-
Aiwa XR-EM20 - page 1
U XR-EM20 8C-CL7-903-01 011228ACK-H-BF For assistance and information (United States and Puerto Rico) Owner’ s record For your convenience, record the model number and serial number (you will find them on the rear of your set) in the space provided below . Please refer to them when you contact your Aiwa dealer in case of difficulty . Model No. Se ...
-
Aiwa XR-EM20 - page 2
2 En W ARNING To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture. Explanation of Graphical Symbols: The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’ s enclosure that may be ...
-
Aiwa XR-EM20 - page 3
3 En Outdoor Antenna Power lines - An outside antenna system should not be located in the vicinity of overhead power lines or other electric light or power circuits, or where it can fall into such power lines or circuits. When installing an outside antenna system, extreme care should be taken to keep from touching such power lines or circuits as co ...
-
Aiwa XR-EM20 - page 4
4 En Remote control Detach the battery compartment lid at the rear of the remote control and insert two R6 (size AA) batteries with correct polarity . R6(AA) • Replace the batteries with new ones when the operational distance between the remote control and main unit becomes shorter . • Remove the batteries if the unit is not going to be used fo ...
-
Aiwa XR-EM20 - page 5
5 En PA RTS AND CONTROLS Main unit 4 s CLEAR CD and T ape: stops playback. Radio: clears a preset station. 5 PHONES jack Plug in optional headphones set with a stereo mini plug (ø3.5 mm). Speaker output is canceled. 6 V OLUME Adjusts the volume etc.. 7 T ONE Selects the sound adjusting mode, " BAS " (bass) or " TRE " (treble). ...
-
Aiwa XR-EM20 - page 6
6 En Remote control 1 4 7 5 6 9 8 ! 0 2 3 Buttons with the same or similar names on the main unit basically have the same function. 1 PO WER 2 0–10, +10 CD: selects a track of the specified number . Radio: tunes in the station with the specified preset number . The numbered buttons take on these functions when pressed with SHIFT held down : CLOCK ...
-
Aiwa XR-EM20 - page 7
7 En ADJUSTMENTS BEFORE OPERA TION CLOCK SET SHIFT f , g s POWER 6 ST ANDBY/ON T APE, TUNER/A UX/BAND , CD CD , TUNER/BAND , T APE,A UX, s T ONE DISPLA Y DISPLA Y f , g Setting the clock 1 Hold down SHIFT and press CLOCK on the remote control. When the unit is turned off, you can also press SET . 2 Within 6 seconds, press f or g to set the time. Ea ...
-
Aiwa XR-EM20 - page 8
8 En This unit plays back finalized CD-R/RW discs as well as audio CDs. Playing a CD 1 Press OPEN to open the disc compartment. Place a disc with the label side up. Then close the disc compartment by pressing OPEN. 2 Press E to start play . To stop play Press s . To pause play Press E . Press again to resume play . To skip to the beginning of the c ...
-
Aiwa XR-EM20 - page 9
9 En Programmed play Plays back up to 30 selected tracks in programmed order . 1 Hold down SHIFT and press PROGRAM on the remote control in stop mode. " PRGM " flashes on the display . 2 Press the numbered buttons on the remote control to program a track. -T o select the 25th track, press +10, +10 and 5. -T o select the 11th track, press ...
-
Aiwa XR-EM20 - page 10
10 En RADIO OPERA TIONS Manual tuning 1 Press TUNER/AUX/BAND (TUNER/BAND on the remote control) repeatedly to select a band. 2 Press f or g repeatedly to tune in a station. " TUNE " is displayed when a station is tuned in. " 1 " is displayed for FM stereo reception. To search for a station automatically (Auto search) Hold down f ...
-
Aiwa XR-EM20 - page 11
11 En SOUND ADJUSTMENTS V olume Tu rn VOLUME (press VOLUME + , - on the remote control). Adjust from 0 (minimum) to 30 and MAX (maximum). Tip : V olume level setting is retained during power -off standby. If the unit is turned off with the volume set to 17 or higher , it is automatically turned down to 16 the next time the unit is turned on. VO L U ...
-
Aiwa XR-EM20 - page 12
12 En T APE PLA YBACK Playback Use only type I (normal) tapes. 1 Press z PUSH EJECT to open the cassette holder . 2 Insert the tape. Insert with the exposed side down and the side to be played facing out from the unit, and press z PUSH EJECT to close the cassette holder . 3 Press c to start play . To stop playback Press s . To rewind or fast forwar ...
-
Aiwa XR-EM20 - page 13
13 En To start CD recording more easily Insert the tape to be recorded, load the disc, and press SYNCHRO REC. Regardless of the function currently selected, CD play and tape recording start simultaneously . • In CD stop mode, tape recording starts from the beginning of the disc (all tracks recording). When CD playback stops, tape recording stops ...
-
Aiwa XR-EM20 - page 14
14 En 4 Press the numbered buttons on the remote control to enter the length of the recording tape. 10 to 99 minutes can be specified. - For a 60-minute tape press 6 and 0. In a few seconds, the unit determines the tracks to be recorded for each side. The recording time left for side A appears on the display . • f or g can also be used to specify ...
-
Aiwa XR-EM20 - page 15
15 En Side A T ab for side A 8 Hold down SHIFT and press CD EDIT/CHECK once to switch back to side A. 9 Press REC/REC P AUSE once. The tape is rewound to the beginning of side A. " REC MUTE " flashes on the display and the lead segment is played through for 10 seconds, and recording starts. Go to the next step when recording on side A fin ...
-
Aiwa XR-EM20 - page 16
16 En TIMER OPERA TIONS Sleep timer Tu r ns off the unit automatically after a specified time. 1 Hold down SHIFT and press SLEEP on the remote control. " 5 " and " SLP " is displayed. 2 Within 6 seconds, press f or g repeatedly to set the sleep timer duration. With each press, the timer duration changes in 5-minute steps between ...
-
Aiwa XR-EM20 - page 17
17 En T imer recor ding Timer recording is available only for TUNER and AUX (with an external timer) sources. 1 Hold down SHIFT and press TIMER on the remote control repeatedly so that " 5 REC " is displayed. 2 Within 6 seconds, press SET . 3 Press f or g to set the timer-on time, and press SET . Each press changes the time in 1-minute st ...
-
Aiwa XR-EM20 - page 18
18 En Care and maintenance Occasional care and maintenance of the unit and the software are needed to optimize the performance of your unit. To clean the cabinet Use a soft and dry cloth. If the unit surfaces are extremely dirty , use a soft cloth lightly moistened with mild detergent solution. Do not use strong solvents such as alcohol, benzine or ...
-
Aiwa XR-EM20 - page 19
19 En Specifications MAIN UNIT CX-LEM20 TUNER FM tuning range 87.5 MHz to 108 MHz FM usable sensitivity (IHF) 13.2 dBf FM antenna terminal 75 ohms (unbalanced) AM tuning range 530 kHz to 1710 kHz (10 kHz step) 531 kHz to 1602 kHz (9 kHz step) AM usable sensitivity 350 µV/m AM antenna Loop antenna AMPLIFIER Power output 6 W + 6 W (40 Hz - 20 kHz, T ...
-
Aiwa XR-EM20 - page 20
Printed in China NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and ...
У вас вопрос, касающийся Aiwa XR-EM20?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Aiwa XR-EM20, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Aiwa XR-EM20 со всей вероятностью он захочет поделиться методом ее решения.