-
Napoleon Fireplaces SRPT03-XXXX - page 1
T a bletop P a tio Hea ter Owner ’ s Manual Standard: ANSI Z83.26-2007 / CSA 2.37-2007 ANSI Z83.26a-2008 / CSA 2.37a-2008 Gas-Fired Outdoor Infrared Patio Heaters. Questions, problems, missing / replacement parts? Before returning to your retailer , call our customer service department at 1-866-814-0585, 8 a.m.-5 p.m., EST , Monday-Friday . I ...
-
Napoleon Fireplaces SRPT03-XXXX - page 2
2 This appliance can produce carbon monoxide which has no odor . Using it in an enclosed space can kill you. Never use this appliance in an enclosed space such as a camper , tent or home. DANGER CARBON MONOXIDE HAZARD W ARNING: Improper installation, adjustment, alteration, services or maintenance can cause injury , death or property damage. Read t ...
-
Napoleon Fireplaces SRPT03-XXXX - page 3
3 PRECAUTIONS The installation must conform with local codes or , in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFP A 54, NFP A58 Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2 The heater , when installed, must be electrically grounded in accordance with local codes ...
-
Napoleon Fireplaces SRPT03-XXXX - page 4
4 PRECAUTIONS Within a partial enclosure which includes an overhead cover and three side walls, as long as 30 percent or more of the horizontal periphery of the enclosure is permanently open. This appliance requires 16.4oz (1lb) LP_gas supply cylinder . The LP-gas supply cylinder to be used must be: Constructed and marked in accordance with the Spe ...
-
Napoleon Fireplaces SRPT03-XXXX - page 5
5 35(&$87,216 35(&$87,216 35(&$87,216 35(&$87,216 WARNINGS AND CAUTIONS This heater is designed to operate with a standard 1 Ib propane cylinder with Approved Cylinder Connection. NOTE: PLEASE READ THE FOLLOWING SAFETY RULES: TOOLS NEEDED: (NOT INCLUDED) Adjustable open end wrench Philips screwdriver Estimated time for assembly: 15 ...
-
Napoleon Fireplaces SRPT03-XXXX - page 6
6 P ARTS LIST Please check the contents of the packaging as to whether anything is missing! The fasteners used comply with ANSI/BL.1 1 Base 1 Housing 1 Burner Column 2 Emitter Screen Shield 1 Emitter Screen 1 Reflector Dome 1 Dome Cap 1 Decorative Dome Cap Nut 1 2 3 4 5 6 7 8 9 10 11 12 13 3 7 M4 x 8 Bolts 7 M4 x 6 Bolts 3 M6 Nuts 6 6mm W ashers 1 ...
-
Napoleon Fireplaces SRPT03-XXXX - page 7
7 Step 1 Step 2 ASSEMBL Y W ARNING : ONL Y AN AUTHORIZED GAS TECHNICIAN SHOULD INST ALL THIS PRODUCT . Step 2 Insert the three clamps of the burner column (3) into the three spring pieces of the housing (2) per the picture and screw over . Make sure the clamp and the spring piece fit together . Step 1 Attach housing (2) to base (1) using seven M4 x ...
-
Napoleon Fireplaces SRPT03-XXXX - page 8
Step 4 ASSEMBL Y 8 Step 3 Attach emitter screen (5) to burner column (3) using three M4 x 8 bolts (9) Note: The ignition hole on emitter screen must line to the control knob. Step 4 Attach reflector dome (6) to emitter screen (5) using six 6mm washers (12) and three M6 nuts (1 1). Then attach dome cap (7) and decorative dome cap nut (8) to refl ...
-
Napoleon Fireplaces SRPT03-XXXX - page 9
ASSEMBL Y 9 Step 5 Step 6 Step 5 Attach emitter screen shield (4) to burner column (3) using four M4 x 8 bolts (9). Step 6 Open the access door . Open up the gas bottle cover . Attach it to the regulator . Aim at the screw thread. T urn counter clockwise and tighten. 4 4 4 4 3 3 9 Hardware Used 9 M4 x 8 bolt X 4 Regulator Gas bottle T ighten ...
