-
Denso CU-7011 - page 1
User's Manual ...
-
Denso CU-7011 - page 2
Copyright © DENSO WAVE INCORPORATED, 2001 All rights reserved. No part of this publication may be reproduced in any form or by any means without permission in writing from the publisher. Specifications are subject to change without prior notice. All products and company names mentioned in this manual are trademarks or regis- tered trademarks of th ...
-
Denso CU-7011 - page 3
i Pr eface Please READ through these operating instructions carefully. It will enable you to operate your CU-7011 correctly. After you have finished reading the instructions, keep this manual handy for speedy reference. ...
-
Denso CU-7011 - page 4
ii How this book is organized This manual is made up of 10 chapters and appendix. Chapter 1 Ethernet System Configuration Chapter 2 Functions of the CU-7011 Chapter 3 Components and Functions Chapter 4 CU Status Indication by LED Indicators Chapter 5 Applying Power to the CU-7011 Chapter 6 Connecting to Ethernet Chapter 7 Charging the Rechargeable ...
-
Denso CU-7011 - page 5
iii ■ Related Publications BHT-7000 User's Manual BHT-7000 User's Manual "LAN Support Version" BHT-100 Series User's Manuals BHT-100 Series User's Manual "LAN Support Version" BHT-BASIC Programmer's Manual BHT-BASIC Programmer's Manual (BHT-100 series) ...
-
Denso CU-7011 - page 6
iv Alerts you to those conditions which could cause serious bodily injury or death if the instructions are not followed correctly. W ARNING CAUTION Alerts you to those conditions which could cause minor bodily injury or substantial property damage if the instruc- tions are not followed correctly. Meaning of Symbols A triangle ( ) with a picture ins ...
-
Denso CU-7011 - page 7
v • Avoid dropping the battery cartridge or letting it undergo any shock or impact. Doing so could cause the batteries to break, generate heat, rupture or burn. • Only use the dedicated charger (CU-7011, CU-7001, C-700 or C-750) for charging the battery cartridge. Using a different type of charger could cause battery-rupture or leakage of batte ...
-
Denso CU-7011 - page 8
vi Handling the battery cartridge • Never charge a wet or damp battery cartridge. Doing so could cause the batteries to break, generate heat, rupture, or burn. Handling the CU • Never put the CU in places where there are excessively high temperatures, such as inside closed-up automobiles, or in places exposed to direct sunlight. Doing so could ...
-
Denso CU-7011 - page 9
vii ■ Proper Care of the CU Before starting cleaning, unplug the AC adapter from the wall socket for safety. Clean the housing and the charge terminals of the CU and the battery cartridge termi- nals with a dry, soft cloth. • Never use benzene, alcohol, or other organic sol- vents. The housing may be marred or the paint may come off. • If the ...
-
Denso CU-7011 - page 10
Content Overviews Preface ................................................................................................................................. i How this book is organized .............................................................................................. ii SAFETY PRECAUTIONS ................................................ ...
-
Denso CU-7011 - page 11
1 Chapter 1 Ethernet System Configu- ration Connecting CU-7011 units to an Ethernet enables you to use BHTs as a LAN client. For details about FTP and Socket API, refer to the BHT-BASIC Programmer's Manual. For procedures about setting the TCP/IP and FTP on the BHT, refer to the BHT User's Manual. Host computer Optical communication CU-70 ...
-
Denso CU-7011 - page 12
2 Chapter 3 Components and Functions Place the CU on a flat, horizontal plane. Do not install the CU on a wall or in a vertical position. LED indicators DATA (Communications LED, green) Lights when the BHT is communicating with the host computer. POWER (Power LED, green) Lights when the power is applied to the CU-7011. Optical interface port Used t ...
-
Denso CU-7011 - page 13
3 Chapter 4 CU Status Indication by LED Indicators According to the ON/OFF states of the POWER and DATA LED indicators, you may check the machine status of the CU-7011 as listed below. POWER DATA Machine status OFF OFF Power off ON OFF Power on ON ON Communicating with the host Flashing slowly* 1 ON Updating the CU system program Flashing slowly Fl ...
