-
Whynter ARC-13W/S - page 1
WHYNTER SNO PORTABLE AIR CONDITIONER MODEL# : ARC-13W/S ...
-
Whynter ARC-13W/S - page 2
2 Thank you for choosing the Whynter SNO portable air condi tioner. You have bought one of the best portable air conditioners available today . Follow the instructions given in this booklet to obtain the very best performance from your portable air conditioner and take full advant age of the many advance feat ures that your portable air conditioner ...
-
Whynter ARC-13W/S - page 3
3 PARTS OVERVIEW 1. Control panel 2. Pull handle 3. Air outlet grille 4. Air filter with gr ille 5. Drain plug 6. Outdoor air inlet 7. Outdoor ex haust 8. Top handle 9. Power cord ...
-
Whynter ARC-13W/S - page 4
4 Fi g . 2 Incorrect setu p Correct setu p Fi g . 3 ...
-
Whynter ARC-13W/S - page 5
5 SAFETY PRECAUTIONS • Ensure curtains or other objects are not obstructing the air inlet filters. (Fig.2) • Do not bend or crush the exhaust hose while in use. (Fig.2) • Transport the unit in an upright position only, or leave it in an upright position for at least 2 hours before first use. • Always place the unit on even and hard surface. ...
-
Whynter ARC-13W/S - page 6
6 WINDOW KIT INSTALLATION In order for this portable air conditioner to work properly, t he hot air from the back of the unit must be vented to the outsid e. Please follow the instructions below for wind ow kit installation. 1. Extend the exhaust hose (Part 1) at least 6” and inse rt it to the outdoor exhaust outlet at ba ck of the unit. 2. Attac ...
-
Whynter ARC-13W/S - page 7
7 INSTALLATION Fig. 4 When you use this air conditioner unit, hot air must be exhausted out of the room to complete the air exchange of the condenser . When the unit is operating in fan-only mode, no exhaust is required. Exhaust hose Installation The exhaust hose must be installed onto the unit. 1. Pull out about 6” of one end of the exhaust hose ...
-
Whynter ARC-13W/S - page 8
8 Window Installation (Fig. 4) 1. Make sure the exhaust hose is properly installed onto the portable air conditioner. 2. Open window or sliding door for approximately 5” (130 mm) 3. Adjust the length of the window kit to the same length and width of the opening of the window or the slidin g door. Cut the w indow piece if necessary to fit the leng ...
-
Whynter ARC-13W/S - page 9
9 CONTROL PANEL 1. Stand-by or Comfort ( automatic) function button 2. Red - Stand-by 3. Green - Air conditioner is on 4. Orange - On and/or o ff program is enabled 5. Green - Automatic function is on 6. Remote control si gnal reception button Fi g . 5 ...
-
Whynter ARC-13W/S - page 10
10 OPERATIONS SWITCHING ON THE AIR CONDITIONER The portable air conditioner can be switched on by the remote control or by pressing the On/Off button on the control panel. Without using the remote control, the unit can only be switched on the Comfor t (automatic) function. To transmit signals from the remote contro l to the air conditioner, point t ...
-
Whynter ARC-13W/S - page 11
11 INSTALLING BATTERIES • Only use 2 LR03 1.5V Batteries (inc luded) in the remote control. • Always change both batteries at the same time. • To insert the batteries, open the flap on the back of the remo te control. Strictly adhere to the polarity signs on the bottom of the battery housing, close the flap once the batteries have been insert ...
-
Whynter ARC-13W/S - page 12
12 REMOTE CONTROL BUTTONS DISPLAYS T1 On/Off D1 Fan speed or the automatic fan function mode (AUTO) T2 Comfort button (automatic) D2 Heating (not enabled) T3 Night Comfort button D3 Cooling function indicator T4 Function Mode selector D4 Dehumidifying function indicator T5 Fan Speed selector D5 Outdoor air outlet enabled (not enabled) T6 Set Time a ...
-
Whynter ARC-13W/S - page 13
13 Fig. 8 Fig. 9 SWITCHING ON/OFF THE AIR CONDITIONER (Button T 1 ) Press the T1 button to switch on/off the air conditioner (Fig. 8). The control system of the air conditioner stores the previously programmed data in its memory; therefore, the settings ar e not lost when the air conditioner is switched off. When the red LED (2) on the control pane ...
-
Whynter ARC-13W/S - page 14
14 When the Comfort function is on, the compressor will stop when the temperature is below 72°F and the compressor will st art when the temperature is above 72°F. F i g . 1 4 NIGHT COMFORT BUTTON (Button T3) Press the T3 button to activate the night comfort function (Fig.14). In this function, the air conditioner gradually increases the set tempe ...
-
Whynter ARC-13W/S - page 15
15 COOLING/ DEHUMIDIFICATION ONLY/ FAN ONLY F UNCTION (Button T4) Cooling Mode In this mode, the air conditioner cools and dehumidifies the room. To activate this function, press the T4 Fu nction Mode Select or button until the FROST symbol appears on the display (Fig. 10). When this function mode is set, the compressor will start in approximately ...
