-
Dover Finishing Products 2220 - page 1
2020/2220/2520/2210/2510/2200/2500 1 03.27883.100 INSTALLATION INSTRUCTIONS AND OPERATING MANUAL FIREPLACE 2020/2220/2520/2210/2510/2200/2500 ...
-
Dover Finishing Products 2220 - page 2
2020/2220/2520/2210/2510/2200/2500 3 03.27883.100 Table of contents pag e Foreword 1. Introduction ....................................................................................................................... 3 2. Safety ....................................................................................................................... ...
-
Dover Finishing Products 2220 - page 3
2020/2220/2520/2210/2510/2200/2500 3 03.27883.100 Foreword The Installation Manual and Operators Instructions must accompany this appliance. As well as instructions for installa tion and information about use, you will also find advice concerning safety and maintenance. Please read this booklet carefull y before installation and before firing the u ...
-
Dover Finishing Products 2220 - page 4
2020/2220/2520/2210/2510/2200/2500 4 03.27883.100 3 . Princip l e The Dovre model is designed to provide a fireplace convection system without the need to construct a masonry convec tion chamber. The principle of operation is that the cooler air from the lower part of the room is drawn under the base of the inner cast iron unit. Warm air is produce ...
-
Dover Finishing Products 2220 - page 5
2020/2220/2520/2210/2510/2200/2500 5 03.27883.100 4 . Installation guideline 4 .1. Preparatory measures The fireplace should be hermetically connected to a well - functioning chimney, suff i- ciently enclosed to keep combustible materials (floor and walls) at a distance, and should be installed in a room with sufficien t ventilation. Please inform ...
-
Dover Finishing Products 2220 - page 6
2020/2220/2520/2210/2510/2200/2500 6 03.27883.100 The same is true for a cover plate or exhaust hood on top of the chimney. The exhaust hood must not narrow the chimney's outlet and should be designed in a way that wind will not hinder, but promote the smoke flow. • Especially if the flue runs through unhe ated rooms or outside the house, fu ...
-
Dover Finishing Products 2220 - page 7
2020/2220/2520/2210/2510/2200/2500 7 03.27883.100 Convection air may be led to arrive from both the room and outside (other room, cellar, exterior) to the bottom side of the fire place. In case convection air is supplied (directly or indirectly) from outside, it may also be useful as a supply of fresh air for combustion. At any rate, assure proper ...
-
Dover Finishing Products 2220 - page 8
2020/2220/2520/2210/2510/2200/2500 8 03.27883.100 4 .1.4. Combustible material round the fireplace Within the radiation area of the fireplace Assure a distance of at least 80 cm between the opening of the fireplace and co m- bustible material. That distance may be reduced to 40 cm if the combustible mat e- rial is sufficiently shielded and well ven ...
-
Dover Finishing Products 2220 - page 9
2020/2220/2520/2210/2510/2200/2500 9 03.27883.100 4.2.3. Fitting frame surround The decorative frames, 3 and 4 sides versions are fitted to the applaice after install a- tion. Ensure that sufficient space is allowed to both sides of the recess. ...
-
Dover Finishing Products 2220 - page 10
2020/2220/2520/2210/2510/2200/2500 10 03.27883.100 4.2.4. Assembling the “cold handle” Assemble the different parts of the handle, I.e. a screw M8x50, a wooden handle and a nut, as indicated on the s- ketch. 4.2.5. Electrical connection For protection, the unit must always be connected to power. The appliance is su p- plied with a speed control ...
-
Dover Finishing Products 2220 - page 11
2020/2220/2520/2210/2510/2200/2500 11 03.27883.100 4 .3. Installation The appliance is designed to be built into a new or existing chimney breast install a- tion to provide space heating by radiant an convected heat. 4.3.1. To be built into a new chimney Build the new fire place arou nd the appliance ensuring that no materials are built onto the ap ...
-
Dover Finishing Products 2220 - page 12
2020/2220/2520/2210/2510/2200/2500 12 03.27883.100 4.4. Finishing When the appliance is installed in the right place, its connection with the chi m- ney made airtight, and the masonry mantle completely mounted, all loose parts are installed in the appliance. Your fireplace i s now ready to be used. Depending on the materials used for mounting, it i ...