-
Denso CU-7011 - page 14
4 • If smoke, abnormal odors or noises come from the CU, immediately unplug the AC adapter from the wall socket and contact your nearest dealer. Failure to do so could cause fire or electrical shock. • If foreign material or water gets into the CU, immediately unplug the AC adapter from the wall socket and contact your nearest dealer. Failure t ...
-
Denso CU-7011 - page 15
5 Chapter 6 Connecting to Ethernet 6.1 Setting the T ransmission Speed of the CU-701 1 Set the transmission speed of the CU-7011 to the same value as that of the BHT, by using the DIP switch provided on the bottom of the CU-7011. (1) Unplug the AC adapter from the wall socket. (2) Turn the CU-7011 upside down. (3) Remove the protection sheet of the ...
-
Denso CU-7011 - page 16
6 6.2 Interface Cable Connection Connect the modular plug* of the Ethernet cable to the Ethernet port of the CU-7011. (*10Base-T 8-pin modular, RJ45, ITA/ETA category 3 or higher) Lock lever Ethernet cable •W hen connecting the modular plug, insert it until it snaps into place. To disconnect it, press the lock lever and pull it out. • Do not fo ...
-
Denso CU-7011 - page 17
7 6.3 Communication with the Host Computer This section describes how to start communication with the host computer according to the FTP in System Mode. (1) Turn on the host computer. (2) On the host computer, start the FTP server program. (3) Turn on the BHT and run System Mode. Set the TCP/IP parameters (incl. IP address and subnet mask)) and FTP ...
-
Denso CU-7011 - page 18
8 Chapter 7 Charging the Rechargeable Battery Cartridge You may charge the battery cartridge loaded in the BHT. Service Life of Rechargeable Battery Cartridge: Lithium-ion batteries used in the battery cartridge will gradually deteriorate during the repeated cycles of charging and discharging due to its properties, even under normal use. When the b ...
-
Denso CU-7011 - page 19
9 Operator's Action Place the BHT on the CU-7011. ⇓ After approx. 6 hours ⇓ Remove the BHT. CU-7011 Status On standby ⇓ Normal charging ⇓ Charging completed ⇓ On standby Indicator LED on the BHT OFF ON (in red) ON (in green) OFF ■ Charging Operation and BHT's Indicator LED The charging time is approx. 6 hours if the "Char ...
-
Denso CU-7011 - page 20
10 Chapter 8 Displaying the CU System Information on the BHT You may display the CU-7011 system information on the BHT's LCD. Set the BHT on the CU-7011 and operate the BHT to display the SYSTEM INFORMA- TION screen on the LCD. From that screen, you may call up the system program version and MAC address. For details about the displaying proced ...
-
Denso CU-7011 - page 21
11 Chapter 10 MAC Addr ess The MAC address of the CU-7011 is printed on the nameplate. Nameplate MAC address (example) ...
-
Denso CU-7011 - page 22
12 Appendix Specifications [ 1 ] Pr oduct Specifications Power Source -Europe 230 VAC, 16 VA -U.S. 120 VAC, 13 VA -Australia 10 to 18 VDC, 450 mA (on 12 VDC) Power Consumption 8 VA Dimensions 112 x 142 x 84 mm (W) x (L) x (H) (4.41 x 5.59 x 3.31 inches) Weight Approx. 220 g (Approx. 7.76 oz.) Operating Ambient Temperature 0˚C to 40˚C (32˚F to 10 ...
-
Denso CU-7011 - page 23
Communication Unit CU-701 1 User's Manual First Edition, October 2001 DENSO WAVE INCORPORATED The purpose of this manual is to provide accurate information in the handling and operating of the CU-7011. Please feel free to send your comments regarding any errors or omissions you may have found, or any suggestions you may have for generally impr ...
У вас вопрос, касающийся Denso CU-7011?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Denso CU-7011, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Denso CU-7011 со всей вероятностью он захочет поделиться методом ее решения.