-
Whynter ARC-13W/S - page 16
16 Fan Only Mode In this mode, only the fan of the air conditioner runs and circulates the air in the room. To activate this funct ion mode, pres s the T4 Function Mode Selector button until just the FAN symbol appears on the display (Fig.12). Subsequently, set t he desired fan spee d. Please note that when switching function mode, there will be an ...
-
Whynter ARC-13W/S - page 17
17 FAN SPEED CONTROL (Button T5) Press the T5 button to set the fan speed. To change the fan speed, press this button repeatedly to achieve the following sequen ce (Fig 13): - Low, Medium, High and Automatic When set in Automatic fan speed mode, the air conditioner automatically adjusts the fan speed. In this mode, the greater the difference betwee ...
-
Whynter ARC-13W/S - page 18
18 SETTING THE FUNCTION PROGRAM MODES This air conditioner has two distinct function programs that can be used to stop and start the appliance at certain times (for example the air conditioner can be programmed to start just before you get home so when you arrive home, the temperature is pleasant). If you wish to use there functions, it is necessar ...
-
Whynter ARC-13W/S - page 19
19 Setting the On/Off times of the 1 st and 2 nd Function Programs (PROGR. 1 and PROGR.2) To set the air conditioner On/Off times for the two programs proceed as follows (Fig. 16): • To set the start time of the 1 st program - Press the T6 Set Time and Program button repeatedly until the PROGR.1 (D8) symbol with a vertical line on the left appear ...
-
Whynter ARC-13W/S - page 20
20 ENABLING AND DISABL ING THE F UNCTION PROGRAMS (Button T11) The function program(s) (either one or both) can be enabled or disabled (Fig. 17). - Press the T11 Enable Program button once and the 1 st program (D8) is enabled. Press the T11 button again, the 2 nd program (D9) is enabled. - Press the T11 button again, the 1 st and 2 nd programs (D8 ...
-
Whynter ARC-13W/S - page 21
21 RESETTING ALL REMOTE CONT ROL FUNCTIONS (Button T10) Press the T10 button to reset all remote control settings including timer and temperature settings (Fig. 18). Fig. 18 ...
-
Whynter ARC-13W/S - page 22
22 CONTROLLING THE AI R FLOW DIRECTION The direction of the airflow can be controlled vertically by moving the louvers up or down (Fig. 19). HOW TO MANAGE THE AIR CONDITION ER WITHOUT THE REMOTE CONTRO L If it is not possible to use the remote control eithe r because it was lost, has malfunctioned or the b atteries are flat, the ai r conditioner ca ...
-
Whynter ARC-13W/S - page 23
23 TRANSPORTATION The air conditioner is equipped with wheels and handles for easy portability. Before moving the air conditioner, proceed as follows: - Switch off the air conditioner and disconnect the plug from the power outlet - Drain water by removing the drain plug. - Always transport the air conditioner in an upright position only. For short ...
-
Whynter ARC-13W/S - page 24
24 MAINTENANCE CLEANING THE AIR FILTER To ensure the air intake is filtered pr operly and to assure that your air conditioner runs efficiently, it is crucial to clean the air filters regularly. When the air conditioner has been in use for a certain amount of time, the green LED (3) on the co ntrol panel (Fig. 5) will sta rt to flash indicating that ...
-
Whynter ARC-13W/S - page 25
25 CLEANING THE AIR CONDITIONER • Always switch off the air conditioner and disconnect the plug from the power supp ly outlet before cleaning the air conditioner. • Use a soft damp cloth to wipe the body of the air conditioner. • Never use harsh chemicals, oil-based pr oducts, detergents, chemically treated cloths or other cleaning solutions. ...
-
Whynter ARC-13W/S - page 26
26 TROUBLESHOOTING Problem Possible Causes Solutions The portable air conditione r does not turn on There was a power failure The automatic switch, line fuse, or breaker has b een tripp ed The power supply voltage is too low The power cord is damag ed The LCDI plug for the unit is tripped Restore the power supply Flip the switch / change the fuse / ...
-
Whynter ARC-13W/S - page 27
27 The exhaust is obstructed The unit is set in dehumidifying or fan mode The unit is set to low fan speed Check for and remove any obstruction s Set the unit in cooling mode Set the unit to a higher fan speed The unit has worked for a long time, but the room is not cold enough Windows or doors are open There are too many people in the room There i ...
-
Whynter ARC-13W/S - page 28
28 TECHNICAL DATA * Uninsulated rooms such as sunrooms, gar ages, or attics should be less than 450 sq. ft. Cooling capacity 13,000 BTU Recommended room size* 450 – 500 sq. ft. E.E.R. – Energy efficiency rate 11.06 Power supply 115v/ 60Hz Maximum power input 1175 W Maximum input 10.21 Amp Dehumidifying capacity 43 Pts / Day Function programs 2 ...
-
Whynter ARC-13W/S - page 29
29 ONE YEAR LIMITED WARRANTY & FIVE YEAR WARRANTY ON COMPRESSOR This WHYNTER SNO portable air conditioner is warranted, to the or iginal owner within the 48 continental states, for one year fr om the date of purchase against defects in material and workmanship under normal use and service. Should your SNO portable air conditioner prove defectiv ...
У вас вопрос, касающийся Whynter ARC-13W/S?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Whynter ARC-13W/S, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Whynter ARC-13W/S со всей вероятностью он захочет поделиться методом ее решения.