-
Dover Finishing Products 2220 - page 13
2020/2220/2520/2210/2510/2200/2500 13 03.27883.100 Example of fireplace installation within combustible material Fireproof floor Combustible ceiling Opening against eventual pressure buildup Chimney Extra opening for ventilation fireplace Stainless steel pipe Insulation (if necessary) Canvection air outlet Convection air inlet Combustible floor Con ...
-
Dover Finishing Products 2220 - page 14
2020/2220/2520/2210/2510/2200/2500 14 03.27883.100 Example of installation in an existante fireplace Existant chimney Extra opening for ventilation firepalce Refractory cement or special connector Opening against eve n tual pressure builup Convection air outlet Convection air inlet Ventilation: min 15 mm) E xistant fir e- place ...
-
Dover Finishing Products 2220 - page 15
2020/2220/2520/2210/2510/2200/2500 15 03.27883.100 5 . Instructions for use 5.1. Fuel The only suitable fuels for this stove are wood, brown coal briquettes and charcoal (when you u se a coal - basket). No other fuels are allowed to be burnt, as they can inflict serious damage to your stove. Do not burn any tre ated wood either, such as scrap wood, ...
-
Dover Finishing Products 2220 - page 16
2020/2220/2520/2210/2510/2200/2500 16 03.27883.100 glowing enough, you can put the logs, the charcoal or the brown coal briquettes on the fire. 5.3. Burning wood Always keep the stove doors tightly closed. Never let the doo rs open when the fire is burning. Add extra fuel when necessary. Never add too much fuel. It is best to fill the stove for one ...
-
Dover Finishing Products 2220 - page 17
2020/2220/2520/2210/2510/2200/2500 17 03.27883.100 Before adding some extra coals, u se the shaker grate or the supplied shovel, and shake till the glowing parts fall into the ash plate ; then add the coals. After a few minutes, add some more coals until you can only see the glow of the prev ious filling. When the fire basket or the cast - iron pla ...
-
Dover Finishing Products 2220 - page 18
2020/2220/2520/2210/2510/2200/2500 18 03.27883.100 6 . Maintenance It takes only little effort to keep your appliance in good condition. Regularly check whether the sealing cord s till closes the doors tightly enough. Minor paint damage can be touched up with a can of spray paint. Your dealer can supply yo u with the correct spray product. During t ...
-
Dover Finishing Products 2220 - page 19
2020/2220/2520/2210/2510/2200/2500 19 03.27883.100 Annex 1: technical data sheet Model 2500 / 2510 / 2520 2510D / 2520/2/3 2200 / 2210 / 2220 / 2020 Nominal heat output 10 kW 10 kW 8 kW (2020: 7 kW) Flue connection (diametre) 150 mm 150 mm Advised combustibles Hout Bois Wood Holz Bruinkool lignite Browncoal Braunkohl Kolen Charbon Coal Kohlen Hout ...
-
Dover Finishing Products 2220 - page 20
2020/2220/2520/2210/2510/2200/2500 20 03.27883.100 Annex 2 : D imensions 2500 2200 ...
-
Dover Finishing Products 2220 - page 21
2020/2220/2520/2210/2510/2200/2500 21 03.27883.100 2220 2210S 2520S 2510S ...
-
Dover Finishing Products 2220 - page 22
2020/2220/2520/2210/2510/2200/2500 22 03.27883.100 2020S 2520S/2/3 2510D ...
-
Dover Finishing Products 2220 - page 23
2020/2220/2520/2210/2510/2200/2500 72 03.27883.100 DOVRE N.V. Tel : +32 (0) 14 65 91 91 Nijverheidsstraat 18 Fax : +32 (0) 14 65 90 09 B - 2381 Weelde E - mail : info@dovre.be _______ ____________________________________________________ 03.27883.100 0608 I n het kader van een continue productverbetering, kunnen specificaties van het geleverde toest ...
У вас вопрос, касающийся Dover Finishing Products 2220?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Dover Finishing Products 2220, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Dover Finishing Products 2220 со всей вероятностью он захочет поделиться методом ее решения.