEEP button (Fig. 6 & ). The indoor unit’s OPERATION Indicator Lamp (red) (Fig 3. 5 ) lights and the TIMER ...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 13
En-11 CAUTION ÷ Never place fingers or foreign objects inside the outlet ports, since the internal fan operates at high speed and could cause personal injury. ADJUSTING THE DIRECTION OF AIR CIRCULATION Vertical (up-down) direction of airflow is adjusted by pressing the Remote Control Unit's AIR FLOW DIRECTION button. Horizontal (right-left) a ...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 14
En-12 To Select SWING Operation Press the SWING LOUVER button (Fig.6 £ ). The SWING Indicator Lamp (orange) (Fig. 3 7 ) will light. In this mode, the Air Flow Direction Louvers will swing automatically to direct the airflow both up and down. To Stop SWING Operation Press the SWING LOUVER button (Fig.6 £ ) once again. The SWING Indicator Lamp (ora ...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 15
En-13 CLEANING AND CARE WARNING Before cleaning the unit, be sure to stop the unit and disconnect the power. 1. Disconnect the power. 2. Turn off the electrical breaker. ¶ A fan operates at high speed inside the unit, and personal injury could result. When cleaning the air conditioner, turn off the electrical breaker. The unit can be damaged by ga ...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 16
En-14 Cleaning the Intake Grille 1. Open the Intake Grille. 1 Place your fingers at both lower ends of the grille panel, and lift forward; if the grille seems to catch partway through its movement, continue lifting up- ward to remove. 2 Pull past the intermediate catch and open the Intake Grille wide so that it becomes horizontal. 4. Set the mounti ...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 17
En-15 Cleaning the Air Filter 1. Open the Intake Grille, and remove the Air Filter. Lift up the air filter's handle, disconnect the two lower tabs and pull out. 2. Remove dust with a vacuum cleaner or by washing. After washing, allow to dry thoroughly in a shaded place. 3. Replace the Air Filter and close the Intake Grille. 1 Align the sides o ...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 18
En-16 ÷ If the unit is stopped and then immediately started again, the compressor will not operate for about 3 minutes, in order to prevent fuse blowouts. ÷ Whenever the Power is disconnected and then reconnected to a power outlet, the protection circuit will operate for about 3 minutes, preventing unit operation during that period. ÷ During ope ...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 19
En-17 Items to Check ÷ Has there been a power failure? ÷ Has a fuse blown out, or a circuit breaker been tripped? ÷ Is the POWER switch set to the OFF position? ÷ Is the timer operating? ÷ Is the air filter dirty? ÷ Are the air conditioner’s intake grille or outlet port blocked? ÷ Did you adjust the room temperature settings (thermostat) c ...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 20
En-18 OPERATING TIPS Temperature and Humidity Range DB : Dry Bulb Temperature WB : Wet Bulb Temperature ÷ If the air conditioner is used under higher temperature conditioner than those listed, the built-in protection circuit may operate to prevent internal circuit damage. Also, during Cooling and Dry modes, if the unit is used under conditions of ...
-
Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE - page 21
(800) 888-FGAI ...
У вас вопрос, касающийся Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Fujitsu Cooling Model room air conditioner WALL MOUNTED TYPE со всей вероятностью он захочет поделиться методом ее решения.