-
Haier HWD-D1000TXVE - page 1
USER MANUAL Automatic Drum W ashing Machine HWD-D1200TXVE HWD-D1200TXVEME HWD-D1000TXVE HWD-D1000TXVEME ...
-
Haier HWD-D1000TXVE - page 2
page no. Before use Parts .......................................................................................................... 1 Safety instructions ................................................................................. 2 - 4 Installation ............................................................................................ 5 ...
-
Haier HWD-D1000TXVE - page 3
1 This diagram may vary slightly with the layout of the washing machine you have just purchased due to technical improvements. NOTICE Please read these instructions carefully before using this appliance. The instructions contain important information which will help you get the best out of the appliance and ensure safe and proper installation, use ...
-
Haier HWD-D1000TXVE - page 4
2 Using your appliance will be simple, but please make sure read the following to get the best out of it and to ensure your own safety . BEFORE SWITCHING THE APPLIANCE ON FOR THE FIRST TIME: DO ✓ Ensure you connect the appliance directly to a domestic mains water supply . ✓ Ensure that the appliance is situated on a firm level base. ✓ Ensure ...
-
Haier HWD-D1000TXVE - page 5
3 DURING DAIL Y USE OF THE APPLIANCE DO ✓ Unplug the appliance before carrying out any maintenance or repair . ✓ Hold the plug and not the electric cable when unplugging the washing machine. ✓ Keep the door slightly open when not in use to prevent formation of odours. ✓ After each wash programme, turn off the machine and switch it off at th ...
-
Haier HWD-D1000TXVE - page 6
4 Electrical connection (UK ONL Y) For your safety please read the following information W arning: This appliance must be earthed. The appliance must be connected to a 220 volt 240 cycle AC supply by means of a three pin socket, suitably earthed and should be protected by a 13 amp fuse. The appliance is supplied with a standard 3 pin mains plug fi ...
-
Haier HWD-D1000TXVE - page 7
Caution: protective gloves should be warn • Remove all the packing materials (including the foam base) to prevent vibration during use, as show in Fig. 1. On opening, water drops may be visible on the appliance. This is a normal phenomenon. • Check that the appliance is also supplied with the following: • Remove the packing bolts as shown in ...
-
Haier HWD-D1000TXVE - page 8
6 Connecting the hose to the cold water supply 1. Connect the nut on the water inlet hose to the connector on the water valve. Ensure all seals are in place. 2. Tighten the nut to secure the hose. Drain hose • The height of the drainage outlet must be between 80-100cm. T o prevent the drain hose from dropping, attach it using the drain hose clip ...
-
Haier HWD-D1000TXVE - page 9
7 C o n t r o l p a n e l A. Po w er bu tt on G . St ar t/ Pau se b ut to n B . Pro g r am m e selec t io n d ial H . b ut to n C . D et er g en t d istr ib ut io n dr a w er I. D r y b ut to n D . S p in spe ed sett in g b ut to n J . Ex t ra r in se b ut to n E. D ispl ay K . D e lay b ut to n F . W ash sta tu s in d ic ato r L. Wa sh tem p er at ...
-
Haier HWD-D1000TXVE - page 10
8 G. Start/Pause button When the washing machine is connected to the power socket and a programme is selected, touch this button to start operation. T ouch this button again during operation to pause the programme. The display screen will flash and the machine will be paused. Press the button again and the programme will continue. H. button Econom ...
-
Haier HWD-D1000TXVE - page 11
9 Programme selection guide NOTE: “O” indicates that softener can be added if need; “ ★ ” indicates that detergent must be added; “X” indicates that detergent must not added; “*” indicates cold water . 1) The wash temperature indicates the maximum temperature. 2) The wash temperature refers to the maximum temperature. The wash cyc ...
-
Haier HWD-D1000TXVE - page 12
10 Preparing for a cycle Detergent selection Only special low foam detergent should be used in automatic drum washing machines. For blended or wool fabrics, special detergent should be used. Dry cleaning solvent should not be used. Caution: do not use too much detergent. Laundry treatment • Sort out clothes according to type and extent of dirt. T ...
-
Haier HWD-D1000TXVE - page 13
1. Loading Open the door , put in the laundry piece by piece and then tightly close the door . Notes: 1) Before the first run of the appliance it is advisable to run the machine empty on a quick wash with no detergent to clean through the system. 2) Do not overload the washing machine. • Overalls (cotton approx. 950g) • T -shirt (approx. 300g) ...
-
Haier HWD-D1000TXVE - page 14
12 3. Selecting washing programme T o get the best wash, an appropriate washing programme should be selected according to the type of laundry . 4. W ashing temperature settings Set the washing temperature as required, otherwise set at position * when a cold wash is acceptable. 5. Function selection buttons Select functions as required (refer to the ...
-
Haier HWD-D1000TXVE - page 15
1. Control panel lock function: T o prevent children from accidentally changing the settings, the control panel can be locked by pressing the “T emperature” and “Delay” buttons at the same time. After the panel is locked, the sign “LOCK” and the remaining wash time will be displayed on the LED alternately . Now all the function keys exc ...
-
Haier HWD-D1000TXVE - page 16
14 1. T urn off the water tap and pull out electricity plug after each wash. Open the porthole to prevent formation of moisture and odours. If the washing machine is left idle for a long period, drain the water in the machine and replace the drain hose. 2. Unplug the machine during cleaning and maintenance. Use a soft cloth dampened with soap liqui ...
-
Haier HWD-D1000TXVE - page 17
5. T o prevent blockage to the water supply by ingress of foreign substances, clean the water inlet and inlet filter regularly . 6. If the machine is to be moved to a distant place, replace the vibration absorbing locks (packing screws, rubber gaskets) removed before installation to prevent damage as shown below . 7. If the washing machine is left ...
-
Haier HWD-D1000TXVE - page 18
16 T rouble shooting In the unlikely event of difficulties with your appliance please follow the trouble shooting guide below . If the problem persists, contact an approved service engineer . If an error code is displayed, please refer to the error code guide below . Problem Possible cause How to correct the problem The washing machine fails to op ...
-
Haier HWD-D1000TXVE - page 19
1 7 M o d el / I tem H W D - D 1 0 0 0 T X V E/ M E H W D -D 1 2 0 0 T X V E/ M E Po w er So u rc e 2 2 0 - 2 4 0 V / 5 0 H z 2 2 0 - 2 4 0 V / 5 0 H z W o rkin g C ur ren t ( M a x ) ( A) 1 0 1 0 Tap W a ter Pr essur e ( M Pa) 0 . 0 3 P 1 0 . 0 3 P 1 W ash in g Po w er ( W ) 2 0 0 2 0 0 Sp in n in g Po w er ( W ) 3 5 0 4 5 0 M a x Lo ad ( kg ) 6 6 ...
-
Haier HWD-D1000TXVE - page 20
W e apologise for any inconvenience caused by minor inconsistencies in these instructions, which may occur as a result of product improvement and development. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be handed over to the applicable collection point for the re ...
У вас вопрос, касающийся Haier HWD-D1000TXVE?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Haier HWD-D1000TXVE, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Haier HWD-D1000TXVE со всей вероятностью он захочет поделиться методом ее решения.