-
Napoleon Fireplaces SRPT03-XXXX - page 10
10 SAFETY CHECK Check for leak Your patio heater has been checked at all factory connections for leakage. To check the connections at the tube/regulator/cylinder. 1) Make leakage solution by mixing 1 part liquid dish soap and 3 parts water. 2) Spoon several drops (or use squirt bottle) of the solution onto the tube/regulator/cylinder connections. 3 ...
-
Napoleon Fireplaces SRPT03-XXXX - page 11
11 OPERA TION Before turning gas supply ON W ARNING: DO NOT A TTEMPT TO OPERA TE HEA TER UNTIL YOU HA VE READ AND UNDERST AND ALL PRECAUTION . F AILURE TO DO SO CAN RESUL T IN SERIOUS PERSONAL INJUR Y , DEA TH, OR PROPERTY DAMAGE. Before Lighting Heater should be thoroughly inspected before each use, and by a qualified service person at least annua ...
-
Napoleon Fireplaces SRPT03-XXXX - page 12
12 OPERA TION Flame Characteristic The flame pattern at the emitter screen should be visually checked whenever heater is operated. Normally the burner flame is blue, but little yellow flame is acceptable. If flames extend beyond surface of the emitter grid , or the phenomena of flame lift or light back, or black spot is accumulating on the emitter ...
-
Napoleon Fireplaces SRPT03-XXXX - page 13
13 OPERA TION NOTE: The burner may be noisy when initially turned on. T o eliminate excessive noise from the burner , turn the Control Knob to the "LOW" position. Then, turn the knob to the level of heater desired. When heater is ON: Emitter screen will become bright red due to intense heat. The color is more visible at night. Burner will ...
-
Napoleon Fireplaces SRPT03-XXXX - page 14
14 LOCA TING HEADER FOR USE CAUTION: WHEN CERT AIN MA TERIALS OR ITEMS ARE LEFT , ABOVE, BESIDE OR UNDER THIS HEA TER WHILE IN USE, THEY WILL BE SUBJECT TO RADIANT HEA T AND COULD BE SERIOUSL Y DAMAGED. This heater is primarily used for the heating of outdoor patios, decks, spas, pools and open working areas. Always make sure that adequate fresh ai ...
-
Napoleon Fireplaces SRPT03-XXXX - page 15
15 MAINTENANCE/ST ORAGE DO NOT touch or move heater for at least 45 minutes after use. Allow all burner elements to cool before touching. FOR YOUR SAFETY ; W ARNING: NOTE: In a salt-air environment (such as near an ocean). corrosion occurs more quickly than normal. Frequently check for corroded areas and repair them promptly . NOTE: wait until heat ...
-
Napoleon Fireplaces SRPT03-XXXX - page 16
16 MAINTENANCE/ST ORAGE NOTE: wait until heater is cool before covering. T urn the control knob to "OFF" position. T urn clockwise to disconnect cylinder from regulator . Store heater upright in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail, snow , dust and debris). If desired, cover heater to pro ...
-
Napoleon Fireplaces SRPT03-XXXX - page 17
17 PROBLEM PROBABLE CAUSE SOLUTION Pilot will not light Gas valve may be OFF T urn the gas valve ON T ank fuel empty Refill LP gas tank Air in supply system Purge air from lines Loose connection Loose connection Check all fittings Pilot will not stay on Debris around pilot Clean dirty area T ighten connection Thermocouple Contact customer service G ...
-
Napoleon Fireplaces SRPT03-XXXX - page 18
18 ONE-YEAR LIMITED WARRANTY The appliance has been manufactured under the highest standards of quality and workmanship. We warrant to the original consumer purchaser that all aspects of this product will be free of defects in material and workmanship for one (1) year from the date of purchase. A replacement for any defective part will be supplied ...
-
Napoleon Fireplaces SRPT03-XXXX - page 19
19 SRPT03-XXXX color m a t e r i a l & b a s e v e n t h o l e s h a p e reflector reflector 1. 1PC reflector 2. 2PCS reflector 3. 3PCS reflector venthole shape 1. Round 2. Rhombic 3. Rectan gle material & base 1. Steel w/ bigger base 2. S/S w/ bigger base 3. Stee ...
У вас вопрос, касающийся Napoleon Fireplaces SRPT03-XXXX?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Napoleon Fireplaces SRPT03-XXXX, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Napoleon Fireplaces SRPT03-XXXX со всей вероятностью он захочет поделиться методом ее решения.